Tumeletso Lekgoba
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Tumeletso Lekgoba has a total of 21 co-authors. Here are the top co-authors by number of shared publications:
- Freeman Ntuli
Department of Chemical, Materials and Metallurgical Engineering Botswana International University of Science and Technology Palapye Botswana
7 shared publications - Vepika Kandjou
Department of Chemical Materials and Metallurgical Engineering (CMME), Faculty of Engineering and Technology (FET), BIUST, P/Bag 16 Palapye, Botswana
3 shared publications Edison Muzenda
2 shared publications- Aoyi Ochieng
Department of Chemical, Materials and Metallurgical Engineering, Botswana International University of Science and Technology, Palapye, Botswana
1 shared publication Boitshepho Ivy Marakalala
1 shared publication- Bonface Orero
Department of Chemical, Materials and Metallurgical Engineering, Botswana International University of Science and Technology, Palapye, Botswana
1 shared publication
Latest Publications
- Open Access
- 14 October 2026
- Published by Wiley in Water and Environment Journal
Assessing Distinctive Physiochemical Properties of Geopolymers, Their Green Development and Utilization in Wastewater Treatment
The quest for better and advanced materials that comply with economic and environmental sustainability principles has led to the development of several materials, including geopolymers. Derived from aluminosilicates and acid/alkali activators, geopolymers have proven to be a good alternative to several materials, to be environmentally benign and cheap to produce as they can be produced from valorizing waste. It is therefore necessary to know more about geopolymers to facilitate their industrial application and commercialization. In this regard, the paper reviews the physicochemical characteristics of geopolymers to fine‐tune them to specific applications, especially in wastewater treatment. The paper critically and comparatively analyses the difference between geopolymers and alkali‐activated materials, the alternative substrates for geopolymerization and greener ways for developing geopolymers. The paper further discusses the application of geopolymers to wastewater treatment and the mechanisms through which geopolymers remove impurities from wastewater.
- 14 October 2026
- Published by Wiley in Water and Environment Journal
Open AccessAssessing Distinctive Physiochemical Properties of Geopolymers, Their Green Development and Utilization in Wastewater Treatment
The quest for better and advanced materials that comply with economic and environmental sustainability principles has led to the development of several materials, including geopolymers. Derived from aluminosilicates and acid/alkali activators, geopolymers have proven to be a good alternative to several materials, to be environmentally benign and cheap to produce as they can be produced from valorizing waste. It is therefore necessary to know more about geopolymers to facilitate their industrial application and commercialization. In this regard, the paper reviews the physicochemical characteristics of geopolymers to fine‐tune them to specific applications, especially in wastewater treatment. The paper critically and comparatively analyses the difference between geopolymers and alkali‐activated materials, the alternative substrates for geopolymerization and greener ways for developing geopolymers. The paper further discusses the application of geopolymers to wastewater treatment and the mechanisms through which geopolymers remove impurities from wastewater.
- Open Access
- 13 July 2026
- Published by Elsevier in Next Materials
- Vol. 13
A review on geopolymers as green composite materials and their application in remediation of wastewater
- 13 July 2026
- Published by Elsevier in Next Materials
- Vol. 13
Open AccessA review on geopolymers as green composite materials and their application in remediation of wastewater
- Open Access
- 15 May 2025
- Published by Elsevier in Next Materials
- Vol. 8
Hybridization of fly ash – Moringa based composite for coagulation and disinfection of raw water
- 15 May 2025
- Published by Elsevier in Next Materials
- Vol. 8
Open AccessHybridization of fly ash – Moringa based composite for coagulation and disinfection of raw water
- Open Access
- 8 February 2025
- Published by Elsevier in Next Materials
- Vol. 7
Coal to graphene-based materials: Evaluating coal as a potential feedstock to pave way for large scale production of graphene and related materials, a review
- 8 February 2025
- Published by Elsevier in Next Materials
- Vol. 7
Open AccessCoal to graphene-based materials: Evaluating coal as a potential feedstock to pave way for large scale production of graphene and related materials, a review
- Open Access
- 24 March 2023
- Published by IWA Publishing in Water Science & Technology
- Vol. 87 (7) , 1587-1599
Characterization and utilization of water treatment sludge for coagulation of raw water
One of the critical steps in the treatment of raw water for human consumption is clarification. It encompasses coagulation and flocculation to reduce the concentration of suspended solids in turn producing a semi-solid slurry called water treatment sludge (WTS). It is necessary to characterize and find economic and sustainable ways to utilize the WTS. The WTS used in this work was characterized and contained aluminum (Al) (20.3% Al2O3) and iron (Fe) (5.28% Fe2O3) making it suitable for the development of a coagulant. A less energy-intensive way, through atmospheric acid leaching of WTS, was developed to extract Al and Fe for use as a coagulant. The sulphuric acid concentration and solid loading that gave the highest Al concentration were determined to be 3N and 5 g/100 mL, respectively. Turbidity reduction achieved with the developed coagulant ranged from 91 to 99% and was higher than that obtained in related studies due to the higher concentrations of Al and Fe in the WTS used in this study. Since the coagulant was very acidic, it was co-dosed with calcium oxide at 10 g/L of water to adjust the pH of the final water to allowable pH values for potable water (6.5–9.5).
