Elwin Hunter-Sellars
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Elwin Hunter-Sellars has a total of 49 co-authors. Here are the top co-authors by number of shared publications:
- Simon H. Pang
Materials Science Division, Lawrence Livermore National Laboratory, 7000 East Avenue, Livermore, California 94550, United States
7 shared publications - Corinne Donahue Scown
Lawrence Berkeley National Lab
3 shared publications - Edna Rodriguez Calzado
Bureau of Economic Geology University of Texas at Austin Austin Texas USA
3 shared publications - Maxwell A. T. Marple
Lawrence Livermore National Laboratory
3 shared publications - Alexander P. Bump2 shared publications
- Anthony J. Varni
Materials Science Division Lawrence Livermore National Laboratory 7000 East Avenue Livermore CA 94550 USA
2 shared publications
Latest Publications
- Open Access
- 30 January 2026
- Published by American Chemical Society (ACS) in Environmental Science & Technology
- Vol. 60 (7) , 5430-5441
The Potential and Cost of Carbon Dioxide Removal Using Direct Air Capture with Land-Based Wind and Utility-Scale Photovoltaics
The rapid deployment of direct air capture and storage (DACS) is critical for achieving emission targets, necessitating precise evaluation of the scale and cost of carbon dioxide removal. This study examines the availability of land, electricity generation, and geologic CO2 storage within the United States, estimating a technical potential for low-temperature, adsorbent-based DACS to remove approximately 9 gigatonnes of CO2 annually. By 2050, a substantial portion of this removal could be achieved at net-removed costs below $300/tonneCO2, though costs are highly variable depending on factors such as facility scale, construction expenses, climate-dependent productivity and heating efficiency, and geologic storage conditions. In the short term, DACS deployment will help identify key research priorities for advancing technology and reducing removal costs. Concurrently, there is an urgent need for scientifically robust and standardized frameworks for monitoring, reporting, and verifying DACS performance across both established and emerging technologies and energy sources.
- 30 January 2026
- Published by American Chemical Society (ACS) in Environmental Science & Technology
- Vol. 60 (7) , 5430-5441
Open AccessThe Potential and Cost of Carbon Dioxide Removal Using Direct Air Capture with Land-Based Wind and Utility-Scale Photovoltaics
The rapid deployment of direct air capture and storage (DACS) is critical for achieving emission targets, necessitating precise evaluation of the scale and cost of carbon dioxide removal. This study examines the availability of land, electricity generation, and geologic CO2 storage within the United States, estimating a technical potential for low-temperature, adsorbent-based DACS to remove approximately 9 gigatonnes of CO2 annually. By 2050, a substantial portion of this removal could be achieved at net-removed costs below $300/tonneCO2, though costs are highly variable depending on factors such as facility scale, construction expenses, climate-dependent productivity and heating efficiency, and geologic storage conditions. In the short term, DACS deployment will help identify key research priorities for advancing technology and reducing removal costs. Concurrently, there is an urgent need for scientifically robust and standardized frameworks for monitoring, reporting, and verifying DACS performance across both established and emerging technologies and energy sources.
- 1 June 2025
- Published by Wiley in Advanced Sustainable Systems
- Vol. 9 (8)
Understanding the Role of Hydroxyl Functionalization in Linear Poly(Ethylenimine) for Oxidation‐Resistant Direct Air Capture of CO 2
Aminopolymer‐based adsorbents are a prominent class of materials being used for direct air capture of CO 2 at the industrial scale. However, improving their working lifetime, specifically by increasing their resilience to oxidative degradation, remains an ongoing challenge. Toward this end, functionalization of aminopolymers with non‐amine functionalities such as hydroxyls has emerged in recent years as a promising strategy toward improving adsorbent lifetime. Although there is a growing body of work demonstrating the effectiveness of this approach and investigating the origin of this improved stability, studies to date have primarily focused on branched aminopolymer systems such as branched poly(ethylenimine). In this work, hydroxyl‐functionalized linear poly(ethylenimine) is used to continue to probe the underlying protective mechanism of this strategy. A combination of thermogravimetric analysis, NMR relaxometry, differential scanning calorimetry, and computational simulations is used to better understand the relationship between the extent of chemical functionalization, physical properties, and adsorbent performance.
- 1 June 2025
- Published by Wiley in Advanced Sustainable Systems
- Vol. 9 (8)
Understanding the Role of Hydroxyl Functionalization in Linear Poly(Ethylenimine) for Oxidation‐Resistant Direct Air Capture of CO 2
Aminopolymer‐based adsorbents are a prominent class of materials being used for direct air capture of CO 2 at the industrial scale. However, improving their working lifetime, specifically by increasing their resilience to oxidative degradation, remains an ongoing challenge. Toward this end, functionalization of aminopolymers with non‐amine functionalities such as hydroxyls has emerged in recent years as a promising strategy toward improving adsorbent lifetime. Although there is a growing body of work demonstrating the effectiveness of this approach and investigating the origin of this improved stability, studies to date have primarily focused on branched aminopolymer systems such as branched poly(ethylenimine). In this work, hydroxyl‐functionalized linear poly(ethylenimine) is used to continue to probe the underlying protective mechanism of this strategy. A combination of thermogravimetric analysis, NMR relaxometry, differential scanning calorimetry, and computational simulations is used to better understand the relationship between the extent of chemical functionalization, physical properties, and adsorbent performance.
