HLHong Liang

Hong Liang

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Hong Liang has a total of 53 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Inertial migration and self-assembly of staggered spheroidal particle pairs in square duct flows

    by Hong Liang, Zheng Wang, Feilong Yao, Lizhong Huang, Chun Shao, Yang Li

    In this paper, a staggered spheroidal particle pair inside a three-dimensional duct Poiseuille flow with Reynolds number (Re) up to 120 is investigated via the lattice Boltzmann method. Validation tests show excellent agreement with numerical and experimental results obtained by other groups. The entire migration dynamics and the final equilibrium state of the oblate and prolate particle pairs are analyzed and compared to those of the spherical particle pairs. The effects of initial axial spacing, particle aspect ratio, and Re are explored herein. Simulation results indicate that spheroidal particles tend to distribute orderly in the streamwise direction after they reach the corresponding face equilibrium positions. A key finding is that the prolate particle pairs eventually tumble with periodic oscillating axial spacing. Present results reveal that the initial axial spacing does not influence the equilibrium positions and interparticle spacings of spheroidal particle pairs. However, it does affect the migration process from the initial to the final stable or dynamic stable state. As Re increases from 20 to 120, spheroidal particles in the staggered pair gradually migrate toward the lower and upper walls, and the dimensionless average axial spacing between the adjacent prolate particles increases from 3.49 to 5.05 and collapses onto a single curve as a linear function of the particle Re. Compared to the oblate particle pair, the prolate particles are closer to the duct wall, and the corresponding axial spacing is larger at the same Re. For a staggered spheroidal particle pair, particles reach the equilibrium state under the attractive and repulsive forces. A second spheroidal particle prefers to occupy the eddy center generated by the first focusing particle. For the prolate particles with the tumbling mode, the distance between the particle and the eddy center gradually changes, and the axial spacing of the prolate particle pair also fluctuates periodically.

  • Open Access

    Semi-implicit Lax-Wendroff kinetic scheme for electron-phonon coupling

    by Jiaming Li, Hong Liang, Meng Lian, Chuang Zhang, Jiangrong Xu

    A semi-implicit Lax-Wendroff scheme is developed for electron-phonon coupling process in metals based on the two-temperature kinetic equations. The core of this method is to integrate the evolution information of physical equations into the numerical modeling process, which leads to that the time step or cell size is not limited by the relaxation time and mean free path. Specifically, the finite difference method is used to solve the kinetic model again when reconstructing the interfacial distribution function, through which the particle migration, scattering and electron-phonon coupling processes are coupled together within a single time step. Numerical tests demonstrate that this method could efficiently capture electron-phonon coupling or heat conduction processes from the ballistic to diffusive regimes. It provides a new tool for describing electron-phonon coupling or thermal management in microelectronic devices.

  • Open Access

    Semi-implicit Lax-Wendroff kinetic scheme for hydrodynamic phonon transport

    by Shijie Li, Hong Liang, Songze Chen, Chuang Zhang

    A semi-implicit Lax-Wendroff kinetic scheme is developed for hydrodynamic phonon transport in solid materials based on the Boltzmann transport equation under the double relaxation time approximation, in which both the normal and resistive scattering processes are accounted. The trapezoidal and midpoint rules are adopted for the temporal integration of the scattering and migration terms under the framework of finite volume method, respectively. Instead of direct numerical interpolation, the kinetic equation is solved again when reconstructing the interfacial flux, in order to realize the coupling of phonon migration and scattering within a numerical time step. Specifically, the finite difference scheme is introduced and the second-order upwind or central schemes are used for the reconstruction of the interfacial distribution function and its spatial gradient. Consequently, the cell size and time step of the present method could be larger than the phonon mean free path and relaxation time in the limit of small Knudsen numbers. Numerical tests demonstrate that the present method can accurately capture multi-scale thermal conduction phenomena within different normal or resistive scattering rates.

