AMAnton Muhin

Anton Muhin

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Anton Muhin has a total of 66 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Positive Degradation Kinetics of 265 nm AlGaN-Based UV-C LEDs: Experimental Analysis and Modeling

    by Francesco Piva, Nicola Roccato, Matteo Buffolo, Simone Leonardo Longato, Marco Pilati, Norman Susilo, Daniel Heuer Vidal, Anton Muhin, Luca Sulmoni, Tim Wernicke, et al.

  • Open Access

    Analysis of the External Quantum Efficiency of 233 nm Far‐Ultraviolet‐C‐Light Emitting Diodes with Distributed Polarization Doped p ‐AlGaN‐Layers

    by Anton Muhin, Tim Kolbe, Fedir Schuldt, Martin Guttmann, Sylvia Hagedorn, Jens Rass, Sven Einfeldt, Markus Weyers, Tim Wernicke, Michael Kneissl

    AlGaN‐based far‐ultraviolet‐C light emitting diodes (far‐UVC LEDs) with an emission wavelength of 233 nm and a peak external quantum efficiency () of 1% are explored to derive the radiative recombination efficiency (), the light extraction efficiency (), and the carrier injection efficiency (). In order to investigate the over a wide range of current density, and exclude the effect of heating, continuous wave and pulsed electroluminescence measurements are performed on far‐UVC LEDs with distributed polarization doped p ‐AlGaN layers. By applying the ABC‐model based Titkov–Dai method and calibrated Monte Carlo ray‐tracing simulations, a maximum of , a , and a can be determined. The different efficiency parameters of the 233 nm far‐UVC LEDs are compared to state‐of‐the‐art AlGaN‐based 265 nm LEDs and InGaN multi quantum well blue LEDs. In this context, strategies for most promising approaches to advance the of far‐UVC LEDs are discussed.


  • Open Access

    Light Extraction and External Quantum Efficiency of 235 nm Far–Ultraviolet‐C Light‐Emitting Diodes on Single‐Crystal AlN Substrates

    by Marcel Schilling, Carsten Hartmann, Martin Guttmann, Uta Juda, Anton Muhin, Jakob Höpfner, Tim Wernicke, Thomas Straubinger, Michael Kneissl

    The effect of bulk AlN single‐crystal substrate thickness on the light extraction efficiency and external quantum efficiency of far ultraviolet‐C light emitting diodes (far‐UVC LEDs) has been investigated. AlGaN multi‐quantum well LEDs designed for emission around 235 nm are grown by metal organic vapor phase epitaxy on low defect density bulk AlN substrates as well as on AlN/sapphire templates. As the AlN substrate is thinned step‐by‐step from 550 to 70 μm by chemo‐mechanical polishing, the output power of LEDs increased from 3 μW for a thickness of 550 to 110 μW for a thickness of 70 μm (on‐wafer at a dc current of 100 mA). From the Lambert–Beer law an effective absorption coefficient of (84 ± 4) cm−1 is derived for the AlN substrate. Monte Carlo ray‐tracing simulations for an AlN substrate thickness of 70 μm yield an on‐wafer LEE of (0.9 ± 0.1)% and the internal quantum efficiency was estimated to be (5.6 ± 1.5)%.


  • Open Access

    Effect of the AlGaN Multi‐Quantum Well Growth Temperature on the Efficiency of Metal‐Organic Vapor‐Phase Epitaxy‐Grown Far‐Ultraviolet‐C Light‐Emitting Diodes Emitting near 235 nm

    by Marcel Schilling, Norman Susilo, Anton Muhin, Giulia Cardinali, Jan Ruschel, Hyun Kyong Cho, Jens Rass, Jakob Höpfner, Tim Wernicke, Sven Einfeldt, et al.

    The effect of the active region growth temperature (TMQW) on the external quantum efficiency (EQE) of AlGaN‐based far‐ultraviolet‐C light‐emitting diodes (far‐UVC LEDs) emitting near 235 nm is investigated. AlGaN multi‐quantum well (MQW) active regions are grown at temperatures between 850 and 1100 °C by metal‐organic vapor‐phase epitaxy, while special care is taken to keep aluminum mole fractions and thicknesses constant for all MQWs. Temperature‐ and excitation‐power‐dependent photoluminescence spectroscopy reveal a more than tenfold increase of the radiative recombination efficiency (RRE) when the growth temperature increases from 850 to 1020–1060 °C. The output powers for mounted far‐UVC LEDs at 0.2 A increase from 0.5 mW for TMQW of 900 °C to 2.5 mW for TMQW of 1020 °C, corresponding to an increase in EQE from 0.04% to 0.23% at 0.2 A. However, lifetime measurements reveal a reduction of the L70 lifetime from 400 to 1 h when TMQW increases from 900 to 1060 °C. In this investigation, it is shown that optimizing the growth conditions provides a promising approach to further increase the RRE and EQE and lifetime of far‐UVC LEDs.


  • Unraveling carrier distribution in far-UVC LEDs by temperature-dependent electroluminescence measurements

    by Jakob Höpfner, Florian Kühl, Marcel Schilling, Anton Muhin, Martin Guttmann, Gregor Hofmann, Friedhard Römer, Tim Wernicke, Bernd Witzigmann, Michael Kneissl

    The hole transport and the carrier distribution in AlGaN-based far-ultraviolett (UVC) light emitting diodes (LEDs) emitting around 233 nm was investigated. Temperature-dependent electroluminescence measurements on dual wavelength AlGaN multiple quantum well (MQW) LEDs show a strong shift in the spectral power distribution from 250 to 233 nm with decreasing temperature. Comparing experimental data with simulation shows that the hole mobility and the electron to hole mobility ratios have a significant influence on the carrier injection efficiency (CIE) and that the change in the spectral power distribution is originating from a change in the hole distribution in the MQWs. Poor hole injection and charge carrier confinement in the AlGaN MQW active region was identified as one of the main reasons for the low CIE in far-UVC LEDs.


