Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Walaa S. Aburayan has a total of 31 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Peptide-Based Molecular Glues for Targeted Protein Degradation

    by Walaa S. Aburayan, Ibrahim A. Alradwan, Beshair A. Alsaffar, Othman A. Alhazzaa, Fahad A. Almughem, Abdullah A. Alshehri, Ibtihal S. Alduhaymi, Mohannad M. Fallatah, Meshael Alturki, Hassa A. Alshaya, et al.

    Targeted protein degradation has transformed drug discovery by replacing occupancy-driven inhibition with event-driven removal of disease-causing proteins, opening previously “undruggable” targets, including transcription factors, scaffolding proteins, and intrinsically disordered regions, to therapeutic intervention. Within this landscape, peptide-based molecular glues have emerged as a distinct and underexplored modality, combining the extended, adaptable interaction surfaces of peptides with the mechanistic simplicity of induced-proximity pharmacology. Unlike bifunctional degraders such as PROTACs, which require the concurrent optimization of two linked ligands, peptide molecular glues act through a single engineered interface, stabilizing cooperative ternary complexes between a target protein and an E3 ubiquitin ligase to drive ubiquitination and proteasomal degradation. This review highlights the current understanding of peptide molecular glue biology across five interconnected dimensions: the mechanistic basis of E3 ligase recruitment and cooperative ternary complex formation; rational design strategies spanning sequence selection, structural stabilization, and computational and AI-guided optimization; the structural and biophysical determinants, such as conformational flexibility, interface complementarity, and thermodynamic and kinetic stability, that distinguish productive from non-productive complexes; and emerging therapeutic applications in oncology, hematological malignancy, neurodegeneration, and inflammatory disease, several of which have already reached clinical evaluation. We further examine the comparative advantages of peptide-based architectures, including reduced molecular weight, access to challenging interfaces, and expansion of the addressable E3 ligase repertoire, against persistent translational barriers in proteolytic stability, membrane permeability, immunogenicity, and manufacturability. Taken together, the evidence positions peptide-based molecular glues not as incremental variants of existing degrader platforms, but as a mechanistically distinct therapeutic class capable of substantially widening the druggable proteome.

  • Open Access

    Eflornithine Hydrochloride-Loaded Electrospun Nanofibers as a Potential Face Mask for Hirsutism Application

    by Shuruq S. Almuwallad, Dunia A. Alzahrani, Walaa S. Aburayan, Ahmed J. Alfahad, Khulud A. Alsulami, Alhassan H. Aodah, Samar A. Alsudir, Sulaiman S. Alhudaithi, Essam A. Tawfik

    Hirsutism is a distressing condition that can affect women’s self-esteem due to the excessive amount of hair growth in different body parts, including the face. A temporary managing option is to develop a self-care routine to remove unwanted hair through shaving or waxing. Laser or electrolysis are alternative methods, but in some cases, the use of medications, such as the topical cream Vaniqa®, can help in reducing the growth of unwanted hair. Electrospun fibers have been used in several drug delivery applications, including skin care products, owing to their biocompatibility, biodegradability, high surface area-to-volume ratio, and dry nature that can release the encapsulated drugs with maximum skin penetration. Therefore, polyvinyl pyrrolidone (PVP) fibers were fabricated in combination with hyaluronic acid to deliver the active compound of Vaniqa®, i.e., Eflornithine hydrochloride (EFH), as a face mask to inhibit excess facial hair growth. The prepared drug-loaded fibers showed a diameter of 490 ± 140 nm, with an encapsulation efficiency of 88 ± 7% and a drug loading capacity of 92 ± 7 μg/mg. The in vitro drug release of EFH-loaded fibers exhibited an initial burst release of 80% in the first 5 min, followed by a complete release after 360 min, owing to the rapid disintegration of the fibrous mat (2 s). The in vitro cytotoxicity indicated a high safety profile of EFH at all tested concentrations (500–15.625 μg/mL) after 24-h exposure to human dermal fibroblast (HFF-1) cells. Therefore, this drug-loaded nanofibrous system can be considered a potentially medicated face mask for the management of hirsutism, along with the moisturizing effect that it possesses. Topical applications of the developed system showed reduced hair growth in mice to a certain extent.


  • Open Access

    Melittin from Bee Venom Encapsulating Electrospun Fibers as a Potential Antimicrobial Wound Dressing Patches for Skin Infections

    by Walaa S. Aburayan, Areej M. Alajmi, Ahmed J. Alfahad, Wijdan K. Alsharif, Abdullah A. Alshehri, Rayan Y. Booq, Samar A. Alsudir, Fatemah M. Alsulaihem, Haitham A. Bukhary, Moutaz Y. Badr, et al.

