Ngan Nguyen
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Ngan Nguyen has a total of 9 co-authors. Here are the top co-authors by number of shared publications:
- Chulhun Seo
Department of Information and Communication Convergence, Soongsil University, Seoul, South Korea
4 shared publications - Nam Ha-Van
School of Electrical Engineering, Aalto University, Espoo, Finland
3 shared publications - Minh Thuy Le
School of Electrical and Electronic Engineering, Hanoi University of Science and Technology, Hanoi, Vietnam
2 shared publications - David Gonzalez-Ovejero
Univ. Rennes, CNRS, Institut dlectronique et des Technologies du numRique (IETR), UMR 6164, Rennes, France
1 shared publication - Giang Le
Department of Information and Communication Convergence, Soongsil University, Seoul, South Korea
1 shared publication - Hong Son Vu
Department of Electrical Engineering, University of North Texas, Denton, TX, USA
1 shared publication
Latest Publications
- 17 September 2024
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Antennas and Propagation
- Vol. 72 (11) , 8858-8863
Low-Profile and Broadband Dual-Linearly Polarized Offset Dual-Reflector Antenna for W-Band Applications
A low-profile, broadband, dual-linearly polarized offset dual-reflector antenna is presented for high-gain operation at W-band (75–110 GHz). The dual-linear polarization is achieved by exciting two orthogonal modes in an overmoded parallel-plate waveguide (PPW), namely, the quasi-transverse electromagnetic (TEM) mode and the quasi-TE1 mode. The offset dual-reflector system is illuminated by a dual-mode corrugated feed horn in the PPW. Since the reflector system only collimates the beam in one plane, an exponentially flared section is integrated at the end of its radiating aperture to collimate the beam in the orthogonal plane. The antenna is built in aluminum and fabricated as a split block using computer numerical control (CNC) milling. Experimental results show an input reflection coefficient better than −10 dB over a fractional bandwidth exceeding 38% for the two modes of operation. A good agreement is observed between simulated and measured far-field patterns for both operating modes, thus validating the antenna concept. The measured gain remains stable over the entire W-band with a maximum value of 28.8 and 28.5 dBi for the quasi-TEM mode and the quasi-TE1 mode, respectively.
- 17 September 2024
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Antennas and Propagation
- Vol. 72 (11) , 8858-8863
Low-Profile and Broadband Dual-Linearly Polarized Offset Dual-Reflector Antenna for W-Band Applications
A low-profile, broadband, dual-linearly polarized offset dual-reflector antenna is presented for high-gain operation at W-band (75–110 GHz). The dual-linear polarization is achieved by exciting two orthogonal modes in an overmoded parallel-plate waveguide (PPW), namely, the quasi-transverse electromagnetic (TEM) mode and the quasi-TE1 mode. The offset dual-reflector system is illuminated by a dual-mode corrugated feed horn in the PPW. Since the reflector system only collimates the beam in one plane, an exponentially flared section is integrated at the end of its radiating aperture to collimate the beam in the orthogonal plane. The antenna is built in aluminum and fabricated as a split block using computer numerical control (CNC) milling. Experimental results show an input reflection coefficient better than −10 dB over a fractional bandwidth exceeding 38% for the two modes of operation. A good agreement is observed between simulated and measured far-field patterns for both operating modes, thus validating the antenna concept. The measured gain remains stable over the entire W-band with a maximum value of 28.8 and 28.5 dBi for the quasi-TEM mode and the quasi-TE1 mode, respectively.
- 4 May 2021
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Microwave and Wireless Components Letters
- Vol. 31 (7) , 913-916
A Broadband High-Efficiency Rectifier for Mid-Field Wireless Power Transfer
In this letter, a compact broadband high-efficiency microwave rectifier is presented for powering implantable medical devices located deeply in the human body. By utilizing a modified real frequency technique and an RF step-up transformer at the input matching network, the proposed rectifier has a measured conversion efficiency ( η) exceeding 50% over a 62% fractional bandwidth from 900 to 1700 MHz at 0-dBm input power level. For measured η above 50%, the widest dynamic input power range achieved is from -7 to 14.2 dBm at 1.5 GHz, and the circuit sensitivity reaches up to -20 dBm with at least 8% conversion efficiency. The circuit has a compact size of 16×11 mm 2 , being suitable for biomedical implant applications.
- 4 May 2021
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Microwave and Wireless Components Letters
- Vol. 31 (7) , 913-916
A Broadband High-Efficiency Rectifier for Mid-Field Wireless Power Transfer
In this letter, a compact broadband high-efficiency microwave rectifier is presented for powering implantable medical devices located deeply in the human body. By utilizing a modified real frequency technique and an RF step-up transformer at the input matching network, the proposed rectifier has a measured conversion efficiency ( η) exceeding 50% over a 62% fractional bandwidth from 900 to 1700 MHz at 0-dBm input power level. For measured η above 50%, the widest dynamic input power range achieved is from -7 to 14.2 dBm at 1.5 GHz, and the circuit sensitivity reaches up to -20 dBm with at least 8% conversion efficiency. The circuit has a compact size of 16×11 mm 2 , being suitable for biomedical implant applications.
