Elisa Oliveira da Costa
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Elisa Oliveira da Costa has a total of 27 co-authors. Here are the top co-authors by number of shared publications:
Maria de Fátima Bitencourt
3 shared publications- Barbara Eva Kunz
The Open University, School of Environment, Earth and Ecosystem Sciences, Milton Keynes, UK
2 shared publications Jiří Konopásek
2 shared publications- Leo M. Kriegsman
National Museum of Natural History/Naturalis, PO Box 9517, NL‐2300 RA Leiden, The Netherlands
2 shared publications - Nicolas Riel
Institute of Geosciences, Johannes Gutenberg University, Mainz, Germany
2 shared publications - Boris J. P. Kaus
Institute of Geosciences, Johannes Gutenberg University Mainz, Mainz, Germany
1 shared publication
Latest Publications
- Open Access
- 2 July 2026
- Published by American Geophysical Union (AGU) in Geochemistry, Geophysics, Geosystems
- Vol. 27 (7)
Thermodynamic Modeling of Lithium Enrichment During Partial Melting: The Importance of Partition Coefficients
Predicting the partial melting conditions that generate Li‐rich peraluminous melts is of major economic and societal importance. However, existing models disagree on the optimal conditions (e.g., pressure, temperature, protolith) and, consequently, on targets for exploration. A key source of divergence in model outcomes lies in the choices of partition coefficients used to describe lithium distribution between minerals and melt . Here, we use thermodynamic modeling to simulate isobaric stepwise partial melting of a global compilation of pelite compositions, at crustal pressures and considering variable water saturation and melt extraction thresholds, to calculate melt lithium enrichment predicted by four recently published sets. Our results quantify the conditions that maximize lithium enrichment. Depending on choices, the predicted optimal conditions range from high‐pressure, low‐temperature melting of wacke‐like compositions, to intermediate‐pressure, high‐temperature melting of both wacke‐ and shale‐like compositions, or in some cases show limited sensitivity to these parameters. Among these scenarios, the intermediate‐pressure, high‐temperature melting regimes (associated with biotite breakdown) are most consistent with existing geological and geochemical evidence from lithium‐rich granite and pegmatites. Such behavior is produced when lithium is treated as strongly compatible in biotite relative to other minerals, such as is thought to be the case in fluorinated biotite. Moving forward, pressure‐, temperature‐, and composition‐dependent lithium partitioning models—such as recently developed for biotite—will be crucial to accurately evaluate Li behavior in anatectic systems.
- 2 July 2026
- Published by American Geophysical Union (AGU) in Geochemistry, Geophysics, Geosystems
- Vol. 27 (7)
Open AccessThermodynamic Modeling of Lithium Enrichment During Partial Melting: The Importance of Partition Coefficients
Predicting the partial melting conditions that generate Li‐rich peraluminous melts is of major economic and societal importance. However, existing models disagree on the optimal conditions (e.g., pressure, temperature, protolith) and, consequently, on targets for exploration. A key source of divergence in model outcomes lies in the choices of partition coefficients used to describe lithium distribution between minerals and melt . Here, we use thermodynamic modeling to simulate isobaric stepwise partial melting of a global compilation of pelite compositions, at crustal pressures and considering variable water saturation and melt extraction thresholds, to calculate melt lithium enrichment predicted by four recently published sets. Our results quantify the conditions that maximize lithium enrichment. Depending on choices, the predicted optimal conditions range from high‐pressure, low‐temperature melting of wacke‐like compositions, to intermediate‐pressure, high‐temperature melting of both wacke‐ and shale‐like compositions, or in some cases show limited sensitivity to these parameters. Among these scenarios, the intermediate‐pressure, high‐temperature melting regimes (associated with biotite breakdown) are most consistent with existing geological and geochemical evidence from lithium‐rich granite and pegmatites. Such behavior is produced when lithium is treated as strongly compatible in biotite relative to other minerals, such as is thought to be the case in fluorinated biotite. Moving forward, pressure‐, temperature‐, and composition‐dependent lithium partitioning models—such as recently developed for biotite—will be crucial to accurately evaluate Li behavior in anatectic systems.
