Avijit Dalal
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Research Interests
Avijit Dalal has a total of 41 co-authors. Here are the top co-authors by number of shared publications:
- Aniruddha Mondal
Division of Materials Science, Department of Engineering Sciences and Mathematics, Luleå University of Technology, Luleå, Sweden
8 shared publications Aniruddha Mondal
3 shared publications- Rajat Mahapatra
National Institute of Technology Durgapur
3 shared publications - Shyam Murli Manohar Dhar Dwivedi
National Institute of Technology Durgapur
3 shared publications Ankita Choudhury
Department of Physics, National Institute of Technology Durgapur 1 , Durgapur 713209, India
2 shared publications- Anupam Ghosh
Functional and Renewable Energy Materials Laboratory Department of Physics Indian Institute of Technology Ropar Punjab 140001 India
2 shared publications
Latest Publications
- 11 October 2024
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Electron Device Letters
- Vol. 45 (12) , 2435-2438
Effect of Ag Nanoparticle Texturing on Al₂O₃ Nanowires for Improved Photodetection
This work utilized the glancing angle deposition (GLAD) method to grow an Al 2 O 3 nanowires (NW) device and an Ag nanoparticles (NP) textured Al 2 O 3 NW device on an n-Si substrate. The growth of the proposed nanostructures is facilitated by virtue of the shadowing effect of the GLAD process. The polycrystalline crystal structure was determined through independent crystallographic investigations. After Ag NP texturing on Al 2 O 3 NW, an improvement in optical absorption and Raman emission was observed. Ag texturing on Al 2 O 3 NW considerably improved the most important photodetection parameters, including photosensitivity, responsivity, quantum efficiency, detectivity, and noise equivalent of power (NEP). This overall improvement in the photodetection parameters is primarily due to the enhancement in the photocurrent by localized surface plasmon resonance (LSPR) exhibited by Ag NP. The proposed device with Ag NP also exhibited an ultrafast photo response. Therefore, the finding reveals that the Ag NP textured Al 2 O 3 NW device is a feasible option for high-speed photodetection applications.
- 11 October 2024
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Electron Device Letters
- Vol. 45 (12) , 2435-2438
Effect of Ag Nanoparticle Texturing on Al₂O₃ Nanowires for Improved Photodetection
This work utilized the glancing angle deposition (GLAD) method to grow an Al 2 O 3 nanowires (NW) device and an Ag nanoparticles (NP) textured Al 2 O 3 NW device on an n-Si substrate. The growth of the proposed nanostructures is facilitated by virtue of the shadowing effect of the GLAD process. The polycrystalline crystal structure was determined through independent crystallographic investigations. After Ag NP texturing on Al 2 O 3 NW, an improvement in optical absorption and Raman emission was observed. Ag texturing on Al 2 O 3 NW considerably improved the most important photodetection parameters, including photosensitivity, responsivity, quantum efficiency, detectivity, and noise equivalent of power (NEP). This overall improvement in the photodetection parameters is primarily due to the enhancement in the photocurrent by localized surface plasmon resonance (LSPR) exhibited by Ag NP. The proposed device with Ag NP also exhibited an ultrafast photo response. Therefore, the finding reveals that the Ag NP textured Al 2 O 3 NW device is a feasible option for high-speed photodetection applications.
- 29 November 2023
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Electron Devices
- Vol. 71 (3) , 1433-1440
Investigation of Highly Efficient Dual-Band Photodetector Performance of Spin-on-Doping (SOD) Grown p-Type Phosphorus Doped ZnO (P:ZnO)/n-Ga2O3 Heterojunction Device
We developed a stable and reproducible p-type P:ZnO thin film using a cost-effective solution-derived spin-on-doping (SOD) technique. We created a pure p-n heterojunction by depositing a highly transparent Ga $_{\text{2}}$ O $_{\text{3}}$ thin film on P:ZnO for photodetector applications. The films’ surface morphology and thickness were analyzed using AFM and FEGSEM. At the same time, UV-visible (UV–Vis) and PL spectroscopy were employed to investigate their optical properties, including absorption, energy bandgap, and defect-related carrier transitions. The resulting P:ZnO/Ga $_{\text{2}}$ O $_{\text{3}}$ heterojunction demonstrated excellent photo-response performance, with a responsivity of 4.76 A/W, detectivity of 10.13 $\times$ 10 $^{\text{12}}$ Jones, and rapid response speed. The device exhibited sensitivity to UV-C and UV–Vis wavelength regions, showcasing its potential for high-performance, dual-band, and low-power photodetectors.
