Yuya Onozuka
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Yuya Onozuka has a total of 8 co-authors. Here are the top co-authors by number of shared publications:
Motoki Shino
Graduate School of Frontier Sciences, The University of Tokyo, Chiba, Japan
5 shared publicationsGenki Murata
JTEKT Corporation,Kariya,Aichi,Japan
3 shared publicationsNobuyasu Tomokuni
Kindai University,Department of Robotics,Hiroshima,Japan
3 shared publicationsRyosuke Matsumi
Graduate School of Frontier Sciences, The University of Tokyo, Chiba, Japan
2 shared publications- Motoki Shino
Department of Human and Engineered Environmental Studies, Graduate School of Frontier Sciences, The University of Tokyo, Kashiwa 277-8563, Japan
1 shared publication Ryo Kawahata
Univ. of Tokyo
1 shared publication
Latest Publications
- 27 September 2021
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 4501-4508
Autonomous Mobile Robot Navigation Independent of Road Boundary Using Driving Recommendation Map
Numerous autonomous navigation systems have been proposed, so far, for use in walking environments. Of these, systems that do not rely on high-definition maps and precise localization are cheaper to maintain and easier to implement in unknown outdoor environments. In these systems, road-following navigation using road boundaries is commonly used. In outdoor environments, however, the road boundary is indistinct in some cases. Therefore, it is necessary to infer an area recommended by traffic rules and navigate based on this inference. This paper proposes an autonomous navigation system that is independent of the road boundaries by using a driving recommendation map. In this system, the driving recommendation degree is inferred by deep learning-based semantic segmentation using automatically labeled training data, and a map that probabilistically represents the driving recommendation degree is generated using this information. The proposed autonomous navigation system has demonstrated its usefulness in an environment with indistinct road boundaries. The demonstration shows the proposed autonomous navigation system can plan a path based on driving recommendation degree and properly drive in a scene where the road boundary is indistinct.
- 27 September 2021
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 4501-4508
Autonomous Mobile Robot Navigation Independent of Road Boundary Using Driving Recommendation Map
Numerous autonomous navigation systems have been proposed, so far, for use in walking environments. Of these, systems that do not rely on high-definition maps and precise localization are cheaper to maintain and easier to implement in unknown outdoor environments. In these systems, road-following navigation using road boundaries is commonly used. In outdoor environments, however, the road boundary is indistinct in some cases. Therefore, it is necessary to infer an area recommended by traffic rules and navigate based on this inference. This paper proposes an autonomous navigation system that is independent of the road boundaries by using a driving recommendation map. In this system, the driving recommendation degree is inferred by deep learning-based semantic segmentation using automatically labeled training data, and a map that probabilistically represents the driving recommendation degree is generated using this information. The proposed autonomous navigation system has demonstrated its usefulness in an environment with indistinct road boundaries. The demonstration shows the proposed autonomous navigation system can plan a path based on driving recommendation degree and properly drive in a scene where the road boundary is indistinct.
- Open Access
Weakly-Supervised Recommended Traversable Area Segmentation Using Automatically Labeled Images for Autonomous Driving in Pedestrian Environment with No Edges
Detection of traversable areas is essential to navigation of autonomous personal mobility systems in unknown pedestrian environments. However, traffic rules may recommend or require driving in specified areas, such as sidewalks, in environments where roadways and sidewalks coexist. Therefore, it is necessary for such autonomous mobility systems to estimate the areas that are mechanically traversable and recommended by traffic rules and to navigate based on this estimation. In this paper, we propose a method for weakly-supervised recommended traversable area segmentation in environments with no edges using automatically labeled images based on paths selected by humans. This approach is based on the idea that a human-selected driving path more accurately reflects both mechanical traversability and human understanding of traffic rules and visual information. In addition, we propose a data augmentation method and a loss weighting method for detecting the appropriate recommended traversable area from a single human-selected path. Evaluation of the results showed that the proposed learning methods are effective for recommended traversable area detection and found that weakly-supervised semantic segmentation using human-selected path information is useful for recommended area detection in environments with no edges.