- 27 January 2025
- Published by American Chemical Society (ACS) in The Journal of Physical Chemistry C
- Vol. 129 (5) , 2701-2712
Detecting Reactive Products in Carbon Capture Polymers with Chemical Shift Anisotropy and Machine Learning
- 27 January 2025
- Published by American Chemical Society (ACS) in The Journal of Physical Chemistry C
- Vol. 129 (5) , 2701-2712
Detecting Reactive Products in Carbon Capture Polymers with Chemical Shift Anisotropy and Machine Learning
- Open Access
- 4 December 2024
- Published by CarbonPlan
The potential and cost of carbon dioxide removal using direct air capture with land-based wind and utility-scale photovoltaics
Rapid deployment of direct air capture and storage (DACS) is essential for meeting net-zero emission targets and requires accurate assessment of both the scale and cost of carbon dioxide removal. This analysis, focused on land, renewable electricity, and geologic CO2 storage availability within the United States, estimates a technical potential capacity for low-temperature, adsorbent DACS of approximately 9 gigatonnes of CO2 per year. Much of this removal could be accomplished at costs between $200–250 per tonne of CO2, depending on the scale and location of the facility, and the associated storage costs. High-potential regions were identified in West Texas, the Rocky Mountains, and Alaska, among others. In the near term, DACS deployment will identify critical research areas for technology improvement to reduce the cost of carbon removal; simultaneously, there is a need for scientifically guided and rigorous standards for DACS monitoring, reporting, and verification across existing and emerging DACS technologies and energy sources.
- 4 December 2024
- Published by CarbonPlan
Open AccessThe potential and cost of carbon dioxide removal using direct air capture with land-based wind and utility-scale photovoltaics
Rapid deployment of direct air capture and storage (DACS) is essential for meeting net-zero emission targets and requires accurate assessment of both the scale and cost of carbon dioxide removal. This analysis, focused on land, renewable electricity, and geologic CO2 storage availability within the United States, estimates a technical potential capacity for low-temperature, adsorbent DACS of approximately 9 gigatonnes of CO2 per year. Much of this removal could be accomplished at costs between $200–250 per tonne of CO2, depending on the scale and location of the facility, and the associated storage costs. High-potential regions were identified in West Texas, the Rocky Mountains, and Alaska, among others. In the near term, DACS deployment will identify critical research areas for technology improvement to reduce the cost of carbon removal; simultaneously, there is a need for scientifically guided and rigorous standards for DACS monitoring, reporting, and verification across existing and emerging DACS technologies and energy sources.
- Open Access
- 4 December 2024
- Published by CarbonPlan
The potential and cost of carbon dioxide removal using direct air capture with land-based wind and utility-scale photovoltaics
Rapid deployment of direct air capture and storage (DACS) is essential for meeting net-zero emission targets and requires accurate assessment of both the scale and cost of carbon dioxide removal. This analysis, focused on land, renewable electricity, and geologic CO2 storage availability within the United States, estimates a technical potential capacity for low-temperature, adsorbent DACS of approximately 9 gigatonnes of CO2 per year. Much of this removal could be accomplished at costs between $200–250 per tonne of CO2, depending on the scale and location of the facility, and the associated storage costs. High-potential regions were identified in West Texas, the Rocky Mountains, and Alaska, among others. In the near term, DACS deployment will identify critical research areas for technology improvement to reduce the cost of carbon removal; simultaneously, there is a need for scientifically guided and rigorous standards for DACS monitoring, reporting, and verification across existing and emerging DACS technologies and energy sources.
- 4 December 2024
- Published by CarbonPlan
Open AccessThe potential and cost of carbon dioxide removal using direct air capture with land-based wind and utility-scale photovoltaics
Rapid deployment of direct air capture and storage (DACS) is essential for meeting net-zero emission targets and requires accurate assessment of both the scale and cost of carbon dioxide removal. This analysis, focused on land, renewable electricity, and geologic CO2 storage availability within the United States, estimates a technical potential capacity for low-temperature, adsorbent DACS of approximately 9 gigatonnes of CO2 per year. Much of this removal could be accomplished at costs between $200–250 per tonne of CO2, depending on the scale and location of the facility, and the associated storage costs. High-potential regions were identified in West Texas, the Rocky Mountains, and Alaska, among others. In the near term, DACS deployment will identify critical research areas for technology improvement to reduce the cost of carbon removal; simultaneously, there is a need for scientifically guided and rigorous standards for DACS monitoring, reporting, and verification across existing and emerging DACS technologies and energy sources.
