Hui Yang
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Hui Yang has a total of 32 co-authors. Here are the top co-authors by number of shared publications:
- Anlin Yi
Southwest Jiaotong University
4 shared publications - Lianshan Yan
Southwest Jiaotong University
4 shared publications - Xihua Zou
Southwest Jiaotong University
4 shared publications - Lin Jiang
Southwest Jiaotong University
3 shared publications Anlin Yi
Southwest Jiaotong Univ, Sch Informat Sci & Technol, Chengdu 610031, Peoples R China
2 shared publications- Lu Zhang
Southwest Jiaotong University
2 shared publications
Latest Publications
- 1 September 2026
- Published by Institute of Electrical and Electronics Engineers (IEEE) in Journal of Lightwave Technology
- Vol. 44 (18) , 8084-8091
Low-Complexity Linear Optical Field Reconstruction via Time-Domain Tri-Phase-Shift Self-Coherent Detection
- 1 September 2026
- Published by Institute of Electrical and Electronics Engineers (IEEE) in Journal of Lightwave Technology
- Vol. 44 (18) , 8084-8091
Low-Complexity Linear Optical Field Reconstruction via Time-Domain Tri-Phase-Shift Self-Coherent Detection
- Open Access
- 1 August 2026
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Photonics Journal
- Vol. 18 (4) , 7900707
Low-Complexity Self-Coherent Optical Transmission Scheme Based on Dual-Fiber Differential Detection
- 1 August 2026
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Photonics Journal
- Vol. 18 (4) , 7900707
Open AccessLow-Complexity Self-Coherent Optical Transmission Scheme Based on Dual-Fiber Differential Detection
- 4 December 2025
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Microwave Theory and Techniques
- Vol. 74 (3) , 2773-2781
Microwave Covert Communication System Enabled by Dual Optical Frequency Combs for Ultrawideband Spectrum Spreading and Despreading
Spread-spectrum-based covert communication has attracted significant attention for implementing high-security communication systems, due to the large available bandwidth and the superior anti-interception capabilities. However, conventional electronic spread-spectrum techniques usually suffer from inherent bandwidth limitations of the electronic bottleneck. Here, a microwave covert communication system enabled by dual optical frequency combs (OFCs) is proposed for ultrawideband spectrum spreading and despreading. By integrating the direct-sequence spread spectrum (DSSS) in the digital domain with the analog phase-coded spread spectrum generated by dual OFCs in the optical domain, the bandwidth constraints of traditional electronic approaches are effectively mitigated. An ultrawideband microwave signal with a 9.6-GHz bandwidth and a spreading factor up to 1500 is generated successfully. As a result, a time-domain peak-to-average power ratio (PAPR) of 12.5 dB and a frequency-domain flatness of less than 5 dB are achieved, thereby enabling exceptional concealment in both time and frequency domains. At the receiver, an optical predespreading unit and a digital postprocessing unit, together with phase precompensation and clock synchronization, are codesigned to achieve a stable gain of 26.7 dB. Furthermore, under a signal-to-noise ratio (SNR) of −18 dB, the system maintains reliable demodulation performance with a bit error rate (BER) below $3.8\times 10^{-3}$ (threshold of the 7% preforward error correction). Overall, the proposed system has successfully demonstrated significant specifications for covert communications.
