Anne C. Berends
Anne C. Berends has a total of 27 co-authors. Here are the top co-authors by number of shared publications:
- Marie Anne van de Haar
Seaborough Research B.V. Matrix VII Innovation Center Science Park 106 Amsterdam 1098 XG The Netherlands
2 shared publications Michael R. Krames
Seaborough Research BV, Matrix VII Innovation Center, Science Park 106, 1098 XG, Amsterdam, The Netherlands
2 shared publications- Andries Meijerink
Debye Institute for Nanomaterials Science, Utrecht University
1 shared publication - Celso de Mello Donegá
Utrecht University
1 shared publication - Chenghui Xia
School of Materials Science and Engineering Ocean University of China Qingdao China
1 shared publication Christina H. M. van Oversteeg
Condensed Matter and Interfaces, Debye Institute for Nanomaterials Science, Utrecht University, 3508 TA Utrecht, The Netherlands
1 shared publication
Latest Publications
- Open Access
- 18 October 2024
- Published by Elsevier in Journal of Biotechnology
- Vol. 396, 53-61
Lipid analysis of human primary dermal fibroblasts and epidermal keratinocytes after near-infrared exposure using mass spectrometry imaging
- 18 October 2024
- Published by Elsevier in Journal of Biotechnology
- Vol. 396, 53-61
Open AccessLipid analysis of human primary dermal fibroblasts and epidermal keratinocytes after near-infrared exposure using mass spectrometry imaging
- Open Access
Effects of Near-Infrared Light on Well-Being and Health in Human Subjects with Mild Sleep-Related Complaints: A Double-Blind, Randomized, Placebo-Controlled Study
Modern urban human activities are largely restricted to the indoors, deprived of direct sunlight containing visible and near-infrared (NIR) wavelengths at high irradiance levels. Therapeutic exposure to doses of red and NIR, known as photobiomodulation (PBM), has been effective for a broad range of conditions. In a double-blind, randomized, placebo-controlled study, we aimed to assess the effects of a PBM home set-up on various aspects of well-being, health, sleep, and circadian rhythms in healthy human subjects with mild sleep complaints. The effects of three NIR light (850 nm) doses (1, 4, or 6.5 J·cm−2) were examined against the placebo. Exposure was presented five days per week between 9:30 am and 12:30 pm for four consecutive weeks. The study was conducted in both summer and winter to include seasonal variation. The results showed PBM treatment only at 6.5 J·cm−2 to have consistent positive benefits on well-being and health, specifically improving mood, reducing drowsiness, reducing IFN-γ, and resting heart rate. This was only observed in winter. No significant effects on sleep or circadian rhythms were noted. This study provides further evidence that adequate exposure to NIR, especially during low sunlight conditions, such as in the winter, can be beneficial for human health and wellness.
Open AccessEffects of Near-Infrared Light on Well-Being and Health in Human Subjects with Mild Sleep-Related Complaints: A Double-Blind, Randomized, Placebo-Controlled Study
Modern urban human activities are largely restricted to the indoors, deprived of direct sunlight containing visible and near-infrared (NIR) wavelengths at high irradiance levels. Therapeutic exposure to doses of red and NIR, known as photobiomodulation (PBM), has been effective for a broad range of conditions. In a double-blind, randomized, placebo-controlled study, we aimed to assess the effects of a PBM home set-up on various aspects of well-being, health, sleep, and circadian rhythms in healthy human subjects with mild sleep complaints. The effects of three NIR light (850 nm) doses (1, 4, or 6.5 J·cm−2) were examined against the placebo. Exposure was presented five days per week between 9:30 am and 12:30 pm for four consecutive weeks. The study was conducted in both summer and winter to include seasonal variation. The results showed PBM treatment only at 6.5 J·cm−2 to have consistent positive benefits on well-being and health, specifically improving mood, reducing drowsiness, reducing IFN-γ, and resting heart rate. This was only observed in winter. No significant effects on sleep or circadian rhythms were noted. This study provides further evidence that adequate exposure to NIR, especially during low sunlight conditions, such as in the winter, can be beneficial for human health and wellness.
- Open Access
- 10 June 2021
- Published by American Chemical Society (ACS) in ACS Nano
- Vol. 15 (6) , 9987-9999
Synthesis and Formation Mechanism of Colloidal Janus-Type Cu2–xS/CuInS2 Heteronanorods via Seeded Injection
Colloidal heteronanocrystals allow for the synergistic combination of properties of different materials. For example, spatial separation of the photogenerated electron and hole can be achieved by coupling different semiconductors with suitable band offsets in one single nanocrystal, which is beneficial for improving the efficiency of photocatalysts and photovoltaic devices. From this perspective, axially segmented semiconductor heteronanorods with a type-II band alignment are particularly attractive since they ensure the accessibility of both photogenerated charge carriers. Here, a two-step synthesis route to Cu2–xS/CuInS2 Janus-type heteronanorods is presented. The heteronanorods are formed by injection of a solution of preformed Cu2–xS seed nanocrystals in 1-dodecanethiol into a solution of indium oleate in oleic acid at 240 °C. By varying the reaction time, Janus-type heteronanocrystals with different sizes, shapes, and compositions are obtained. A mechanism for the formation of the heteronanocrystals is proposed. The first step of this mechanism consists of a thiolate-mediated topotactic, partial Cu+ for In3+ cation exchange that converts one of the facets of the seed nanocrystals into CuInS2. This is followed by homoepitaxial anisotropic growth of wurtzite CuInS2. The Cu2–xS seed nanocrystals also act as sacrificial Cu+ sources, and therefore, single composition CuInS2 nanorods are eventually obtained if the reaction is allowed to proceed to completion. The two-stage seeded growth method developed in this work contributes to the rational synthesis of Cu2–xS/CuInS2 heteronanocrystals with targeted architectures by allowing one to exploit the size and faceting of premade Cu2–xS seed nanocrystals to direct the growth of the CuInS2 segment.
