DBDmitriy Babkin

Dmitriy Babkin

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Dmitriy Babkin has a total of 7 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Partitioning and Speciation of Lanthanides in the Magnetite (Hematite)–Hydrothermal Solution System at 450°C and 100 MPa

    by N. V. Smagunov, S. V. Lipko, V. L. Tauson, O. Yu. Belozerova, D. N. Babkin

    —First results of the experimental study of a hydrothermal multisystem including lanthanides (Ln) and Fe oxides (magnetite and hematite) are presented. Ln concentrations in solutions and crystals were determined by ICP-MS and LA-ICP-MS, respectively. The Ln partition and cocrystallization coefficients obtained are interpreted as the maximum estimates of “true” values corresponding to structurally bound admixture. It is shown that Ln (except for Eu) are the compatible elements in hydrothermal magnetite; heavy Ln (beginning with Tb) are compatible in hematite. The pronounced tendency of the increase of both coefficients with increasing Ln atomic number beginning from Gd–Tb was established. This is of great importance when light to heavy Ln ratio is used as a typochemical guide for localization of ore source. The Ln-rich phases in association with magnetite and hematite were obtained. These phases have oxychloride (without Fe) and oxyhydroxide (with Fe) composition and exemplify the simultaneous occurrence of light and heavy Ln within a single hydrothermal system due to the co-crystallization of phases selectively accumulating light and heavy lanthanides.


  • Open Access

    Distribution of Trace Elements (Ag, Pd, Cd, and Mn) between Pyrite and Pyrrhotite and Selectivity of Surficial Nonautonomous Phases in a Hydrothermal System

    by Sergey Lipko, Vladimir Tauson, Nikolay Smagunov, Dmitriy Babkin, Irina Parkhomenko

    The dual distribution coefficients (D) that are related to structurally and superficially bound trace element (TE) in pyrite (Py) and pyrrhotite (Po) associations, crystallized hydrothermally at 400 °C and 1 kbar pressure, were determined. Three independent methods were used to estimate the structural and surficial TE contents (Cstr and Csur) and the corresponding D Py/Po values (Dstr and Dsur), which were found, on average, to be 12.4, 0.8, 0.9, and 0.06 (Dstr) and 2.6, 0.7, 2.0, and 0.07 (Dsur) for Ag, Pd, Cd, and Mn, respectively. The coincidence of a dual D for several elements was a result of coupled changes in Csur and Cstr. The selectivity (S) of the surficial nonautonomous phases (NAPs) that were responsible for TE accumulation (which is the ratio of TE concentrations in surficial and structural modes) was determined. It was shown that the interpretation of TE uptake by surficial phases was adequate and that this phenomenon is common in nature, independently of the system where it occurs—i.e., in experimental autoclaves or in hydrothermal ore deposits. Studies of NAPs selectivity can help in evaluating the total element compatibility in minerals and the maximum possible contents of structurally bound admixtures of the element (solubility) in minerals under given conditions. A significant surficial impurity accumulation effect is most important and well-pronounced for incompatible micro-elements with concentrations of less than ~0.1 wt%. The surficial mode may be a source of Pd and other platinum group elements and more abundant and easily refined than the structurally bound mode.


  • Open Access

    Partitioning and Surficial Segregation of Trace Elements in Iron Oxides in Hydrothermal Fluid Systems

    by Nikolay Smagunov, Vladimir Tauson, Sergey Lipko, Dmitriy Babkin, Taisa Pastushkova, Olga Belozerova, Nikolay Bryansky

    Partitioning experiments were done by hydrothermal synthesis of crystals containing trace elements (TEs) by internal sampling of fluid at the temperature of 450 °C and pressure of 1 kbar. The crystal phases obtained were magnetite, hematite, and Ni-spinel, which were studied using X-ray diffraction (XRD), X-ray electron probe microanalysis (EPMA), laser ablation inductively coupled plasma mass spectrometry (LA-ICP-MS), atomic absorption spectrometry (AAS), and atomic force microscopy (AFM). The solutions from the sampler’s fluid probes were analysed by AAS for TEs included elements of the iron group plus aluminium. The highest co-crystallisation coefficients of TE and Fe between mineral and fluid (DTE/Fe) in magnetite were measured for V, Al, Ni and Cr (in decreasing order of n units in value), a lower value was observed for Co (2 × 10−1), and still lower values for Ti, Zn, and Mn (n × 10−2–10−3). In hematite, DTE/Fe values were highest for Al and V (order of n units in value), while lower values characterised Ti, Cr, and Co (n × 10−1–10−3), and the lowest values were exhibited by Cu, Mn, and Zn (n × 10−5). Copper was confirmed to be the most incompatible with all minerals studied; however, Cu had a high content on crystal surfaces. This surficial segregation contributes to the average TE concentration even when a thin layer of nonautonomous phase (NAP) is enriched in the element of interest. The accumulation of TEs on the surface of crystals increased bulk content 1–2 orders of magnitude above the content of structurally-bound elements even in coarse crystals. The inverse problem—evaluation of TE/Fe ratios in fluids involved in the formation of magnetite-containing deposits—revealed that the most abundant metals in fluids were Fe followed by Mn, Zn, and Cu, which comprised 10 to 30% of the total iron content.