Open AccessWeakly-Supervised Recommended Traversable Area Segmentation Using Automatically Labeled Images for Autonomous Driving in Pedestrian Environment with No Edges
Detection of traversable areas is essential to navigation of autonomous personal mobility systems in unknown pedestrian environments. However, traffic rules may recommend or require driving in specified areas, such as sidewalks, in environments where roadways and sidewalks coexist. Therefore, it is necessary for such autonomous mobility systems to estimate the areas that are mechanically traversable and recommended by traffic rules and to navigate based on this estimation. In this paper, we propose a method for weakly-supervised recommended traversable area segmentation in environments with no edges using automatically labeled images based on paths selected by humans. This approach is based on the idea that a human-selected driving path more accurately reflects both mechanical traversability and human understanding of traffic rules and visual information. In addition, we propose a data augmentation method and a loss weighting method for detecting the appropriate recommended traversable area from a single human-selected path. Evaluation of the results showed that the proposed learning methods are effective for recommended traversable area detection and found that weakly-supervised semantic segmentation using human-selected path information is useful for recommended area detection in environments with no edges.
- 1 January 2021
- Published by Japan Society of Mechanical Engineers in The Proceedings of JSME annual Conference on Robotics and Mechatronics (Robomec)
- Vol. 2021, 2P1-B13
Autonomous Driving Considering Recommended Traversable Areas in Pedestrian Environment with Indistinct Road Boundary
The objective of this research is to develop autonomous mobility adaptable to the pedestrian environment with indistinct road boundaries using a recommended traversable area detection system. In previous research, we proposed a learning method for weakly-supervised semantic segmentation, which was effective in improving the performance of detecting recommended traversable areas. In this paper, we developed an autonomous navigation system based on a driving recommendation map using a recommended traversable area detection system. By setting appropriate weights to consider recommended traversable areas, generating paths in the direction of right and left turns while suppressing path generation to non-recommended areas was achieved. Also, by adding a new class of driving trajectory and sidewalk area, the system can selectively enter sidewalks in scenes where physical features and edges cannot be taken. Finally, the usefulness of the developed system in a real environment with indistinct road boundaries was verified.
- 1 January 2021
- Published by Japan Society of Mechanical Engineers in The Proceedings of JSME annual Conference on Robotics and Mechatronics (Robomec)
- Vol. 2021, 2P1-B13
Autonomous Driving Considering Recommended Traversable Areas in Pedestrian Environment with Indistinct Road Boundary
The objective of this research is to develop autonomous mobility adaptable to the pedestrian environment with indistinct road boundaries using a recommended traversable area detection system. In previous research, we proposed a learning method for weakly-supervised semantic segmentation, which was effective in improving the performance of detecting recommended traversable areas. In this paper, we developed an autonomous navigation system based on a driving recommendation map using a recommended traversable area detection system. By setting appropriate weights to consider recommended traversable areas, generating paths in the direction of right and left turns while suppressing path generation to non-recommended areas was achieved. Also, by adding a new class of driving trajectory and sidewalk area, the system can selectively enter sidewalks in scenes where physical features and edges cannot be taken. Finally, the usefulness of the developed system in a real environment with indistinct road boundaries was verified.
- 24 October 2020
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 4114-4119
Dynamic Stability Control of Inverted-Pendulum-Type Robotic Wheelchair for Going Up and Down Stairs
The wheelchair is the major means of transport for elderly and physically disabled people in their daily lives. However it cannot overcome architectural barriers such as curbs and stairs. In this study, we developed an inverted-pendulum-type robotic wheelchair for climbing stairs. The wheelchair has a seat slider and two rotary links between the front and rear wheels on each side. When climbing up stairs, the wheelchair rotates the rotary links while maintaining an inverted state of a movable body by controlling the position of the center of gravity using the seat slider. In previous research, we proposed the control method for climbing up stairs using the rotary links and seat slider, confirming a period of approximately 5 s to rotate the rotary links. In this paper, we propose a control method for going down stairs, and experimentally verify the control effectiveness and stability.
- 24 October 2020
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 4114-4119
Dynamic Stability Control of Inverted-Pendulum-Type Robotic Wheelchair for Going Up and Down Stairs
The wheelchair is the major means of transport for elderly and physically disabled people in their daily lives. However it cannot overcome architectural barriers such as curbs and stairs. In this study, we developed an inverted-pendulum-type robotic wheelchair for climbing stairs. The wheelchair has a seat slider and two rotary links between the front and rear wheels on each side. When climbing up stairs, the wheelchair rotates the rotary links while maintaining an inverted state of a movable body by controlling the position of the center of gravity using the seat slider. In previous research, we proposed the control method for climbing up stairs using the rotary links and seat slider, confirming a period of approximately 5 s to rotate the rotary links. In this paper, we propose a control method for going down stairs, and experimentally verify the control effectiveness and stability.
