Paulo Henrique Michels-Brito
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Paulo Henrique Michels-Brito has a total of 37 co-authors. Here are the top co-authors by number of shared publications:
- Jon Otto Fossum
Department of Physics, Norwegian University of Science and Technology (NTNU), Trondheim, Norway
4 shared publications - Josef Breu
Department of Chemistry, University of Bayreuth, Bayreuth, Germany
3 shared publications - Alexander Sexton
Norwegian University of Science and Technology
1 shared publication Alexsandro Kirch
Departamento de Física dos Materiais e Mecânica, Instituto de Física, Universidade de São Paulo, 05508-090 São Paulo, SP Brazil
1 shared publicationAntonio Malfatti-Gasperini
Brazilian Synchrotron Light Laboratory, LNLS, Brazilian Center for Research in Energy and Materials, CNPEM, Campinas 13083-970, Brazil
1 shared publication- Barbara Pacakova
Department of Physics, Norwegian University of Science and Technology-NTNU, Trondheim, Norway
1 shared publication
Latest Publications
- Open Access
- 18 June 2026
- Published by Elsevier in SSRN Electronic Journal
CO2 Adsorption in Nickel-exchanged Natural Montmorillonite and Bentonite
High adsorption capacity, selectivity, long term applicability and economic justification are some of the necessary requirements of a good CO2 adsorbent. Clay minerals may be a viable alternative in this regard as they are abundant, environmentally friendly and have been shown to adsorb CO2 under specific conditions. Using Powder X-ray diffraction, thermogravimetric analysis and adsorption isotherm measurements, we have investigated the CO2 adsorption of Nickel exchanged Wyoming montmorillonite (SWy-2) and a bentonite sample. Results indicate a partial intercalation of nickel in both samples, showing increased anhydrous d-spacing compared to the pristine samples. Both samples also displayed adsorption of CO2, however the nickel-bentonite samples was incompletely dehydrated and the uptake can thus not be directly attributed to the intercalation of nickel. CO2 uptakes of 0.48 mmol/g and 0.91 mmol/g at 50 bar 25°C were measured for the Ni-SWy-2 and Ni-Bent respectively. The results are consistent with previous findings in nickel exchanged fluorohectorite, where the anhydrous uptake has been attributed to the existence of nickel hydroxide islands. The anhydrous CO2 uptake in the Ni-SWy-2 sample is likely due to the same mechanism, however further investigations are necessary to unambiguously prove this.
- 18 June 2026
- Published by Elsevier in SSRN Electronic Journal
Open AccessCO2 Adsorption in Nickel-exchanged Natural Montmorillonite and Bentonite
High adsorption capacity, selectivity, long term applicability and economic justification are some of the necessary requirements of a good CO2 adsorbent. Clay minerals may be a viable alternative in this regard as they are abundant, environmentally friendly and have been shown to adsorb CO2 under specific conditions. Using Powder X-ray diffraction, thermogravimetric analysis and adsorption isotherm measurements, we have investigated the CO2 adsorption of Nickel exchanged Wyoming montmorillonite (SWy-2) and a bentonite sample. Results indicate a partial intercalation of nickel in both samples, showing increased anhydrous d-spacing compared to the pristine samples. Both samples also displayed adsorption of CO2, however the nickel-bentonite samples was incompletely dehydrated and the uptake can thus not be directly attributed to the intercalation of nickel. CO2 uptakes of 0.48 mmol/g and 0.91 mmol/g at 50 bar 25°C were measured for the Ni-SWy-2 and Ni-Bent respectively. The results are consistent with previous findings in nickel exchanged fluorohectorite, where the anhydrous uptake has been attributed to the existence of nickel hydroxide islands. The anhydrous CO2 uptake in the Ni-SWy-2 sample is likely due to the same mechanism, however further investigations are necessary to unambiguously prove this.
- Open Access
- 29 March 2023
- Published by American Chemical Society (ACS) in Langmuir
- Vol. 39 (14) , 4895-4903
Intercalation of CO2 Selected by Type of Interlayer Cation in Dried Synthetic Hectorite
- 29 March 2023
- Published by American Chemical Society (ACS) in Langmuir
- Vol. 39 (14) , 4895-4903
Open AccessIntercalation of CO2 Selected by Type of Interlayer Cation in Dried Synthetic Hectorite
- Open Access
- 28 January 2022
- Published by American Association for the Advancement of Science (AAAS) in Science Advances
- Vol. 8 (4) , eabl8147
Bright, noniridescent structural coloration from clay mineral nanosheet suspensions
Structural colors originate by constructive interference following reflection and scattering of light from nanostructures with periodicity comparable to visible light wavelengths. Bright and noniridescent structural colorations are highly desirable. Here, we demonstrate that bright noniridescence structural coloration can be easily and rapidly achieved from suspended two-dimensional nanosheets of a clay mineral. We show that brightness is enormously improved by using double clay nanosheets, thus optimizing the clay refractive index that otherwise hampers structural coloration from such systems. Intralayer distances, and thus the structural colors, can be precisely and reproducibly controlled by clay concentration and ionic strength independently, and noniridescence is readily and effortlessly obtained in this system. Embedding such clay-designed nanosheets in recyclable solid matrices could provide tunable vivid coloration and mechanical strength and stability at the same time, thus opening a previously unknown venue for sustainable structural coloration.
