Mengjie Ying
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Mengjie Ying has a total of 29 co-authors. Here are the top co-authors by number of shared publications:
- Feiyu Liu
School of Mechanics and Engineering Science, Shanghai University, Shanghai, China
4 shared publications Fei-Yu Liu
School of Mechanics and Engineering Science, Shanghai University, Shanghai, PR China
3 shared publicationsJun Fu
School of Mechanics and Engineering Science, Shanghai Univ., Shanghai 200444, China
3 shared publicationsJun Wang
3 shared publications- Jun Wang
Wenzhou University
3 shared publications Jing-Ting Li
School of Mechanics and Engineering Science, Shanghai University, Shanghai, PR China
2 shared publications
Latest Publications
- Open Access
Shear Behavior of the Recycled Concrete Aggregate–Geogrid Interface Under Various Particle Size Distributions: Experiment Investigation and Prediction
Geosynthetic materials provide effective reinforcement for recycled concrete aggregate (RCA), offering a promising approach to green and low-carbon transportation development. This study investigates the interfacial shear behavior of RCA–geogrid systems under varying particle sizes (G1, G2, G3, G4), normal stresses (50, 100, 150 kPa), and shear rates (0.5, 1.0, 2.0, 4.0 mm/min). Prediction models for interfacial shear strength and deformation are proposed. Results indicate that the interface exhibits shear softening across different particle size distributions and normal stresses. RCA with well-graded particle size distributions (G1, G2, G3) showed higher peak shear strength and friction angle, along with smaller vertical displacements, compared to poorly graded RCA (G4). While shear rate had little influence on peak shear strength, it significantly affected vertical displacement. Furthermore, predictive formulas for interface shear strength and deformation were developed considering the curvature coefficient. Since shear strength is critical in determining RCA’s capacity to resist shear forces, these findings highlight its importance for ensuring structural integrity and enhancing its application in sustainable construction.
Open AccessShear Behavior of the Recycled Concrete Aggregate–Geogrid Interface Under Various Particle Size Distributions: Experiment Investigation and Prediction
Geosynthetic materials provide effective reinforcement for recycled concrete aggregate (RCA), offering a promising approach to green and low-carbon transportation development. This study investigates the interfacial shear behavior of RCA–geogrid systems under varying particle sizes (G1, G2, G3, G4), normal stresses (50, 100, 150 kPa), and shear rates (0.5, 1.0, 2.0, 4.0 mm/min). Prediction models for interfacial shear strength and deformation are proposed. Results indicate that the interface exhibits shear softening across different particle size distributions and normal stresses. RCA with well-graded particle size distributions (G1, G2, G3) showed higher peak shear strength and friction angle, along with smaller vertical displacements, compared to poorly graded RCA (G4). While shear rate had little influence on peak shear strength, it significantly affected vertical displacement. Furthermore, predictive formulas for interface shear strength and deformation were developed considering the curvature coefficient. Since shear strength is critical in determining RCA’s capacity to resist shear forces, these findings highlight its importance for ensuring structural integrity and enhancing its application in sustainable construction.
- 11 May 2026
- Published by SAGE Publications in Transportation Research Record: Journal of the Transportation Research Board
Microscopic Analysis of Particle Regularity Effects on Cyclic Shear Behavior at Gravel–Geogrid Interfaces
The apparent shape of particles is a key determinant of the mechanical properties of a gravel–geogrid interface. A quantitative analysis of particle shape was conducted to study the effect of particle regularity on the cyclic shear characteristics of a gravel–geogrid interface. The discrete-element method was utilized to establish particles of varying regularities in particle flow software and to simulate direct shear tests. Changes in porosity, coordination number, shear band proportion, particle rotation angle, and fabric anisotropy were analyzed for varying particle regularities and cycle numbers. The results demonstrate that the vertical displacement and shear stress of the gravel–geogrid interface increase with decreasing particle regularity. The interface exhibits reduced porosity and elevated coordination number for lower-regularity particles. The shear band proportion decreases with increasing particle regularity, with low-regularity particles having 1.4–1.7 times more shear band proportion than high-regularity particles. The rotation angle of a particle with a regularity of 0.707 is only 0.4–0.6 times that of a particle with a regularity of 0.975, showing an opposite trend to the shear band proportion. Simultaneously, particles within the shear band also show a significantly higher rotation angle than those outside. Additionally, the mean rotation angle decreases with increasing cycle number. The principal stress direction of the contact force at the gravel–geogrid interface shifts with the increase in shear displacement. The deflection of the direction of the principal stress axis between high-regularity particles is slightly less than that of low-regularity particles.
- 11 May 2026
- Published by SAGE Publications in Transportation Research Record: Journal of the Transportation Research Board
Microscopic Analysis of Particle Regularity Effects on Cyclic Shear Behavior at Gravel–Geogrid Interfaces
The apparent shape of particles is a key determinant of the mechanical properties of a gravel–geogrid interface. A quantitative analysis of particle shape was conducted to study the effect of particle regularity on the cyclic shear characteristics of a gravel–geogrid interface. The discrete-element method was utilized to establish particles of varying regularities in particle flow software and to simulate direct shear tests. Changes in porosity, coordination number, shear band proportion, particle rotation angle, and fabric anisotropy were analyzed for varying particle regularities and cycle numbers. The results demonstrate that the vertical displacement and shear stress of the gravel–geogrid interface increase with decreasing particle regularity. The interface exhibits reduced porosity and elevated coordination number for lower-regularity particles. The shear band proportion decreases with increasing particle regularity, with low-regularity particles having 1.4–1.7 times more shear band proportion than high-regularity particles. The rotation angle of a particle with a regularity of 0.707 is only 0.4–0.6 times that of a particle with a regularity of 0.975, showing an opposite trend to the shear band proportion. Simultaneously, particles within the shear band also show a significantly higher rotation angle than those outside. Additionally, the mean rotation angle decreases with increasing cycle number. The principal stress direction of the contact force at the gravel–geogrid interface shifts with the increase in shear displacement. The deflection of the direction of the principal stress axis between high-regularity particles is slightly less than that of low-regularity particles.
