V. P. Khvostikov
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
V. P. Khvostikov has a total of 8 co-authors. Here are the top co-authors by number of shared publications:
N. Kh. Timoshina
Russian Academy of Sciences
2 shared publicationsS. V. Sorokina
Russian Academy of Sciences
2 shared publicationsA. A. Usikova
Russian Academy of Sciences
1 shared publication- Fedor Yu. Soldatenkov
Ioffe Institute
1 shared publication M. G. Rastegaeva
Russian Academy of Sciences
1 shared publication- Maxim Z. Shvarts
Ioffe Institute
1 shared publication
Latest Publications
- 17 September 2011
- Published by Pleiades Publishing Ltd in Semiconductors
- Vol. 45 (9) , 1219-1226
A decrease in ohmic losses and an increase in power in GaSb photovoltaic converters
The transmission-line model with radial and rectangular geometry of contact pads has been used to study the contact systems Cr-Au, Cr-Au-Ag-Au, Ti-Pt-Au, Pt-Ti-Pt-Au, Pt-Au, Ti-Au, Ti-Pt-Ag, Ti-Pt-Ag-Au, and Pt-Ag deposited on the p-GaSb surface by the methods of magnetron sputtering and resistive evaporation. It is established that the contact systems Ti-Pt-Ag-Au and Ti-Pt-Ag exhibit the smallest values of the specific contact resistance (ρ c ≤ 10−6 Ω cm2), which makes it possible to use these systems in fabrication of photovoltaic converters generating photocurrents with densities as high as 15 A/cm2.
- 17 September 2011
- Published by Pleiades Publishing Ltd in Semiconductors
- Vol. 45 (9) , 1219-1226
A decrease in ohmic losses and an increase in power in GaSb photovoltaic converters
The transmission-line model with radial and rectangular geometry of contact pads has been used to study the contact systems Cr-Au, Cr-Au-Ag-Au, Ti-Pt-Au, Pt-Ti-Pt-Au, Pt-Au, Ti-Au, Ti-Pt-Ag, Ti-Pt-Ag-Au, and Pt-Ag deposited on the p-GaSb surface by the methods of magnetron sputtering and resistive evaporation. It is established that the contact systems Ti-Pt-Ag-Au and Ti-Pt-Ag exhibit the smallest values of the specific contact resistance (ρ c ≤ 10−6 Ω cm2), which makes it possible to use these systems in fabrication of photovoltaic converters generating photocurrents with densities as high as 15 A/cm2.
- 6 May 2009
- Published by Pleiades Publishing Ltd in Semiconductors
- Vol. 43 (5) , 668-671
Solar cells based on gallium antimonide
Liquid-phase epitaxy and diffusion from the gas phase have been used to create various kinds of GaSb-based solar cell structures intended for use in cascaded solar-radiation converters. A narrow-gap (GaSb) solar cell was studied in tandem based on a combination of semiconductors GaAs-GaSb (two p-n junctions) and GaInP/GaAs-GaSb (three p-n junctions). The maximum efficiency of photovoltaic conversion in GaSb behind the wide-gap cells is η = 6.5% (at sunlight concentration ratio of 275X, AM1.5D Low AOD spectrum).
- 6 May 2009
- Published by Pleiades Publishing Ltd in Semiconductors
- Vol. 43 (5) , 668-671
Solar cells based on gallium antimonide
Liquid-phase epitaxy and diffusion from the gas phase have been used to create various kinds of GaSb-based solar cell structures intended for use in cascaded solar-radiation converters. A narrow-gap (GaSb) solar cell was studied in tandem based on a combination of semiconductors GaAs-GaSb (two p-n junctions) and GaInP/GaAs-GaSb (three p-n junctions). The maximum efficiency of photovoltaic conversion in GaSb behind the wide-gap cells is η = 6.5% (at sunlight concentration ratio of 275X, AM1.5D Low AOD spectrum).