F. Jerry Lucia
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Research Interests
F. Jerry Lucia has a total of 10 co-authors. Here are the top co-authors by number of shared publications:
- Charles Kerans
Department of Earth and Planetary Sciences, Jackson School of Geosciences The University of Texas at Austin 2305 Speedway, Stop C1160 Austin Texas 78712‐1692 USA
2 shared publications - B. Rendall
ExxonMobil Upstream Research Company , 22777 Springwood Village Parkway, Houston, Texas 77389
1 shared publication Beatriz Garcia-Fresca
Chevron Energy Technology Company, 6001 Bollinger Canyon Road, San Ramon, California
1 shared publication- Franz O. Meyer
Saudi Aramco
1 shared publication - John M. Sharp
Department of Geological Sciences, University of Texas, 1 University Station, Austin, TX 78712-0254, USA
1 shared publication - Jr. James W. Jennings
The University of Texas at Austin
1 shared publication
Latest Publications
- 30 May 2018
- Published by Society of Exploration Geophysicists in Geophysics
- Vol. 83 (4) , MR199-MR210
Matrix microcrystalline structure and acoustic properties of oomoldic dolograinstone
Previous studies have shown that carbonate rock with rounded moldic macropores has a higher compressional velocity at a given porosity than rock with interparticle or intercrystalline porosity and high-aspect-ratio macropores. Our study of Permian dolograinstone challenges this commonly accepted result. Petrophysical and acoustic velocities were measured on 55 mini core plugs collected along an approximately 1 km long horizontal transect within a single grainstone unit having lateral changes from grainstone with dominantly interparticle porosity to grainstone with mostly moldic porosity. The studied dolograinstone samples have a large scattering of acoustic velocity (up to 1500 m/s) at equal porosity. Some oomoldic grainstone samples have either higher velocity or significantly lower velocity than that of the intercrystalline grainstone samples. Petrographic analysis under plain light and UV light combined with mercury injection capillary pressure data and scanning electron microscopy analysis indicates that moldic samples with a lower than average velocity for a given porosity have a matrix with between 50% and 75% of the total porosity as intercrystalline microporosity between large moldic pores. Conversely, rocks with a higher than average velocity for a given porosity find a lack of micropores in the microcrystalline part of the matrix. The amount of micro- and mesoporosity in the matrix is the primary control on acoustic properties of those moldic dolograinstone samples. Therefore, the matrix microcrystalline structure can exert a stronger control on acoustic property than do the macropore types and shapes. These results indicate that using acoustic data from the subsurface to identify pore shape and reservoir properties still remains a challenge.
- 30 May 2018
- Published by Society of Exploration Geophysicists in Geophysics
- Vol. 83 (4) , MR199-MR210
Matrix microcrystalline structure and acoustic properties of oomoldic dolograinstone
Previous studies have shown that carbonate rock with rounded moldic macropores has a higher compressional velocity at a given porosity than rock with interparticle or intercrystalline porosity and high-aspect-ratio macropores. Our study of Permian dolograinstone challenges this commonly accepted result. Petrophysical and acoustic velocities were measured on 55 mini core plugs collected along an approximately 1 km long horizontal transect within a single grainstone unit having lateral changes from grainstone with dominantly interparticle porosity to grainstone with mostly moldic porosity. The studied dolograinstone samples have a large scattering of acoustic velocity (up to 1500 m/s) at equal porosity. Some oomoldic grainstone samples have either higher velocity or significantly lower velocity than that of the intercrystalline grainstone samples. Petrographic analysis under plain light and UV light combined with mercury injection capillary pressure data and scanning electron microscopy analysis indicates that moldic samples with a lower than average velocity for a given porosity have a matrix with between 50% and 75% of the total porosity as intercrystalline microporosity between large moldic pores. Conversely, rocks with a higher than average velocity for a given porosity find a lack of micropores in the microcrystalline part of the matrix. The amount of micro- and mesoporosity in the matrix is the primary control on acoustic properties of those moldic dolograinstone samples. Therefore, the matrix microcrystalline structure can exert a stronger control on acoustic property than do the macropore types and shapes. These results indicate that using acoustic data from the subsurface to identify pore shape and reservoir properties still remains a challenge.