- 4 August 2025
- Published by Springer Nature in Acta Geotechnica
- Vol. 20 (9) , 4775-4802
Test and DEM study on cyclic shear behavior of sand–irregular concrete interface under dynamic normal loading
- 4 August 2025
- Published by Springer Nature in Acta Geotechnica
- Vol. 20 (9) , 4775-4802
Test and DEM study on cyclic shear behavior of sand–irregular concrete interface under dynamic normal loading
- 8 November 2024
- Published by SAGE Publications in Transportation Research Record: Journal of the Transportation Research Board
- Vol. 2679 (4) , 371-383
Effect of Particle Shape on Cyclic Shear Behavior of Granular Mixtures–Geogrid Interface
The cyclic shear stiffness and damping ratio of angular and round particle geogrid interfaces is of much concern in reinforcement structure seismic analysis. In this study, various component percentages of crushed limestone and spherical granular medium mixtures were used to investigate the role of particle regularity in static and cyclic direct shear tests. The test results revealed that an increase in the proportion of round particles decreased cyclic shear strength and volume change. The phenomenon of shear softening was observed with a high amplitude of shear displacement when the proportion of round particles was increased in the mixture. As the percentage of round particles increased, the maximum interface shear stiffness decreased significantly from, 39.69 to 28.28 MPa/m, but a reverse trend in the maximum damping ratio was observed, from 0.308 to 0.37. The effect of cyclic shear history and proportion of round particles on interface strength parameters was also analyzed. A linear regression model was fitted to the data for quantifying the relationship between the proportion of round particles and friction angle. The results suggest that different percentages of round and angular particles can produce varying degrees of particle interlock between aggregate and geogrid, influencing the macro-mechanical behavior of the reinforced soil interface.
- 8 November 2024
- Published by SAGE Publications in Transportation Research Record: Journal of the Transportation Research Board
- Vol. 2679 (4) , 371-383
Effect of Particle Shape on Cyclic Shear Behavior of Granular Mixtures–Geogrid Interface
The cyclic shear stiffness and damping ratio of angular and round particle geogrid interfaces is of much concern in reinforcement structure seismic analysis. In this study, various component percentages of crushed limestone and spherical granular medium mixtures were used to investigate the role of particle regularity in static and cyclic direct shear tests. The test results revealed that an increase in the proportion of round particles decreased cyclic shear strength and volume change. The phenomenon of shear softening was observed with a high amplitude of shear displacement when the proportion of round particles was increased in the mixture. As the percentage of round particles increased, the maximum interface shear stiffness decreased significantly from, 39.69 to 28.28 MPa/m, but a reverse trend in the maximum damping ratio was observed, from 0.308 to 0.37. The effect of cyclic shear history and proportion of round particles on interface strength parameters was also analyzed. A linear regression model was fitted to the data for quantifying the relationship between the proportion of round particles and friction angle. The results suggest that different percentages of round and angular particles can produce varying degrees of particle interlock between aggregate and geogrid, influencing the macro-mechanical behavior of the reinforced soil interface.
- 4 April 2024
- Published by Springer Nature in Acta Geotechnica
- Vol. 19 (9) , 6091-6116
Macro and mesoscopic shear behavior of interface between sand and concrete with different JRC under cyclic load
- 4 April 2024
- Published by Springer Nature in Acta Geotechnica
- Vol. 19 (9) , 6091-6116
Macro and mesoscopic shear behavior of interface between sand and concrete with different JRC under cyclic load
- 1 July 2023
- Published by Springer Nature in Acta Geotechnica
- Vol. 19 (2) , 805-819
Evaluating the subgrade deformation monitoring effect of sensor-enabled piezoelectric geocables based on cyclic dynamic shear tests
- 1 July 2023
- Published by Springer Nature in Acta Geotechnica
- Vol. 19 (2) , 805-819
Evaluating the subgrade deformation monitoring effect of sensor-enabled piezoelectric geocables based on cyclic dynamic shear tests
- 7 October 2022
- Published by Elsevier in Construction and Building Materials
- Vol. 357
Experimental study on cyclic shear characteristics of geogrid and rubber–sand mixture interface
- 7 October 2022
- Published by Elsevier in Construction and Building Materials
- Vol. 357
Experimental study on cyclic shear characteristics of geogrid and rubber–sand mixture interface
- 1 February 2022
- Published by Elsevier in Geotextiles and Geomembranes
- Vol. 50 (1) , 99-115
Analysis of cyclic shear characteristics of reinforced soil interfaces under cyclic loading and unloading
- 1 February 2022
- Published by Elsevier in Geotextiles and Geomembranes
- Vol. 50 (1) , 99-115
Analysis of cyclic shear characteristics of reinforced soil interfaces under cyclic loading and unloading
- 1 September 2021
- Published by Elsevier in Construction and Building Materials
- Vol. 301, 124143
Effect of particle-size gradation on cyclic shear properties of recycled concrete aggregate
- 1 September 2021
- Published by Elsevier in Construction and Building Materials
- Vol. 301, 124143
Effect of particle-size gradation on cyclic shear properties of recycled concrete aggregate