  • Open Access

    Parametric Gaussian quadratures for Discrete Unified Gas Kinetic Scheme

    by Lu Wang, Hong Liang, Jiangrong Xu

    The discrete unified gas kinetic scheme (DUGKS) has emerged as a promising Boltzmann solver capable of effectively capturing flow physics across all Knudsen numbers. However, simulating rarefied flows at high Knudsen numbers remains computationally demanding. This paper introduces a parametric Gaussian quadrature (PGQ) rule designed to improve the computational efficiency of DUGKS. The PGQ rule employs Gaussian functions for weighting and introduces several novel forms of higher-dimensional Gauss-Hermite quadrature. Initially, the velocity space is mapped to polar or spherical coordinates using a parameterized integral transformation method, which converts multiple integrals into repeated parametric integrals. Subsequently, Gaussian points and weight coefficients are computed based on the newly defined parametric weight functions. The parameters in PGQ allow the distribution of Gaussian points to be adjusted according to computational requirements, addressing the limitations of traditional Gaussian quadratures where Gaussian points are difficult to match the distribution of real particles in rarefied flows. To validate the proposed approach, numerical examples across various Knudsen numbers are provided. The simulation results demonstrate that PGQ offers superior computational efficiency and flexibility compared to the traditional Newton-Cotes rule and the half-range Gaussian Hermite rule, achieving computational efficiency that is tens of times higher than that of the Newton-Cotes method. This significantly enhances the computational efficiency of DUGKS and augments its ability to accurately simulate rarefied flow dynamics.

  • Self-ordering and organization of a staggered oblate particle pair in three-dimensional square ducts

    by Yang Li, Chun Shao, Lizhong Huang, Ruijin Wang, Hong Liang

    We numerically investigate the formation and ordering of staggered oblate particle pairs in three-dimensional straight ducts with a square cross section. The lattice Boltzmann method is employed to simulate rigid particle pairs in a Newtonian liquid. The effects of initial axial spacing, Reynolds number, blockage ratio, and particle aspect ratio on the formation process, migration behavior, and interparticle spacing are explored in detail. Current results indicate that the process from initial to final steady state can be divided into two stages. The first stage is rapid migration from initial positions toward equilibrium positions under shear-induced lift force and wall-induced repulsive force. The second stage is the slow self-assembly of stable particle pairs in the axial direction due to the interparticle interaction. Interestingly, initial axial spacing significantly affects the formation process of particle pairs but does not affect the final steady state. It is found that the equilibrium positions of staggered particle pairs move slightly toward the duct walls, and the axial spacing increases with increasing Reynolds number or particle aspect ratio, or decreasing blockage ratio. For a staggered particle pair, the second particle will occupy the eddy center induced by the first focusing particle. Based on the existing data, a correlation is put forward to predict the axial interparticle spacing of staggered oblate particle pairs in duct flows. The present results may give insights into manipulating and comprehending non-spherical particle dynamics in microfluidic applications.


  • Open Access

    A thermal lattice Boltzmann model for evaporating multiphase flows

    by Hong Liang, Wenyong Liu, Yang Li, Yikun Wei

    Modeling thermal multiphase flows has become a widely sought methodology due to its scientific relevance and broad industrial applications. Much progress has been achieved using different approaches, and the lattice Boltzmann method is one of the most popular methods for modeling liquid–vapor phase change. In this paper, we present a novel thermal lattice Boltzmann model for accurately simulating liquid–vapor phase change. The proposed model is built based on the equivalent variant of the temperature governing equation derived from the entropy balance law, in which the heat capacitance is absorbed into transient and convective terms. Then a modified equilibrium distribution function and a proper source term are elaborately designed in order to recover the targeting equation in the incompressible limit. The most striking feature of the present model is that the calculations of the Laplacian term of temperature, the gradient term of temperature, and the gradient term of density can be simultaneously avoided, which makes the formulation of the present model is more concise in contrast to all existing lattice Boltzmann models. Several benchmark examples, including droplet evaporation in open space, droplet evaporation on a heated wall, and nucleate boiling phenomenon, are carried out to assess numerical performance of the present model. It is found that the present model effectively improves the numerical accuracy in solving the interfacial behavior of liquid–vapor phase change within the lattice Boltzmann method framework.