- 1 January 2017
- Published by American Association of Petroleum Geologists AAPG/Datapages in AAPG Bulletin
- Vol. 101 (1) , 73-94
Facies-independent reservoir characterization of the micropore-dominated Word field (Edwards Formation), Lavaca County, Texas
Micropore-dominated carbonate reservoirs remain challenging for accurate hydrocarbon evaluation and production because conventional reservoir models using depositional textures and petrophysical properties to distribute porosity and permeability cannot be applied. Nevertheless, understanding the distribution of pore systems and predicting the fluid flow behavior of microporous reservoirs is fundamental because micropores constitute a significant percentage of the total porosity and storage capacity. We present the results from an integrated study on the producing micropore-dominated Word field characterized by a facies-independent, diagenetically controlled pore system that approaches 100% microporosity. Four cored wells through the Albian Edwards Formation were described and correlated using stacking patterns and vertical facies trends; pore type characterization was done through thin section petrography, routine core analyses, scanning electron microscopy, and mercury injection capillary pressure data. This study is an example of a permeable reservoir in which intergrain pores are cemented during burial diagenesis and micropores, being more resistant to cementation, remain open to depths greater than 4000 m (13,000 ft). A unique relationship exists between porosity, permeability, median pore throat size, and microcrystalline textures, independent of facies and fabrics. Cumulative gas production data show there is a correlation between the total porosity and the structural position of the wells: wells high on the structure have the highest production. We demonstrate that an equally well–connected micropore network exists in mud-dominated rocks via the matrix and via grain-to-grain contacts in grain-dominated rocks. The here described intragrain micropore network through grain-to-grain contacts in cemented grainstones is a new carbonate flow path that will likely become more important as more unconventional carbonate reservoirs are explored.
- 1 January 2017
- Published by American Association of Petroleum Geologists AAPG/Datapages in AAPG Bulletin
- Vol. 101 (1) , 73-94
Facies-independent reservoir characterization of the micropore-dominated Word field (Edwards Formation), Lavaca County, Texas
Micropore-dominated carbonate reservoirs remain challenging for accurate hydrocarbon evaluation and production because conventional reservoir models using depositional textures and petrophysical properties to distribute porosity and permeability cannot be applied. Nevertheless, understanding the distribution of pore systems and predicting the fluid flow behavior of microporous reservoirs is fundamental because micropores constitute a significant percentage of the total porosity and storage capacity. We present the results from an integrated study on the producing micropore-dominated Word field characterized by a facies-independent, diagenetically controlled pore system that approaches 100% microporosity. Four cored wells through the Albian Edwards Formation were described and correlated using stacking patterns and vertical facies trends; pore type characterization was done through thin section petrography, routine core analyses, scanning electron microscopy, and mercury injection capillary pressure data. This study is an example of a permeable reservoir in which intergrain pores are cemented during burial diagenesis and micropores, being more resistant to cementation, remain open to depths greater than 4000 m (13,000 ft). A unique relationship exists between porosity, permeability, median pore throat size, and microcrystalline textures, independent of facies and fabrics. Cumulative gas production data show there is a correlation between the total porosity and the structural position of the wells: wells high on the structure have the highest production. We demonstrate that an equally well–connected micropore network exists in mud-dominated rocks via the matrix and via grain-to-grain contacts in grain-dominated rocks. The here described intragrain micropore network through grain-to-grain contacts in cemented grainstones is a new carbonate flow path that will likely become more important as more unconventional carbonate reservoirs are explored.
- 1 September 2012
- Published by American Association of Petroleum Geologists AAPG/Datapages in AAPG Bulletin
- Vol. 96 (9) , 1757-1781
Outcrop-constrained hydrogeological simulations of brine reflux and early dolomitization of the Permian San Andres Formation
Our hydrogeologic model tests the effectiveness of brine reflux as the mechanism for early dolomitization of the Permian San Andres Formation. Brine circulation is constrained by sequence-stratigraphic parameters and a heterogeneous distribution of petrophysical properties based on outcrop data. The model simulates accumulation of the San Andres platform and calculates fluid flow and solute transport in response to relative sea level fluctuations. It tracks porosity loss caused by compaction and the concomitant permeability feedback. The amount of dolomite potentially formed is calculated by means of a magnesium mass balance between brine and rock. Results show that (1) brine reflux is an effective mechanism to deliver magnesium to dolomitize large carbonate successions; (2) relative sea level–controlled transient boundary conditions result in intricate flow and salinity patterns that can generate irregular dolomite bodies with complex spatial distributions; (3) pervasive dolomitization can result from several short-lived reflux events by the amalgamation of brine plumes sourced in different locations and times; and (4) the model successfully recreates the dolostone and limestone patterns observed in San Andres outcrops.
