Daehoon Na
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Daehoon Na has a total of 34 co-authors. Here are the top co-authors by number of shared publications:
- Jeongeun Song
Seoul National University
2 shared publications - Jin-Seok Heo
Seoul National University
2 shared publications - Kahyun Kim
Seoul National University
2 shared publications - Woo-Seok Choi
Seoul National University
2 shared publications Anil Kavala
Samsung Electronics, Hwaseong 18448, South Korea
1 shared publicationByung-Kwan Chun
Samsung Electronics, Hwaseong 18448, South Korea
1 shared publication
Latest Publications
- 23 October 2025
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Journal of Solid-State Circuits
- Vol. 61 (1) , 267-280
A 42-Gb/s Noise-Tolerant Single-Ended Clock-Referenced PAM3 Transceiver for Chiplet Interfaces
This article describes a single-ended (SE) clock-referenced PAM3 (CR-PAM3) transceiver that achieves an energy efficiency of 0.275 pJ/b at a high data rate of 42 Gb/s. The proposed CR-PAM3 signaling provides tolerance to supply noise and reference offset in SE chiplet or die-to-die (D2D) interfaces by using forwarded clock as reference voltages instead of generating them at the RX side. To minimize power consumption for PAM3, a differentially weighted data driver is employed. The proposed XTC-combined FS-puller helps voltage level transition while canceling FEXT from adjacent channels. A decision feedback equalizer (DFE)-embedded sampler enables low-power feedback within 1 UI by eliminating the CML summer structure and directly adding a tap branch to the sampler. A digital on-chip foreground training sequence is used to sequentially train TX per-lane deskew, clock swing level, and RX quadrature error corrector (QEC). Six data lanes, two clock lanes, and one replica lane for testing are implemented using an on-chip 2-mm channel in a 28-nm CMOS technology. In the presence of 200-mVpp 120-MHz sinusoidal supply noise injected at TX, horizontal and vertical eyes with CR-PAM3 are measured as 0.34 UI and 121 mV at BER $\lt 10^{-12}$ , while the conventional PAM3 eye is closed.
- 23 October 2025
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Journal of Solid-State Circuits
- Vol. 61 (1) , 267-280
A 42-Gb/s Noise-Tolerant Single-Ended Clock-Referenced PAM3 Transceiver for Chiplet Interfaces
This article describes a single-ended (SE) clock-referenced PAM3 (CR-PAM3) transceiver that achieves an energy efficiency of 0.275 pJ/b at a high data rate of 42 Gb/s. The proposed CR-PAM3 signaling provides tolerance to supply noise and reference offset in SE chiplet or die-to-die (D2D) interfaces by using forwarded clock as reference voltages instead of generating them at the RX side. To minimize power consumption for PAM3, a differentially weighted data driver is employed. The proposed XTC-combined FS-puller helps voltage level transition while canceling FEXT from adjacent channels. A decision feedback equalizer (DFE)-embedded sampler enables low-power feedback within 1 UI by eliminating the CML summer structure and directly adding a tap branch to the sampler. A digital on-chip foreground training sequence is used to sequentially train TX per-lane deskew, clock swing level, and RX quadrature error corrector (QEC). Six data lanes, two clock lanes, and one replica lane for testing are implemented using an on-chip 2-mm channel in a 28-nm CMOS technology. In the presence of 200-mVpp 120-MHz sinusoidal supply noise injected at TX, horizontal and vertical eyes with CR-PAM3 are measured as 0.34 UI and 121 mV at BER $\lt 10^{-12}$ , while the conventional PAM3 eye is closed.
