Aingeru Astigarraga
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Interests
Aingeru Astigarraga has a total of 6 co-authors. Here are the top co-authors by number of shared publications:
- Alberto Lopez-Gasso
Department of Electrical and Electronic Engineering, TECNUN—Technological Campus of the University of Navarra, 20018 San Sebastian, Spain
1 shared publication - Andoni Beriain
Department of Electrical and Electronic Engineering, TECNUN—Technological Campus of the University of Navarra, 20018 San Sebastian, Spain
1 shared publication - David del Rio
Tecnun, University of Navarra, Donostia-San Sebastián, Spain
1 shared publication - Diego Golpe
TECNUN—Technological Campus of the University of Navarra, Paseo de Manuel Lardizabal, 13, 20018 San Sebastian, Spain
1 shared publication - Hector Solar
Department of Electrical and Electronic Engineering, TECNUN—Technological Campus of the University of Navarra, 20018 San Sebastian, Spain
1 shared publication - Roc Berenguer
Tecnun School of Engineering, University of Navarra, San Sebastin, Spain
1 shared publication
Latest Publications
- Open Access
- 18 November 2020
- Published by MDPI AG in Micromachines
- Vol. 11 (11) , 1013
A 21 m Operation Range RFID Tag for “Pick to Light” Applications with a Photovoltaic Harvester
In this paper, a novel Radio-Frequency Identification (RFID) tag for “pick to light” applications is presented. The proposed tag architecture shows the implementation of a novel voltage limiter and a supply voltage (VDD) monitoring circuit to guarantee a correct operation between the tag and the reader for the “pick to light” application. The feasibility to power the tag with different photovoltaic cells is also analyzed, showing the influence of the illuminance level (lx), type of source light (fluorescent, LED or halogen) and type of photovoltaic cell (photodiode or solar cell) on the amount of harvested energy. Measurements show that the photodiodes present a power per unit package area for low illuminance levels (500 lx) of around 0.08 μW/mm2, which is slightly higher than the measured one for a solar cell of 0.06 μW/mm2. However, solar cells present a more compact design for the same absolute harvested power due to the large number of required photodiodes in parallel. Finally, an RFID tag prototype for “pick to light” applications is implemented, showing an operation range of 3.7 m in fully passive mode. This operation range can be significantly increased to 21 m when the tag is powered by a solar cell with an illuminance level as low as 100 lx and a halogen bulb as source light.
- 18 November 2020
- Published by MDPI AG in Micromachines
- Vol. 11 (11) , 1013
Open AccessA 21 m Operation Range RFID Tag for “Pick to Light” Applications with a Photovoltaic Harvester
In this paper, a novel Radio-Frequency Identification (RFID) tag for “pick to light” applications is presented. The proposed tag architecture shows the implementation of a novel voltage limiter and a supply voltage (VDD) monitoring circuit to guarantee a correct operation between the tag and the reader for the “pick to light” application. The feasibility to power the tag with different photovoltaic cells is also analyzed, showing the influence of the illuminance level (lx), type of source light (fluorescent, LED or halogen) and type of photovoltaic cell (photodiode or solar cell) on the amount of harvested energy. Measurements show that the photodiodes present a power per unit package area for low illuminance levels (500 lx) of around 0.08 μW/mm2, which is slightly higher than the measured one for a solar cell of 0.06 μW/mm2. However, solar cells present a more compact design for the same absolute harvested power due to the large number of required photodiodes in parallel. Finally, an RFID tag prototype for “pick to light” applications is implemented, showing an operation range of 3.7 m in fully passive mode. This operation range can be significantly increased to 21 m when the tag is powered by a solar cell with an illuminance level as low as 100 lx and a halogen bulb as source light.