Ibukunoluwa Momson
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Ibukunoluwa Momson has a total of 30 co-authors. Here are the top co-authors by number of shared publications:
- Kenneth K. O.
Department of Electrical and Computer Engineering, Texas Analog Center of Excellence, The University of Texas at Dallas, Richardson, TX, USA
4 shared publications - Wooyeol Choi
Seoul National University
3 shared publications Shenggang Dong
Department of Electrical and Computer Engineering, Texas Analog Center of Excellence, The University of Texas at Dallas, Richardson, TX, USA
2 shared publications- Shenggang Dong
Texas Analog Center of Excellence and the Department of Electrical and Computer Engineering, University of Texas at Dallas, Richardson, TX, USA
2 shared publications - Suhwan Lee
Department of Electrical and Computer Engineering, Texas Analog Center of Excellence, The University of Texas at Dallas, Richardson, TX, USA
2 shared publications Ahmad Zubair
Intel Corporation, Santa Clara, CA, USA
1 shared publication
Latest Publications
- 10 June 2025
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Journal of Solid-State Circuits
- Vol. 60 (9) , 3082-3094
10-GSymbols/s Supply-Modulated APSKC SiGe HBT Transmitter RF Front End for Operation at 250 GHz With 6.8-dBm Peak Modulated Power
This article presents a 250-GHz supply-modulated SiGe heterojunction bipolar transistor (HBT) ( $f_{T}$ and $f_{\max }$ of 350 and 450 GHz, respectively) transmitter RF front end that integrates a transformer-coupled four-stage power amplifier (PA) whose fourth stage is supply-modulated at a symbol rate of 10 GSymbols/s utilizing a high-speed low-dropout regulator (LDO). An integrated LO chain with a frequency multiplier generates a 121-GHz LO signal. Additionally, on-chip bipolar current-mode logic circuits are used to decode 1- or 2-bit PRBS data stream(s) and to drive the LDO that implements two- or four-level supply modulation. The transmitter supports 16-customized-APSK and 32-customized-APSK constellations, achieving instrumentation-limited data rates of 40 and 50 Gb/s with the peak modulated output power of 6.8 dBm and error vector magnitudes (EVMs) of −18.9 and −20.4 dB, respectively, while consuming approximately 1 W of dc power. The use of supply modulation with the APSK modulations increases both the peak modulated output power and RF-to-dc efficiency by $3{\times }$ and $2{\times }$ , respectively, compared to when conventional quadrature amplitude modulation (QAM) modulation with power backoff is employed. The measured 6.8-dBm peak modulated power is the highest for a transmitter IC operating at this frequency range.
- 10 June 2025
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Journal of Solid-State Circuits
- Vol. 60 (9) , 3082-3094
10-GSymbols/s Supply-Modulated APSKC SiGe HBT Transmitter RF Front End for Operation at 250 GHz With 6.8-dBm Peak Modulated Power
This article presents a 250-GHz supply-modulated SiGe heterojunction bipolar transistor (HBT) ( $f_{T}$ and $f_{\max }$ of 350 and 450 GHz, respectively) transmitter RF front end that integrates a transformer-coupled four-stage power amplifier (PA) whose fourth stage is supply-modulated at a symbol rate of 10 GSymbols/s utilizing a high-speed low-dropout regulator (LDO). An integrated LO chain with a frequency multiplier generates a 121-GHz LO signal. Additionally, on-chip bipolar current-mode logic circuits are used to decode 1- or 2-bit PRBS data stream(s) and to drive the LDO that implements two- or four-level supply modulation. The transmitter supports 16-customized-APSK and 32-customized-APSK constellations, achieving instrumentation-limited data rates of 40 and 50 Gb/s with the peak modulated output power of 6.8 dBm and error vector magnitudes (EVMs) of −18.9 and −20.4 dB, respectively, while consuming approximately 1 W of dc power. The use of supply modulation with the APSK modulations increases both the peak modulated output power and RF-to-dc efficiency by $3{\times }$ and $2{\times }$ , respectively, compared to when conventional quadrature amplitude modulation (QAM) modulation with power backoff is employed. The measured 6.8-dBm peak modulated power is the highest for a transmitter IC operating at this frequency range.