- 4 December 2025
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Microwave Theory and Techniques
- Vol. 74 (3) , 2773-2781
Microwave Covert Communication System Enabled by Dual Optical Frequency Combs for Ultrawideband Spectrum Spreading and Despreading
Spread-spectrum-based covert communication has attracted significant attention for implementing high-security communication systems, due to the large available bandwidth and the superior anti-interception capabilities. However, conventional electronic spread-spectrum techniques usually suffer from inherent bandwidth limitations of the electronic bottleneck. Here, a microwave covert communication system enabled by dual optical frequency combs (OFCs) is proposed for ultrawideband spectrum spreading and despreading. By integrating the direct-sequence spread spectrum (DSSS) in the digital domain with the analog phase-coded spread spectrum generated by dual OFCs in the optical domain, the bandwidth constraints of traditional electronic approaches are effectively mitigated. An ultrawideband microwave signal with a 9.6-GHz bandwidth and a spreading factor up to 1500 is generated successfully. As a result, a time-domain peak-to-average power ratio (PAPR) of 12.5 dB and a frequency-domain flatness of less than 5 dB are achieved, thereby enabling exceptional concealment in both time and frequency domains. At the receiver, an optical predespreading unit and a digital postprocessing unit, together with phase precompensation and clock synchronization, are codesigned to achieve a stable gain of 26.7 dB. Furthermore, under a signal-to-noise ratio (SNR) of −18 dB, the system maintains reliable demodulation performance with a bit error rate (BER) below $3.8\times 10^{-3}$ (threshold of the 7% preforward error correction). Overall, the proposed system has successfully demonstrated significant specifications for covert communications.
- 10 October 2024
- Published by Elsevier in Optical Fiber Technology
- Vol. 88
An OSNR monitoring scheme for elastic optical networks with probabilistic shaping
- 10 October 2024
- Published by Elsevier in Optical Fiber Technology
- Vol. 88
An OSNR monitoring scheme for elastic optical networks with probabilistic shaping
- Open Access
- 19 July 2022
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Photonics Journal
- Vol. 14 (4) , 1-8
Comparison of DC-Value Method and Kramers–Kronig Receiver in Optical OFDM SSB-DD Transmission
Short reach optical communications are desperate for cost-effective solutions to improve capacity and compatibility in dealing with massive access and applications. Single sideband-direct detection (SSB-DD) is highly recognized for improving capacity with single PD, but it is confronted with signal-signal beating interference (SSBI). Recently, a DC-Value method has been proposed for optical signal phase retrieval for single carrier signal transmission. To further explore the effectiveness and compatibility of DC-Value method, in this letter for the first time, the orthogonal frequency division multiplexing (OFDM)-based multi-carrier modulation formats are processed by the DC-Value method in the receiver. Simulation results demonstrate that, for both OFDM and Nyquist-shaped single carrier (SC), the DC-Value method is beneficial in applying lower sampling rate to achieve comparable transmission performance than that of Kramers-Kronig receiver. In addition, althrough OFDM holds 2 dB increment of the optimum carrier-signal power ratio (CSPR) than Nyquist-SC, it offers more robustness to fibre transmission.
- 19 July 2022
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Photonics Journal
- Vol. 14 (4) , 1-8
Open AccessComparison of DC-Value Method and Kramers–Kronig Receiver in Optical OFDM SSB-DD Transmission
Short reach optical communications are desperate for cost-effective solutions to improve capacity and compatibility in dealing with massive access and applications. Single sideband-direct detection (SSB-DD) is highly recognized for improving capacity with single PD, but it is confronted with signal-signal beating interference (SSBI). Recently, a DC-Value method has been proposed for optical signal phase retrieval for single carrier signal transmission. To further explore the effectiveness and compatibility of DC-Value method, in this letter for the first time, the orthogonal frequency division multiplexing (OFDM)-based multi-carrier modulation formats are processed by the DC-Value method in the receiver. Simulation results demonstrate that, for both OFDM and Nyquist-shaped single carrier (SC), the DC-Value method is beneficial in applying lower sampling rate to achieve comparable transmission performance than that of Kramers-Kronig receiver. In addition, althrough OFDM holds 2 dB increment of the optimum carrier-signal power ratio (CSPR) than Nyquist-SC, it offers more robustness to fibre transmission.
- Open Access
- 16 November 2021
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Photonics Journal
- Vol. 14 (1) , 1-6
Next-Generation Passive Optical Network Based on Sparse Code Multiple Access and Graph Neural Networks
Sparse code multiple access (SCMA) is a promising technology to provide high throughput and overall improved system performance at affordable cost for next-generation passive optical networks (NG-PONs). Message passing algorithm (MPA) based on a factor graph is usually used for low-complexity multi-user detection in SCMA. However, MPA requires accurate and effective channel estimation due to the interference between the user's signals on the same resource block and suffers uncertain convergence caused by the cycles in the factor graph. In this paper, a graph neural networks (GNN)-based detection method is proposed for SCMA-PON, which performs channel impairment compensation and signal detection in a joint manner. 25.5 Gb/s SCMA-OFDM system over 20/60 km single mode fiber link is simulated to demonstrate the feasibility with 8.5-G class optical devices. The simulation results show that GNN-based detection method outperforms MPA and is more robust to the nonlinear distortion for the same level of computational complexity.