  • Open Access

    Simulation of Carrier Injection Efficiency in AlGaN-Based UV-Light-Emitting Diodes

    by Gregor Hofmann, Anton Muhin, Norman Susilo, Friedhard Römer, Tim Wernicke, Michael Kneissl, Bernd Witzigmann

    Numerical simulations of carrier transport in aluminium gallium nitride based ultraviolet light emitting diodes (UV-LED) are performed in order to understand injection efficiency for light sources in the deep ultraviolet. With our simulator, calibrated with experimental data from a 265 nm UV-LED, quantum efficiencies have been analyzed. The maximum internal quantum efficiency (IQE) of 30% consists of the product from radiative recombination efficiency (RRE) of 60% and carrier injection efficiency (CIE) of 50%. It is found that poor hole injection into the active region and a surplus of electrons limit both efficiencies, and leads to significant electron leakage into the p-side. This leakage is bias dependent, and has a minimum at maximum IQE. Further simulations show that distributed polarization doping (DPD) could improve carrier injection efficiency.


  • Open Access

    Modeling of the Electrical Characteristics and Degradation Mechanisms of UV-C LEDs

    by Nicola Roccato, Francesco Piva, Carlo De Santi, Matteo Buffolo, Normal Susilo, Daniel Hauer Vidal, Anton Muhin, Luca Sulmoni, Tim Wernicke, Micheal Kneissl, et al.

    In this paper we investigate the reliability of AlGaN-based UV-C LEDs with an emission wavelength of 265 nm. By submitting the devices to constant current stress, two main electrical degradation processes are identified: a turn-on voltage shift and an increase in the forward leakage current. In particular, these processes were respectively attributed to: (i) a partial passivation of the Mg-doping concentration in the region adjacent to the contact, probably caused by a local hydrogen diffusion, and ii) a diffusion/generation process of defects in the interlayer, responsible for the increase in the trap-assisted tunneling. To validate these hypotheses, we employed TCAD simulations by varying only the Mg-doping concentration in the region adjacent to the p-contact and the defect density in the interlayer. Thus, we correctly reproduced the experimental variation in electrical characteristics, confirming the physical mechanisms identified.


  • Open Access

    Carrier Transport in a Deep Ultraviolet Mixed Quantum Well Light Emitting Diode

    by Friedhard Römer, Gregor Hofmann, Jakob Höpfner, Marcel Schilling, Anton Muhin, Tim Wernicke, Michael Kneissl, Bernd Witzigmann

    Aluminium Gallium Nitride (AlGaN) based light emitting diodes (LED) are the enabling technology for compact emitters of deep ultraviolet (DUV) radiation and are in high demand for environmental and medical applications. The efficiency of recent DUV LEDs is in the range of a few percent providing some potential for improvement. Apart from the light extraction efficiency the hole injection into the active region presents a major obstacle towards more efficient DUV LEDs. In this work, we investigate the emission spectra of a mixed multi quantum well (MQW) DUV LED to attain details on the active region carrier transport that allow an improvement of the hole injection. Changing the position of the long wavelength marker quantum well yields characteristic emission spectra which have been modelled with a multi scale carrier transport and luminescence simulator. The numerical modelling enables the extraction of opaque carrier transport characteristics in AlGaN such as the hole mobility in the highly doped barriers of the MQW.


  • Modeling the electrical characteristic and degradation mechanisms of UV-C LEDs

    by Nicola Roccato, Francesco Piva, Carlo De Santi, Matteo Buffolo, Normal Susilo, Daniel Hauer Vidal, Anton Muhin, Luca Sulmoni, Tim Wernicke, Micheal Kneissl, et al.

    In this paper, we investigated the degradation mechanisms that negatively affect the reliability of UV-C LEDs. In particular, we modeled the process that involves trap generation identified through experimental electrical characteristics and contact degradation by means of numerical TCAD simulations.

  • Open Access

    234 nm far-ultraviolet-C light-emitting diodes with polarization-doped hole injection layer

    by Tim Kolbe, Arne Knauer, Jens Rass, Hyun Kyong Cho, Sylvia Hagedorn, Fedir Bilchenko, Anton Muhin, Jan Ruschel, Michael Kneissl, Sven Einfeldt, et al.

    Far-ultraviolet-C (far-UVC) light-emitting diodes (LEDs) with an emission wavelength of 234 nm with different polarization-doped AlGaN hole injection layers (HILs) are compared regarding their emission power, voltage, and leakage current. The influence of the thickness of the polarization-doped layer (PDL), an additional Mg doping of the PDL, as well as a combination of a PDL with a conventionally Mg-doped AlGaN HIL will be discussed. The different PDL thicknesses show nearly no influence on the emission power or voltage. However, the leakage current of the LEDs below the turn-on voltage decreases with an increasing thickness of the PDL. In contrast, an additional Mg doping of the PDL ([Mg] ∼ 1.5 × 1019 cm−3) results in a fivefold decrease in the emission power at an unchanged voltage and leakage current. Finally, a combination of a PDL and a conventionally Mg-doped AlGaN layer ([Mg] ∼ 1.5 × 1019 cm−3) as a HIL shows also a similar emission power and voltage compared to the single PDL, but the leakage current increases. Based on these optimizations, 234 nm LEDs were realized with a maximum external quantum efficiency of 1% at 20 mA, an emission power of 4.7 mW, and a voltage of 9.0 V at 100 mA. This shows that the polarization doping concept is well suited to realize far-UVC LEDs with improved performance compared to LEDs with a conventionally Mg-doped p-side.