- Open Access
- 15 July 2025
- Published by Springer Nature in Research Square
Lithium mobilisation during metapelite melting: insights and open questions
The growing demand for Lithium – due to its use in modern economies and green energy – is prompting closer examination of all geological processes that control Li mobilisation. For example, while studies on the genesis of enriched peraluminous granitoids and pegmatites have traditionally focused on the final magmatic-hydrothermal stages of enrichment, recent studies have addressed how the preceding metapelite melting stage controls Li mobilisation. However, these studies employed different partition coefficients to estimate Li fluxes and thus predict contrasting Li behaviour. In this study, we investigate Li mobilisation during metapelite melting by comparing experimental and natural examples (starting compositions, partition coefficients and in-situ mineral concentrations) with equilibrium melting models. Melting models based on experimental partition coefficients predict that biotite-dehydration melting producing either peritectic garnet or cordierite generates more enriched melts; however, the model predicted concentrations in cordierite are lower, and concentrations in muscovite are higher than those observed in nature. In contrast, equilibrium melting models based on natural partition coefficients suggest that initial muscovite melts will be more enriched, and biotite-dehydration melts more enriched, if formed with peritectic garnet (as cordierite sequesters Li). In addition, the lack of temperature-dependent partition coefficients fails to optimally reproduce natural mineral concentration trends. Based on the comparison of experiments and natural examples, we suggest that Li behaviour during equilibrium melting is affected by protolith and mineral major element compositions, particularly water and fluorine contents.
- 15 July 2025
- Published by Springer Nature in Research Square
Open AccessLithium mobilisation during metapelite melting: insights and open questions
The growing demand for Lithium – due to its use in modern economies and green energy – is prompting closer examination of all geological processes that control Li mobilisation. For example, while studies on the genesis of enriched peraluminous granitoids and pegmatites have traditionally focused on the final magmatic-hydrothermal stages of enrichment, recent studies have addressed how the preceding metapelite melting stage controls Li mobilisation. However, these studies employed different partition coefficients to estimate Li fluxes and thus predict contrasting Li behaviour. In this study, we investigate Li mobilisation during metapelite melting by comparing experimental and natural examples (starting compositions, partition coefficients and in-situ mineral concentrations) with equilibrium melting models. Melting models based on experimental partition coefficients predict that biotite-dehydration melting producing either peritectic garnet or cordierite generates more enriched melts; however, the model predicted concentrations in cordierite are lower, and concentrations in muscovite are higher than those observed in nature. In contrast, equilibrium melting models based on natural partition coefficients suggest that initial muscovite melts will be more enriched, and biotite-dehydration melts more enriched, if formed with peritectic garnet (as cordierite sequesters Li). In addition, the lack of temperature-dependent partition coefficients fails to optimally reproduce natural mineral concentration trends. Based on the comparison of experiments and natural examples, we suggest that Li behaviour during equilibrium melting is affected by protolith and mineral major element compositions, particularly water and fluorine contents.
- Open Access
- 18 March 2025
- Published by Copernicus GmbH
Lithium behaviour during partial melting
Lithium has been receiving increased attention due to its relevance to the green energy transition and increasing demand. One of the main sources of Li is peraluminous granitoids and pegmatites. Current models for the genesis of such enriched lithologies include the fractional crystallisation of melts derived from sedimentary protoliths (e.g., Linnen et al., 2012); the low-volume melting of Li-rich protoliths (e.g., Shaw et al., 2016); and the subsequent re-melting of S-type orthogneisses (Ballouard et al., 2024; Koopmans et al., 2024). Hence, understanding the behaviour of Li during partial melting is critical, regardless of the preferred model. However, modelling studies have shown contrasting trends in melt Li concentrations during partial melting reactions due to the use of different distribution coefficient sets (Ballouard et al., 2024; Koopmans et al., 2024). In this study, we coupled existing and newly acquired mineral Li concentration data from high-grade terranes, and phase equilibria and trace element modelling to improve our understanding of Li behaviour during partial melting. Our main results highlight that: (1) when present cordierite is the main mineral host of Li in metapelitic migmatites; and (2) the experimentally observed temperature-dependent variation of cordierite Li concentrations (Evensen and London, 2003) is also observed in natural samples, but – as expected – with different concentrations levels. Moreover, our results show that the mineral distribution coefficients of natural samples do not match experimentally derived Li distribution coefficients for cordierite and biotite. We discuss possible reasons for divergent distribution coefficients based on the comparison of physicochemical parameters associated with these distribution coefficients and typical high-grade metapelites. Our findings also indicate that low-pressure melting with peritectic cordierite will suppress melt Li concentrations, in agreement with Ballouard et al. (2024). This study highlights how metamorphic minerals and melting conditions affect Li behaviour during partial melting. Moreover, our findings and discussion highlight that further experimental and natural constraints on Li distribution coefficients are necessary for a precise understanding of how Li is mobilised during metapelite melting. References:Ballouard et al. (2024) Contrib to Min and Petr 178(11), 75Evensen and London (2003) Contrib to Min and Petr 144, 739-757Koopmans et al. (2024) Geology 52(1), 7-11Linnen et al (2012) Elements 8(4), 275-280Shaw et al. (2016) Precamb Res 281, 338-362 This project has received funding from the European Union’s Horizon 2020 research and innovation programme under the Marie Skłodowska-Curie grant agreement no. 956125.