- 24 March 2023
- Published by IWA Publishing in Water Science & Technology
- Vol. 87 (7) , 1587-1599
Open AccessCharacterization and utilization of water treatment sludge for coagulation of raw water
One of the critical steps in the treatment of raw water for human consumption is clarification. It encompasses coagulation and flocculation to reduce the concentration of suspended solids in turn producing a semi-solid slurry called water treatment sludge (WTS). It is necessary to characterize and find economic and sustainable ways to utilize the WTS. The WTS used in this work was characterized and contained aluminum (Al) (20.3% Al2O3) and iron (Fe) (5.28% Fe2O3) making it suitable for the development of a coagulant. A less energy-intensive way, through atmospheric acid leaching of WTS, was developed to extract Al and Fe for use as a coagulant. The sulphuric acid concentration and solid loading that gave the highest Al concentration were determined to be 3N and 5 g/100 mL, respectively. Turbidity reduction achieved with the developed coagulant ranged from 91 to 99% and was higher than that obtained in related studies due to the higher concentrations of Al and Fe in the WTS used in this study. Since the coagulant was very acidic, it was co-dosed with calcium oxide at 10 g/L of water to adjust the pH of the final water to allowable pH values for potable water (6.5–9.5).
- 11 November 2022
- Published by Springer Nature in International Journal of Environmental Science and Technology
- Vol. 20 (9) , 9537-9554
UV photodegradation of textile dyes using TiO2–ZnO supported on banana peel activated carbon
- 11 November 2022
- Published by Springer Nature in International Journal of Environmental Science and Technology
- Vol. 20 (9) , 9537-9554
UV photodegradation of textile dyes using TiO2–ZnO supported on banana peel activated carbon
- Open Access
- 26 November 2021
- Published by Modestum Ltd in European Journal of Sustainable Development Research
- Vol. 6 (1) , em0173
Sequestration of Heavy Metals From Coal Wash Water Using Biochar From Pyrolysis of Morula Shells
Biomass is a source of low-cost adsorbents used in the removal of contaminants. In this study, shells from an indigenous tree in Southern Africa called Morula were pyrolyzed to produce biochar that was used to sequester heavy metals from coal wash water. The produced biochar was activated using hydrochloric acid (HCl) and parameters such as the cation exchange capacity (CEC), point of zero charge (pHzc), elemental composition, mineral composition, proximate analysis and surface functional groups were determined. Batch adsorption experiments were carried out at 150 rpm for 60 min and 25 ºC at different metal ion concentrations and adsorbent dosages. The metal ions of interest were Zn, Ni and Fe and it was found that Fe recorded higher removals for both raw and activated biochar. Generally higher removals were noticed for both raw and activated at lower dosages (0.2 – 1.0 g/100 mL) and lower metal ion concentration (between 40 and 60 ppm) while lower removals were found at higher dosages (1 – 5 g/100 mL) and higher metal ion concentrations (between 400 – 600 ppm).