- Open Access
- 12 July 2024
- Published by Institution of Engineering and Technology (IET) in Electronics Letters
- Vol. 60 (14)
A 20‐Gb/s 4‐tap time‐domain DFE with pulse width modulation for a DQ‐DQS matched parallel receiver
A 4‐tap time‐domain decision feedback equalizer (TD‐DFE) is presented to implement a multi‐tap DFE in a matched DQ (data)‐DQS (strobe) tree architecture. Traditionally, matched architecture holds an advantage in terms of power noise immunity, but it suffers from low‐speed performance due to the unavailability of decision feedback equalizer (DFE) applications. By adopting the proposed TD‐DFE, both high‐speed operation and power noise immunity can be achieved within the matched architecture. An 8‐DQ parallel receiver with the proposed 4‐tap TD‐DFE, designed in 28 nm CMOS, achieves a data rate of 20 Gb/s with 0.6 UI eye‐opening even with 215 mV power fluctuations.
- 12 July 2024
- Published by Institution of Engineering and Technology (IET) in Electronics Letters
- Vol. 60 (14)
Open AccessA 20‐Gb/s 4‐tap time‐domain DFE with pulse width modulation for a DQ‐DQS matched parallel receiver
A 4‐tap time‐domain decision feedback equalizer (TD‐DFE) is presented to implement a multi‐tap DFE in a matched DQ (data)‐DQS (strobe) tree architecture. Traditionally, matched architecture holds an advantage in terms of power noise immunity, but it suffers from low‐speed performance due to the unavailability of decision feedback equalizer (DFE) applications. By adopting the proposed TD‐DFE, both high‐speed operation and power noise immunity can be achieved within the matched architecture. An 8‐DQ parallel receiver with the proposed 4‐tap TD‐DFE, designed in 28 nm CMOS, achieves a data rate of 20 Gb/s with 0.6 UI eye‐opening even with 215 mV power fluctuations.
- 2 February 2021
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Journal of Solid-State Circuits
- Vol. 56 (4) , 1129-1140
A 1.8-Gb/s/Pin 16-Tb NAND Flash Memory Multi-Chip Package With F-Chip for High-Performance and High-Capacity Storage
This article presents a 1.2-V, 1.8-Gb/s/pin 16-Tb NAND flash memory multi-chip package incorporating 16 dies of 1-Tb NAND flash memory and the third-generation F-chip. The proposed third-generation F-chip is developed to meet the performance requirements of a high-capacity storage device that adopts a PCIe Gen four-host interface for higher data throughput. It is implemented with dual bi-directional transceiver architecture and signal retiming scheme to maximize the valid data window opening on solid-state drive (SSD) channels. Also, it facilitates training between F-chip and NAND using an on-chip delay-locked loop whose locking is proposed in strobe-based NAND systems to achieve sufficient signal integrity (SI) of the in-package channel at a speed of 1.8 Gb/s/pin. Embedded built-in self-test evaluates un-selected paths and determines if re-training is required without losing data throughput performance. This work achieves a 35% improvement in the I/O operational speed performance and a 23% reduction in the I/O power consumption in comparison with the previous generations.
- 2 February 2021
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Journal of Solid-State Circuits
- Vol. 56 (4) , 1129-1140
A 1.8-Gb/s/Pin 16-Tb NAND Flash Memory Multi-Chip Package With F-Chip for High-Performance and High-Capacity Storage
This article presents a 1.2-V, 1.8-Gb/s/pin 16-Tb NAND flash memory multi-chip package incorporating 16 dies of 1-Tb NAND flash memory and the third-generation F-chip. The proposed third-generation F-chip is developed to meet the performance requirements of a high-capacity storage device that adopts a PCIe Gen four-host interface for higher data throughput. It is implemented with dual bi-directional transceiver architecture and signal retiming scheme to maximize the valid data window opening on solid-state drive (SSD) channels. Also, it facilitates training between F-chip and NAND using an on-chip delay-locked loop whose locking is proposed in strobe-based NAND systems to achieve sufficient signal integrity (SI) of the in-package channel at a speed of 1.8 Gb/s/pin. Embedded built-in self-test evaluates un-selected paths and determines if re-training is required without losing data throughput performance. This work achieves a 35% improvement in the I/O operational speed performance and a 23% reduction in the I/O power consumption in comparison with the previous generations.