- Open Access
- 16 May 2020
- Published by Springer Nature in ROBOMECH Journal
- Vol. 7 (1) , 1-13
Attitude control of an inverted-pendulum-type robotic wheelchair to climb stairs considering dynamic equilibrium
The wheelchair is the major means of transport for elderly and physically disabled people in their daily lives. However it cannot overcome architectural barriers such as curbs and stairs. In this study, we developed an inverted-pendulum-type robotic wheelchair for climbing stairs. This wheelchair has a seat slider and two rotary links between the front and rear wheels on each side. When climbing stairs, the wheelchair rotates the rotary links while maintaining an inverted state of a mobile body by controlling the position of the center of gravity using a seat slider. In previous research, we confirmed that the wheelchair can climb by applying the control method consisting of a center-of-gravity control phase and rotary link control phase. However, it took approximately 15 s to rotate the rotary links during climbing because faster climbing causes the movement of wheels and the wheelchair to fall. This paper focuses on a control method to restrain the movement of the wheels when the stair climbing speed is increased. We realized that the movement was caused by forces acting on the pitch angle, such as the inertial force and the reaction of the driving force. We proposed the method considering the dynamic equilibrium of the pitch angle and confirmed the effect of the restraining wheels’ movement when the proposed method was applied.
- 16 May 2020
- Published by Springer Nature in ROBOMECH Journal
- Vol. 7 (1) , 1-13
Open AccessAttitude control of an inverted-pendulum-type robotic wheelchair to climb stairs considering dynamic equilibrium
The wheelchair is the major means of transport for elderly and physically disabled people in their daily lives. However it cannot overcome architectural barriers such as curbs and stairs. In this study, we developed an inverted-pendulum-type robotic wheelchair for climbing stairs. This wheelchair has a seat slider and two rotary links between the front and rear wheels on each side. When climbing stairs, the wheelchair rotates the rotary links while maintaining an inverted state of a mobile body by controlling the position of the center of gravity using a seat slider. In previous research, we confirmed that the wheelchair can climb by applying the control method consisting of a center-of-gravity control phase and rotary link control phase. However, it took approximately 15 s to rotate the rotary links during climbing because faster climbing causes the movement of wheels and the wheelchair to fall. This paper focuses on a control method to restrain the movement of the wheels when the stair climbing speed is increased. We realized that the movement was caused by forces acting on the pitch angle, such as the inertial force and the reaction of the driving force. We proposed the method considering the dynamic equilibrium of the pitch angle and confirmed the effect of the restraining wheels’ movement when the proposed method was applied.
- 1 January 2019
- Published by Japan Society of Mechanical Engineers in The Proceedings of JSME annual Conference on Robotics and Mechatronics (Robomec)
- Vol. 2019, 2P1-A15
Attitude control of inverted pendulum type robotic wheelchair with the ability to climb stairs considering dynamic equilibrium
We have been developing an inverted pendulum type robotic wheelchair with the ability to climb stairs. This wheelchair has a seat slider and two rotary links between the front and rear wheels on each side. It is controled by a linear-quadratic regulator consisting of a center of gravity control mode and a rotary link control mode. This paper focuses on a method for restraining movement of wheels when it climbs stairs more quickly because this movement causes fall of the wheelchair. We grasped that the movement was caused by forces acting on pitch angle, such as inertial force and reaction of driving force. We proposed a control method considering dynamic equilibrium of the attitude and confirmed the effect of restraining wheels’ movement by applying the method.
- 1 January 2019
- Published by Japan Society of Mechanical Engineers in The Proceedings of JSME annual Conference on Robotics and Mechatronics (Robomec)
- Vol. 2019, 2P1-A15
Attitude control of inverted pendulum type robotic wheelchair with the ability to climb stairs considering dynamic equilibrium
We have been developing an inverted pendulum type robotic wheelchair with the ability to climb stairs. This wheelchair has a seat slider and two rotary links between the front and rear wheels on each side. It is controled by a linear-quadratic regulator consisting of a center of gravity control mode and a rotary link control mode. This paper focuses on a method for restraining movement of wheels when it climbs stairs more quickly because this movement causes fall of the wheelchair. We grasped that the movement was caused by forces acting on pitch angle, such as inertial force and reaction of driving force. We proposed a control method considering dynamic equilibrium of the attitude and confirmed the effect of restraining wheels’ movement by applying the method.