- 18 March 2025
- Published by Copernicus GmbH
Open AccessLithium behaviour during partial melting
Lithium has been receiving increased attention due to its relevance to the green energy transition and increasing demand. One of the main sources of Li is peraluminous granitoids and pegmatites. Current models for the genesis of such enriched lithologies include the fractional crystallisation of melts derived from sedimentary protoliths (e.g., Linnen et al., 2012); the low-volume melting of Li-rich protoliths (e.g., Shaw et al., 2016); and the subsequent re-melting of S-type orthogneisses (Ballouard et al., 2024; Koopmans et al., 2024). Hence, understanding the behaviour of Li during partial melting is critical, regardless of the preferred model. However, modelling studies have shown contrasting trends in melt Li concentrations during partial melting reactions due to the use of different distribution coefficient sets (Ballouard et al., 2024; Koopmans et al., 2024). In this study, we coupled existing and newly acquired mineral Li concentration data from high-grade terranes, and phase equilibria and trace element modelling to improve our understanding of Li behaviour during partial melting. Our main results highlight that: (1) when present cordierite is the main mineral host of Li in metapelitic migmatites; and (2) the experimentally observed temperature-dependent variation of cordierite Li concentrations (Evensen and London, 2003) is also observed in natural samples, but – as expected – with different concentrations levels. Moreover, our results show that the mineral distribution coefficients of natural samples do not match experimentally derived Li distribution coefficients for cordierite and biotite. We discuss possible reasons for divergent distribution coefficients based on the comparison of physicochemical parameters associated with these distribution coefficients and typical high-grade metapelites. Our findings also indicate that low-pressure melting with peritectic cordierite will suppress melt Li concentrations, in agreement with Ballouard et al. (2024). This study highlights how metamorphic minerals and melting conditions affect Li behaviour during partial melting. Moreover, our findings and discussion highlight that further experimental and natural constraints on Li distribution coefficients are necessary for a precise understanding of how Li is mobilised during metapelite melting. References:Ballouard et al. (2024) Contrib to Min and Petr 178(11), 75Evensen and London (2003) Contrib to Min and Petr 144, 739-757Koopmans et al. (2024) Geology 52(1), 7-11Linnen et al (2012) Elements 8(4), 275-280Shaw et al. (2016) Precamb Res 281, 338-362 This project has received funding from the European Union’s Horizon 2020 research and innovation programme under the Marie Skłodowska-Curie grant agreement no. 956125.
- 20 August 2018
- Published by Universidade Federal do Rio de Janeiro in Anuário do Instituto de Geociências
- Vol. 41 (2) , 710-719
Lysocline and CCD Fluctuations Record in Pelotas Basin During the Late Quaternary
- 20 August 2018
- Published by Universidade Federal do Rio de Janeiro in Anuário do Instituto de Geociências
- Vol. 41 (2) , 710-719
Lysocline and CCD Fluctuations Record in Pelotas Basin During the Late Quaternary