Laura Segui
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Laura Segui has a total of 657 co-authors. Here are the top co-authors by number of shared publications:
- Hector Gomez
Irfu, CEA, Université Paris-Saclay, F-91191 Gif-sur-Yvette, France
36 shared publications - Theopisti Dafni
Center for Astroparticles and High Energy Physics (CAPA), University of Zaragoza, Zaragoza, Aragon, Spain
36 shared publications - Igor Garcia Irastorza
University of Zaragoza
32 shared publications - Susana Cebrian
University of Zaragoza
32 shared publications A Tomás
Laboratorio de Física Nuclear y Astropartículas, Universidad de Zaragoza, Zaragoza, Spain
22 shared publicationsA Rodríguez
Laboratorio de Física Nuclear y Astropartículas, Universidad de Zaragoza, Zaragoza, Spain
20 shared publications
Latest Publications
- Open Access
- 18 October 2023
- Published by MDPI AG in Electronics
- Vol. 12 (20) , 4308
Firmware and Software Implementation Status of the ICBLM and nBLM Systems for the ESS Facility
The European Spallation Source (ESS) is a neutron source powered by a 5 MW, 2 GeV superconducting proton linac which is currently being constructed in Lund. Due to high beam current, just a few microseconds of operation with a misaligned beam can melt the accelerating cavity wall. Therefore, a Beam Loss Monitor (BLM) system is necessary to protect hardware and personnel from the consequences of beam loss. The BLM’s main function is to inhibit beam production when excessively high beam losses are detected. Besides protection functionality, the system is anticipated to provide the means to monitor the beam losses during all modes of operation with the objective of preventing excessive machine activation. This paper concentrates on implementation for ionization chamber Beam Loss Monitor (ICBLM) and Neutron Sensitive Beam Loss Monitor (nBLM) systems. The required microsecond reaction time has been achieved due to the application of an FPGA. A single detector module was installed and successfully tested at LINAC4 at CERN, in the section where conditions are similar to the ones expected in the ESS linac. The summary of these tests is also included.
- 18 October 2023
- Published by MDPI AG in Electronics
- Vol. 12 (20) , 4308
Open AccessFirmware and Software Implementation Status of the ICBLM and nBLM Systems for the ESS Facility
The European Spallation Source (ESS) is a neutron source powered by a 5 MW, 2 GeV superconducting proton linac which is currently being constructed in Lund. Due to high beam current, just a few microseconds of operation with a misaligned beam can melt the accelerating cavity wall. Therefore, a Beam Loss Monitor (BLM) system is necessary to protect hardware and personnel from the consequences of beam loss. The BLM’s main function is to inhibit beam production when excessively high beam losses are detected. Besides protection functionality, the system is anticipated to provide the means to monitor the beam losses during all modes of operation with the objective of preventing excessive machine activation. This paper concentrates on implementation for ionization chamber Beam Loss Monitor (ICBLM) and Neutron Sensitive Beam Loss Monitor (nBLM) systems. The required microsecond reaction time has been achieved due to the application of an FPGA. A single detector module was installed and successfully tested at LINAC4 at CERN, in the section where conditions are similar to the ones expected in the ESS linac. The summary of these tests is also included.
- 1 January 2023
- Published by IOP Publishing in Journal of Instrumentation
- Vol. 18 (01) , P01013
Detector design and performance tests of the ESS-neutron Beam Loss Monitor detectors
A new type of beam loss monitor has been developed based on the detection of fast neutrons produced by beam losses in hadron linear accelerators. This neutron sensitive Beam Loss Monitor (nBLM) has been concieved to fulfil the requirements of the European Spallation Source (ESS) and it will be part of the ESS neutron sensitive BLM system (ESS-nBLM). It has been specifically designed for the low energy part, where only neutrons and gammas produced by the loss can exit the accelerator vessel. Here other types of BLM, based on charged particle detection, suffer from the lack of signal compared to the photon background induced by the radio-frequency cavities. However, it can also be operated in regions of higher energy. The detector is of the Micromegas type and have been designed at IRFU to be able to detect fast neutrons while having a small sensitivity to gammas and thermal neutrons. In this work we focus on the proof of neutron-to-gamma rejection and the first operation of the detector in real beam conditions during the commissioning of LINAC4 (CERN). Controlled beam losses were provoked and have been detected by the nBLM detector installed, demonstrating also the discrimination of the neutron signal from RF x-ray background.
