Hanna Koponen
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Hanna Koponen has a total of 15 co-authors. Here are the top co-authors by number of shared publications:
- Jarkko Tissari
Department of Environmental and Biological Sciences, University of Eastern Finland, Yliopistonranta 8, 70211 Kuopio, Finland
2 shared publications - Olli Sippula
University of Eastern Finland
2 shared publications - Ari Laitinen
Aerosol Physics Laboratory, Physics Unit, Faculty of Engineering and Natural Sciences, Tampere University, 33720 Tampere, Finland
1 shared publication - Heikki Suhonen
Fine Particle and Aerosol Technology Laboratory, Department of Environmental and Biological Sciences, University of Eastern Finland, P.O. Box 1627, 70211, Kuopio, Finland
1 shared publication - Henna Rinta-Kiikka
Department of Environmental and Biological Sciences, University of Eastern Finland, Yliopistonranta 8, 70211 Kuopio, Finland
1 shared publication - Jorma Jokiniemi
Fine Particle and Aerosol Technology Laboratory, Department of Environmental and Biological Sciences, University of Eastern Finland, P.O. Box 1627, 70211 Kuopio, Finland
1 shared publication
Latest Publications
- Open Access
- 16 July 2024
- Published by MDPI AG in Atmosphere
- Vol. 15 (7) , 839
The Effect of Wood Species on Fine Particle and Gaseous Emissions from a Modern Wood Stove
Residential wood combustion (RWC) is a significant source of gaseous and particulate emissions causing adverse health and environmental effects. Several factors affect emissions, but the effects of the fuel wood species on emissions are currently not well understood. In this study, the Nordic wood species (named BirchA, BirchB, Spruce, SpruceDry, Pine and Alder) were combusted in a modern stove, and the emissions were studied. The lowest emissions were obtained from the combustion of BirchA and the highest from Spruce and Alder. The fine particle mass (PM2.5) was mainly composed of elemental carbon (50–70% of PM2.5), which is typical in modern appliances. The lowest PAH concentrations were measured from BirchA (total PAH 107 µg/m3) and Pine (250 µg/m3). In the ignition batch, the PAH concentration was about 4-fold (416 µg/m3). The PAHs did not correlate with other organic compounds, and thus, volatile organic compounds (VOCs) or organic carbon (OC) concentrations cannot be used as an indicator of PAH emissions. Two birch species from different origins with a similar chemical composition but different density produced partially different emission profiles. This study indicates that emission differences may be due more to the physical properties of the wood and the combustion conditions than to the wood species themselves.
- 16 July 2024
- Published by MDPI AG in Atmosphere
- Vol. 15 (7) , 839
Open AccessThe Effect of Wood Species on Fine Particle and Gaseous Emissions from a Modern Wood Stove
Residential wood combustion (RWC) is a significant source of gaseous and particulate emissions causing adverse health and environmental effects. Several factors affect emissions, but the effects of the fuel wood species on emissions are currently not well understood. In this study, the Nordic wood species (named BirchA, BirchB, Spruce, SpruceDry, Pine and Alder) were combusted in a modern stove, and the emissions were studied. The lowest emissions were obtained from the combustion of BirchA and the highest from Spruce and Alder. The fine particle mass (PM2.5) was mainly composed of elemental carbon (50–70% of PM2.5), which is typical in modern appliances. The lowest PAH concentrations were measured from BirchA (total PAH 107 µg/m3) and Pine (250 µg/m3). In the ignition batch, the PAH concentration was about 4-fold (416 µg/m3). The PAHs did not correlate with other organic compounds, and thus, volatile organic compounds (VOCs) or organic carbon (OC) concentrations cannot be used as an indicator of PAH emissions. Two birch species from different origins with a similar chemical composition but different density produced partially different emission profiles. This study indicates that emission differences may be due more to the physical properties of the wood and the combustion conditions than to the wood species themselves.
- Open Access
High Temperature Electrical Charger to Reduce Particulate Emissions from Small Biomass-Fired Boilers
New particulate matter (PM) filtering technologies are needed to meet the emission regulations for small combustion appliances. In this work, we investigate the performance of a novel electrical particle filtration system, the single needle shielded corona charger (SCC), which offers an advantageous solution for PM control in boilers by enhancing particulate deposition within existing boiler sections. Experiments under different operating conditions of a wood-fired boiler were performed, wherein the SCC was installed upstream of either a condensing heat exchanger (CHX) or a cyclone. PM reduction was found to be strongly affected by the SCC temperature and the following collection surface area, and reached its highest reduction efficiency of >90% at the temperature range of 400–500 °C when operating in combination with a CHX. The SCC–cyclone combination was less efficient, providing a 27% PM reduction, as a result of the low surface area and residence time in the cyclone. These results indicate that the SCC can feasibly provide particle filtration when combined with a CHX, wet scrubber, or a cyclone to meet the new emission regulation requirements. The system is best suited for small-scale boilers but can be scaled up to larger boilers by increasing the number of corona chargers.
Open AccessHigh Temperature Electrical Charger to Reduce Particulate Emissions from Small Biomass-Fired Boilers
New particulate matter (PM) filtering technologies are needed to meet the emission regulations for small combustion appliances. In this work, we investigate the performance of a novel electrical particle filtration system, the single needle shielded corona charger (SCC), which offers an advantageous solution for PM control in boilers by enhancing particulate deposition within existing boiler sections. Experiments under different operating conditions of a wood-fired boiler were performed, wherein the SCC was installed upstream of either a condensing heat exchanger (CHX) or a cyclone. PM reduction was found to be strongly affected by the SCC temperature and the following collection surface area, and reached its highest reduction efficiency of >90% at the temperature range of 400–500 °C when operating in combination with a CHX. The SCC–cyclone combination was less efficient, providing a 27% PM reduction, as a result of the low surface area and residence time in the cyclone. These results indicate that the SCC can feasibly provide particle filtration when combined with a CHX, wet scrubber, or a cyclone to meet the new emission regulation requirements. The system is best suited for small-scale boilers but can be scaled up to larger boilers by increasing the number of corona chargers.