- 8 April 2024
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Microwave and Wireless Technology Letters
- Vol. 34 (6) , 745-748
Advancements in 300 mm GaN-on-Si Technology With Industry’s First Circuit Demonstration of Monolithically Integrated GaN and Si Transistors
Advancements in 300 mm GaN-on-Si enhancement-mode (E-mode) GaN N-MOSHEMT technology featuring monolithically integrated Si pMOS by layer transfer are presented. In this work, a true gate-last flow is employed, where the high-temperature activation steps of the Si pMOS transistors are completed before depositing the gate dielectric of the GaN N-MOSHEMT. In addition to the Si pMOS integration, GaN N-MOSHEMT performance is enhanced with an $f_{\mathrm{MAX}}$ of 335 GHz ( $L_{G}$ $=$ 90 nm). A mmWave power amplifier (PA) with a high area power density of 3.11 W/mm $^{2}$ and 99.1 dB figure-of-merit is demonstrated using the improved GaN N-MOSHEMT. Employing GaN N-MOSHEMT and Si pMOS, a vector modulator-based mmWave phase shifter with a 5-bit current-controlled digital-to-analog converter (DAC) is designed and fabricated in this process. The phase shifter achieves full functionality with 360 $^{\circ}$ phase tuning coverage, 5.3 $^{\circ}$ measured RMS phase error, and less than $\pm$ 1.7 dB magnitude variation across different phase states, occupying 0.12 mm $^{2}$ . This is the industry’s first demonstration of a complex monolithic GaN-Si CMOS circuit, implemented in 300 mm GaN-on-Si technology.
- 8 April 2024
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Microwave and Wireless Technology Letters
- Vol. 34 (6) , 745-748
Advancements in 300 mm GaN-on-Si Technology With Industry’s First Circuit Demonstration of Monolithically Integrated GaN and Si Transistors
Advancements in 300 mm GaN-on-Si enhancement-mode (E-mode) GaN N-MOSHEMT technology featuring monolithically integrated Si pMOS by layer transfer are presented. In this work, a true gate-last flow is employed, where the high-temperature activation steps of the Si pMOS transistors are completed before depositing the gate dielectric of the GaN N-MOSHEMT. In addition to the Si pMOS integration, GaN N-MOSHEMT performance is enhanced with an $f_{\mathrm{MAX}}$ of 335 GHz ( $L_{G}$ $=$ 90 nm). A mmWave power amplifier (PA) with a high area power density of 3.11 W/mm $^{2}$ and 99.1 dB figure-of-merit is demonstrated using the improved GaN N-MOSHEMT. Employing GaN N-MOSHEMT and Si pMOS, a vector modulator-based mmWave phase shifter with a 5-bit current-controlled digital-to-analog converter (DAC) is designed and fabricated in this process. The phase shifter achieves full functionality with 360 $^{\circ}$ phase tuning coverage, 5.3 $^{\circ}$ measured RMS phase error, and less than $\pm$ 1.7 dB magnitude variation across different phase states, occupying 0.12 mm $^{2}$ . This is the industry’s first demonstration of a complex monolithic GaN-Si CMOS circuit, implemented in 300 mm GaN-on-Si technology.
- 18 March 2021
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Solid-State Circuits Letters
- Vol. 4, 80-83
425-to-25-GHz CMOS-Integrated Downconverter
An integrated 425-GHz radio frequency (RF) to 25-GHz intermediate frequency (IF) second-order subharmonic downconverter, including an on-chip 8X local oscillator (LO) signal multiplier circuit that provides ~1 dBm at 200 GHz from an externally applied 25-GHz signal, and a 25-GHz IF amplifier, achieves a conversion gain of 6.7 dB and a noise figure of ~17 dB. The downconverter consumes 190 mW of dc power. Compared to the previously reported CMOS and SiGe HBT receivers/downconverters operating around 400 GHz and above, the downconverter achieves ~18-dB lower single side band noise figure. Finally, a passive switching mixer can have an available output noise spectral density less than kT, which can make its NF less than its conversion loss.