- 10 June 2021
- Published by American Chemical Society (ACS) in ACS Nano
- Vol. 15 (6) , 9987-9999
Open AccessSynthesis and Formation Mechanism of Colloidal Janus-Type Cu2–xS/CuInS2 Heteronanorods via Seeded Injection
Colloidal heteronanocrystals allow for the synergistic combination of properties of different materials. For example, spatial separation of the photogenerated electron and hole can be achieved by coupling different semiconductors with suitable band offsets in one single nanocrystal, which is beneficial for improving the efficiency of photocatalysts and photovoltaic devices. From this perspective, axially segmented semiconductor heteronanorods with a type-II band alignment are particularly attractive since they ensure the accessibility of both photogenerated charge carriers. Here, a two-step synthesis route to Cu2–xS/CuInS2 Janus-type heteronanorods is presented. The heteronanorods are formed by injection of a solution of preformed Cu2–xS seed nanocrystals in 1-dodecanethiol into a solution of indium oleate in oleic acid at 240 °C. By varying the reaction time, Janus-type heteronanocrystals with different sizes, shapes, and compositions are obtained. A mechanism for the formation of the heteronanocrystals is proposed. The first step of this mechanism consists of a thiolate-mediated topotactic, partial Cu+ for In3+ cation exchange that converts one of the facets of the seed nanocrystals into CuInS2. This is followed by homoepitaxial anisotropic growth of wurtzite CuInS2. The Cu2–xS seed nanocrystals also act as sacrificial Cu+ sources, and therefore, single composition CuInS2 nanorods are eventually obtained if the reaction is allowed to proceed to completion. The two-stage seeded growth method developed in this work contributes to the rational synthesis of Cu2–xS/CuInS2 heteronanocrystals with targeted architectures by allowing one to exploit the size and faceting of premade Cu2–xS seed nanocrystals to direct the growth of the CuInS2 segment.
- Open Access
- 17 May 2021
- Published by American Chemical Society (ACS) in ACS Photonics
- Vol. 8 (6) , 1784-1793
Saturation Mechanisms in Common LED Phosphors
- 17 May 2021
- Published by American Chemical Society (ACS) in ACS Photonics
- Vol. 8 (6) , 1784-1793
Open AccessSaturation Mechanisms in Common LED Phosphors
- 9 November 2020
- Published by American Chemical Society (ACS) in Chemical Reviews
- Vol. 120 (24) , 13461-13479
YAG:Ce3+ Phosphor: From Micron-Sized Workhorse for General Lighting to a Bright Future on the Nanoscale
The renowned yellow phosphor yttrium aluminum garnet (YAG) doped with trivalent cerium has found its way into applications in many forms: as powder of micron sized crystals, as a ceramic, and even as a single crystal. However, additional technological advancement requires providing this material in new form factors, especially in terms of particle size. Where many materials have been developed on the nanoscale with excellent optical properties (e.g., semiconductor quantum dots, perovskite nanocrystals, and rare earth doped phosphors), it is surprising that the development of nanocrystalline YAG:Ce is not as mature as for these other materials. Control over size and shape is still in its infancy, and optical properties are not yet at the same level as other materials on the nanoscale, even though YAG:Ce microcrystalline materials exceed the performance of most other materials. This review highlights developments in synthesis methods and mechanisms and gives an overview of the state of the art morphologies, particle sizes, and optical properties of YAG:Ce on the nanoscale.
- 9 November 2020
- Published by American Chemical Society (ACS) in Chemical Reviews
- Vol. 120 (24) , 13461-13479
YAG:Ce3+ Phosphor: From Micron-Sized Workhorse for General Lighting to a Bright Future on the Nanoscale
The renowned yellow phosphor yttrium aluminum garnet (YAG) doped with trivalent cerium has found its way into applications in many forms: as powder of micron sized crystals, as a ceramic, and even as a single crystal. However, additional technological advancement requires providing this material in new form factors, especially in terms of particle size. Where many materials have been developed on the nanoscale with excellent optical properties (e.g., semiconductor quantum dots, perovskite nanocrystals, and rare earth doped phosphors), it is surprising that the development of nanocrystalline YAG:Ce is not as mature as for these other materials. Control over size and shape is still in its infancy, and optical properties are not yet at the same level as other materials on the nanoscale, even though YAG:Ce microcrystalline materials exceed the performance of most other materials. This review highlights developments in synthesis methods and mechanisms and gives an overview of the state of the art morphologies, particle sizes, and optical properties of YAG:Ce on the nanoscale.