Huan Liu
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Huan Liu has a total of 13 co-authors. Here are the top co-authors by number of shared publications:
Weitao Pan
State Key Laboratory of Integrated Services Networks, Xidian University, Xian, China
3 shared publicationsYa Gao
3 shared publicationsZhiliang Qiu
State Key Laboratory of Integrated Services Networks, Xidian University, Xian, China
3 shared publicationsJun Li
National Key Laboratory of Science and Technology on Space Microwave, Xi’an Institute of Space Radio Technology, Xi’an 710100, China
2 shared publicationsLing Zheng
School of Communication and Information Engineering, Xi’an University of Posts and Telecommunications, Xi’an 710121, China
2 shared publications- Ling Zheng
State Key Laboratory of Integrated Service Networks Xidian University 710071 Xi'an China
2 shared publications
Latest Publications
- 16 June 2023
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 414-419
Optimization of FPGA Resource Based on Modular and Serial Programming Method
To improve imaging quality of satellite camera in orbit, the blackbody temperature control system with the FPGA as the core is used. However, the system tends to take up plenty of the limited logic resources of the FPGA chip since it adopts a complex algorithm to control many blackbodies. To cope with such as problem, the paper adopts two approaches to optimize the utilization of logic resources. One is the software modular programming method that adopts a top-down approach to plan out the overall architecture of the software, which can increase code reuse and readability, thereby saving a lot of logic resources. While, the other one is the serial programming method that achieves the temperature control of multiple blackbodies by using only one logic cell of the FPGA chip, greatly increasing the utilization of logic resources. Through comparative study, the paper provides methods to optimize the utilization of FPGA resources and serve as a reference for other similar control systems.
- 16 June 2023
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 414-419
Optimization of FPGA Resource Based on Modular and Serial Programming Method
To improve imaging quality of satellite camera in orbit, the blackbody temperature control system with the FPGA as the core is used. However, the system tends to take up plenty of the limited logic resources of the FPGA chip since it adopts a complex algorithm to control many blackbodies. To cope with such as problem, the paper adopts two approaches to optimize the utilization of logic resources. One is the software modular programming method that adopts a top-down approach to plan out the overall architecture of the software, which can increase code reuse and readability, thereby saving a lot of logic resources. While, the other one is the serial programming method that achieves the temperature control of multiple blackbodies by using only one logic cell of the FPGA chip, greatly increasing the utilization of logic resources. Through comparative study, the paper provides methods to optimize the utilization of FPGA resources and serve as a reference for other similar control systems.
- Open Access
- 30 May 2022
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Access
- Vol. 10, 57665-57673
A Universal, Low-Delay, SEC-DEC-TAEC Code for State Register Protection
Finite State Machine (FSM) is widely used in electronic systems and its reliability is critical to the system. Ionizing radiation induced soft error is one of the major concerns in the design of electronic systems, especially in avionics or space applications. Nowadays, the majority of electronic systems relies on single-error correction, double-error detection (SEC-DED) codes to mitigate soft errors. However, the presence of multiple bit upsets is becoming more prevalent as CMOS technology scales down. In addition, state registers in FSMs usually have variable bit-widths and have strict requirement on encoding and decoding delay, which poses challenges for error mitigation techniques. This paper presents an Error Detection and Correction (EDAC) code for state register protection, which can achieve single-error correction, double-error correction and triple-adjacent-error correction (SEC-DEC-TAEC) ability. The proposed code can be used to protect data with 4n bit-width (n = 2,3,4,...) using one common encoder and decoder code block and introduces minimal delay. Experiment results show that the proposed code has better error correction ability than most existing MCU correction codes. Besides, it reduces area occupation by 30% and delay by 15% compared with Orthogonal Latin Square (OLS) code in the case of 8 bit-width data.
- 30 May 2022
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Access
- Vol. 10, 57665-57673
Open AccessA Universal, Low-Delay, SEC-DEC-TAEC Code for State Register Protection
Finite State Machine (FSM) is widely used in electronic systems and its reliability is critical to the system. Ionizing radiation induced soft error is one of the major concerns in the design of electronic systems, especially in avionics or space applications. Nowadays, the majority of electronic systems relies on single-error correction, double-error detection (SEC-DED) codes to mitigate soft errors. However, the presence of multiple bit upsets is becoming more prevalent as CMOS technology scales down. In addition, state registers in FSMs usually have variable bit-widths and have strict requirement on encoding and decoding delay, which poses challenges for error mitigation techniques. This paper presents an Error Detection and Correction (EDAC) code for state register protection, which can achieve single-error correction, double-error correction and triple-adjacent-error correction (SEC-DEC-TAEC) ability. The proposed code can be used to protect data with 4n bit-width (n = 2,3,4,...) using one common encoder and decoder code block and introduces minimal delay. Experiment results show that the proposed code has better error correction ability than most existing MCU correction codes. Besides, it reduces area occupation by 30% and delay by 15% compared with Orthogonal Latin Square (OLS) code in the case of 8 bit-width data.
