Shuang Yu
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Shuang Yu has a total of 48 co-authors. Here are the top co-authors by number of shared publications:
Changchun Pan
3 shared publications- Changchun Pan
Chinese Academy of Sciences
2 shared publications Erting Li
Research Institute of Experiment and Detection, Petro China Xinjiang Oilfield Company, Karamay, Xinjiang 834000, China
2 shared publicationsHaizhu Zhang
2 shared publicationsJun Jin
Research Institute of Experiment and Detection, Petro China Xinjiang Oilfield Company, Karamay, Xinjiang 834000, China
2 shared publicationsWenyu Huang
2 shared publications
Latest Publications
- 18 September 2025
- Published by Elsevier in Organic Geochemistry
- Vol. 211
Generation and maturation of diamondoids for petroleum reservoirs in the Tarim Basin, NW China
- 18 September 2025
- Published by Elsevier in Organic Geochemistry
- Vol. 211
Generation and maturation of diamondoids for petroleum reservoirs in the Tarim Basin, NW China
- Open Access
- 26 April 2024
- Published by American Chemical Society (ACS) in ACS Omega
- Vol. 9 (18) , 20512-20531
Tracing Oils and Gas Accumulation in Complex Petroleum Systems Based on Biomarkers, Light Hydrocarbons, and Diamondoids from Concomitant Crude Oils: A Case Study in the Shawan Sag of the Junggar Basin, NW China
The Shawan Sag is one of the most promising blocks in the western Junggar Basin for natural gas and oil exploration. To date, the research and exploration degree here is still low, and there is limited understanding of the origin and migration of natural gas and oils, which seriously restricts future exploration and development. At least three oil charging episodes and one gas charging episode could be confirmed in the reservoirs on the western slope of the Shawan Sag based on the analysis of concentrations and ratios of hopanes and steranes, diamondoids, and light hydrocarbons. The first and second charging oils originated from the peak and late oil generation window stages of Lower Permian Fengcheng Formation (P(1)f) source rocks, respectively. The third charging oil originated from the late oil generation window stage of source rocks of the Middle Permian lower Wuerhe Formation (P(2)w). Combining the carbon isotopic compositions and the gas composition, the fourth charging gas was derived from the postmature source rocks of Carboniferous(C) and Lower Permian Jiamuhe Formation (P(1)j) and the high-postmature source rock of Lower Permian Fengcheng Formation (P(1)f). The preservation conditions of nature gas in the Mesozoic (T-K) cap rocks in the Shawan Sag, as indicated by methyladamantanes (MAs)/methyldiamantanes (MDs) ratio, are better than those in the Mahu Sag. In this study, the methyladamantane maturity parameters of oils in the reservoirs were proposed to evaluate the maturity and further determine the migration direction of late-charging natural gas. The results suggest that late postmatured natural gases were charged from the southern part to the northwest of the Shawan Sag. Therefore, the southeastern direction of Well SP1 is a favorable area for natural gas exploration in the Shawan Sag. Meanwhile the northern part of the sag is favorable for the exploration of high-mature oil generated from source rocks within the Middle Permian Lower Wuerhe Formation.
- 26 April 2024
- Published by American Chemical Society (ACS) in ACS Omega
- Vol. 9 (18) , 20512-20531
Open AccessTracing Oils and Gas Accumulation in Complex Petroleum Systems Based on Biomarkers, Light Hydrocarbons, and Diamondoids from Concomitant Crude Oils: A Case Study in the Shawan Sag of the Junggar Basin, NW China
The Shawan Sag is one of the most promising blocks in the western Junggar Basin for natural gas and oil exploration. To date, the research and exploration degree here is still low, and there is limited understanding of the origin and migration of natural gas and oils, which seriously restricts future exploration and development. At least three oil charging episodes and one gas charging episode could be confirmed in the reservoirs on the western slope of the Shawan Sag based on the analysis of concentrations and ratios of hopanes and steranes, diamondoids, and light hydrocarbons. The first and second charging oils originated from the peak and late oil generation window stages of Lower Permian Fengcheng Formation (P(1)f) source rocks, respectively. The third charging oil originated from the late oil generation window stage of source rocks of the Middle Permian lower Wuerhe Formation (P(2)w). Combining the carbon isotopic compositions and the gas composition, the fourth charging gas was derived from the postmature source rocks of Carboniferous(C) and Lower Permian Jiamuhe Formation (P(1)j) and the high-postmature source rock of Lower Permian Fengcheng Formation (P(1)f). The preservation conditions of nature gas in the Mesozoic (T-K) cap rocks in the Shawan Sag, as indicated by methyladamantanes (MAs)/methyldiamantanes (MDs) ratio, are better than those in the Mahu Sag. In this study, the methyladamantane maturity parameters of oils in the reservoirs were proposed to evaluate the maturity and further determine the migration direction of late-charging natural gas. The results suggest that late postmatured natural gases were charged from the southern part to the northwest of the Shawan Sag. Therefore, the southeastern direction of Well SP1 is a favorable area for natural gas exploration in the Shawan Sag. Meanwhile the northern part of the sag is favorable for the exploration of high-mature oil generated from source rocks within the Middle Permian Lower Wuerhe Formation.
