CWCui Wang

Cui Wang

*This is an algorithmically generated author record based on publicly available information.

Cui Wang has a total of 33 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • A Composite Control Strategy for Buck Converter Based on LESO and MPC

    by Zhuo Wang, Yaofang Zhang, Cui Wang, Yupeng Xiang, Huimin Xiong

    For buck converters operating under variable load conditions, fast transient response characteristics and strong interference immunity are critical factors ensuring stable and reliable operation. To address the issues of response lag and insufficient interference immunity during load transients, this paper proposes a robust cascaded control scheme combining discrete‐time model predictive control (MPC) with an improved linear active disturbance rejection control (LADRC). To overcome the inherent bandwidth limitations and phase lag of conventional linear extended state observer (LESO), a differential feedforward path is introduced into the traditional LESO architecture. The improved LESO achieves faster load disturbance estimation while maintaining robust noise immunity. An efficient two‐step predictive MPC algorithm is employed in the inner loop to eliminate computational delays and ensure rapid current tracking. Rigorous discrete‐time stability analysis based on the Jury criterion and Lyapunov theory provides a theoretical foundation for parameter design. Experimental results validate that the proposed method significantly reduces voltage recovery time and overshoot under load transients, demonstrating superior robustness.


  • Space Vector Modulation With Common-Mode Voltage Reduction and Dead Zone Compensation for Cascaded H-Bridge Multilevel Converters

    by Wenjun Zeng, Guohua Zhou, Nengmou Xu, Yongjie Chen, Wei Wang, Cui Wang

    This article proposes two space vector modulation (SVM) methods to reduce common-mode voltage (CMV) and compensate for the effect of dead zones in cascaded H-bridge multilevel converters (CHBMC). Firstly, a zero CMV (ZCMV) SVM method is proposed to use reference phase signals to obtain optimal switching sequences, ZCMV switching states, and corresponding duty cycles by simple calculations and judgements. The proposed ZCMV SVM method can minimize switching frequency, reduce switching losses, and theoretically realize ZCMV output. Secondly, the dead zones in CHBMC and the effect of the dead zones on CMV and output waveforms are analyzed. A ZCMV with dead zone compensation (ZCMV-C) SVM method is proposed in this article. The ZCMV-C SVM method compensates for the asymmetrical output waveforms and CMV spikes caused by the dead zones, reduces the leakage current, and only requires simple calculations and judgements. Finally, compared with preceding methods, the proposed ZCMV SVM method requires the least computational time. Furthermore, the proposed two SVM methods can be extended to any level of converters without affecting the computational time. Simulations and experiments verify the effectiveness of the proposed two SVM methods.


  • A Control Strategy for Bidirectional DC–DC Converters Based on Switching Theory

    by Yaofang Zhang, Zhuo Wang, Cui Wang, Yupeng Xiang, Huimin Xiong, Jianbin Zhu

    Bidirectional DC–DC converters are critical components in modern power electronic systems, yet their performance under conventional control strategies is often limited by slow transient response and weak disturbance rejection. To overcome these limitations, this paper proposed a switching control strategy based on multiple Lyapunov functions. A hybrid switching system model is formulated to capture the converter dynamics across different operating modes, and a feasible Lyapunov solution is derived to characterize system stability. Building on this formulation, a mode‐dependent switching law is designed to guarantee asymptotic stability of the closed‐loop system. A MATLAB/Simulink‐based simulation model and a hardware experimental prototype are developed to validate the proposed approach. Both simulation and experimental results demonstrate that, compared with conventional PI control, the proposed strategy achieves substantially faster dynamic response and enhanced robustness against disturbances. Specifically, the response time is reduced from 50 to 20 ms while overshoot is completely eliminated from 25% to 0%. These results confirm the effectiveness and practical feasibility of the proposed switching control strategy.

  • SVPWM Strategy With Minimum Common-Mode Voltage for Multilevel Converter Combining the Concept of the Nearest Level

    by Cui Wang, Wenjun Zeng, Yeqin Wang, Qiangsheng Dai, Yunhe Wang, Xiaopin Yang

    Multilevel converters are widely used in medium- and high-voltage high-power industrial applications. Space vector pulsewidth modulation (SVPWM) is one of the very promising modulation strategies for multilevel converters. However, the SVPWM strategy is difficult to implement as the number of levels increases. The output common-mode voltage (CMV) of the converter is another problem in the implementation of SVPWM strategy. In this article, a new SVPWM strategy with minimum CMV for the multilevel converter is proposed by combining the concept of the nearest level. The proposed SVPWM strategy only utilizes simple arithmetic operations and logical judgments and completely avoids trigonometric functions and irrational number operations. Compared with the existing SVPWM methods, the proposed SVPWM strategy can quickly calculate the switching state with the minimum CMV in real time by the concept of the nearest level and avoids solving the nonhomogeneous linear equations in the process of calculating the switching state corresponding to the space vector. It can be extended to any level converter without additional computational burden. Finally, the proposed SVPWM strategy is verified with extensive simulation and experimental studies.


