Chuliang Liu

Generally speaking, vibration signals collected by sensors always contain complex frequency components, which will bring great trouble to bearing condition monitoring and fault diagnosis. A reliable fault signal component extraction method is significant to detect the fault-induced weak repetitive transients. Therefore, many signal decomposition or extraction methods have been developed and are widely employed in fault diagnosis. Based on the recently proposed variational mode extraction (VME) method, an adaptive optimal mode extraction method was designed with a new strategy to extract the mode center frequency and a novel indicator to optimize the balance parameter. The spectrum is first divided into several modes by enveloping curve fitting (ECF), and the center frequencies of each mode are extracted, respectively. All potential fault modes are then extracted sequentially utilizing the extracted center frequency and fixed balance parameter. For the extracted modes, the kurtosis index is applied to select the target mode. Finally, the relative amplitude ratio (RAR) index is used to adaptively adjust the balance parameter. The comparison results reveal that the adaptive mode extraction method can extract the weak fault feature under strong interference.

Helicopter tail rotors adopt a segmented driveline connected by flexible couplings, and dry friction dampers to suppress resonance. Modeling for this system can provide a basic foundation for parameter analysis. In this work, the lateral-torsional vibration equation of the shaft with continuous internal damping is established. The static and dynamic effects caused by flexible diaphragm couplings subject to parallel and angular misalignment is derived. A novel dual rub-impact model between the shaft and dry friction damper with multiple stages is proposed. Finally, a model of a helicopter tail rotor driveline incorporating all the above elements is formulated. Numerical simulations are carried out by an improved Adams–Bashforth method following the design flowchart. The dynamics of multiple vibration suppression, and the static and dynamic misalignment are analyzed to illustrate the accuracy and characteristics of the model. The coeffect of the rub impact and the misalignment on shafts and dampers are presented through the results of simulation and experiment. It provides an accurate and comprehensive mathematical model for the helicopter driveline. Response characteristics of multiple damping stages, static and dynamic misalignment, and their interaction are revealed.