- 1 October 2021
- Published by Elsevier in Computer Networks
- Vol. 198
Architecture design and performance analysis of a novel memory system for high-bandwidth onboard switching fabric
- 1 October 2021
- Published by Elsevier in Computer Networks
- Vol. 198
Architecture design and performance analysis of a novel memory system for high-bandwidth onboard switching fabric
- 13 July 2020
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Circuits and Systems II: Express Briefs
- Vol. 68 (1) , 211-215
Low-Cost and Programmable CRC Implementation Based on FPGA
Cyclic redundancy check (CRC) is a well-known error detection code that is widely used in Ethernet, PCIe, and other transmission protocols. The existing FPGA-based implementation solutions encounter the problem of excessive resource utilization in high-performance scenarios. The padding zeros problem and the introduction of programmability further exacerbate this problem. In this brief, the stride-by-5 algorithm is proposed to achieve the optimal utilization of FPGA resources. The pipelining go back algorithm is proposed to solve the padding zeros problem. The method of reprogramming by HWICAP is proposed to realize programmability with small and constant resource utilization. The experimental results show that the resource utilization of the proposed non-segmented architecture is 80.7%-87.5% and 25.1%-46.2% lower than that of two state-of-the-art FPGA-based CRC implementations, and the proposed segmented architecture has lower resource utilization, by 81.7%-85.9% and 2.9%-20.8%, than two state-of-the-art architectures. Furthermore, throughput and programmability are guaranteed. The source code has been made available on GitHub 1.
- 13 July 2020
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Circuits and Systems II: Express Briefs
- Vol. 68 (1) , 211-215
Low-Cost and Programmable CRC Implementation Based on FPGA
Cyclic redundancy check (CRC) is a well-known error detection code that is widely used in Ethernet, PCIe, and other transmission protocols. The existing FPGA-based implementation solutions encounter the problem of excessive resource utilization in high-performance scenarios. The padding zeros problem and the introduction of programmability further exacerbate this problem. In this brief, the stride-by-5 algorithm is proposed to achieve the optimal utilization of FPGA resources. The pipelining go back algorithm is proposed to solve the padding zeros problem. The method of reprogramming by HWICAP is proposed to realize programmability with small and constant resource utilization. The experimental results show that the resource utilization of the proposed non-segmented architecture is 80.7%-87.5% and 25.1%-46.2% lower than that of two state-of-the-art FPGA-based CRC implementations, and the proposed segmented architecture has lower resource utilization, by 81.7%-85.9% and 2.9%-20.8%, than two state-of-the-art architectures. Furthermore, throughput and programmability are guaranteed. The source code has been made available on GitHub 1.
- Open Access
- 21 June 2020
- Published by Institute of Electrical and Electronics Engineers (IEEE) in TechRxiv
Low-Cost and Programmable CRC Implementation based on FPGA (Extended Version)
Cyclic redundancy check (CRC) is a well-known error detection code that is widely used in Ethernet, PCIe, and other transmission protocols. The existing FPGA-based implementation solutions are faced with the problem of excessive resource utilization in high-performance scenarios. The padding zeros problem and the introduction of programmability further exacerbate this problem. In this brief, the stride-by-5 algorithm is proposed to achieve the optimal utilization of FPGA resources. The pipelining go back algorithm is proposed to solve the padding zeros problem. The method of reprogramming by HWICAP is proposed to realize programmability with a small and constant resource utilization. The experimental results show that the resource utilization of proposed non-segmented architecture is 80.7%-87.5% and 25.1%-46.2% lower than those of two state-of-the-art FPGA-based CRC implementations, and the proposed segmented architecture has a lower resource utilization by 81.7%-85.9% and 2.9%-20.8% compared wtih the two state-of-the-art architectures; meanwhile, the throughput and programmability are guaranteed. We made the source code available on GitHub.
- 21 June 2020
- Published by Institute of Electrical and Electronics Engineers (IEEE) in TechRxiv
Open AccessLow-Cost and Programmable CRC Implementation based on FPGA (Extended Version)
Cyclic redundancy check (CRC) is a well-known error detection code that is widely used in Ethernet, PCIe, and other transmission protocols. The existing FPGA-based implementation solutions are faced with the problem of excessive resource utilization in high-performance scenarios. The padding zeros problem and the introduction of programmability further exacerbate this problem. In this brief, the stride-by-5 algorithm is proposed to achieve the optimal utilization of FPGA resources. The pipelining go back algorithm is proposed to solve the padding zeros problem. The method of reprogramming by HWICAP is proposed to realize programmability with a small and constant resource utilization. The experimental results show that the resource utilization of proposed non-segmented architecture is 80.7%-87.5% and 25.1%-46.2% lower than those of two state-of-the-art FPGA-based CRC implementations, and the proposed segmented architecture has a lower resource utilization by 81.7%-85.9% and 2.9%-20.8% compared wtih the two state-of-the-art architectures; meanwhile, the throughput and programmability are guaranteed. We made the source code available on GitHub.