- Open Access
Characterization of the Lower Cretaceous Shale in Lishu Fault Depression, Southeastern Songliao Basin: Implications for Shale Gas Resources Potential
Large thickness of shales over 180.0 m was developed in the source rocks of the Shahezi and Yingcheng formations in the Lishu Fault Depression. Moreover, the high amount of gas content and the total hydrocarbon value of gas logging in several boreholes illustrate that there is a great potential of shale gas resources in this region. Therefore, an integrated characterization of shales from the lower Cretaceous Shahezi and Yingcheng formations was provided to evaluate shale gas resources potential. The measurement results illustrated that the organic-rich shale samples with kerogen type Ⅱ during high to over thermal maturity had a higher content of brittle minerals (>50%) and clay mineral dominated by illite. The shales had a total porosity of 3.11–4.70%, a permeability of 1.24 × 10−3–1.52 × 10−3 μm2, and possessed pore types including dissolution pores, inter-layer pores of clay minerals, micro-fractures, intra-granular pores, and organic pores, which were dominated by micropores and mesopores (0.5–1.7 nm, 2.2–34.3 nm) with a significant contribution from OM and clay minerals. According to the N2 adsorption isotherms, the pore volume was comprised primarily of mesopores with mean widths of 4.314–6.989 nm, while the surface area was comprised primarily of micropores with widths in ranges of 0.5–0.8 nm and 1.0–1.7 nm. Thus, the shales have a suitable porosity and permeability, indicating that fine storage capacity and favorable gas flow capacity occur in the Shahezi and Yingcheng formations, which exhibit a good reservoir quality and excellent exploration potential since the considerable thickness of shales could form a closed reservoir and served as cap rocks for in situ gas generation and accumulation. Especially, according to the measured CH4 excess adsorption amount and the calculated maximum absolute adsorption capacities of CH4 based on the Langmuir adsorption model, the estimated GIP values (1.388–3.307 m3/t) of the shales happened to be in a sampling depth under geological hydrostatic pressure and temperature conditions. This means that the shale storage capacity and high gas content from well site desorption completely met the standard of industrial exploitation when synthetically considering the GIP model. As a consequence, shales in the Shahezi and Yingcheng formations in the Lishu Fault Depression could be potential targets for shale gas exploration.
Open AccessCharacterization of the Lower Cretaceous Shale in Lishu Fault Depression, Southeastern Songliao Basin: Implications for Shale Gas Resources Potential
Large thickness of shales over 180.0 m was developed in the source rocks of the Shahezi and Yingcheng formations in the Lishu Fault Depression. Moreover, the high amount of gas content and the total hydrocarbon value of gas logging in several boreholes illustrate that there is a great potential of shale gas resources in this region. Therefore, an integrated characterization of shales from the lower Cretaceous Shahezi and Yingcheng formations was provided to evaluate shale gas resources potential. The measurement results illustrated that the organic-rich shale samples with kerogen type Ⅱ during high to over thermal maturity had a higher content of brittle minerals (>50%) and clay mineral dominated by illite. The shales had a total porosity of 3.11–4.70%, a permeability of 1.24 × 10−3–1.52 × 10−3 μm2, and possessed pore types including dissolution pores, inter-layer pores of clay minerals, micro-fractures, intra-granular pores, and organic pores, which were dominated by micropores and mesopores (0.5–1.7 nm, 2.2–34.3 nm) with a significant contribution from OM and clay minerals. According to the N2 adsorption isotherms, the pore volume was comprised primarily of mesopores with mean widths of 4.314–6.989 nm, while the surface area was comprised primarily of micropores with widths in ranges of 0.5–0.8 nm and 1.0–1.7 nm. Thus, the shales have a suitable porosity and permeability, indicating that fine storage capacity and favorable gas flow capacity occur in the Shahezi and Yingcheng formations, which exhibit a good reservoir quality and excellent exploration potential since the considerable thickness of shales could form a closed reservoir and served as cap rocks for in situ gas generation and accumulation. Especially, according to the measured CH4 excess adsorption amount and the calculated maximum absolute adsorption capacities of CH4 based on the Langmuir adsorption model, the estimated GIP values (1.388–3.307 m3/t) of the shales happened to be in a sampling depth under geological hydrostatic pressure and temperature conditions. This means that the shale storage capacity and high gas content from well site desorption completely met the standard of industrial exploitation when synthetically considering the GIP model. As a consequence, shales in the Shahezi and Yingcheng formations in the Lishu Fault Depression could be potential targets for shale gas exploration.