- 16 November 2021
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Photonics Journal
- Vol. 14 (1) , 1-6
Open AccessNext-Generation Passive Optical Network Based on Sparse Code Multiple Access and Graph Neural Networks
Sparse code multiple access (SCMA) is a promising technology to provide high throughput and overall improved system performance at affordable cost for next-generation passive optical networks (NG-PONs). Message passing algorithm (MPA) based on a factor graph is usually used for low-complexity multi-user detection in SCMA. However, MPA requires accurate and effective channel estimation due to the interference between the user's signals on the same resource block and suffers uncertain convergence caused by the cycles in the factor graph. In this paper, a graph neural networks (GNN)-based detection method is proposed for SCMA-PON, which performs channel impairment compensation and signal detection in a joint manner. 25.5 Gb/s SCMA-OFDM system over 20/60 km single mode fiber link is simulated to demonstrate the feasibility with 8.5-G class optical devices. The simulation results show that GNN-based detection method outperforms MPA and is more robust to the nonlinear distortion for the same level of computational complexity.
- 1 June 2021
- Published by Elsevier in Optics Communications
- Vol. 489
A modified convolutional neural network-based signal demodulation method for direct detection OFDM/OQAM-PON
- 1 June 2021
- Published by Elsevier in Optics Communications
- Vol. 489
A modified convolutional neural network-based signal demodulation method for direct detection OFDM/OQAM-PON
- Open Access
- 1 June 2020
- Published by IOP Publishing in IOP Conference Series: Earth and Environmental Science
- Vol. 512 (1) , 012035
Study on the optimal operation of urban combineddrainage channel box
This paper optimizes the operation mode of the combined drainage channel box sluice in H river basin of a city in south China to solve the problem of frequent sluice opening.Based on the InfoWorks ICM software, the hydraulic model of drainage system of the river basin was established, the measured rainfall and liquid level were screened, the model parameters were determined by using the rainfall data of medium and heavy rain, and the model was verified by using the rainfall data of heavy rain. The optimal liquid level is obtained by analyzing and comparing the simulation results. The simulation results are basically consistent with the actual precipitation.After optimization, the optimal liquid level of the combined drainage channel box sluice gate increased by 0.8m compared with the manually operated maximum liquid level. After the operation mode of sluice is optimized, the annual sluice opening times are reduced by 78%. After the experience, the InfoWorks ICM hydraulic model has high reliability, and the optimal sluice opening liquid level can be obtained through simulation analysis, which can more effectively prevent waterlogging and reduce river pollution.
- 1 June 2020
- Published by IOP Publishing in IOP Conference Series: Earth and Environmental Science
- Vol. 512 (1) , 012035
Open AccessStudy on the optimal operation of urban combineddrainage channel box
This paper optimizes the operation mode of the combined drainage channel box sluice in H river basin of a city in south China to solve the problem of frequent sluice opening.Based on the InfoWorks ICM software, the hydraulic model of drainage system of the river basin was established, the measured rainfall and liquid level were screened, the model parameters were determined by using the rainfall data of medium and heavy rain, and the model was verified by using the rainfall data of heavy rain. The optimal liquid level is obtained by analyzing and comparing the simulation results. The simulation results are basically consistent with the actual precipitation.After optimization, the optimal liquid level of the combined drainage channel box sluice gate increased by 0.8m compared with the manually operated maximum liquid level. After the operation mode of sluice is optimized, the annual sluice opening times are reduced by 78%. After the experience, the InfoWorks ICM hydraulic model has high reliability, and the optimal sluice opening liquid level can be obtained through simulation analysis, which can more effectively prevent waterlogging and reduce river pollution.