Donald Michael McFarland
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Donald Michael McFarland has a total of 71 co-authors. Here are the top co-authors by number of shared publications:
- Alexander F. Vakakis
University of Illinois at Urbana-Champaign
14 shared publications - Lawrence A. Bergman
University of Illinois at Urbana–Champaign, Urbana, Illinois 61801
12 shared publications - Huancai Lu
Ningbo Institute of Digital Twin, Eastern Institute of Technology, 568 Tongxin Road, Ningbo 315200, P. R. China
11 shared publications - Hanbo Jiang
Eastern Institute of Technology
6 shared publications - Young S. Lee
New Mexico State University
4 shared publications - Tao Han3 shared publications
Latest Publications
- 13 November 2026
- Published by World Scientific Pub Co Pte Ltd in International Journal of Applied Mechanics
Tuning Moving Vehicle Suspensions for Vibration Mitigation of Damped Bridges
It has been widely recognized that traversing vehicles can dampen bridge vibrations. This work clarifies the efficacy of different vehicle suspension tuning approaches for bridge vibration mitigation using an equivalent tuned mass damper (TMD) model and presents a parametric analysis of the key physical factors governing vehicle–bridge interaction. The vehicle–bridge system is modelled as a TMD traveling on an elastically supported beam. A finite element model is developed to numerically validate the analytical model. Transmissibility functions, obtained using the time-freezing technique, and complex eigenvalue loci are employed in the tuning process. For an undamped bridge, the optimal stiffness and damping ratio of the vehicle suspension are obtained from an extended fixed-point principle, under which the analytical model is equivalent to a smooth bridge coupled to a TMD and subjected to a harmonic transverse excitation at the contact point. For a damped bridge, the optimal vehicle suspension parameters are determined from the intersection of the eigenvalue loci of the system. Vehicle damping can induce curve veering of the instantaneous coupled eigenvalues during the vehicle passage, and this phenomenon is further examined through a perturbation analysis. In the parametric analysis, the root-mean-square values of the kinetic and potential energy of the bridge are used to quantify the vibration mitigation performance. Tuning at bridge midspan generally achieves the greatest bridge energy reduction under both sinusoidal and stochastic excitations, since the maximum bridge displacement occurs at that position. Among the considered tuning methods, the optimal parameters determined by enforcing a zero gradient at the fixed point of the fundamental bridge frequency and equal transmissibility magnitudes at the other two fixed points are shown to be the most effective. Based on the midspan tuning strategy, a parametric study of the sprung mass, vehicle speed, excitation frequency, surface roughness class, bridge damping, and bearing stiffness is performed, which reveals the importance of frequency match and phase lag between the bridge and the vehicle in mitigating the bridge responses. This study also shows that bridge surface roughness can significantly influence the efficacy of vibration mitigation.
- 13 November 2026
- Published by World Scientific Pub Co Pte Ltd in International Journal of Applied Mechanics
Tuning Moving Vehicle Suspensions for Vibration Mitigation of Damped Bridges
It has been widely recognized that traversing vehicles can dampen bridge vibrations. This work clarifies the efficacy of different vehicle suspension tuning approaches for bridge vibration mitigation using an equivalent tuned mass damper (TMD) model and presents a parametric analysis of the key physical factors governing vehicle–bridge interaction. The vehicle–bridge system is modelled as a TMD traveling on an elastically supported beam. A finite element model is developed to numerically validate the analytical model. Transmissibility functions, obtained using the time-freezing technique, and complex eigenvalue loci are employed in the tuning process. For an undamped bridge, the optimal stiffness and damping ratio of the vehicle suspension are obtained from an extended fixed-point principle, under which the analytical model is equivalent to a smooth bridge coupled to a TMD and subjected to a harmonic transverse excitation at the contact point. For a damped bridge, the optimal vehicle suspension parameters are determined from the intersection of the eigenvalue loci of the system. Vehicle damping can induce curve veering of the instantaneous coupled eigenvalues during the vehicle passage, and this phenomenon is further examined through a perturbation analysis. In the parametric analysis, the root-mean-square values of the kinetic and potential energy of the bridge are used to quantify the vibration mitigation performance. Tuning at bridge midspan generally achieves the greatest bridge energy reduction under both sinusoidal and stochastic excitations, since the maximum bridge displacement occurs at that position. Among the considered tuning methods, the optimal parameters determined by enforcing a zero gradient at the fixed point of the fundamental bridge frequency and equal transmissibility magnitudes at the other two fixed points are shown to be the most effective. Based on the midspan tuning strategy, a parametric study of the sprung mass, vehicle speed, excitation frequency, surface roughness class, bridge damping, and bearing stiffness is performed, which reveals the importance of frequency match and phase lag between the bridge and the vehicle in mitigating the bridge responses. This study also shows that bridge surface roughness can significantly influence the efficacy of vibration mitigation.