- 1 January 2023
- Published by IOP Publishing in Journal of Instrumentation
- Vol. 18 (01) , P01013
Detector design and performance tests of the ESS-neutron Beam Loss Monitor detectors
A new type of beam loss monitor has been developed based on the detection of fast neutrons produced by beam losses in hadron linear accelerators. This neutron sensitive Beam Loss Monitor (nBLM) has been concieved to fulfil the requirements of the European Spallation Source (ESS) and it will be part of the ESS neutron sensitive BLM system (ESS-nBLM). It has been specifically designed for the low energy part, where only neutrons and gammas produced by the loss can exit the accelerator vessel. Here other types of BLM, based on charged particle detection, suffer from the lack of signal compared to the photon background induced by the radio-frequency cavities. However, it can also be operated in regions of higher energy. The detector is of the Micromegas type and have been designed at IRFU to be able to detect fast neutrons while having a small sensitivity to gammas and thermal neutrons. In this work we focus on the proof of neutron-to-gamma rejection and the first operation of the detector in real beam conditions during the commissioning of LINAC4 (CERN). Controlled beam losses were provoked and have been detected by the nBLM detector installed, demonstrating also the discrimination of the neutron signal from RF x-ray background.
- Open Access
- 10 December 2022
- Published by Elsevier in Nuclear Instruments and Methods in Physics Research Section A: Accelerators, Spectrometers, Detectors and Associated Equipment
- Vol. 1048
X-ray detectors for the BabyIAXO solar axion search
- 10 December 2022
- Published by Elsevier in Nuclear Instruments and Methods in Physics Research Section A: Accelerators, Spectrometers, Detectors and Associated Equipment
- Vol. 1048
Open AccessX-ray detectors for the BabyIAXO solar axion search
- Open Access
- 25 February 2022
- Published by American Physical Society (APS) in Physical Review Accelerators and Beams
- Vol. 25 (2) , 022802
Neutron sensitive beam loss monitoring system for the European Spallation Source linac
The European Spallation Source (ESS), currently under construction in Lund, Sweden, will be a neutron source based on a partly superconducting linac. The ESS linac will be accelerating protons to 2 GeV with a peak current of 62.5 mA and ultimately delivering a 5 MW beam to a rotating tungsten target for neutron production. For a successful tuning and operation of a linac, a beam loss monitoring (BLM) system is required. BLM systems are designed to protect the machine from beam-induced damage and unnecessary activation of the components. This paper focuses on one of the BLM systems to be deployed at the ESS linac, namely the neutron sensitive BLM (nBLM). An overview of the ESS nBLM system design will be presented. In addition to this, results of the tests performed with the full nBLM data acquisition chain will be discussed. These tests represent the first evaluation of the system prototype in a realistic environment. They served as an input to initial study of the procedure for neutron detection algorithm configuration discussed in this contribution as well.
- 25 February 2022
- Published by American Physical Society (APS) in Physical Review Accelerators and Beams
- Vol. 25 (2) , 022802
Open AccessNeutron sensitive beam loss monitoring system for the European Spallation Source linac
The European Spallation Source (ESS), currently under construction in Lund, Sweden, will be a neutron source based on a partly superconducting linac. The ESS linac will be accelerating protons to 2 GeV with a peak current of 62.5 mA and ultimately delivering a 5 MW beam to a rotating tungsten target for neutron production. For a successful tuning and operation of a linac, a beam loss monitoring (BLM) system is required. BLM systems are designed to protect the machine from beam-induced damage and unnecessary activation of the components. This paper focuses on one of the BLM systems to be deployed at the ESS linac, namely the neutron sensitive BLM (nBLM). An overview of the ESS nBLM system design will be presented. In addition to this, results of the tests performed with the full nBLM data acquisition chain will be discussed. These tests represent the first evaluation of the system prototype in a realistic environment. They served as an input to initial study of the procedure for neutron detection algorithm configuration discussed in this contribution as well.
- Open Access
- 9 June 2021
- Published by MDPI AG in Applied Sciences
- Vol. 11 (12) , 5362
Current Status and Future Developments of Micromegas Detectors for Physics and Applications
Micromegas (MICRO-MEsh GAseous Structure) detectors have found common use in different applications since their development in 1996 by the group of I. Giomataris and G. Charpak. In this review article, we present implementations of Micromegas sub-detectors in different physics experiments and highlight the current state of development for innovative detection concepts with Micromegas.
- 9 June 2021
- Published by MDPI AG in Applied Sciences
- Vol. 11 (12) , 5362
Open AccessCurrent Status and Future Developments of Micromegas Detectors for Physics and Applications
Micromegas (MICRO-MEsh GAseous Structure) detectors have found common use in different applications since their development in 1996 by the group of I. Giomataris and G. Charpak. In this review article, we present implementations of Micromegas sub-detectors in different physics experiments and highlight the current state of development for innovative detection concepts with Micromegas.