- Open Access
- 4 December 2024
- Published by CarbonPlan
The potential and cost of carbon dioxide removal using direct air capture with land-based wind and utility-scale photovoltaics
- 4 December 2024
- Published by CarbonPlan
Open AccessThe potential and cost of carbon dioxide removal using direct air capture with land-based wind and utility-scale photovoltaics
- 6 May 2024
- Published by Wiley in Macromolecular Chemistry and Physics
- Vol. 225 (14)
Oxidation of Supported Amines for CO2 Direct Air Capture: Assessing Impact on Physical Properties and Mobility via NMR Relaxometry
Aminopolymer‐based adsorbents are commonly investigated for CO2 direct air capture (DAC). In the presence of high temperature and oxygen, which can occur during adsorption‐regeneration cycles, oxidative degradation can significantly reduce adsorbent lifetime. Degradation is typically measured using adsorption performance metrics or chemical characterization. This work demonstrates that the polymer's physical properties, as measured via nuclear magnetic resonance (NMR) relaxometry and differential scanning calorimetry, can be used to quantitatively track degradation. The extent of oxidation of an alumina‐poly(ethylenimine) sample, measured by reductions in amine efficiency (A.E.), is correlated with proton T2 relaxation times. This work hypothesizes that T2 relaxation accurately tracks oxidative degradation in aminopolymers due to the reduction in polymer mobility occurring during the oxidation process. The ability to use NMR relaxometry as a noninvasive technique to probe degradation is demonstrated on a 1‐inch square‐channel monolith adsorbent exposed to actual DAC service conditions. This highlights the potential for relaxometry to evaluate the state of the adsorbent accurately and rapidly compared to typical analytical methods.
- 6 May 2024
- Published by Wiley in Macromolecular Chemistry and Physics
- Vol. 225 (14)
Oxidation of Supported Amines for CO2 Direct Air Capture: Assessing Impact on Physical Properties and Mobility via NMR Relaxometry
Aminopolymer‐based adsorbents are commonly investigated for CO2 direct air capture (DAC). In the presence of high temperature and oxygen, which can occur during adsorption‐regeneration cycles, oxidative degradation can significantly reduce adsorbent lifetime. Degradation is typically measured using adsorption performance metrics or chemical characterization. This work demonstrates that the polymer's physical properties, as measured via nuclear magnetic resonance (NMR) relaxometry and differential scanning calorimetry, can be used to quantitatively track degradation. The extent of oxidation of an alumina‐poly(ethylenimine) sample, measured by reductions in amine efficiency (A.E.), is correlated with proton T2 relaxation times. This work hypothesizes that T2 relaxation accurately tracks oxidative degradation in aminopolymers due to the reduction in polymer mobility occurring during the oxidation process. The ability to use NMR relaxometry as a noninvasive technique to probe degradation is demonstrated on a 1‐inch square‐channel monolith adsorbent exposed to actual DAC service conditions. This highlights the potential for relaxometry to evaluate the state of the adsorbent accurately and rapidly compared to typical analytical methods.
- Open Access
- 17 May 2022
- Published by Elsevier in Chemical Engineering Science
- Vol. 258
Considerations when determining Counter-diffusion constants in liquid phase catalytic reactions using the Zero Length column (ZLC) method
- 17 May 2022
- Published by Elsevier in Chemical Engineering Science
- Vol. 258
Open AccessConsiderations when determining Counter-diffusion constants in liquid phase catalytic reactions using the Zero Length column (ZLC) method
- 1 February 2022
- Published by Elsevier in Chemical Engineering Journal
- Vol. 429
Fabrication of MIL-101-polydimethylsiloxane composites for environmental toluene abatement from humid air
- 1 February 2022
- Published by Elsevier in Chemical Engineering Journal
- Vol. 429
Fabrication of MIL-101-polydimethylsiloxane composites for environmental toluene abatement from humid air
- Open Access
- 10 November 2020
- Published by Royal Society of Chemistry (RSC) in Soft Matter
- Vol. 17 (4) , 947-954
Temperature-induced liquid crystal microdroplet formation in a partially miscible liquid mixture
We demonstrate how, for a binary blend of a thermotropic liquid crystal and methanol, cooling from a miscible to an immiscible state induces the reversible formation of microdroplets, whose size, number and mesogen orientation can be controlled by the temperature protocol.
- 10 November 2020
- Published by Royal Society of Chemistry (RSC) in Soft Matter
- Vol. 17 (4) , 947-954
Open AccessTemperature-induced liquid crystal microdroplet formation in a partially miscible liquid mixture
We demonstrate how, for a binary blend of a thermotropic liquid crystal and methanol, cooling from a miscible to an immiscible state induces the reversible formation of microdroplets, whose size, number and mesogen orientation can be controlled by the temperature protocol.