MAMatias Daniel de Almeida

Matias Daniel de Almeida

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Matias Daniel de Almeida has a total of 6 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Solar cell performance as a function of emitter layer thickness and temperature

    by Matias Daniel de Almeida, Nuggehalli M. Ravindra

    This work investigates the temperature-dependent performance of three homojunction solar cells composed of silicon, gallium arsenide, and indium phosphide, using the open-source simulation software PC1D. Emitter layer thicknesses ranging from 0.01 to 1 $$\upmu$$ μ m were modeled across a temperature range of 273–373 K. The key photovoltaic parameters—short-circuit current density ( $$J_{\textrm{sc}}$$ J sc ), open-circuit voltage ( $$V_{\textrm{oc}}$$ V oc ), and conversion efficiency ( $$\eta$$ η )—were extracted to assess their thermal sensitivity. The results show that $$J_{\textrm{sc}}$$ J sc remains largely invariant with temperature, while $$V_{\textrm{oc}}$$ V oc declines approximately linearly, driving the observed reduction in efficiency, $$\eta$$ η . Silicon exhibited the steepest thermal degradation, with $$\eta$$ η decreasing from 21.8 to 13.5%. GaAs and InP demonstrated greater thermal stability, with $$\eta$$ η decreasing from 26.6 to 20.2% and 27.2 to 20.5%, respectively. Decreasing efficiencies were observed for all three cell configurations with increased emitter layer thickness. The greater temperature sensitivity of Si is attributed to stronger non-radiative recombination and phonon-assisted transitions characteristic of its indirect bandgap. Additional simulations on the impact of increasing surface recombination velocity and bulk carrier lifetime were carried out, indicating optimum performance at high lifetimes and low recombination velocities. These findings emphasize the advantages of direct bandgap materials for high-temperature photovoltaic applications and the efficacy of PC1D in explicating different material behaviors.


  • Generation of shock trains in free liquid jets with a nanosecond green laser

    by Daniel Ursescu, Veselin Aleksandrov, Dan Matei, Ioan Dancus, Matias D. de Almeida, Claudiu A. Stan

    Shock wave trains in liquid jets were previously generated only by ablation with femtosecond x-ray lasers. Here we show that shock trains in water microjets can be also generated using nanosecond green laser pulses with 1- to 10-mJ energy. The ablation of 15-, 20-, 30-, and 70-μm water microjets opened a gap in the jets and launched an initial shock wave. Fully developed shock trains were observed in the 30- and 70-μm jets up to 250-ns delays, and these trains were also transmitted inside the nozzles. A few tens of nanoseconds after the pulse, the shock dynamics and its pressure became similar to the ones generated by x-ray lasers, with a more rapid pressure decay in thinner jets. At time delays exceeding 100 ns in the 30-μm jets, the leading shock pressure stabilized to an approximately constant pressure of 40 MPa. The energy density deposited in the jets was estimated at 30 MJ/cm3 by comparing the jet gaps in the green and x-ray laser experiments, and matched previous estimates for optical ablation in water. The pressure decay in the 30-μm jets was modeled based on the pressure decay observed in x-ray laser experiments.