Bruna Regina dos Santos Silva
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Research Interests
Bruna Regina dos Santos Silva has a total of 11 co-authors. Here are the top co-authors by number of shared publications:
- Angela Maria dos Santos Pessoa
Universidade Federal de Rondônia, Brazil
3 shared publications - Elizanilda Ramalho Do Rêgo
Laboratory of Biotechnology and Plant Breeding, Federal University of Paraiba, Areia 58397-000, PB, Brazil
3 shared publications - Mailson Monteiro Do Rêgo
Laboratory of Biotechnology and Plant Breeding, Federal University of Paraiba, Areia 58397-000, PB, Brazil
3 shared publications - Betsy Dantas de Medeiros
Universidade Estadual da Paraíba, Brasil
1 shared publication - Carlos Henrique Salvino Gadelha Meneses
Programa de Pós-Graduação em Ciências Agrárias, Departamento de Biologia, Centro de Ciências Biológicas e da Saúde, Universidade Estadual da Paraíba, Campina Grande 58429-500, PB, Brazil
1 shared publication - David Johnston-Monje
Department of Plant Agriculture, University of Guelph, Guelph, Ontario, Canada
1 shared publication
Latest Publications
- Open Access
- 1 January 2023
- Published by FapUNIFESP (SciELO) in Horticultura Brasileira
- Vol. 41, e2495
Performance of pepper cultivars, for fresh market, based on fruit traits
Different studies report that pepper fruit cuticle and pericarp thickness vary among marked cultivars and these variations likely influence many fruit quality traits, especially water loss rates. Thus, the objectives of this work was to evaluate the fresh market performance of pepper cultivars based on fruit traits, and indicate the cultivars of Capsicum spp. with less probability of post harvest water loss. Pepper fruits, belonging to C. chinense, C. frutescens and C. baccatum species, were collected in an experimental area at Bonfim’s settlement, Alagoinha, Paraíba, Brazil. After harvest, fruits were taken to the laboratory of biotechnology at Centro de Ciências Agrárias of the Universidade Federal da Paraíba. Fruits were characterized according to pericarp thickness, fruit weight, and fruit length, larger and smaller fruit diameter. The experimental design was completely randomized with eight treatments and four repetitions. Analysis of variance, mean test, heritability, and ratio of coefficient of genetic variation by coefficient of environmental variation, genotypic and environmental correlation, and Tocher’s grouping method were performed. The cultivar habanero vermelha had better performance for fruit weight and larger and smaller fruit diameter. On the other hand ‘dedo de moça’ presented the longest fruits and major pericarp thickness. These two cultivars also belonged to different groups based on Tocher’s method. The genetic correlation between pericarp thickness and fruit weight was high (0.70) and highly significant. Fruit wall thickness also presented highly significant genotypic correlation with larger fruit diameter (0.93) and small fruit diameter. (0.93). Those finds indicate that indirect selection for pericarp thickness could be done based on larger fruit diameter. These correlations are trustworthy and important due to the high heritability values presented for these traits. Some authors suggest selecting fruits with higher cuticle thickness and fruit width values due to lower water loss. Thus, we suggest that small farmers cultivate ‘habanero vermelha’ and ‘dedo de moça’ in order to produce fruits with extended shelf life.
- 1 January 2023
- Published by FapUNIFESP (SciELO) in Horticultura Brasileira
- Vol. 41, e2495
Open AccessPerformance of pepper cultivars, for fresh market, based on fruit traits
Different studies report that pepper fruit cuticle and pericarp thickness vary among marked cultivars and these variations likely influence many fruit quality traits, especially water loss rates. Thus, the objectives of this work was to evaluate the fresh market performance of pepper cultivars based on fruit traits, and indicate the cultivars of Capsicum spp. with less probability of post harvest water loss. Pepper fruits, belonging to C. chinense, C. frutescens and C. baccatum species, were collected in an experimental area at Bonfim’s settlement, Alagoinha, Paraíba, Brazil. After harvest, fruits were taken to the laboratory of biotechnology at Centro de Ciências Agrárias of the Universidade Federal da Paraíba. Fruits were characterized according to pericarp thickness, fruit weight, and fruit length, larger and smaller fruit diameter. The experimental design was completely randomized with eight treatments and four repetitions. Analysis of variance, mean test, heritability, and ratio of coefficient of genetic variation by coefficient of environmental variation, genotypic and environmental correlation, and Tocher’s grouping method were performed. The cultivar habanero vermelha had better performance for fruit weight and larger and smaller fruit diameter. On the other hand ‘dedo de moça’ presented the longest fruits and major pericarp thickness. These two cultivars also belonged to different groups based on Tocher’s method. The genetic correlation between pericarp thickness and fruit weight was high (0.70) and highly significant. Fruit wall thickness also presented highly significant genotypic correlation with larger fruit diameter (0.93) and small fruit diameter. (0.93). Those finds indicate that indirect selection for pericarp thickness could be done based on larger fruit diameter. These correlations are trustworthy and important due to the high heritability values presented for these traits. Some authors suggest selecting fruits with higher cuticle thickness and fruit width values due to lower water loss. Thus, we suggest that small farmers cultivate ‘habanero vermelha’ and ‘dedo de moça’ in order to produce fruits with extended shelf life.