- 12 August 2021
- Published by Wiley in Advanced Functional Materials
- Vol. 31 (46) , 2104342
Asymmetric Spacer in Dion–Jacobson Halide Perovskites Induces Staggered Alignment to Direct Out‐of‐Plane Carrier Transport and Enhances Ambient Stability Simultaneously
Dion–Jacobson (DJ)‐type 2D halide perovskites present superior environmental stability and a narrower bandgap, yet a contradiction between charge transport and stability remains to be resolved. Herein, it is shown that both symmetry and substitution of the organic spacer in DJ perovskites synergistically direct the narrow interlayer spacing, staggered spacer alignment, and regular phase arrangement, thereby promoting out‐of‐plane carrier transport and ambient stability. Compared to its symmetric para‐xylylenediamine (PDMA) counterpart, the asymmetric 2‐(4‐aminophenyl)ethylamine (PMEA) spacer largely aids in compressing the inorganic octahedra layer to form a non‐confinement structure with decreased exciton binding energy, while stacked benzene rings enable a staggered alignment of spacers. Such non‐confined structures are less remarkable in meta‐substituted diamine‐based DJ perovskites than those para‐ones, which retard carrier transport from 2D to quasi‐2D phases. The preferential PMEA spacer however requires a long relaxation time to form a dense and ordered staggered alignment, which is realized by a slight addition of strong‐coordinating DMSO into the DMF solvent, thus decelerating crystallization and further optimizing lamellar orientation. As a result, a best efficiency of ≈12% is achieved in (PMEA)MA3Pb4I13 based p‐i‐n type planar solar cells. Importantly, such unencapsulated devices can maintain 81% initial efficiencies after storage in ambient conditions ( ≈60% relative humidity, ≈20 °C) for 700 h.
- 12 August 2021
- Published by Wiley in Advanced Functional Materials
- Vol. 31 (46) , 2104342
Asymmetric Spacer in Dion–Jacobson Halide Perovskites Induces Staggered Alignment to Direct Out‐of‐Plane Carrier Transport and Enhances Ambient Stability Simultaneously
Dion–Jacobson (DJ)‐type 2D halide perovskites present superior environmental stability and a narrower bandgap, yet a contradiction between charge transport and stability remains to be resolved. Herein, it is shown that both symmetry and substitution of the organic spacer in DJ perovskites synergistically direct the narrow interlayer spacing, staggered spacer alignment, and regular phase arrangement, thereby promoting out‐of‐plane carrier transport and ambient stability. Compared to its symmetric para‐xylylenediamine (PDMA) counterpart, the asymmetric 2‐(4‐aminophenyl)ethylamine (PMEA) spacer largely aids in compressing the inorganic octahedra layer to form a non‐confinement structure with decreased exciton binding energy, while stacked benzene rings enable a staggered alignment of spacers. Such non‐confined structures are less remarkable in meta‐substituted diamine‐based DJ perovskites than those para‐ones, which retard carrier transport from 2D to quasi‐2D phases. The preferential PMEA spacer however requires a long relaxation time to form a dense and ordered staggered alignment, which is realized by a slight addition of strong‐coordinating DMSO into the DMF solvent, thus decelerating crystallization and further optimizing lamellar orientation. As a result, a best efficiency of ≈12% is achieved in (PMEA)MA3Pb4I13 based p‐i‐n type planar solar cells. Importantly, such unencapsulated devices can maintain 81% initial efficiencies after storage in ambient conditions ( ≈60% relative humidity, ≈20 °C) for 700 h.