Luis Alejandro Ramírez
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Luis Alejandro Ramírez has a total of 8 co-authors. Here are the top co-authors by number of shared publications:
- Gerardo Romero
Electrical and Electronic Engineering Department, Reynosa-Rodhe Multidisciplinary Academic Unit, Autonomous University of Tamaulipas, Carretera Reynosa-San Fernando SN, Reynosa 88779, Tamaulipas, Mexico
3 shared publications - Manuel Alejandro Zuñiga
Electrical and Electronic Engineering Department, Autonomous University of Tamaulipas, Reynosa 88779, Mexico
3 shared publications - Efrain Alcorta Garcia
Universidad Autonóma de Nuevo León
2 shared publications Abdelhamid Rabhi
Université de Picardie Jules Verne
1 shared publication- Aldo Jonathan Muñoz-Vázquez
Department of Computer, Electrical, and Software Engineering, Embry-Riddle Aeronautical University, 3700 Willow Creek Road, Prescott, AZ 86301, USA
1 shared publication - Alejandro Arceo
Faculadad de Ingeniería Mecánica y Eléctrica, Universidad de Colima, México
1 shared publication
Latest Publications
- Open Access
- 27 October 2021
- Published by MDPI AG in Information
- Vol. 12 (11) , 445
Passive Fault-Tolerant Control of a 2-DOF Robotic Helicopter
The presence of faults in dynamic systems causes the potential loss of some of the control objectives. For that reason, a fault-tolerant controller is required to ensure a proper operation, as well as to reduce the risk of accidents. The present work proposes a passive fault-tolerant controller that is based on robust techniques, which are utilized to adjust a proportional-derivative scheme through a linear matrix inequality. In addition, a nonlinear term is included to improve the accuracy of the control task. The proposed methodology is implemented in the control of a two degrees of a freedom robotic helicopter in a simulation environment, where abrupt faults in the actuators are considered. Finally, the proposed scheme is also tested experimentally in the Quanser® 2-DOF Helicopter, highlighting the effectiveness of the proposed controller.
- 27 October 2021
- Published by MDPI AG in Information
- Vol. 12 (11) , 445
Open AccessPassive Fault-Tolerant Control of a 2-DOF Robotic Helicopter
The presence of faults in dynamic systems causes the potential loss of some of the control objectives. For that reason, a fault-tolerant controller is required to ensure a proper operation, as well as to reduce the risk of accidents. The present work proposes a passive fault-tolerant controller that is based on robust techniques, which are utilized to adjust a proportional-derivative scheme through a linear matrix inequality. In addition, a nonlinear term is included to improve the accuracy of the control task. The proposed methodology is implemented in the control of a two degrees of a freedom robotic helicopter in a simulation environment, where abrupt faults in the actuators are considered. Finally, the proposed scheme is also tested experimentally in the Quanser® 2-DOF Helicopter, highlighting the effectiveness of the proposed controller.
- Open Access
- 25 November 2020
- Published by MDPI AG in Applied Sciences
- Vol. 10 (23) , 8359
Fault Diagnosis for a Class of Robotic Systems with Application to 2-DOF Helicopter
This paper considers a general approach to fault diagnosis using a generalized Hamiltonian system representation. It can be considered that, in general, nonlinear systems still represent a problem in fault diagnosis because there are results only for a specific class of them. Therefore, fault diagnosis remains a challenging research area despite the maturity of some of the available results. In this work, a type of nonlinear system that admits a generalized Hamiltonian representation is considered; in practice, there are many systems that have this kind of representation. Thereupon, an approach for fault detection and isolation based on the Hamiltonian representation is proposed. First, following the classic approach, the original system is decoupled in different subsystems so that each subsystem is sensitive to one particular fault. Then, taking advantage of the structure, a simple way to design the residuals is presented. Finally, the proposed scheme is validated at the two-degree of freedom (DOF) helicopter of Quanser®, where the presence of faults in sensors and actuators were considered. The results show the efficacy of the proposed scheme.
- 25 November 2020
- Published by MDPI AG in Applied Sciences
- Vol. 10 (23) , 8359
Open AccessFault Diagnosis for a Class of Robotic Systems with Application to 2-DOF Helicopter
This paper considers a general approach to fault diagnosis using a generalized Hamiltonian system representation. It can be considered that, in general, nonlinear systems still represent a problem in fault diagnosis because there are results only for a specific class of them. Therefore, fault diagnosis remains a challenging research area despite the maturity of some of the available results. In this work, a type of nonlinear system that admits a generalized Hamiltonian representation is considered; in practice, there are many systems that have this kind of representation. Thereupon, an approach for fault detection and isolation based on the Hamiltonian representation is proposed. First, following the classic approach, the original system is decoupled in different subsystems so that each subsystem is sensitive to one particular fault. Then, taking advantage of the structure, a simple way to design the residuals is presented. Finally, the proposed scheme is validated at the two-degree of freedom (DOF) helicopter of Quanser®, where the presence of faults in sensors and actuators were considered. The results show the efficacy of the proposed scheme.
- 1 November 2015
- Published by Trans Tech Publications, Ltd. in Applied Mechanics and Materials
- Vol. 811, 172-178
Fuzzy Control of a Quadrotor for Reconstructed States Feedback Using Multiobserver
A type of aircraft that is currently being very reference in the area of control is the quadrotor helicopter, compared to other UAV's (Unmanned Aerial Vehicles UAV's-) has been of great interest for the research groups. Principally were developed for military applications. However, UAVs don’t have only military use, also civilian use and it is in this last field that can have multiple applications. The State variables of the system obtained are, however, in the most general case, internal operation of the system variables whose values can’t be measured directly on physical quantities. An observer is used for to reconstruct partially or completely the state vector of a system from the known inputs, outputs and the dynamic model of this. The reconstruction and calculation of the state variables is performed in a system known as Multiobserver. Applying the fuzzy representation of type Takagi-Sugeno, also known as multi-model [1], in dynamic model of the quadrotor and developing an algorithm based in law control for reconstructed states feedback, the vehicle is stabilized.
- 1 November 2015
- Published by Trans Tech Publications, Ltd. in Applied Mechanics and Materials
- Vol. 811, 172-178
Fuzzy Control of a Quadrotor for Reconstructed States Feedback Using Multiobserver
A type of aircraft that is currently being very reference in the area of control is the quadrotor helicopter, compared to other UAV's (Unmanned Aerial Vehicles UAV's-) has been of great interest for the research groups. Principally were developed for military applications. However, UAVs don’t have only military use, also civilian use and it is in this last field that can have multiple applications. The State variables of the system obtained are, however, in the most general case, internal operation of the system variables whose values can’t be measured directly on physical quantities. An observer is used for to reconstruct partially or completely the state vector of a system from the known inputs, outputs and the dynamic model of this. The reconstruction and calculation of the state variables is performed in a system known as Multiobserver. Applying the fuzzy representation of type Takagi-Sugeno, also known as multi-model [1], in dynamic model of the quadrotor and developing an algorithm based in law control for reconstructed states feedback, the vehicle is stabilized.