- Open Access
- 6 October 2026
- Published by Elsevier in SSRN Electronic Journal
Constraint-aware online anti-sway trajectory replanning for quadrotor aerial transportation with double-pendulum dynamics
Quadrotor aerial transportation with an intermediate hook exhibits coupled double-pendulum oscillations that complicate safe motion under state constraints. This paper develops a constraint-aware online anti-sway trajectory replanner that reshapes the nominal translational reference by exploiting the coupling of the unactuated swing dynamics. Adaptive time-varying gains, error-correction dynamics, and barrier-based shaping are integrated to regulate the translational error and attenuate the hook and payload oscillations while respecting prescribed position-error and swing-angle bounds. Under ideal tracking by the lower-level controller, a Lyapunov analysis is provided to establish convergence of the error states and satisfaction of the prescribed constraints. Simulations and indoor flight experiments demonstrate effective suppression of the coupled hook--payload oscillations and faster recovery from external disturbances, while maintaining bounded translational errors and the prescribed swing-angle limits.
- 6 October 2026
- Published by Elsevier in SSRN Electronic Journal
Open AccessConstraint-aware online anti-sway trajectory replanning for quadrotor aerial transportation with double-pendulum dynamics
Quadrotor aerial transportation with an intermediate hook exhibits coupled double-pendulum oscillations that complicate safe motion under state constraints. This paper develops a constraint-aware online anti-sway trajectory replanner that reshapes the nominal translational reference by exploiting the coupling of the unactuated swing dynamics. Adaptive time-varying gains, error-correction dynamics, and barrier-based shaping are integrated to regulate the translational error and attenuate the hook and payload oscillations while respecting prescribed position-error and swing-angle bounds. Under ideal tracking by the lower-level controller, a Lyapunov analysis is provided to establish convergence of the error states and satisfaction of the prescribed constraints. Simulations and indoor flight experiments demonstrate effective suppression of the coupled hook--payload oscillations and faster recovery from external disturbances, while maintaining bounded translational errors and the prescribed swing-angle limits.
- 3 October 2026
- Published by Elsevier in Applied Acoustics
- Vol. 257
Experimental study of urban air mobility noise based on scaled-model tests
- 3 October 2026
- Published by Elsevier in Applied Acoustics
- Vol. 257
Experimental study of urban air mobility noise based on scaled-model tests
- 16 June 2026
- Published by Elsevier in Ocean Engineering
- Vol. 362
Vortex-induced vibration and wake modulation of a circular cylinder subjected to harmonic cross-flow perturbations
- 16 June 2026
- Published by Elsevier in Ocean Engineering
- Vol. 362
Vortex-induced vibration and wake modulation of a circular cylinder subjected to harmonic cross-flow perturbations
- Open Access
- 23 March 2026
- Published by Elsevier in SSRN Electronic Journal
Experimental Study of Urban Air Mobility Noise Based on Scaled-Model Tests
This study investigates how ground surface treatment and nearby buildings affect the noise radiation of a hovering unmanned aerial vehicle (UAV) using a scaled-model experimental setup. Sound pressure level spectra were measured along a linear microphone array and at locations on the building surfaces for multiple source positions. Spectral differences were evaluated in representative frequency bands to quantify frequency-dependent and spatial effects. An absorptive ground condition implemented using artificial grass, introduced as a non-rigid surface in contrast to the rigid ground, reduced high-frequency broadband noise by several decibels with minimal spatial variation along the array. In contrast, the presence of a building produced a clear spatial contrast between shadowed and unshielded regions at high frequencies, acting as a partial acoustic barrier. Both effects diminished at lower frequencies as diffraction and interference became more important. Although the band-averaged interaction between grass and building was small, localized narrowband variations were observed at specific frequencies, indicating frequency-selective interference effects. Measurements near the building surface further showed that the local spectral response could be sensitive to local configuration and hovering height. The results highlight the influence of surface conditions, structural layout, and operating clearance in scaled-model UAV noise studies and provide insight for urban air mobility noise assessment.
- 23 March 2026
- Published by Elsevier in SSRN Electronic Journal
Open AccessExperimental Study of Urban Air Mobility Noise Based on Scaled-Model Tests
This study investigates how ground surface treatment and nearby buildings affect the noise radiation of a hovering unmanned aerial vehicle (UAV) using a scaled-model experimental setup. Sound pressure level spectra were measured along a linear microphone array and at locations on the building surfaces for multiple source positions. Spectral differences were evaluated in representative frequency bands to quantify frequency-dependent and spatial effects. An absorptive ground condition implemented using artificial grass, introduced as a non-rigid surface in contrast to the rigid ground, reduced high-frequency broadband noise by several decibels with minimal spatial variation along the array. In contrast, the presence of a building produced a clear spatial contrast between shadowed and unshielded regions at high frequencies, acting as a partial acoustic barrier. Both effects diminished at lower frequencies as diffraction and interference became more important. Although the band-averaged interaction between grass and building was small, localized narrowband variations were observed at specific frequencies, indicating frequency-selective interference effects. Measurements near the building surface further showed that the local spectral response could be sensitive to local configuration and hovering height. The results highlight the influence of surface conditions, structural layout, and operating clearance in scaled-model UAV noise studies and provide insight for urban air mobility noise assessment.