- 15 November 2020
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 30-33
A Novel Optimal Transmitting Source for Midfield Wireless Powering of Micro-implant
Midfield wireless power transfer has been proven as a solution for biomedical micro-implant that can operate at nearly any location in the body. Some previous experiments using an external patterned structure as optimal source demonstrated magnetic and current density focusing characteristic on multilayers tissue, therefore, significantly enhancing efficiency for wireless powering to miniature receivers than conventional inductively coupled coils. This paper proposed a novel compact and simple source transmitter while conserving convergence effect on human tissue.
- 15 November 2020
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 30-33
A Novel Optimal Transmitting Source for Midfield Wireless Powering of Micro-implant
Midfield wireless power transfer has been proven as a solution for biomedical micro-implant that can operate at nearly any location in the body. Some previous experiments using an external patterned structure as optimal source demonstrated magnetic and current density focusing characteristic on multilayers tissue, therefore, significantly enhancing efficiency for wireless powering to miniature receivers than conventional inductively coupled coils. This paper proposed a novel compact and simple source transmitter while conserving convergence effect on human tissue.
- 22 October 2020
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Microwave and Wireless Components Letters
- Vol. 30 (12) , 1189-1192
Multiband Ambient RF Energy Harvesting for Autonomous IoT Devices
This letter presents a novel multiband rectenna for the ambient wireless energy harvesting of an autonomous internet of thing (IoT) sensor. A bow-tie antenna with slits is proposed to obtain four frequency bands at 840 MHz, 1.86, 2.1, and 2.45 GHz, respectively. Furthermore, a multiband rectifying circuit combined of four single ring-loop rectifiers is designed with high conversion efficiency. Finally, a power management circuit with storing and converting the harvested voltage is proposed for smoothing dc output voltage. The energy harvester can be used in practical wireless sensor applications.
- 22 October 2020
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Microwave and Wireless Components Letters
- Vol. 30 (12) , 1189-1192
Multiband Ambient RF Energy Harvesting for Autonomous IoT Devices
This letter presents a novel multiband rectenna for the ambient wireless energy harvesting of an autonomous internet of thing (IoT) sensor. A bow-tie antenna with slits is proposed to obtain four frequency bands at 840 MHz, 1.86, 2.1, and 2.45 GHz, respectively. Furthermore, a multiband rectifying circuit combined of four single ring-loop rectifiers is designed with high conversion efficiency. Finally, a power management circuit with storing and converting the harvested voltage is proposed for smoothing dc output voltage. The energy harvester can be used in practical wireless sensor applications.
- 9 October 2020
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Antennas and Wireless Propagation Letters
- Vol. 19 (12) , 2270-2274
Midfield Wireless Power Transfer for Deep-Tissue Biomedical Implants
Midfield wireless power transfer has proved its advantages in power delivery to miniature implantable medical devices located deeply in the human body, however, the delivered power level is still low. Besides, design proposals for a compact source structure concentrating the transmitter field on a miniature implant remain challenges. This letter presents a novel compact transmitting structure (TX) at the midfield band and shows the capability of focusing the magnetic field inside the human tissue. Source performance has been verified by implantable PIFA antenna with a total size of 9x13 mm2 (RX) that positioned in the heart tissue layer at a 55 mm separated distance of TX and RX. In addition, the power transfer efficiency has been demonstrated by measurement setup using pork muscle, which obtained a good match of the transmission coefficient between the simulation and experiment results. Consequently, for 1W of output power from the midfield transmitter, the received energy could be achieved more than 5.6 mW via the implantable antenna at subwavelength distance.
- 9 October 2020
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Antennas and Wireless Propagation Letters
- Vol. 19 (12) , 2270-2274
Midfield Wireless Power Transfer for Deep-Tissue Biomedical Implants
Midfield wireless power transfer has proved its advantages in power delivery to miniature implantable medical devices located deeply in the human body, however, the delivered power level is still low. Besides, design proposals for a compact source structure concentrating the transmitter field on a miniature implant remain challenges. This letter presents a novel compact transmitting structure (TX) at the midfield band and shows the capability of focusing the magnetic field inside the human tissue. Source performance has been verified by implantable PIFA antenna with a total size of 9x13 mm2 (RX) that positioned in the heart tissue layer at a 55 mm separated distance of TX and RX. In addition, the power transfer efficiency has been demonstrated by measurement setup using pork muscle, which obtained a good match of the transmission coefficient between the simulation and experiment results. Consequently, for 1W of output power from the midfield transmitter, the received energy could be achieved more than 5.6 mW via the implantable antenna at subwavelength distance.