YWYugao Wang

Yugao Wang

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Yugao Wang has a total of 50 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Hydrophobic naphthalene‐based porous organic polymers achieving CH 4 / N 2 adsorption separation under humid conditions

    by Jiebin Wang, Chujie Zhang, Yugao Wang, Jiaxin Jing, Jinping Li, Jiangfeng Yang

    The efficient adsorption separation of CH 4 /N 2 from low‐concentration methane mixtures is a crucial prerequisite for its resource utilization. However, the separation performance of the common adsorbents would be severely weakened under humid conditions. Herein, a series of hydrophobic and porous organic polymers derived from naphthalene (PNs) were synthesized via the anhydrous AlCl 3 ‐catalyzed Friedel‐Crafts alkylation between naphthalene and dichloromethane, demonstrating high performance in CH 4 /N 2 separation with exceptional tolerance to humid conditions. The pore size of the PNs could be tailored by varying the amount of AlCl 3 during synthesis, enabling precise tuning of the micropore size from 0.58 nm to 0.78 nm. With a robust framework of methylene bridges and aromatic rings, the resulting PNs exhibit superior hydrophobicity. Breakthrough experiments under 40% and 75% relative humidity demonstrate that the PNs retain separation performance comparable to dry conditions. These findings underscore the potential of PNs for enriching CH 4 from low‐concentration methane mixtures under humid conditions.

  • Highly-sensitive detection and efficient recovery of silver ions by water-soluble sulfur quantum dots

    by Xinjie Jia, Wei Lei, Weijia Jiang, Yugao Wang

    The treatment and resource utilization of solid waste and wastewater are becoming increasingly important. In this study, we propose a method to synthesize sulfur quantum dots using coked sulfur paste as raw material, which produced sulfur quantum dots with good water solubility, good dispersibility and stable luminescence performance. The synthesized sulfur quantum dots were used as a fluorescent probe for sensitively detecting low concentrations of silver ions (Ag+) based on the principle of fluorescence quenching. The detection method has a wide detection range (0–160 μM) with the lowest limit of detection of 7.1 μM and no quenching effect in the presence of 11 common ions, thus enabling the highly selective detection of silver ions. Moreover, a new method for the recovery of silver involving the strong bonding between sulfur quantum dots and silver ions was developed, i.e., even a low concentration of silver ions (under 200 μM) in industrial wastewater was converted into silver sulfide (Ag2S) and silver sulfate (Ag2SO4) for recovery. Results show that the average recovery rate reached 99.03% in the aqueous environment in the presence of five types of hetero-ions, namely, Na+, K+, Ca2+, Mg2+ and Al3+, showing both high efficiency and selectivity. This investigation realized the resourceful utilization of coked sulfur paste and provides a new pathway for the detection and recovery of low concentrations of silver in industrial wastewater.


  • Open Access

    Synergistic CO2 mineralization using coal fly ash and red mud as a composite system

    by Zhenchao Yao, Yugao Wang, Jun Shen, Yanxia Niu, Jiang Feng Yang, Xianyong Wei

    CO2 mineralization plays a critical role in the storage and utilization of CO2. Coal fly ash (CFA) and red mud (RM) are widely utilized as CO2 mineralizers. However, the inert calcium species in CFA limit its carbonation capacity, meanwhile the substantial Ca2+ releasing of RM is hindered by a covering layer of calcium carbonate. In this study, CO2 mineralization in a composite system of CFA and RM was investigated to enhance the carbonation capacity. Multiple analyzers were employed to characterize the raw materials and resulting mineralization products. The results demonstrated that a synergistic effect existed in the composite system of CFA and RM, resulting in improving CO2 mineralization rate and efficiency. The produced calcium carbonate was ectopically attached the surface of CFA in the composite system, thus slowing down its coverage on the surface of RM. This phenomenon facilitated further releasing Ca2+ from the internal RM, thereby enhancing CO2 mineralization efficiency. Meanwhile, the inclusion of RM significantly improved the alkalinity of the composite system, which not only promoted the dissolution of Ca2+ of the inert CaSO4(H2O)2 in CFA, but also accelerated CO2 mineralization rate. The investigation would be beneficial to CO2 mineralization using industrial solid wastes.


