Annie Héroux
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Annie Héroux has a total of 39 co-authors. Here are the top co-authors by number of shared publications:
- Alessandro Olivo
Elettra – Sincrotrone Trieste SCpA, SS 14 km 163,5 in AREA Science Park, Basovizza, 34149 Trieste, Italy
2 shared publications - Balasubramanian Gopal
Molecular Biophysics Unit, Indian Institute of Science, Bangalore, India
2 shared publications - Dan Dumitrescu
Nobian, Van Asch v. Wijckstraat 53, 3811 LP Amersfoort, The Netherlands
2 shared publications - Dipankar Das Sarma
Solid State and Structural Chemistry Unit Indian Institute of Science Bengaluru India
2 shared publications - Giorgio Bais
ELETTRA – Sincrotrone Trieste Trieste Italy
2 shared publications - Lisa Vaccari
Elettra – Sincrotrone Trieste SCpA, SS 14 km 163,5 in AREA Science Park, Basovizza, 34149 Trieste, Italy
2 shared publications
Latest Publications
- Open Access
- 30 March 2026
- Published by International Union of Crystallography (IUCr) in Journal of Synchrotron Radiation
- Vol. 33 (3) , 902
Macromolecular crystallography at Elettra: current and future perspectives. Corrigendum
Corrigendum to the article by Hegde et al. [(2025). J. Synchrotron Rad. 32 , 757–765].
- 30 March 2026
- Published by International Union of Crystallography (IUCr) in Journal of Synchrotron Radiation
- Vol. 33 (3) , 902
Open AccessMacromolecular crystallography at Elettra: current and future perspectives. Corrigendum
Corrigendum to the article by Hegde et al. [(2025). J. Synchrotron Rad. 32 , 757–765].
- Open Access
- 26 March 2025
- Published by International Union of Crystallography (IUCr) in Journal of Synchrotron Radiation
- Vol. 32 (3) , 757-765
Macromolecular crystallography at Elettra: current and future perspectives
The Elettra synchrotron radiation facility, located in Trieste, Italy, is a third-generation storage ring, operating in top-up mode at both 2.0 and 2.4 GeV. The facility currently hosts one beamline fully dedicated to macromolecular crystallography, XRD2. XRD2 is based on a superconducting wiggler, and it has been open to users since 2018. On-site and remote access for data collection, as well as monitoring tools and automatic data analysis pipelines are available to its users. In addition, since 1994 Elettra has operated a general-purpose diffraction beamline, XRD1, offering the macromolecular community a wide spectrum extending to long wavelengths for phasing and ion identification. Ancillary facilities support the beamlines, providing sample preparation and a high-throughput crystallization platform for the user community. A new CryoEM facility is being established on campus and jointly operated by the Consiglio Nazionale della Ricerche – Istituto Officina dei Materiali (CNR–IOM) and Elettra, providing further opportunities to the Elettra user community. This review outlines the current capabilities and anticipated developments for macromolecular crystallography at Elettra to accompany the upcoming upgrade to Elettra 2.0, featuring a six-bend enhanced achromat lattice. The new source is expected to deliver a high-brilliance beam, enabling the macromolecular crystallography community to better address the emerging and future scientific challenges.
- 26 March 2025
- Published by International Union of Crystallography (IUCr) in Journal of Synchrotron Radiation
- Vol. 32 (3) , 757-765
Open AccessMacromolecular crystallography at Elettra: current and future perspectives
The Elettra synchrotron radiation facility, located in Trieste, Italy, is a third-generation storage ring, operating in top-up mode at both 2.0 and 2.4 GeV. The facility currently hosts one beamline fully dedicated to macromolecular crystallography, XRD2. XRD2 is based on a superconducting wiggler, and it has been open to users since 2018. On-site and remote access for data collection, as well as monitoring tools and automatic data analysis pipelines are available to its users. In addition, since 1994 Elettra has operated a general-purpose diffraction beamline, XRD1, offering the macromolecular community a wide spectrum extending to long wavelengths for phasing and ion identification. Ancillary facilities support the beamlines, providing sample preparation and a high-throughput crystallization platform for the user community. A new CryoEM facility is being established on campus and jointly operated by the Consiglio Nazionale della Ricerche – Istituto Officina dei Materiali (CNR–IOM) and Elettra, providing further opportunities to the Elettra user community. This review outlines the current capabilities and anticipated developments for macromolecular crystallography at Elettra to accompany the upcoming upgrade to Elettra 2.0, featuring a six-bend enhanced achromat lattice. The new source is expected to deliver a high-brilliance beam, enabling the macromolecular crystallography community to better address the emerging and future scientific challenges.