    Skin infection compromises the body’s natural defenses. Several antibiotics are no longer effective owing to the evolution of antimicrobial-resistant (AMR) bacteria, hence, the constant development of novel antibacterial agents. Naturally occurring antibacterial agents may be potential candidates for AMR bacterial infection treatments; however, caution should be taken when administering such agents due to the high incidence of toxicity. A fibrous material system from a biocompatible polymer that could be used as a skin patch for skin infections treatment caused by AMR bacteria is proposed in this study. Bee venom’s active ingredient, melittin, was fabricated using electrospinning technology. Scanning electron microscopy showed that melittin-loaded fibers had smooth surfaces with no signs of beads or pores. The average diameter of this fibrous system was measured to be 1030 ± 160 nm, indicating its successful preparation. The melittin fibers’ drug loading and entrapment efficiency (EE%) were 49 ± 3 µg/mg and 84 ± 5%, respectively. This high EE% can be another successful preparatory criterion. An in vitro release study demonstrated that 40% of melittin was released after 5 min and achieved complete release after 120 min owing to the hydrophilic nature of the PVP polymer. A concentration of ≤10 µg/mL was shown to be safe for use on human dermal fibroblasts HFF-1 after 24-h exposure, while an antibacterial MIC study found that 5 μg/mL was the effective antimicrobial concentration for S. aureus, A. baumannii, E. coli and Candida albicans yeast. A melittin-loaded fibrous system demonstrated an antibacterial zone of inhibition equivalent to the control (melittin discs), suggesting its potential use as a wound dressing patch for skin infections.


  • Open Access

    Formulation and Evaluation of Alcohol-Free Hand Sanitizer Gels to Prevent the Spread of Infections during Pandemics

    by Rayan Y. Booq, Abdullah A. Alshehri, Fahad A. Almughem, Nada M. Zaidan, Walaa S. Aburayan, Abrar A. Bakr, Sara H. Kabli, Hassa A. Alshaya, Mohammed S. Alsuabeyl, Essam J. Alyamani, et al.

    Hand hygiene is an essential factor to prevent or minimize the spread of infections. The ability to prepare an alcohol-free hand sanitizer (AFHS) with antimicrobial properties is crucial, especially during pandemics, when there are high demands and a low supply chain for ethanol and isopropanol. The objective of this study was to prepare AFHS gels based on natural materials that contain essential oils (EOs) that would be effective against a broad spectrum of pathogens. The results showed that the organoleptic characteristics of all prepared hand sanitizer gels were considered acceptable. The pH of the formulations was slightly acidic (circa 3.9) owing to the presence of aloe vera in large proportions (90% v/v), which is known for its acidity. The spreadability for all tested formulations was in the acceptable range. The antimicrobial effectiveness test demonstrated that the prepared hand sanitizer gels had antimicrobial activities against different gram-positive and gram-negative bacteria and Candida albicans yeast. The highest antibacterial effect was observed with tea tree oil hand sanitizers, which lack activity against the yeast, while clove oil hand sanitizers showed effectiveness against all microorganisms, including Candida albicans. The lavender hand sanitizer exhibited the least antimicrobial efficiency. The acceptability study on 20 human volunteers showed that the hand sanitizer gel containing 1.25% (v/v) clove oil did not produce any signs of skin irritation. This study suggested that the prepared natural hand sanitizer gel with 1.25% (v/v) clove oil can be a potential alternative to commonly used alcohol-based hand sanitizers (ABHS).


  • Open Access

    The Delivery of the Novel Drug ‘Halicin’ Using Electrospun Fibers for the Treatment of Pressure Ulcer against Pathogenic Bacteria

    by Walaa S. Aburayan, Rayan Y. Booq, Nouf S. BinSaleh, Haya A. Alfassam, Abrar A. Bakr, Haitham A. Bukhary, Essam J. Alyamani, Essam A. Tawfik

    Pressure ulcer or bedsore is a form of skin infection that commonly occurs with patients admitted to the hospital for an extended period of time, which might lead to severe complications in the absence of medical attention, resulting in infection either by drug-sensitive or drug-resistant bacteria. Halicin, a newly discovered drug effective against several bacterial strains, including multidrug-resistant bacteria, was investigated to reduce bacterial infection burden. This study aims to formulate halicin into electrospun fibers to be applied in bedsores as antibacterial dressing to assess its efficacy against gram-positive (Staphylococcus aureus) and gram-negative bacteria (Escherichia coli and Acinetobacter baumannii) by studying the minimum inhibitory concentration (MIC) and bacterial zone of inhibition assays. The diameters of inhibition growth zones were measured, and the results have shown that the drug-loaded fibers were able to inhibit the growth of bacteria compared to the halicin discs. The release profile of the drug-loaded fibers exhibited a complete release of the drug after 2 h. The results demonstrated that the drug-loaded fibers could successfully release the drug while retaining their biological activity and they may be used as a potential antimicrobial dressing for patients with pressure ulcers caused by multidrug resistant bacteria.