Xue Min
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Xue Min has a total of 21 co-authors. Here are the top co-authors by number of shared publications:
- Jun Xiong
College of Chemistry and Chemical Engineering Wuhan Textile University Wuhan China
2 shared publications Ming Li
School of Chemistry and Chemical Engineering, Hubei Key Laboratory of Biomass Fibers and Eco-Dyeing & Finishing, Wuhan Textile University, Wuhan 430200, China
2 shared publications- Bo Wu1 shared publication
Di Tian
School of Chemistry and Chemical Engineering, Hubei Key Laboratory of Biomass Fibers and Eco-Dyeing & Finishing, Wuhan Textile University, Wuhan 430200, China
1 shared publication- Fan Yang1 shared publication
Hong-Rui Tian
State Key Laboratory of Rare Earth Resource Utilization, Changchun Institute of Applied Chemistry, Chinese Academy of Sciences, Changchun, China
1 shared publication
Latest Publications
- 6 October 2022
- Published by Royal Society of Chemistry (RSC) in CrystEngComm
- Vol. 24 (44) , 7845-7851
Metal phosphonates as heterogeneous catalysts for highly efficient chemical fixation of CO2 under mild conditions
Two new compounds with novel structures were prepared, one of which displays excellent catalytic activity to transform CO2 gas to cyclic carbonates under mild conditions and free of solvent.
- 6 October 2022
- Published by Royal Society of Chemistry (RSC) in CrystEngComm
- Vol. 24 (44) , 7845-7851
Metal phosphonates as heterogeneous catalysts for highly efficient chemical fixation of CO2 under mild conditions
Two new compounds with novel structures were prepared, one of which displays excellent catalytic activity to transform CO2 gas to cyclic carbonates under mild conditions and free of solvent.
- Open Access
- 16 March 2022
- Published by MDPI AG in Preprints.org
Polymer-Coated Daikon-Based Sunlight Absorbers for Highly Efficient Interface Solar Steam Generation
Interface solar steam generation (ISSG) are charming for its applications in desalination and wastewater treatment. Biomass is an attractive substrate for utilizing solar vapor evaporators because of its natural pore structure and water transportability. Polymers like polydopamine (PDA) and polypyrrole (PPy) with broadband spectrum absorption are fascinating in photothermal materials (PTMs). Herein, PDA coated daikon-based (PDA-DK) and PPy coated daikon-based (PPy-DK) PTMs have been exploited for solar steam generation. When polyethylene foam (PEF) was used as an insulating layer to limit heat loss from the PTMs to bulk water, the evaporation rate of PDA-DK and PPy-DK was raised from 0.82 kg m–2 h–1 and 0.96 kg m–2 h–1 to 1.50 kg m–2 h–1 and 1.60 kg m–2 h–1, respectively. Meanwhile, the corresponding photothermal conversion efficiency was increased to 89.01% and 98.97%, which was increased by nearly 40% under 1-sun irradiation. In addition, PDA-DK and PPy-DK exhibited remarkable stability for the solar steam generation without significant change through 15 cycles. Furthermore, PDA-DK and PPy-DK could effectively desalt seawater and purify dyeing wastewater. All the results indicate that PDA-DK and PPy-DK have great potential in real-world applications for solar steam generation.
- 16 March 2022
- Published by MDPI AG in Preprints.org
Open AccessPolymer-Coated Daikon-Based Sunlight Absorbers for Highly Efficient Interface Solar Steam Generation
Interface solar steam generation (ISSG) are charming for its applications in desalination and wastewater treatment. Biomass is an attractive substrate for utilizing solar vapor evaporators because of its natural pore structure and water transportability. Polymers like polydopamine (PDA) and polypyrrole (PPy) with broadband spectrum absorption are fascinating in photothermal materials (PTMs). Herein, PDA coated daikon-based (PDA-DK) and PPy coated daikon-based (PPy-DK) PTMs have been exploited for solar steam generation. When polyethylene foam (PEF) was used as an insulating layer to limit heat loss from the PTMs to bulk water, the evaporation rate of PDA-DK and PPy-DK was raised from 0.82 kg m–2 h–1 and 0.96 kg m–2 h–1 to 1.50 kg m–2 h–1 and 1.60 kg m–2 h–1, respectively. Meanwhile, the corresponding photothermal conversion efficiency was increased to 89.01% and 98.97%, which was increased by nearly 40% under 1-sun irradiation. In addition, PDA-DK and PPy-DK exhibited remarkable stability for the solar steam generation without significant change through 15 cycles. Furthermore, PDA-DK and PPy-DK could effectively desalt seawater and purify dyeing wastewater. All the results indicate that PDA-DK and PPy-DK have great potential in real-world applications for solar steam generation.