- Open Access
- 1 January 2021
- Published by Elsevier in Journal of Biological Chemistry
- Vol. 296, 100066
Crystal structures of glutathione- and inhibitor-bound human GGT1: critical interactions within the cysteinylglycine binding site
- 1 January 2021
- Published by Elsevier in Journal of Biological Chemistry
- Vol. 296, 100066
Open AccessCrystal structures of glutathione- and inhibitor-bound human GGT1: critical interactions within the cysteinylglycine binding site
- Open Access
- 17 March 2012
- Published by International Union of Crystallography (IUCr) in Journal of Synchrotron Radiation
- Vol. 19 (3) , 381-387
Transmission-mode diamond white-beam position monitor at NSLS
Two transmission-mode diamond X-ray beam position monitors installed at National Synchrotron Light Source (NSLS) beamline X25 are described. Each diamond beam position monitor is constructed around two horizontally tiled electronic-grade (p.p.b. nitrogen impurity) single-crystal (001) CVD synthetic diamonds. The position, angle and flux of the white X-ray beam can be monitored in real time with a position resolution of 500 nm in the horizontal direction and 100 nm in the vertical direction for a 3 mm × 1 mm beam. The first diamond beam position monitor has been in operation in the white beam for more than one year without any observable degradation in performance. The installation of a second, more compact, diamond beam position monitor followed about six months later, adding the ability to measure the angular trajectory of the photon beam.
- 17 March 2012
- Published by International Union of Crystallography (IUCr) in Journal of Synchrotron Radiation
- Vol. 19 (3) , 381-387
Open AccessTransmission-mode diamond white-beam position monitor at NSLS
Two transmission-mode diamond X-ray beam position monitors installed at National Synchrotron Light Source (NSLS) beamline X25 are described. Each diamond beam position monitor is constructed around two horizontally tiled electronic-grade (p.p.b. nitrogen impurity) single-crystal (001) CVD synthetic diamonds. The position, angle and flux of the white X-ray beam can be monitored in real time with a position resolution of 500 nm in the horizontal direction and 100 nm in the vertical direction for a 3 mm × 1 mm beam. The first diamond beam position monitor has been in operation in the white beam for more than one year without any observable degradation in performance. The installation of a second, more compact, diamond beam position monitor followed about six months later, adding the ability to measure the angular trajectory of the photon beam.
- 18 October 2006
- Published by International Union of Crystallography (IUCr) in Acta Crystallographica Section D Structural Biology
- Vol. 62 (11) , 1340-1347
Integrated software for macromolecular crystallography synchrotron beamlines II: revision, robots and a database
This manuscript chronicles the evolution of software used originally to control a diffractometer at a macromolecular crystallography beamline. The system has been augmented and rewritten. A modular and carefully organized suite of programs now handles the whole experimental environment from a single vantage point. It provides automatic logging of the experiment and communication with the user, all the way from an initial proposal to perform the work to the end of data collection. This has included construction of a relational database to organize all details of the experiment and incorporation of a robotic specimen changer to provide automation for high-throughput applications.
- 18 October 2006
- Published by International Union of Crystallography (IUCr) in Acta Crystallographica Section D Structural Biology
- Vol. 62 (11) , 1340-1347
Integrated software for macromolecular crystallography synchrotron beamlines II: revision, robots and a database
This manuscript chronicles the evolution of software used originally to control a diffractometer at a macromolecular crystallography beamline. The system has been augmented and rewritten. A modular and carefully organized suite of programs now handles the whole experimental environment from a single vantage point. It provides automatic logging of the experiment and communication with the user, all the way from an initial proposal to perform the work to the end of data collection. This has included construction of a relational database to organize all details of the experiment and incorporation of a robotic specimen changer to provide automation for high-throughput applications.