Hua Yu
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Hua Yu has a total of 34 co-authors. Here are the top co-authors by number of shared publications:
- Kam Ng
Department of Civil and Architectural Engineering and Construction Management, University of Wyoming, Laramie, USA
21 shared publications Chooikim Lau
Univ. of Wyoming
9 shared publicationsChooi Kim Lau
6 shared publications- Chooi Kim Lau
University of Wyoming, Laramie, USA
6 shared publications Kam Ng
Associate Professor, Dept. of Civil and Architectural Engineering and Construction Management, University of Wyoming, 1000 E. University Avenue, Laramie, WY 82071
2 shared publications- Kamal Gautam
University of Wyoming, Laramie, USA
2 shared publications
Latest Publications
- Open Access
- 1 August 2026
- Published by Springer Nature in Transportation Infrastructure Geotechnology
- Vol. 13 (6) , 226
Coal Char-Cement Stabilization of Common Clay Soils
Coal char addition to the physical, chemical, mechanical, mineralogical, and microstructural properties of cement-stabilized kaolin, calcium bentonite, and sodium bentonite was investigated using char contents up to 30% (by mass of cement). This study employed unconfined compression tests, triaxial compression tests, one-dimensional consolidation, thermogravimetric analysis, X-ray diffraction, and scanning electron microscopy to evaluate coal char’s influence on cement hydration and clay-cement interactions. Results showed that coal char increased the unconfined compressive strength of stabilized kaolin and sodium bentonite by an average of 6.2% and 32%, respectively, through enhanced hydration and pore refinement. Calcium bentonite exhibited an 8% strength gain after 7 days but a 10.2% reduction after 56 days, likely because early calcium aluminate silicate hydrate formation, reducing pore solution alkalinity and limiting hydration. Adding 10% coal char reduced the compression index and coefficient of volume change for all soils, with sodium bentonite showing the greatest improvement. Under triaxial compression, shear strength increased by 110.8% for kaolin and 38.6% for calcium bentonite, while sodium bentonite exhibited a 3% reduction due to crack development. These findings demonstrated coal char’s potential to enhance cement stabilization, depending on clay mineralogy.
- 1 August 2026
- Published by Springer Nature in Transportation Infrastructure Geotechnology
- Vol. 13 (6) , 226
Open AccessCoal Char-Cement Stabilization of Common Clay Soils
Coal char addition to the physical, chemical, mechanical, mineralogical, and microstructural properties of cement-stabilized kaolin, calcium bentonite, and sodium bentonite was investigated using char contents up to 30% (by mass of cement). This study employed unconfined compression tests, triaxial compression tests, one-dimensional consolidation, thermogravimetric analysis, X-ray diffraction, and scanning electron microscopy to evaluate coal char’s influence on cement hydration and clay-cement interactions. Results showed that coal char increased the unconfined compressive strength of stabilized kaolin and sodium bentonite by an average of 6.2% and 32%, respectively, through enhanced hydration and pore refinement. Calcium bentonite exhibited an 8% strength gain after 7 days but a 10.2% reduction after 56 days, likely because early calcium aluminate silicate hydrate formation, reducing pore solution alkalinity and limiting hydration. Adding 10% coal char reduced the compression index and coefficient of volume change for all soils, with sodium bentonite showing the greatest improvement. Under triaxial compression, shear strength increased by 110.8% for kaolin and 38.6% for calcium bentonite, while sodium bentonite exhibited a 3% reduction due to crack development. These findings demonstrated coal char’s potential to enhance cement stabilization, depending on clay mineralogy.