- 29 November 2023
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Electron Devices
- Vol. 71 (3) , 1433-1440
Investigation of Highly Efficient Dual-Band Photodetector Performance of Spin-on-Doping (SOD) Grown p-Type Phosphorus Doped ZnO (P:ZnO)/n-Ga2O3 Heterojunction Device
We developed a stable and reproducible p-type P:ZnO thin film using a cost-effective solution-derived spin-on-doping (SOD) technique. We created a pure p-n heterojunction by depositing a highly transparent Ga $_{\text{2}}$ O $_{\text{3}}$ thin film on P:ZnO for photodetector applications. The films’ surface morphology and thickness were analyzed using AFM and FEGSEM. At the same time, UV-visible (UV–Vis) and PL spectroscopy were employed to investigate their optical properties, including absorption, energy bandgap, and defect-related carrier transitions. The resulting P:ZnO/Ga $_{\text{2}}$ O $_{\text{3}}$ heterojunction demonstrated excellent photo-response performance, with a responsivity of 4.76 A/W, detectivity of 10.13 $\times$ 10 $^{\text{12}}$ Jones, and rapid response speed. The device exhibited sensitivity to UV-C and UV–Vis wavelength regions, showcasing its potential for high-performance, dual-band, and low-power photodetectors.
- 24 January 2023
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 133 (4) , 045302
Positive temperature coefficient of resistance of Mg-GeO2 nanowire array film
Here, glancing angle deposition is employed to synthesize the undoped GeO2 and Mg-doped (0.4 and 0.8 at. %) GeO2 nanowires (NWs) on a Si substrate. The microscopic images show the formation of the NW-like morphology of the grown materials. The gradual decrease in the average ratio of length to diameter depicts the worsening of the formation of NWs with the incorporation of Mg into the GeO2 host lattice. This also affects the crystallinity characteristics of the materials, which have been demonstrated from the selected area electron diffraction (SAED) pattern of the materials. The polycrystallinity nature of undoped GeO2 NWs changes to amorphous due to the introduction of Mg, which has been confirmed from both the obtained SAED and x-ray diffraction patterns of the samples. The presence of Mg was confirmed from the obtained broad bands at 473 and 437 cm−1 in the Fourier transmission spectrum of the doped samples. The increasing conductance with the temperature of Au/undoped GeO2 devices can be explained by the thermionic emission process, whereas the Mg-GeO2 device shows an overall decrease in conductance with increasing temperature. We have ascribed the origin of this abnormal conductance as the positive temperature coefficient of resistance, which is one of the first reports, due to the generation of random grain boundaries and enormous electron trapping at the Au/Mg-GeO2 NW junction. Furthermore, the undoped GeO2 NW device shows good temperature-dependent conductivity as well as stability compared to the doped one.
- 24 January 2023
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 133 (4) , 045302
Positive temperature coefficient of resistance of Mg-GeO2 nanowire array film
Here, glancing angle deposition is employed to synthesize the undoped GeO2 and Mg-doped (0.4 and 0.8 at. %) GeO2 nanowires (NWs) on a Si substrate. The microscopic images show the formation of the NW-like morphology of the grown materials. The gradual decrease in the average ratio of length to diameter depicts the worsening of the formation of NWs with the incorporation of Mg into the GeO2 host lattice. This also affects the crystallinity characteristics of the materials, which have been demonstrated from the selected area electron diffraction (SAED) pattern of the materials. The polycrystallinity nature of undoped GeO2 NWs changes to amorphous due to the introduction of Mg, which has been confirmed from both the obtained SAED and x-ray diffraction patterns of the samples. The presence of Mg was confirmed from the obtained broad bands at 473 and 437 cm−1 in the Fourier transmission spectrum of the doped samples. The increasing conductance with the temperature of Au/undoped GeO2 devices can be explained by the thermionic emission process, whereas the Mg-GeO2 device shows an overall decrease in conductance with increasing temperature. We have ascribed the origin of this abnormal conductance as the positive temperature coefficient of resistance, which is one of the first reports, due to the generation of random grain boundaries and enormous electron trapping at the Au/Mg-GeO2 NW junction. Furthermore, the undoped GeO2 NW device shows good temperature-dependent conductivity as well as stability compared to the doped one.