- 1 May 2025
- Published by AIP Publishing in Physics of Fluids
- Vol. 37 (5)
Numerical investigation of pitching airfoil subjected to incoming gust
This work investigates the aerodynamic and acoustic response of a pitching airfoil subjected to time-harmonic gust flows. A low-dissipation and dispersion numerical solver of compressible Navier–Stokes equations was developed with the kinetic energy preserving flux scheme. The incoming gust perturbations were introduced via the momentum source method. Then, the interaction between a gust and a pitching airfoil is subsequently analyzed. In the absence of incoming gusts, the wake of the airfoil is composed of a series of vortex pairs convected downstream, while the lift and drag curves exhibit stable periodic variations. The presence of the gust has significant impact on the wake structure and aerodynamics of the pitching airfoil. Specifically, when the gust has a small wavenumber, the phase of the gust significantly influences the far-field sound. Interestingly, the symmetry of the lift and drag curves, as well as the wake structure, varies with the wavenumber of the incoming flow. The phase angle of the inflow gust also impacts the wake pattern and the aeroacoustics of the pitching airfoil evidently. A gust with a smaller amplitude has minor effects on the aerodynamics and aeroacoustics of the pitching airfoil.
- 1 May 2025
- Published by AIP Publishing in Physics of Fluids
- Vol. 37 (5)
Numerical investigation of pitching airfoil subjected to incoming gust
This work investigates the aerodynamic and acoustic response of a pitching airfoil subjected to time-harmonic gust flows. A low-dissipation and dispersion numerical solver of compressible Navier–Stokes equations was developed with the kinetic energy preserving flux scheme. The incoming gust perturbations were introduced via the momentum source method. Then, the interaction between a gust and a pitching airfoil is subsequently analyzed. In the absence of incoming gusts, the wake of the airfoil is composed of a series of vortex pairs convected downstream, while the lift and drag curves exhibit stable periodic variations. The presence of the gust has significant impact on the wake structure and aerodynamics of the pitching airfoil. Specifically, when the gust has a small wavenumber, the phase of the gust significantly influences the far-field sound. Interestingly, the symmetry of the lift and drag curves, as well as the wake structure, varies with the wavenumber of the incoming flow. The phase angle of the inflow gust also impacts the wake pattern and the aeroacoustics of the pitching airfoil evidently. A gust with a smaller amplitude has minor effects on the aerodynamics and aeroacoustics of the pitching airfoil.
- 8 April 2025
- Published by Elsevier in International Journal of Mechanical Sciences
- Vol. 294
Traveling waves in tensioned Euler-Bernoulli beams with viscoelastic boundary conditions
- 8 April 2025
- Published by Elsevier in International Journal of Mechanical Sciences
- Vol. 294
Traveling waves in tensioned Euler-Bernoulli beams with viscoelastic boundary conditions
- Open Access
- 31 January 2025
- Published by MDPI AG in Mathematics
- Vol. 13 (3) , 491
Efficient Solution of Fokker–Planck Equations in Two Dimensions
Finite element analysis (FEA) of the Fokker–Planck equation governing the nonstationary joint probability density function of the responses of a dynamical system produces a large set of ordinary differential equations, and computations become impractical for systems with as few as four states. Nonetheless, FEA remains of interest for small systems—for example, for the generation of baseline performance data and reference solutions for the evaluation of machine learning-based methods. We examine the effectiveness of two techniques which, while they are well established, have not to our knowledge been applied to this problem previously: reduction of the equations onto a smaller basis comprising selected eigenvectors of one of the coefficient matrices, and splitting of the other coefficient matrix. The reduction was only moderately effective, requiring a much larger basis than was expected and producing solutions with clear artifacts. Operator splitting, however, performed very well. While the methods can be combined, our results indicate that splitting alone is an effective and generally preferable approach.
- 31 January 2025
- Published by MDPI AG in Mathematics
- Vol. 13 (3) , 491
Open AccessEfficient Solution of Fokker–Planck Equations in Two Dimensions
Finite element analysis (FEA) of the Fokker–Planck equation governing the nonstationary joint probability density function of the responses of a dynamical system produces a large set of ordinary differential equations, and computations become impractical for systems with as few as four states. Nonetheless, FEA remains of interest for small systems—for example, for the generation of baseline performance data and reference solutions for the evaluation of machine learning-based methods. We examine the effectiveness of two techniques which, while they are well established, have not to our knowledge been applied to this problem previously: reduction of the equations onto a smaller basis comprising selected eigenvectors of one of the coefficient matrices, and splitting of the other coefficient matrix. The reduction was only moderately effective, requiring a much larger basis than was expected and producing solutions with clear artifacts. Operator splitting, however, performed very well. While the methods can be combined, our results indicate that splitting alone is an effective and generally preferable approach.
- 18 June 2023
- Published by Springer Nature in Nonlinear Dynamics
- Vol. 111 (16) , 14713-14730
One-dimensional granular chains as transmitted force attenuators
- 18 June 2023
- Published by Springer Nature in Nonlinear Dynamics
- Vol. 111 (16) , 14713-14730
One-dimensional granular chains as transmitted force attenuators