- 9 December 2020
- Published by Royal Society of Chemistry (RSC) in CrystEngComm
- Vol. 23 (4) , 876-883
Fabrication of new structures from a 3D cobalt phosphonate network: structural transformation and proton conductivity investigation
Three cobalt-phosphonate networks with unique constructions, namely, [[Co2(2,2′-bipy)2(H4L)(H2O)6]·6H2O] (1), [Co2(2,2′-bipy)2(H4L)(H2O)3] (2) and [Co2(2,2′-bipy)2(H4L)(H2O)2]·H2O (3), were successfully prepared from a 3D cobalt phosphonate network (Co318) utilizing a tetrahedral tetraphosphonic acid ligand. Compound 1 with a zero-dimensional structure was obtained by humidity stimulation of Co318 at room temperature. Furthermore, doubling the amount of 2,2-bipyridine in the reaction system of Co318 leads to a pink compound (2) and a purple compound (3). The structures of these three compounds were confirmed by single-crystal X-ray diffraction and characterized by PXRD, TGA, and IR spectroscopy. The structural transformations of these four compounds were investigated. The proton conductivities of compound 1, 2 and 3 were measured and the results proved that compound 1 displays a higher proton conductivity ability than the other two compounds.
- 9 December 2020
- Published by Royal Society of Chemistry (RSC) in CrystEngComm
- Vol. 23 (4) , 876-883
Fabrication of new structures from a 3D cobalt phosphonate network: structural transformation and proton conductivity investigation
Three cobalt-phosphonate networks with unique constructions, namely, [[Co2(2,2′-bipy)2(H4L)(H2O)6]·6H2O] (1), [Co2(2,2′-bipy)2(H4L)(H2O)3] (2) and [Co2(2,2′-bipy)2(H4L)(H2O)2]·H2O (3), were successfully prepared from a 3D cobalt phosphonate network (Co318) utilizing a tetrahedral tetraphosphonic acid ligand. Compound 1 with a zero-dimensional structure was obtained by humidity stimulation of Co318 at room temperature. Furthermore, doubling the amount of 2,2-bipyridine in the reaction system of Co318 leads to a pink compound (2) and a purple compound (3). The structures of these three compounds were confirmed by single-crystal X-ray diffraction and characterized by PXRD, TGA, and IR spectroscopy. The structural transformations of these four compounds were investigated. The proton conductivities of compound 1, 2 and 3 were measured and the results proved that compound 1 displays a higher proton conductivity ability than the other two compounds.
- 5 June 2019
- Published by Royal Society of Chemistry (RSC) in Dalton Transactions
- Vol. 49 (12) , 3700-3705
A fast and highly selective Congo red adsorption material based on a cadmium-phosphonate network
In this work, a cadmium-phosphonate network was prepared based on a tetrahedral shaped tetraphosphonic acid linker. The resulting three-dimensional compound Cd4(H4L)2(phen)2(H2O)4 (1) exhibited a rapid and efficient adsorption of Congo red (CR) dye, the adsorption capacity of which reached 684 mg g−1. Furthermore, this adsorbent showed excellent structural stability and adsorptive recyclability after three times of adsorption and desorption. The absorption kinetics fitted well with the pseudo-second-order kinetic model, revealing that the adsorption of the cadmium-phosphonate compound undergoes a chemical process, where hydrogen bonding between the amide groups (from CR) and the uncoordinated phosphonate oxygen atoms of the compound plays a pivotal role.
- 5 June 2019
- Published by Royal Society of Chemistry (RSC) in Dalton Transactions
- Vol. 49 (12) , 3700-3705
A fast and highly selective Congo red adsorption material based on a cadmium-phosphonate network
In this work, a cadmium-phosphonate network was prepared based on a tetrahedral shaped tetraphosphonic acid linker. The resulting three-dimensional compound Cd4(H4L)2(phen)2(H2O)4 (1) exhibited a rapid and efficient adsorption of Congo red (CR) dye, the adsorption capacity of which reached 684 mg g−1. Furthermore, this adsorbent showed excellent structural stability and adsorptive recyclability after three times of adsorption and desorption. The absorption kinetics fitted well with the pseudo-second-order kinetic model, revealing that the adsorption of the cadmium-phosphonate compound undergoes a chemical process, where hydrogen bonding between the amide groups (from CR) and the uncoordinated phosphonate oxygen atoms of the compound plays a pivotal role.