- 3 January 2023
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Sensors Journal
- Vol. 23 (3) , 1917-1924
Ion-Sensitive Three-Terminal Device as a Universal Hybrid Platform With TiO2Nanowires on the Channel
We developed a three-terminal ion-sensitive device (TTISD) as a proton (H + ) and arsenic (As 3+ ) sensor for the detection of glucose and As(III) dissolved in water. The TTISD was fabricated using the e-beam evaporation and glancing angle deposition (GLAD) technique. The TiO 2 NWs were grown by GLAD on the conducting nafion channel of the TTISD to immobilize the test specimens. Arsenic (As) contamination in drinking water is a burning issue as it’s a threat to human health beyond the safe limit of As(III) in drinking water (0.005 mg/dl). Glucose concentration within the limit of 0 mg/dl - 200 mg/dl in various body fluids, such as blood, sweat, and saliva is also a necessary parameter to monitor. Early detection of high As(III) concentration in water and regular monitoring of glucose concentration in the human body are essential for human health and safety. This work presents a common nano-hybrid platform for the detection of low concentration glucose (40 mg/dl - 200 mg/dl) and high concentration arsenic (0.02 mg/dl - 2 mg/dl) in drinking water. The device exhibits a rapid response time of ~ 1 s, enabling real-time detection of glucose and As(III).
- 3 January 2023
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Sensors Journal
- Vol. 23 (3) , 1917-1924
Ion-Sensitive Three-Terminal Device as a Universal Hybrid Platform With TiO2Nanowires on the Channel
We developed a three-terminal ion-sensitive device (TTISD) as a proton (H + ) and arsenic (As 3+ ) sensor for the detection of glucose and As(III) dissolved in water. The TTISD was fabricated using the e-beam evaporation and glancing angle deposition (GLAD) technique. The TiO 2 NWs were grown by GLAD on the conducting nafion channel of the TTISD to immobilize the test specimens. Arsenic (As) contamination in drinking water is a burning issue as it’s a threat to human health beyond the safe limit of As(III) in drinking water (0.005 mg/dl). Glucose concentration within the limit of 0 mg/dl - 200 mg/dl in various body fluids, such as blood, sweat, and saliva is also a necessary parameter to monitor. Early detection of high As(III) concentration in water and regular monitoring of glucose concentration in the human body are essential for human health and safety. This work presents a common nano-hybrid platform for the detection of low concentration glucose (40 mg/dl - 200 mg/dl) and high concentration arsenic (0.02 mg/dl - 2 mg/dl) in drinking water. The device exhibits a rapid response time of ~ 1 s, enabling real-time detection of glucose and As(III).
- 13 October 2022
- Published by Elsevier in Ceramics International
- Vol. 49 (4) , 6289-6298
Al nanoparticles decorated Er:TiO2 thin film based plasmonic photodetector
- 13 October 2022
- Published by Elsevier in Ceramics International
- Vol. 49 (4) , 6289-6298
Al nanoparticles decorated Er:TiO2 thin film based plasmonic photodetector
- 1 July 2021
- Published by Elsevier in Journal of Alloys and Compounds
- Vol. 868
Mg:TiO2 alloy thin films based MOS capacitors grown on GaAs substrates
- 1 July 2021
- Published by Elsevier in Journal of Alloys and Compounds
- Vol. 868
Mg:TiO2 alloy thin films based MOS capacitors grown on GaAs substrates
- 12 May 2021
- Published by Elsevier in Materials Research Bulletin
- Vol. 142, 111397
Vapour transport grown photosensitive GeO2 thin film
- 12 May 2021
- Published by Elsevier in Materials Research Bulletin
- Vol. 142, 111397
Vapour transport grown photosensitive GeO2 thin film