- Open Access
- 25 April 2021
- Published by Research, Society and Development in Research, Society and Development
- Vol. 10 (5)
Development of Datura metel in different pot sizes
Datura metel L. belongs to Solanaceae family and presents medicinal and ornamental potential. The use of D. metel as an ornamental plant is still unexplored, however there is a need to gather more information about this species planting, especially for pot cultivation. This study aimed to verify the effects of different pot sizes in the development of D. metel, in order to enable the use of this species in the potted flower market. The work was conducted in a greenhouse at the Biotechnology Department located at Center of Agricultural Sciences of the Federal University of Paraíba (CCA-UFPB), Areia, PB, Brazil. The experimental design used was completely randomized with 3 treatments (pot sizes: T1 = 0.82 dm3, T2 = 1.55 dm3 e T3 = 3.68 dm3) and 10 replications. The variables analyzed were: plant height, stem diameter, canopy diameter, number of ramifications, leaf length, leaf width, leaf number, flower number, flower length, flower diameter, chrolophyll a e chrolophyll b. The data obtained was submited to analysis of variance and later on clustered based Tukey’s test (5%). All the analyses were made on GENES software. There is variation between treatments for characteristics evaluated. Treatments 2 (1.55dm3) and 3 (3.68dm3) had similar values and the highest mean values for the characteristics of plant height, number of leaves and chlorophyll b. The size of the vase influences the development of the Angel’s trumpet (D. metel). Pot size influences D. metel development. The medium size recipient (1.55 dm3) is recommended for cultivation of D. metel because it presents ideal plant development, such as plant height and number of leaves, for use with ornamental species pots.
- 25 April 2021
- Published by Research, Society and Development in Research, Society and Development
- Vol. 10 (5)
Open AccessDevelopment of Datura metel in different pot sizes
Datura metel L. belongs to Solanaceae family and presents medicinal and ornamental potential. The use of D. metel as an ornamental plant is still unexplored, however there is a need to gather more information about this species planting, especially for pot cultivation. This study aimed to verify the effects of different pot sizes in the development of D. metel, in order to enable the use of this species in the potted flower market. The work was conducted in a greenhouse at the Biotechnology Department located at Center of Agricultural Sciences of the Federal University of Paraíba (CCA-UFPB), Areia, PB, Brazil. The experimental design used was completely randomized with 3 treatments (pot sizes: T1 = 0.82 dm3, T2 = 1.55 dm3 e T3 = 3.68 dm3) and 10 replications. The variables analyzed were: plant height, stem diameter, canopy diameter, number of ramifications, leaf length, leaf width, leaf number, flower number, flower length, flower diameter, chrolophyll a e chrolophyll b. The data obtained was submited to analysis of variance and later on clustered based Tukey’s test (5%). All the analyses were made on GENES software. There is variation between treatments for characteristics evaluated. Treatments 2 (1.55dm3) and 3 (3.68dm3) had similar values and the highest mean values for the characteristics of plant height, number of leaves and chlorophyll b. The size of the vase influences the development of the Angel’s trumpet (D. metel). Pot size influences D. metel development. The medium size recipient (1.55 dm3) is recommended for cultivation of D. metel because it presents ideal plant development, such as plant height and number of leaves, for use with ornamental species pots.