  • Insight into Relationship between the Products Distribution and Molecular Properties in Carboxylation between Benzene Polycarboxylic Acids and CO2

    by Rong Wang, Gang Liu, Yu-Qin Sun, Yu-Gao Wang, Jun Shen, Yan-Xia Niu

    CO2 is an important carbon resource, which could be chemically utilized by carboxylation. In this paper, the carboxylation between benzene polycarboxylic acids (BPCAs) and CO2 was conducted using Cs2CO3 as a catalyst. The relationship between the product distribution and Mulliken charge at the reaction site of BPCAs was explored by combining experiments and quantum chemical calculations of molecular properties in the reaction of carboxylation between BPCAs and CO2. The negative Mulliken charge was found to facilitate carboxylation at the reaction site of BPCAs. Hydrogen abstraction was the rate-determining step for carboxylation, and its energy barrier was calculated for different C–H in the BPCA molecule. The results showed that the C–H bond with the more negative Mulliken charge was more easily deprotonated, which further verified the above conclusion. The study provides a convenient approach to predict a product distribution for carboxylation between BPCAs and CO2 according to the Mulliken charge of BPCAs.

  • Effect of solvent extraction on the composition of coal tar residues and their pyrolysis characteristics

    by Zhonghua Lu, Shun Guo, Jun Shen, Yugao Wang, Yanxia Niu, Gang Liu, Qingtao Sheng

    A large amount of coal tar residues (CTRs) produced in the coal coking or gasification industry has not been effectively utilized in China. In this study, CTRs are extracted by 12 organic solvents. Detailed investigations are carried out via ultimate analysis, Fourier transform infrared spectroscopy (FTIR) and thermogravimetry (TG) analyzer. The pyrolysis process of CTRs and their extraction residues (RCTRs) can be accurately fitted by Coast-Redfern integral model. The results indicate that the reaction order (n), apparent activation energy (Ea) and pre-exponential factor (A) were in the range of 2–7, 34.42–60.08 kJ mol−1 and 102-105 min−1, respectively. Correlations are observed between parameters (H, C, O, H/C, WT, Rmax, n, Ea, and lnA) and the yield of RCTRs, suggesting that the composition and pyrolysis behavior are controlled by the solvent extraction. Specifically, extraction with n-heptane, methanol and ethanol could reduce the Ea and promote CTRs decomposition by disrupting the noncovalent bonds. When extracted with CS2, DMF, benzene, toluene, acetone, etc. the recovery rate of tar and the yield of pyrolysis products are improved, however, the reactivity decrease due to the increase in activation energy.


  • Open Access

    Insight into the green path to dimethyl succinate by direct esterification of sodium succinate using CO2 and CH3OH

    by Yugao Wang, Xiao-Chen Han, Bao Gu, Hua-Shuai Wu, Jun Shen, Xian-Yong Wei

    The fermentation for the production of succinic acid (SA) outperforms other methods by low energy consumption and environmental benignity, with the resulted products mainly as disodium succinate (DSA). By the direct esterification of DSA using CO2 and CH3OH, it is expected to avoid the use of inorganic acids in downstream industrial esterification of bio-based DSA. By high-resolution mass spectrometry analysis and theoretical calculation,this study establishes that the direct esterification of DSA consists of three steps by first forming 3-carboxypropanoate,then monomethyl succinate (MMS),and finally DMS. The reaction kinetics of DSA direct esterification is also investigated by experiment and simulation with MATLAB, and the reaction kinetics equation along with reaction rate constant are obtained. The activation energy for the generation of MMS from DSA is 37.15 kJ/mol,and the one for the generation of DMS from MMS is 85.80 kJ/mol,indicating the latter one is the rate-determining step for the direct esterification of DSA.