- 18 March 2021
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Solid-State Circuits Letters
- Vol. 4, 80-83
425-to-25-GHz CMOS-Integrated Downconverter
An integrated 425-GHz radio frequency (RF) to 25-GHz intermediate frequency (IF) second-order subharmonic downconverter, including an on-chip 8X local oscillator (LO) signal multiplier circuit that provides ~1 dBm at 200 GHz from an externally applied 25-GHz signal, and a 25-GHz IF amplifier, achieves a conversion gain of 6.7 dB and a noise figure of ~17 dB. The downconverter consumes 190 mW of dc power. Compared to the previously reported CMOS and SiGe HBT receivers/downconverters operating around 400 GHz and above, the downconverter achieves ~18-dB lower single side band noise figure. Finally, a passive switching mixer can have an available output noise spectral density less than kT, which can make its NF less than its conversion loss.
- 22 January 2021
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Components, Packaging and Manufacturing Technology
- Vol. 11 (3) , 530-532
180-GHz Broadside Radiation Bond-Wire Antenna for Short-Range Wireless Communication
A technique for realizing an efficient broadside radiation bond-wire antenna for short-range wireless communication is demonstrated. The bond wire forming the antenna is located around$375~\mu \text{m}$ ($\sim \lambda $ /4 at 180 GHz) above the ground plane on a printed circuit board (PCB) for constructive interference of reflected waves from the PCB and that radiated from the antenna. At 178.3 GHz, a gold bond wire shaped in a half loop and terminated on a bond pad of a neighboring chip 975-$\mu \text{m}$ away exhibits a measured peak gain of 2.5 dB at the$\phi = 90^{\circ }$ plane. The antenna also exhibits >20 GHz measured −10-dB$\vert \text{S}_{11}\vert $ bandwidth. The simulated efficiency is 52%.- 22 January 2021
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Components, Packaging and Manufacturing Technology
- Vol. 11 (3) , 530-532
180-GHz Broadside Radiation Bond-Wire Antenna for Short-Range Wireless Communication
A technique for realizing an efficient broadside radiation bond-wire antenna for short-range wireless communication is demonstrated. The bond wire forming the antenna is located around$375~\mu \text{m}$ ($\sim \lambda $ /4 at 180 GHz) above the ground plane on a printed circuit board (PCB) for constructive interference of reflected waves from the PCB and that radiated from the antenna. At 178.3 GHz, a gold bond wire shaped in a half loop and terminated on a bond pad of a neighboring chip 975-$\mu \text{m}$ away exhibits a measured peak gain of 2.5 dB at the$\phi = 90^{\circ }$ plane. The antenna also exhibits >20 GHz measured −10-dB$\vert \text{S}_{11}\vert $ bandwidth. The simulated efficiency is 52%.- 24 November 2020
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Journal of Solid-State Circuits
- Vol. 56 (3) , 681-693
A 10-Gb/s 180-GHz Phase-Locked-Loop Minimum Shift Keying Receiver
A 180-GHz minimum shift keying (MSK) receiver (RX) using a phase-locked loop (PLL), which self-synchronizes the carrier frequency, is demonstrated. The mixer-first RX is fabricated in a 65-nm CMOS process. A double-balanced anti-parallel-diode-pair sub-harmonic mixer performs the phase detection, reducing the frequency of local oscillator (LO) by half. Tunable zeros realized by series inductors are used to improve the stability and to increase the data rate handling capability. Without external LO synchronization, the RX demodulates MSK signals at 10 Gb/s with a bit error rate (BER) <; 10 -12 and at the maximum data rate of 12.5 Gb/s with a BER of 3.8 × 10 -5 . The BER at 10 Gb/s is the lowest and the data rate of 12.5 Gb/s is the highest for PLL RXs.
- 24 November 2020
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Journal of Solid-State Circuits
- Vol. 56 (3) , 681-693
A 10-Gb/s 180-GHz Phase-Locked-Loop Minimum Shift Keying Receiver
A 180-GHz minimum shift keying (MSK) receiver (RX) using a phase-locked loop (PLL), which self-synchronizes the carrier frequency, is demonstrated. The mixer-first RX is fabricated in a 65-nm CMOS process. A double-balanced anti-parallel-diode-pair sub-harmonic mixer performs the phase detection, reducing the frequency of local oscillator (LO) by half. Tunable zeros realized by series inductors are used to improve the stability and to increase the data rate handling capability. Without external LO synchronization, the RX demodulates MSK signals at 10 Gb/s with a bit error rate (BER) <; 10 -12 and at the maximum data rate of 12.5 Gb/s with a BER of 3.8 × 10 -5 . The BER at 10 Gb/s is the lowest and the data rate of 12.5 Gb/s is the highest for PLL RXs.