Lintao Zhang
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Lintao Zhang has a total of 24 co-authors. Here are the top co-authors by number of shared publications:
- Kai Wu
Key Laboratory of Advanced Civil Engineering Materials of Ministry of Education, School of Materials Science and Engineering, Tongji University, Shanghai, China
2 shared publications - Danzhu Ma
College of Petroleum Engineering, Liaoning Petrochemical University, Fushun, P.R. China
1 shared publication - Engang Wang
Key Laboratory of Electromagnetic Processing of Materials (Ministry of Education), Northeastern University, Shenyang, China
1 shared publication - Geert De Schutter
Magnel-Vandepitte Laboratory, Department of Structural Engineering and Building Materials, Ghent University, Zwijnaarde, 9052 Ghent, Belgium
1 shared publication - Jiangfeng Long
Tongji University
1 shared publication - Jianguo Han
Chengdu Huge Construction Material Co., Ltd Chengdu China
1 shared publication
Latest Publications
- 14 September 2026
- Published by Elsevier in Construction and Building Materials
- Vol. 543
Particle size dependent performance of recycled lithium tailings as supplementary cementitious materials
- 14 September 2026
- Published by Elsevier in Construction and Building Materials
- Vol. 543
Particle size dependent performance of recycled lithium tailings as supplementary cementitious materials
- 18 July 2022
- Published by Springer Nature in Environmental Science and Pollution Research
- Vol. 29 (59) , 89184-89197
Recycling of sewage sludge in clay-free thermal insulation brick: assessment of microstructure, performance, and environment impact
Recycling municipal sewage sludge in fired bricks not only contributes to environmental protection, but is also an alternative to natural clay resource. The complex compositions of sludge have a great influence on the brick property. This work presents a systematical investigation on fired bricks made only with sludge and shale. The physicochemical properties of the raw mixtures, macroscopic performance, microstructure, and its evolution were quantitatively determined. The coordination between shale and sludge enables the blend of raw materials to achieve the desired gradation and plasticity. Although a reduction in compressive strength was observed, the open porosity was increased to 31.6% and thermal conductivity was reduced to 0.51 W·(m·K)−1, indicating the benefit to the performance of lightweight thermal insulation bricks. The fitting results confirm the pore-forming effect induced by the organic matter in the sludge. The obtained bricks possess good performance, especially in thermal insulation properties, and environmental and economic benefits.
- 18 July 2022
- Published by Springer Nature in Environmental Science and Pollution Research
- Vol. 29 (59) , 89184-89197
Recycling of sewage sludge in clay-free thermal insulation brick: assessment of microstructure, performance, and environment impact
Recycling municipal sewage sludge in fired bricks not only contributes to environmental protection, but is also an alternative to natural clay resource. The complex compositions of sludge have a great influence on the brick property. This work presents a systematical investigation on fired bricks made only with sludge and shale. The physicochemical properties of the raw mixtures, macroscopic performance, microstructure, and its evolution were quantitatively determined. The coordination between shale and sludge enables the blend of raw materials to achieve the desired gradation and plasticity. Although a reduction in compressive strength was observed, the open porosity was increased to 31.6% and thermal conductivity was reduced to 0.51 W·(m·K)−1, indicating the benefit to the performance of lightweight thermal insulation bricks. The fitting results confirm the pore-forming effect induced by the organic matter in the sludge. The obtained bricks possess good performance, especially in thermal insulation properties, and environmental and economic benefits.