- 1 September 2012
- Published by American Association of Petroleum Geologists AAPG/Datapages in AAPG Bulletin
- Vol. 96 (9) , 1757-1781
Outcrop-constrained hydrogeological simulations of brine reflux and early dolomitization of the Permian San Andres Formation
Our hydrogeologic model tests the effectiveness of brine reflux as the mechanism for early dolomitization of the Permian San Andres Formation. Brine circulation is constrained by sequence-stratigraphic parameters and a heterogeneous distribution of petrophysical properties based on outcrop data. The model simulates accumulation of the San Andres platform and calculates fluid flow and solute transport in response to relative sea level fluctuations. It tracks porosity loss caused by compaction and the concomitant permeability feedback. The amount of dolomite potentially formed is calculated by means of a magnesium mass balance between brine and rock. Results show that (1) brine reflux is an effective mechanism to deliver magnesium to dolomitize large carbonate successions; (2) relative sea level–controlled transient boundary conditions result in intricate flow and salinity patterns that can generate irregular dolomite bodies with complex spatial distributions; (3) pervasive dolomitization can result from several short-lived reflux events by the amalgamation of brine plumes sourced in different locations and times; and (4) the model successfully recreates the dolostone and limestone patterns observed in San Andres outcrops.
- Open Access
- 1 October 2001
- Published by GeoScienceWorld in GeoArabia
- Vol. 6 (4) , 619-646
Permeability and Rock Fabric from Wireline Logs, Arab-D Reservoir, Ghawar Field, Saudi Arabia
The goal of reservoir characterization is to distribute petrophysical properties in 3-D. Porosity, permeability, and saturation values have no intrinsic spatial information and must be linked to a 3-D geologic model to be distributed in space. This link is provided by relating petrophysical properties to rock fabrics. The vertical succession of rock fabrics was shown to be useful in constructing a geologic framework for distributing porosity, permeability, and saturation in 3-D. Permeability is perhaps the most difficult petrophysical property to obtain and image because its calculation from wireline logs requires the estimation of pore-size distribution. In this study of the Arab-D reservoir, rock fabric and interparticle porosity were used to estimate pore-size distribution. Cross-plots of water saturation and porosity, calibrated with rock-fabric descriptions, formed the basis for determining the distribution of rock fabric and pore size from resistivity and porosity logs. Interparticle porosity was obtained from travel-time/porosity, cross-plot relationships. A global porosity-permeability transform that related rock fabric, interparticle porosity, and permeability was the basis for calculating permeability from wireline logs. Calculated permeability values compared well with core permeability. In uncored wells, permeability was summed vertically and the horizontal permeability profile compared with flow-meter data. The results showed good correlation in most wells.
- 1 October 2001
- Published by GeoScienceWorld in GeoArabia
- Vol. 6 (4) , 619-646
Open AccessPermeability and Rock Fabric from Wireline Logs, Arab-D Reservoir, Ghawar Field, Saudi Arabia
The goal of reservoir characterization is to distribute petrophysical properties in 3-D. Porosity, permeability, and saturation values have no intrinsic spatial information and must be linked to a 3-D geologic model to be distributed in space. This link is provided by relating petrophysical properties to rock fabrics. The vertical succession of rock fabrics was shown to be useful in constructing a geologic framework for distributing porosity, permeability, and saturation in 3-D. Permeability is perhaps the most difficult petrophysical property to obtain and image because its calculation from wireline logs requires the estimation of pore-size distribution. In this study of the Arab-D reservoir, rock fabric and interparticle porosity were used to estimate pore-size distribution. Cross-plots of water saturation and porosity, calibrated with rock-fabric descriptions, formed the basis for determining the distribution of rock fabric and pore size from resistivity and porosity logs. Interparticle porosity was obtained from travel-time/porosity, cross-plot relationships. A global porosity-permeability transform that related rock fabric, interparticle porosity, and permeability was the basis for calculating permeability from wireline logs. Calculated permeability values compared well with core permeability. In uncored wells, permeability was summed vertically and the horizontal permeability profile compared with flow-meter data. The results showed good correlation in most wells.