  • Axisymmetric phase-field-based lattice Boltzmann model with reduced spurious velocity for incompressible two-phase flows

    by Chunhua Zhang, Zhaoli Guo, Lian-Ping Wang, Hantao Liu, Hong Liang

    In this work, a phase-field-based lattice Boltzmann method with reduced spurious velocity is developed for axisymmetric incompressible two-phase flows. Two sets of lattice Boltzmann equations with multiple-relaxation-time collision operators are used to, respectively, recover the conservative Allen–Cahn equation for interface capturing and the hydrodynamic equations. To reduce the spurious velocity, a novel correction term is introduced into the hydrodynamic lattice Boltzmann equation so that the leading truncation error related to the third derivatives of pressure can be partially removed. Simultaneously, the radius-weighted mirror symmetric boundary is applied to the axis of symmetry because all the moments of the distribution functions are proportional to the radial coordinate. Furthermore, the bulk viscosity is able to be changed independent of the shear viscosity through redefining the source term. A series of classical numerical experiments, including stationary droplet, oscillation of an elliptical droplet, bubble rising, drop splashing, have been conducted to test the performance of the proposed model. Numerical results agree well with the analytical solution and published data in literature, which demonstrates the improved accuracy and numerical stability.


  • Open Access

    Improved lattice Boltzmann model for moving contact-line with soluble surfactant

    by Ting Xu, Xin Bian, Hong Liang

    Modeling moving contact-line with surfactant has become a widely sought methodology due to its scientific relevance and extensive applications. Within the phase field framework, we present an improved lattice Boltzmann (LB) model for simulating moving contact-line dynamics with soluble surfactant. In this model, a LB equation is used to solve the Navier–Stokes equations, and another two LB equations are utilized to solve the two Cahn–Hilliard-like equations. The modified chemical potentials are incorporated in the LB model by using an equivalent variant of the free energy functional and the corresponding equilibrium distribution functions are also amended. These modifications could circumvent the degraded accuracy of previous LB models in capturing the interfacial behavior and surfactant distribution, and also improve the well-posedness of the LB model. In addition, a dynamic contact angle formulation is introduced to account for the surfactant effect on surface wettability and the resulting contact angle is further implemented in the LB model via a popular geometrical wetting approach. We comprehensively evaluate the numerical performance of the LB model by simulating some benchmark problems. It is found that the LB model achieves a higher accuracy than previous LB models in solving the phase field and surfactant profiles, and also numerical prediction of moving contact-line dynamics with surfactant shows good agreement with the analytical solution. Finally, the LB model is applied to investigate droplet shearing dynamics on solid substrate. The influences of capillary number and solid wetting property on droplet deformation and breakup are analyzed in detail.


  • Lattice Boltzmann method for interface capturing

    by Hong Liang, Runlong Wang, Yikun Wei, Jiangrong Xu

    Accurately solving phase interface plays a great role in modeling an immiscible multiphase flow system. In this paper, we propose an accurate interface-capturing lattice Boltzmann method from the perspective of the modified Allen-Cahn equation (ACE). The modified ACE is built based on the commonly used conservative formulation via the relation between the signed-distance function and the order parameter also maintaining the mass-conserved characteristic. A suitable forcing term is carefully incorporated into the lattice Boltzmann equation for correctly recovering the target equation. We then test the proposed method by simulating some typical interface-tracking problems of Zalesaks disk rotation, single vortex, deformation field and demonstrate that the present model can be more numerically accurate than the existing lattice Boltzmann models for the conservative ACE, especially at a small interface-thickness scale.