  • Open Access

    Insight into the green route to dimethyl succinate by direct esterification of sodium succinate using CO2 and CH3OH

    by Yugao Wang, Xiao-Chen Han, Bao Gu, Hua-Shuai Wu, Jun Shen, Xian-Yong Wei

    The fermentation method for preparing SA is distinguished by low energy consumption and environmental friendliness, but the resulting products mainly exist in form of disodium succinate (DSA). Direct esterification of DSA using CO2 and CH3OH as esterification reagent to produce dimethyl succinate (DMS) can avoid use of inorganic acids in downstream esterification industry of bio-based DSA. On basis of high-resolution mass spectrometry analysis and quantum theoretical calculation, the process of DSA direct esterification involved sequentially forming 3-carboxypropanoate, monomethyl succinate (MMS), and DMS. Furthermore, the reaction kinetics of DSA direct esterification was investigated by experiment and numerical simulation method, where the reaction kinetics equation and reaction rate constant were obtained. The activation energy for the generated process of MMS by DSA was 37.15 kJ/mol, while the one for the formed process of DMS from MMS was 85.80 kJ/mol, indicating the latter was the speed control step of DSA direct esterification.

  • Open Access

    Insight into Relationship between Thermal Dissolution of Low-Rank Coals and Their Subsequent Oxidative Depolymerization

    by Yugao Wang, Xiaochen Liu, Zhilei Wang, Chuan Dong, Jun Shen, Xing Fan

    Oxidative depolymerization of low-rank coals is promising for obtaining benzene carboxylic acids (BCAs). However, it is hindered by the low yield of BCAs along with a large number of alphatic acids. Thermal dissolution could modify the physico-chemical structural features of low-rank coals, which is expected to improve the oxidation of LRCs. In this paper, lignite and subbituminous coal were firstly subjected to thermal dissolution with cyclohexane at 250 °C for 2 h. Then, the raw coal and the corresponding thermal insoluble portion (TIP) were oxidized by NaOCl under the same conditions. The residual yields of TIPs oxidation were both lower than those of raw coals oxidation, indicating that TIPs were more easily oxidized than the raw coals. The yield of BCAs obtained by TIPs oxidation was above 19% higher than that from the oxidation of raw coals. Meanwhile, the selectivity of BCAs was improved in the resulting oxidation products from TIPs compared with that from the raw coals. The relationship between BCAs generation and thermal dissolution of low rank coals was investigated by ultimate analysis, Fourier transform infrared spectroscopy, and nitrogen adsorption-desorption analysis. The results suggested that thermal dissolution could enrich aromatic portion in the remaining TIPs, resulting in an increasing of the yield and selectivity of BCAs. Simultaneously, thermal dissolution raised the specific surface area and expanded the looser space structure of TIPS, which were beneficial for the sufficient collision between aromatic structures and oxidant, facilitating the oxidative depolymerization of TIPs. This investigation would provide a novel route for promoting BCAs production by mild oxidative depolymerization of low-rank coals.


  • Open Access

    Absorption of SO2 by triethylenetetramine in ether (alcohol)/H2O system

    by Bin Zhao, Lulu Xu, Yanxia Niu, Fei Gao, Qingtao Sheng, Yugao Wang, Gang Liu, Jun Shen

    The use of organic solvents to remove SO2 from flue gas has the advantages of low investment cost, convenient operation, high efficiency, and reusability. We prepared three absorbents in this paper, namely tetraethylenetetramine (TETA), triethylenetetramine /triethylene glycol dimethyl ether (TriEDGME), and triethylenetetramine/triethylene glycol dimethyl ether/H2O. The atmospheric bubbling method absorbs SO2. The experimental results show that the three kinds of absorbents formed white precipitates after adsorbing SO2. The infrared spectra analysis and element analysis of the three types of precipitate showed that their chemical structures were basically the same. The structural formula is NH2(CH2)2NH(CH2)2NH3SO3NH2·2H2O; the product was determined to be a shaped crystal structure by XRD and SEM. In addition, the thermal stability analysis of the product revealed that the product sublimed at 123 °C and decomposed at about 185 °C.