- 28 January 2022
- Published by American Association for the Advancement of Science (AAAS) in Science Advances
- Vol. 8 (4) , eabl8147
Open AccessBright, noniridescent structural coloration from clay mineral nanosheet suspensions
Structural colors originate by constructive interference following reflection and scattering of light from nanostructures with periodicity comparable to visible light wavelengths. Bright and noniridescent structural colorations are highly desirable. Here, we demonstrate that bright noniridescence structural coloration can be easily and rapidly achieved from suspended two-dimensional nanosheets of a clay mineral. We show that brightness is enormously improved by using double clay nanosheets, thus optimizing the clay refractive index that otherwise hampers structural coloration from such systems. Intralayer distances, and thus the structural colors, can be precisely and reproducibly controlled by clay concentration and ionic strength independently, and noniridescence is readily and effortlessly obtained in this system. Embedding such clay-designed nanosheets in recyclable solid matrices could provide tunable vivid coloration and mechanical strength and stability at the same time, thus opening a previously unknown venue for sustainable structural coloration.
- Open Access
- 29 December 2020
- Published by American Chemical Society (ACS) in Langmuir
- Vol. 37 (1) , 160-170
Unmodified Clay Nanosheets at the Air–Water Interface
Quasi-two-dimensional (2D) nanolayers, such as graphene oxide or clay layers, adhere to gas–liquid or liquid–liquid interfaces. Particularly, clays are of wide general interest in this context because of their extensive and crucial use as Pickering emulsion stabilizers, as well as for their ability to provide colloidosome capsules. So far, clays could only be localized at oil–water or air–saline-water interfaces in aggregated states, while our results now show that clay nanosheets without any modification can be located at air–deionized-water interfaces. The clay mineral used in the present work is synthetic fluorohectorite with a very high aspect ratio and superior quality in homogeneity and charge distribution compared to other clay minerals. This clay mineral is more suitable for achieving unmodified clay anchoring to fluid interfaces compared to other clay minerals used in previous works. In this context, we studied clay nanosheet organization at the air–water interface by combining different experimental methods: Langmuir–Blodgett trough studies, scanning electron microscopy (SEM) studies of film deposits, grazing-incidence X-ray off-specular scattering (GIXOS), and Brewster angle microscopy (BAM). Clay films formed at the air–water interface could be transferred to solid substrates by the Langmuir–Schaefer method. The BAM results indicate a dynamic equilibrium between clay sheets on the interface and in the subphase. Because of this dynamic equilibrium, the Langmuir monolayer surface pressure does not change significantly when pure clay sheets are spread on the liquid surface. However, also, GIXOS results confirm that there are clay nanosheets at the air–water interface. In addition, we find that clay sheets modified by a branched polymer are much more likely to be confined to the interface.
- 29 December 2020
- Published by American Chemical Society (ACS) in Langmuir
- Vol. 37 (1) , 160-170
Open AccessUnmodified Clay Nanosheets at the Air–Water Interface
Quasi-two-dimensional (2D) nanolayers, such as graphene oxide or clay layers, adhere to gas–liquid or liquid–liquid interfaces. Particularly, clays are of wide general interest in this context because of their extensive and crucial use as Pickering emulsion stabilizers, as well as for their ability to provide colloidosome capsules. So far, clays could only be localized at oil–water or air–saline-water interfaces in aggregated states, while our results now show that clay nanosheets without any modification can be located at air–deionized-water interfaces. The clay mineral used in the present work is synthetic fluorohectorite with a very high aspect ratio and superior quality in homogeneity and charge distribution compared to other clay minerals. This clay mineral is more suitable for achieving unmodified clay anchoring to fluid interfaces compared to other clay minerals used in previous works. In this context, we studied clay nanosheet organization at the air–water interface by combining different experimental methods: Langmuir–Blodgett trough studies, scanning electron microscopy (SEM) studies of film deposits, grazing-incidence X-ray off-specular scattering (GIXOS), and Brewster angle microscopy (BAM). Clay films formed at the air–water interface could be transferred to solid substrates by the Langmuir–Schaefer method. The BAM results indicate a dynamic equilibrium between clay sheets on the interface and in the subphase. Because of this dynamic equilibrium, the Langmuir monolayer surface pressure does not change significantly when pure clay sheets are spread on the liquid surface. However, also, GIXOS results confirm that there are clay nanosheets at the air–water interface. In addition, we find that clay sheets modified by a branched polymer are much more likely to be confined to the interface.