- 1 December 2020
- Published by IOP Publishing in Journal of Cosmology and Astroparticle Physics
- Vol. 2020 (12) , 043
A pulsed compact low-background X-ray generator
A novel type of pulsed X-ray generator especially suitable for rare event searches, as dark matter and neutrino experiments, has been developed. Being compact and built with selected radio-pure materials, it is appropriate for low-background experiments. UV light generated by a pulsed lamp produces photoelectrons on a metallic cathode, which are subsequently accelerated to produce X-rays. The X-rays are emitted in bunches with a time resolution better than 1 ns and the system provides a fast trigger for event tagging. We present the idea of the new X-ray generator as well as experimental results showing the proof of concept of the device. Data are in good agreement with simulation results and future optimisations of the system are also discussed.
- 1 December 2020
- Published by IOP Publishing in Journal of Cosmology and Astroparticle Physics
- Vol. 2020 (12) , 043
A pulsed compact low-background X-ray generator
A novel type of pulsed X-ray generator especially suitable for rare event searches, as dark matter and neutrino experiments, has been developed. Being compact and built with selected radio-pure materials, it is appropriate for low-background experiments. UV light generated by a pulsed lamp produces photoelectrons on a metallic cathode, which are subsequently accelerated to produce X-rays. The X-rays are emitted in bunches with a time resolution better than 1 ns and the system provides a fast trigger for event tagging. We present the idea of the new X-ray generator as well as experimental results showing the proof of concept of the device. Data are in good agreement with simulation results and future optimisations of the system are also discussed.
- Open Access
- 20 February 2019
- Published by American Physical Society (APS) in Physical Review D
- Vol. 99 (3) , 032008
Search for invisible modes of nucleon decay in water with the SNO+ detector
This paper reports results from a search for nucleon decay through invisible modes, where no visible energy is directly deposited during the decay itself, during the initial water phase of . However, such decays within the oxygen nucleus would produce an excited daughter that would subsequently deexcite, often emitting detectable gamma rays. A search for such gamma rays yields limits of at 90% Bayesian credibility level (with a prior uniform in rate) for the partial lifetime of the neutron, and for the partial lifetime of the proton, the latter a 70% improvement on the previous limit from SNO. We also present partial lifetime limits for invisible dinucleon modes of for , for and for , an improvement over existing limits by close to 3 orders of magnitude for the latter two.- 20 February 2019
- Published by American Physical Society (APS) in Physical Review D
- Vol. 99 (3) , 032008
Open AccessSearch for invisible modes of nucleon decay in water with the SNO+ detector
This paper reports results from a search for nucleon decay through invisible modes, where no visible energy is directly deposited during the decay itself, during the initial water phase of . However, such decays within the oxygen nucleus would produce an excited daughter that would subsequently deexcite, often emitting detectable gamma rays. A search for such gamma rays yields limits of at 90% Bayesian credibility level (with a prior uniform in rate) for the partial lifetime of the neutron, and for the partial lifetime of the proton, the latter a 70% improvement on the previous limit from SNO. We also present partial lifetime limits for invisible dinucleon modes of for , for and for , an improvement over existing limits by close to 3 orders of magnitude for the latter two. - Open Access
- 20 September 2017
- Published by IOP Publishing in Journal of Physics: Conference Series
- Vol. 888 (1) , 012053
Scattering length monitoring at the SNO+ detector
SNO+ is a neutrinoless double beta decay and low energy neutrino experiment located in Sudbury, Canada. To improve our understanding of the detector energy resolution and systematics, calibration systems have been developed to continuously monitor the optical properties of the detector, such as absorption, reemission and scattering. This poster provides an overview of the scattering calibration system: the Scattering Module of the Embedded LED/Laser Light Injection Entity (SMELLIE), designed to measure the scattering length in situ, over a wavelength range of 375nm – 700nm. We present analyses for both water and scintillator filled detector states.
- 20 September 2017
- Published by IOP Publishing in Journal of Physics: Conference Series
- Vol. 888 (1) , 012053
Open AccessScattering length monitoring at the SNO+ detector
SNO+ is a neutrinoless double beta decay and low energy neutrino experiment located in Sudbury, Canada. To improve our understanding of the detector energy resolution and systematics, calibration systems have been developed to continuously monitor the optical properties of the detector, such as absorption, reemission and scattering. This poster provides an overview of the scattering calibration system: the Scattering Module of the Embedded LED/Laser Light Injection Entity (SMELLIE), designed to measure the scattering length in situ, over a wavelength range of 375nm – 700nm. We present analyses for both water and scintillator filled detector states.