- 2 February 2026
- Published by Elsevier in Construction and Building Materials
- Vol. 513
Development and evaluation of coal char-based colored adhered manufactured stone masonry veneer
- 2 February 2026
- Published by Elsevier in Construction and Building Materials
- Vol. 513
Development and evaluation of coal char-based colored adhered manufactured stone masonry veneer
- 31 January 2026
- Published by Elsevier in Journal of Building Engineering
- Vol. 120
Lightweight coal char-based aggregates for concrete applications
- 31 January 2026
- Published by Elsevier in Journal of Building Engineering
- Vol. 120
Lightweight coal char-based aggregates for concrete applications
- 13 January 2026
- Published by Springer Nature in International Journal of Geosynthetics and Ground Engineering
- Vol. 12 (1) , 8
Coal Char as an Additive: Effects on Cement-Stabilized Soils with High Bentonite Content
- 13 January 2026
- Published by Springer Nature in International Journal of Geosynthetics and Ground Engineering
- Vol. 12 (1) , 8
Coal Char as an Additive: Effects on Cement-Stabilized Soils with High Bentonite Content
- 5 October 2025
- Published by Elsevier in Transportation Geotechnics
- Vol. 56
Investigation of the effect of coal char on cement-treated bentonite-sand mixtures for pavement applications
- 5 October 2025
- Published by Elsevier in Transportation Geotechnics
- Vol. 56
Investigation of the effect of coal char on cement-treated bentonite-sand mixtures for pavement applications
- 25 September 2025
- Published by Elsevier in Construction and Building Materials
- Vol. 495
Novel lightweight coal char-based aggregates for potential ASR mitigation
- 25 September 2025
- Published by Elsevier in Construction and Building Materials
- Vol. 495
Novel lightweight coal char-based aggregates for potential ASR mitigation
- Open Access
Effect of Coal-Derived Graphene Oxide on the Mechanical and Microstructural Characteristics of Concrete
Past studies have offered insights into how graphite-derived graphene oxide (GDGO) can improve the mechanical properties and alter microstructural characteristics of concrete. These advantages can significantly impact the construction industry regarding cost, sustainability, and efficiency. However, the high cost of GDGO can make commercial implementation unattainable. This paper comprehensively investigates coal-derived GO as a cost-saving alternative to commercial GDGO while achieving comparable concrete performance. Different GO proportions were incorporated into concrete mixes through laboratory experiments to determine the effect on mechanical properties and microstructures. In this research, concrete mixes were formulated by replacing a portion of cement with coal-derived GO and adding this GO as an additive to concrete at varying percentages (0.05%, 0.10%, 0.25%, 0.50%, 1%, and 1.5% by weight of cement). The study revealed flexural, split tensile, and compressive strength improvements of 3.3%, 2.3%, and 21.2%, respectively, at a minimal 0.05 wt.% GO replacement. Optimal inclusions of GO as an additive ranging from 0.05 to 0.25 wt.% were identified to exhibit a maximum increase in mechanical properties. More precisely, adding 0.10 weight percent of GO as an additive to concrete showed increases in flexural, split tensile, and compressive strengths of 14.05%, 9.7%, and 34.2%, respectively. Furthermore, detailed analyses, including modulus of elasticity, Poisson’s ratio, heat of hydration, and microstructural analysis provided comprehensive insights into the enhanced mechanical performance of GO-incorporated concrete. Additionally, the study revealed a lower Ca/Si ratio in GO concrete, further validating the reinforcing properties of the GO.
Open AccessEffect of Coal-Derived Graphene Oxide on the Mechanical and Microstructural Characteristics of Concrete
Past studies have offered insights into how graphite-derived graphene oxide (GDGO) can improve the mechanical properties and alter microstructural characteristics of concrete. These advantages can significantly impact the construction industry regarding cost, sustainability, and efficiency. However, the high cost of GDGO can make commercial implementation unattainable. This paper comprehensively investigates coal-derived GO as a cost-saving alternative to commercial GDGO while achieving comparable concrete performance. Different GO proportions were incorporated into concrete mixes through laboratory experiments to determine the effect on mechanical properties and microstructures. In this research, concrete mixes were formulated by replacing a portion of cement with coal-derived GO and adding this GO as an additive to concrete at varying percentages (0.05%, 0.10%, 0.25%, 0.50%, 1%, and 1.5% by weight of cement). The study revealed flexural, split tensile, and compressive strength improvements of 3.3%, 2.3%, and 21.2%, respectively, at a minimal 0.05 wt.% GO replacement. Optimal inclusions of GO as an additive ranging from 0.05 to 0.25 wt.% were identified to exhibit a maximum increase in mechanical properties. More precisely, adding 0.10 weight percent of GO as an additive to concrete showed increases in flexural, split tensile, and compressive strengths of 14.05%, 9.7%, and 34.2%, respectively. Furthermore, detailed analyses, including modulus of elasticity, Poisson’s ratio, heat of hydration, and microstructural analysis provided comprehensive insights into the enhanced mechanical performance of GO-incorporated concrete. Additionally, the study revealed a lower Ca/Si ratio in GO concrete, further validating the reinforcing properties of the GO.
- 31 March 2025
- Published by Elsevier in Construction and Building Materials
- Vol. 473
Durability of water-based silane/siloxane treated coal char brick subjected to weatherometer exposure
- 31 March 2025
- Published by Elsevier in Construction and Building Materials
- Vol. 473
Durability of water-based silane/siloxane treated coal char brick subjected to weatherometer exposure