Mathew Dzingai
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Mathew Dzingai has a total of 2 co-authors. Here are the top co-authors by number of shared publications:
- Kirsten Claire Corin
Centre for Minerals Research, Department of Chemical Engineering, University of Cape Town, Private Bag X03, Rondebosch 7701, South Africa
2 shared publications - Malibongwe Shadrach Manono
Centre for Minerals Research, Department of Chemical Engineering, University of Cape Town, Private Bag X3, Rondebosch 7701, South Africa
2 shared publications
Latest Publications
- Open Access
Probing the Effect of Water Recycling on Flotation through Anion Spiking Using a Low-Grade Cu–Ni–PGM Ore: The Effect of NO3−, SO42− and S2O32−
Water scarcity necessitates the recycling of process water within mineral processing practices. This may however come with its disadvantages for unit operations such as froth flotation as this process is water intensive and sensitive to water chemistry. It is therefore important to monitor the water chemistry of the recycle stream of process water and any other water source to flotation. Monitoring the concentrations of the anions in recycled process water is therefore important to consider as these are speculated to impact flotation performance. Batch flotation tests were conducted using synthetically prepared plant water (3 SPW) with a TDS of 3069 mg/L as the baseline experiment. 3 SPW contained 528 mg/LNO3− and 720 mg/L SO42−, other anions and cations, and no S2O32−. Upon spiking 3 SPW with selected anions, viz, NO3−, SO42− and S2O32−, it was noted that NO3− and SO42− exhibited threshold concentrations while S2O32− did not show a threshold concentration for both copper and nickel grade. Spiking 3 SPW with 352 mg/L more of NO3− to a total 880 mg/L NO3− concentration resulted in the highest copper and nickel grade compared to 3 SPW while increasing the S2O32− from 60 to 78 mg/L increased nickel and copper grade. 720 to 1200 mg/L SO42− and 528 to 880 mg/L NO3− were deemed the concentration boundaries within which lies the threshold concentration above which flotation performance declines with respect to metal grades, while for S2O32− the threshold concentration lies outside the range considered for this study. Anion distribution between the pulp and the froth did not seem to impact the recovery of copper or nickel. Notably, the correlation between the concentrate grades and anion distribution between the froth and the pulp seemed to be ion dependent.
Open AccessProbing the Effect of Water Recycling on Flotation through Anion Spiking Using a Low-Grade Cu–Ni–PGM Ore: The Effect of NO3−, SO42− and S2O32−
Water scarcity necessitates the recycling of process water within mineral processing practices. This may however come with its disadvantages for unit operations such as froth flotation as this process is water intensive and sensitive to water chemistry. It is therefore important to monitor the water chemistry of the recycle stream of process water and any other water source to flotation. Monitoring the concentrations of the anions in recycled process water is therefore important to consider as these are speculated to impact flotation performance. Batch flotation tests were conducted using synthetically prepared plant water (3 SPW) with a TDS of 3069 mg/L as the baseline experiment. 3 SPW contained 528 mg/LNO3− and 720 mg/L SO42−, other anions and cations, and no S2O32−. Upon spiking 3 SPW with selected anions, viz, NO3−, SO42− and S2O32−, it was noted that NO3− and SO42− exhibited threshold concentrations while S2O32− did not show a threshold concentration for both copper and nickel grade. Spiking 3 SPW with 352 mg/L more of NO3− to a total 880 mg/L NO3− concentration resulted in the highest copper and nickel grade compared to 3 SPW while increasing the S2O32− from 60 to 78 mg/L increased nickel and copper grade. 720 to 1200 mg/L SO42− and 528 to 880 mg/L NO3− were deemed the concentration boundaries within which lies the threshold concentration above which flotation performance declines with respect to metal grades, while for S2O32− the threshold concentration lies outside the range considered for this study. Anion distribution between the pulp and the froth did not seem to impact the recovery of copper or nickel. Notably, the correlation between the concentrate grades and anion distribution between the froth and the pulp seemed to be ion dependent.
- Open Access
Simulating the Effect of Water Recirculation on Flotation through Ion-Spiking: Effect of Ca2+ and Mg2+
Froth flotation is a multifaceted complex process which is water intensive. The use of recycled water as an alternative source of water to meet water demands of the process may introduce deleterious inorganic ions that affect the mineral surface, pulp chemistry, and reagent action, hence the need to establish whether threshold ion concentrations exist beyond which flotation performance will be adversely affected. This is of paramount importance in informing appropriate recycle streams and allowing simple, cost-effective water treatment methods to be applied. Here we report that increasing ionic strengths of synthetic plant water (SPW); 3, 5, and 10 SPW respectively, resulted in an increase in water recovery in the order 0.073 mol·dm−3 (3 SPW) < 0.121 mol·dm−3 (5 SPW) < 0.242 mol·dm−3 (10 SPW), indicating an increase in froth stability as higher water recoveries are linked to increased froth stabilities. This behavior is linked to the action of inorganic electrolytes on bubble coalescence which is reported in literature. There was, however, no significant effect on the valuable mineral recovery. Spiking 3 SPW to 400 mg/L Ca2+ resulted in higher copper and nickel grades compared to 3 SPW, 5 SPW, and 10 SPW and was deemed to be the Ca2+ ion threshold concentration for this study since 3 SPW spiked with further Ca2+ to a concentration of 800 mg/L resulted in a decrease in the concentrate grade. The spiking of 3 SPW with Mg2+ resulted in higher copper and nickel grades compared to all other synthetic plant water conditions tested in this study.
Open AccessSimulating the Effect of Water Recirculation on Flotation through Ion-Spiking: Effect of Ca2+ and Mg2+
Froth flotation is a multifaceted complex process which is water intensive. The use of recycled water as an alternative source of water to meet water demands of the process may introduce deleterious inorganic ions that affect the mineral surface, pulp chemistry, and reagent action, hence the need to establish whether threshold ion concentrations exist beyond which flotation performance will be adversely affected. This is of paramount importance in informing appropriate recycle streams and allowing simple, cost-effective water treatment methods to be applied. Here we report that increasing ionic strengths of synthetic plant water (SPW); 3, 5, and 10 SPW respectively, resulted in an increase in water recovery in the order 0.073 mol·dm−3 (3 SPW) < 0.121 mol·dm−3 (5 SPW) < 0.242 mol·dm−3 (10 SPW), indicating an increase in froth stability as higher water recoveries are linked to increased froth stabilities. This behavior is linked to the action of inorganic electrolytes on bubble coalescence which is reported in literature. There was, however, no significant effect on the valuable mineral recovery. Spiking 3 SPW to 400 mg/L Ca2+ resulted in higher copper and nickel grades compared to 3 SPW, 5 SPW, and 10 SPW and was deemed to be the Ca2+ ion threshold concentration for this study since 3 SPW spiked with further Ca2+ to a concentration of 800 mg/L resulted in a decrease in the concentrate grade. The spiking of 3 SPW with Mg2+ resulted in higher copper and nickel grades compared to all other synthetic plant water conditions tested in this study.