- 20 November 2019
- Published by Revista Agropecuraria Tecnica - AGROTEC in Agropecuária Técnica
- Vol. 40 (1-2) , 25-30
Influência de substratos sobre propagação de cambará por meio de estacas
O cambará (Lantana camara L.) pode ser propagado tanto por sementes como por estaquia. Na estaquia um dos principais fatores que afetam o enraizamento é o tipo de substrato. Assim, o objetivo deste trabalho foi avaliar a influência de diferentes substratos sobre propagação de cambará por meio de estacas. Para tanto foram utilizados os seguintes substratos: areia lavada (T1); Plantmax® (T2); vermiculita (T3); pó de coco (T4) e solo (T5). Os dados foram submetidos à análise de variância e as médias comparadas pelo teste de Scott-Knott a 5% de probabilidade. Quando comparou-se as médias verificou-se que a areia lavada e a vermiculita proporcionaram resultados superiores para todas as variáveis analisadas, tendo a areia lavada obtido médias superiores aos demais tratamentos. Para a produção de mudas de cambará recomenda-se o uso de areia lavada e vermiculita como substrato alternativo.
- 20 November 2019
- Published by Revista Agropecuraria Tecnica - AGROTEC in Agropecuária Técnica
- Vol. 40 (1-2) , 25-30
Influência de substratos sobre propagação de cambará por meio de estacas
O cambará (Lantana camara L.) pode ser propagado tanto por sementes como por estaquia. Na estaquia um dos principais fatores que afetam o enraizamento é o tipo de substrato. Assim, o objetivo deste trabalho foi avaliar a influência de diferentes substratos sobre propagação de cambará por meio de estacas. Para tanto foram utilizados os seguintes substratos: areia lavada (T1); Plantmax® (T2); vermiculita (T3); pó de coco (T4) e solo (T5). Os dados foram submetidos à análise de variância e as médias comparadas pelo teste de Scott-Knott a 5% de probabilidade. Quando comparou-se as médias verificou-se que a areia lavada e a vermiculita proporcionaram resultados superiores para todas as variáveis analisadas, tendo a areia lavada obtido médias superiores aos demais tratamentos. Para a produção de mudas de cambará recomenda-se o uso de areia lavada e vermiculita como substrato alternativo.
- Open Access
A Metagenomic Advance for the Cloning and Characterization of a Cellulase from Red Rice Crop Residues
Many naturally-occurring cellulolytic microorganisms are not readily cultivable, demanding a culture-independent approach in order to study their cellulolytic genes. Metagenomics involves the isolation of DNA from environmental sources and can be used to identify enzymes with biotechnological potential from uncultured microbes. In this study, a gene encoding an endoglucanase was cloned from red rice crop residues using a metagenomic strategy. The amino acid identity between this gene and its closest published counterparts is lower than 70%. The endoglucanase was named EglaRR01 and was biochemically characterized. This recombinant protein showed activity on carboxymethylcellulose, indicating that EglaRR01 is an endoactive lytic enzyme. The enzymatic activity was optimal at a pH of 6.8 and at a temperature of 30 °C. Ethanol production from this recombinant enzyme was also analyzed on EglaRR01 crop residues, and resulted in conversion of cellulose from red rice into simple sugars which were further fermented by Saccharomyces cerevisiae to produce ethanol after seven days. Ethanol yield in this study was approximately 8 g/L. The gene found herein shows strong potential for use in ethanol production from cellulosic biomass (second generation ethanol).
Open AccessA Metagenomic Advance for the Cloning and Characterization of a Cellulase from Red Rice Crop Residues
Many naturally-occurring cellulolytic microorganisms are not readily cultivable, demanding a culture-independent approach in order to study their cellulolytic genes. Metagenomics involves the isolation of DNA from environmental sources and can be used to identify enzymes with biotechnological potential from uncultured microbes. In this study, a gene encoding an endoglucanase was cloned from red rice crop residues using a metagenomic strategy. The amino acid identity between this gene and its closest published counterparts is lower than 70%. The endoglucanase was named EglaRR01 and was biochemically characterized. This recombinant protein showed activity on carboxymethylcellulose, indicating that EglaRR01 is an endoactive lytic enzyme. The enzymatic activity was optimal at a pH of 6.8 and at a temperature of 30 °C. Ethanol production from this recombinant enzyme was also analyzed on EglaRR01 crop residues, and resulted in conversion of cellulose from red rice into simple sugars which were further fermented by Saccharomyces cerevisiae to produce ethanol after seven days. Ethanol yield in this study was approximately 8 g/L. The gene found herein shows strong potential for use in ethanol production from cellulosic biomass (second generation ethanol).