- 26 November 2021
- Published by Modestum Ltd in European Journal of Sustainable Development Research
- Vol. 6 (1) , em0173
Open AccessSequestration of Heavy Metals From Coal Wash Water Using Biochar From Pyrolysis of Morula Shells
Biomass is a source of low-cost adsorbents used in the removal of contaminants. In this study, shells from an indigenous tree in Southern Africa called Morula were pyrolyzed to produce biochar that was used to sequester heavy metals from coal wash water. The produced biochar was activated using hydrochloric acid (HCl) and parameters such as the cation exchange capacity (CEC), point of zero charge (pHzc), elemental composition, mineral composition, proximate analysis and surface functional groups were determined. Batch adsorption experiments were carried out at 150 rpm for 60 min and 25 ºC at different metal ion concentrations and adsorbent dosages. The metal ions of interest were Zn, Ni and Fe and it was found that Fe recorded higher removals for both raw and activated biochar. Generally higher removals were noticed for both raw and activated at lower dosages (0.2 – 1.0 g/100 mL) and lower metal ion concentration (between 40 and 60 ppm) while lower removals were found at higher dosages (1 – 5 g/100 mL) and higher metal ion concentrations (between 400 – 600 ppm).
- 1 April 2021
- Published by Elsevier in Journal of Water Process Engineering
- Vol. 40
Application of coal fly ash for treatment of wastewater containing a binary mixture of copper and nickel
- 1 April 2021
- Published by Elsevier in Journal of Water Process Engineering
- Vol. 40
Application of coal fly ash for treatment of wastewater containing a binary mixture of copper and nickel
- Open Access
- 24 July 2020
- Published by EDP Sciences
- Vol. 181
Effect of co-digestion of food waste and cow dung on biogas yield
This paper aims at finding the effect of co-digestion of cow dung and food waste on total biogas yield. Biogas production was improved through co-digestion of cow dung and food waste (FW) containing a small fraction of inoculum under mesophilic temperature (37ºC) over a retention time of 24 days. Co-digestion ratios of 1:1, 2:1 and 3:1 for cowdung/foodwaste were used for the study on anaerobic digestion on the co digested matter. Tests were carried out starting with the preparation of substrates, substrate characterization to determine the moisture content (MC), total solids (TS), volatile solids (VS) and ultimately batch anaerobic digestion experiments under thermophilic conditions (370C). The moisture content, volatile solids and total solids for food waste were 78, 22 and 90.7% respectively while the characteristics for cow dung were 67.2, 32.8 and 96.0 % respectively. From the study, a mixing ratio of cow dung: food waste of 1:2 was found to be the optimum substrate mixture for biogas production at 25595.7 Nml. The accumulated gas volumes of 18756.6, 14042.5, 13940.8 and 13839.1 Nml were recorded for cow dung: food waste ratios of 2:1, 1:1, 1:3 and 3:1 respectively. For a co-digestion containing more of the food waste than cow dung, a higher volume of biogas is produce.
- 24 July 2020
- Published by EDP Sciences
- Vol. 181
Open AccessEffect of co-digestion of food waste and cow dung on biogas yield
This paper aims at finding the effect of co-digestion of cow dung and food waste on total biogas yield. Biogas production was improved through co-digestion of cow dung and food waste (FW) containing a small fraction of inoculum under mesophilic temperature (37ºC) over a retention time of 24 days. Co-digestion ratios of 1:1, 2:1 and 3:1 for cowdung/foodwaste were used for the study on anaerobic digestion on the co digested matter. Tests were carried out starting with the preparation of substrates, substrate characterization to determine the moisture content (MC), total solids (TS), volatile solids (VS) and ultimately batch anaerobic digestion experiments under thermophilic conditions (370C). The moisture content, volatile solids and total solids for food waste were 78, 22 and 90.7% respectively while the characteristics for cow dung were 67.2, 32.8 and 96.0 % respectively. From the study, a mixing ratio of cow dung: food waste of 1:2 was found to be the optimum substrate mixture for biogas production at 25595.7 Nml. The accumulated gas volumes of 18756.6, 14042.5, 13940.8 and 13839.1 Nml were recorded for cow dung: food waste ratios of 2:1, 1:1, 1:3 and 3:1 respectively. For a co-digestion containing more of the food waste than cow dung, a higher volume of biogas is produce.
- 1 April 2020
- Published by EJournal Publishing in Journal of Clean Energy Technologies
- Vol. 8 (2) , 16-19
Effect of Substrate to Inoculum Ratio on Biogas Yield
- 1 April 2020
- Published by EJournal Publishing in Journal of Clean Energy Technologies
- Vol. 8 (2) , 16-19
Effect of Substrate to Inoculum Ratio on Biogas Yield