- Open Access
- 26 January 2022
- Published by Springer Nature in Metallurgical and Materials Transactions B
- Vol. 53 (2) , 1321
Correction to: Influence of the Vertical Pole Parameters on Molten Steel Flow and Meniscus Behavior in a FAC-EMBr Controlled Mold
- 26 January 2022
- Published by Springer Nature in Metallurgical and Materials Transactions B
- Vol. 53 (2) , 1321
Open AccessCorrection to: Influence of the Vertical Pole Parameters on Molten Steel Flow and Meniscus Behavior in a FAC-EMBr Controlled Mold
- 12 December 2020
- Published by Wiley in Structural Concrete
- Vol. 22 (2) , 926-938
Quantitative evaluation of interfacial transition zone of sustainable concrete with recycled and steel slag as aggregate
Utilizing steel slag and recycled concrete as fine aggregate could save the consumption of natural resource and reduce the environmental pollution. In this work, the effect of steel slag aggregate and recycled aggregate on the compressive strength and chloride migration coefficient of three types of concretes were investigated and compared with natural aggregate. The interfacial transition zone (ITZ) microstructure and the connection between aggregate and bulk cement matrix was determined by using a quantitative backscattered electron (BSE) image analysis, N2 adsorption–desorption and X‐ray diffraction analysis. Results showed that the compressive strength and chloride resistance ability of natural aggregate concrete (NAC) and steel slag aggregate concrete (SAC) was highly dependent on aggregate volume content. The performance of recycled aggregate concrete (RAC) were much poorer than that of SAC and NAC. Pore structure and phase analysis confirmed that the improved properties of SAC can be partially attributed to the densified ITZ. Regarding RAC, a porous ITZ was observed in BSE image and pore structure analysis, which caused a poor compressive strength and a large chloride migration coefficient. It was found that the improvement of chloride resistance ability by using supplementary cementitious materials in NAC was more remarkable than that in SAC.
- 12 December 2020
- Published by Wiley in Structural Concrete
- Vol. 22 (2) , 926-938
Quantitative evaluation of interfacial transition zone of sustainable concrete with recycled and steel slag as aggregate
Utilizing steel slag and recycled concrete as fine aggregate could save the consumption of natural resource and reduce the environmental pollution. In this work, the effect of steel slag aggregate and recycled aggregate on the compressive strength and chloride migration coefficient of three types of concretes were investigated and compared with natural aggregate. The interfacial transition zone (ITZ) microstructure and the connection between aggregate and bulk cement matrix was determined by using a quantitative backscattered electron (BSE) image analysis, N2 adsorption–desorption and X‐ray diffraction analysis. Results showed that the compressive strength and chloride resistance ability of natural aggregate concrete (NAC) and steel slag aggregate concrete (SAC) was highly dependent on aggregate volume content. The performance of recycled aggregate concrete (RAC) were much poorer than that of SAC and NAC. Pore structure and phase analysis confirmed that the improved properties of SAC can be partially attributed to the densified ITZ. Regarding RAC, a porous ITZ was observed in BSE image and pore structure analysis, which caused a poor compressive strength and a large chloride migration coefficient. It was found that the improvement of chloride resistance ability by using supplementary cementitious materials in NAC was more remarkable than that in SAC.
- 7 August 2002
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Ultrasonics, Ferroelectrics, and Frequency Control
- Vol. 49 (2) , 266-270
Design optimization of beam-like ferroelectrics-silicon microphone and microspeaker
Design optimization of beam-like ferroelectrics-silicon integrated microphone and microspeaker is studied. The Pt/Pb(Zr,Ti)O/sub 3//Pt/SiO/sub 2//Si/sub 3/N/sub 4/ cantilever structure is designed theoretically using multimorph model. The sensitivity and the sound pressure level (SPL) of the integrated microphone and microspeaker are calculated. It is found that the sensitivity of the microphone and the SPL of the microspeaker are very high. This integrated microphone and microspeaker will be valuable for high quality micro-acoustic devices.
- 7 August 2002
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Ultrasonics, Ferroelectrics, and Frequency Control
- Vol. 49 (2) , 266-270
Design optimization of beam-like ferroelectrics-silicon microphone and microspeaker
Design optimization of beam-like ferroelectrics-silicon integrated microphone and microspeaker is studied. The Pt/Pb(Zr,Ti)O/sub 3//Pt/SiO/sub 2//Si/sub 3/N/sub 4/ cantilever structure is designed theoretically using multimorph model. The sensitivity and the sound pressure level (SPL) of the integrated microphone and microspeaker are calculated. It is found that the sensitivity of the microphone and the SPL of the microspeaker are very high. This integrated microphone and microspeaker will be valuable for high quality micro-acoustic devices.