  • A Novel SVPWM Strategy for Multilevel Converters Based on Sector Triangle Numbering

    by Cui Wang, Changxue Li, Wanzheng Duan, Wenjun Zeng, Yunhe Wang, Yunmin Xie, Xinyu Liu

    In order to simplify the location of the reference vector, avoid calculating a large number of redundant switching states and selecting the optimal switching state, and apply the space vector modulation to any level converters, a novel space vector pulse width modulation (SVPWM) strategy based on sector triangle numbering for multilevel converters is proposed in this article. First, the reference vector located in the large sector $N$ is rotated clockwise to Sector I, and the numbers $T_{n}$ , $K$ , and $q$ of the small sector triangle where the rotated vector is located are calculated. Then, the three vertex vectors of the small sector triangle where the reference vector is located are directly calculated using $N$ , $T_{n}$ , $K$ , and $q$ to realize the reference vector location, which is a very simple reference vector location method. Next, the switching state corresponding to the space vector is calculated using the minimum common-mode voltage constraint, which does not need to calculate the redundant switching states and select the optimal switching state. The proposed SVPWM strategy is applicable to any level converters without increasing the calculation workload and has strong engineering applicability. Simulations and experiments verified the correctness and feasibility of the proposed SVPWM strategy.


  • SVPWM Strategy Based on the 45$^\circ$ Coordinates to Suppress Common-Mode Voltage for Multilevel Converters

    by Cui Wang, Wenjun Zeng, Yunhe Wang, Changxue Li, Wanzheng Duan, Xiaopin Yang, Yunmin Xie

    This paper proposes an optimized space vector pulse width modulation (SVPWM) strategy with minimum commonmode voltage (CMV). Compared with earlier SVPWM methods, the proposed optimized strategy is implemented in the 45° coordinates. Locating the sector triangle, calculating the duty cycles, and determining the switching sequences require only basic arithmetic operations, which greatly reduces the computational complexity. The switching state with minimum CMV corresponding to the space vector can be calculated directly. The proposed optimized modulation strategy effectively solves the problem that the traditional SVPWM is difficult to be implemented as the number of levels increases. It can be easily extended to any level converters without additional computational burden. Based on the proposed optimized SVPWM strategy with minimum CMV, the SVPWM strategy for eliminating CMV is proposed. The proposed SVPWM strategy for eliminating CMV improves the utilization of the redundant cells and reduces the THD of phase voltages without increasing the difficulty of implementing SVPWM algorithm. Finally, the proposed two SVPWM strategies are verified with extensive simulations and experiments.


  • Open Access

    A Dynamic-Weighted Attenuation Memory Extended Kalman Filter Algorithm and Its Application in the Underwater Positioning

    by Bo Guo, Jianye Ma, Cui Wang

    Extended Kalman filter (EKF) plays an important role in the acoustic signal processing of underwater positioning. However, accumulative errors and model inaccuracies lead to divergence. Then, attenuation memory EKF is created in response to this issue which needs to manually select all or part of the parameters. Thus, a dynamic-weighted attenuation memory EKF is proposed. Firstly, several underwater positioning simulations under different conditions are carried out. Results show, with the change of parameter conditions in positioning, the ideal attenuation coefficient changes between 0.5 and 1, but it is difficult to express it in function formula or statistical form. Secondly, a dynamic selection method of attenuation factor is designed. In the later contrast simulation, the proposed method has improved the positioning performance compared with the existing attenuation memory filter algorithm. Finally, the results of physical model verification experiment show that the dynamic-weighted attenuation memory EKF algorithm not only suppresses divergence better but also avoids the subjectivity of attenuation coefficient selection to a certain extent.


  • Space Vector Modulation in the 45° Coordinates α′β′ for Multilevel Converters

    by Cui Wang, Qing-Chang Zhong, Nengfei Zhu, Si-Zhe Chen, Xiao-Pin Yang

    Space vector modulation (SVM) strategy is widely used in two-level and three-level converters because of its advantages. However, the sector triangles, switching states, and switching sequences increase dramatically as the number of levels increases, which makes it difficult to implement the SVM algorithm in industrial applications of high-voltage and high-power multilevel converters. To extend the SVM strategy to high-voltage and high-power converters, a new SVM algorithm is proposed in the paper with the 45° coordinates α'β'. In the α'β' coordinates, based on the relationship between the phase voltage and the line voltage of a star-connected converter, the reference vectors calculated from phase-voltage reference signals are directly used as line-voltage reference vectors. Moreover, two line-voltage levels are used as two components of the space vector, with the sum of these two components being the third line-voltage level. These three components are directly used as the switching state signals of the control line voltages. The proposed method avoids the 2/3 conversion which must be completed in the conventional SVM algorithm and does not need to calculate redundant switching states. It greatly simplifies the SVM algorithm and ensures that the common-mode voltage of the converter is zero. Finally, the proposed algorithm is validated with extensive experimental results.


  • Open Access

    Wind Turbine Lubrication Based on Parallel Control of Multiple Factors

    by Xiaopin Yang, Xinyu Liu, Guiyue Kou, Chunxia Xu, Wenhua Zhang, Rui Hu, Cui Wang, Zhiying Zhao

    The lubrication needs of wind turbines vary with the operating conditions. To provide a dynamic lubrication scheme for wind turbines under variable conditions, this paper designs a dynamically adjustable lubrication scheme through parallel control of multiple influencing factors. Based on mid- and long-term loads, the proposed scheme fully considers the influence of various sudden changes in addition to slowly changing factors like load, operating hours, and speed, such as to dynamically adjust the injection flow as per the specific operating condition of the turbine. The ideal lubrication effect was tracked through the adjustment of the injection flow or injection time, and used to determine the optimal dynamic lubrication control strategy during turbine operation. The proposed control strategy overcomes the defects of the traditional fixed-time fixed-flow lubrication approach, and provides reasonable on-demand lubrication schemes for wind turbines in different operating conditions. The on-demand injection of lubricant prevents under- or over-lubrication, reduces the rate of mechanical failure, and extends the service life of wind turbines. Suffice it to say that the proposed control strategy can lower power generation cost and save energy, making wind turbines more profitable.