Christoph Clemens

Measuring weather data in an urban environment is an important task on the journey towards smart cities. Heavy rain can cause flooding in cities and prevent emergency services from reaching their destination because roads or underpasses are blocked. In order to provide a high-resolution site-specific overview in urban areas during heavy rainfall, a dense measurement network is necessary. To achieve this, a smart low-cost rain gauge is needed. In this paper, the current status of the development of an inductive rain gauge is presented. The sensor is based on the eddy current principle and evaluates the frequency of an electrical resonant circuit. For this purpose, a coil is placed under a metal plate. When raindrops hit the plate, it starts to oscillate, which changes the distance to the coil accordingly and causes changes in the frequency of the resonant circuit. Since the sensor is cost-effective, operates self-sufficiently in terms of energy and transmits data wirelessly via LoRaWAN, it can be used flexibly. This enables dense, area-wide coverage over the urban area of interest. The first experimental investigations show a correlation between the size of the rain droplets and the frequency change. Small droplets cause a shift of about 8 kHz and larger droplets of up to 40 kHz. The results prove that raindrops can be detected and categorized using this measurement principle. These data will be used as a basis for future work on calculating precipitation.

Measurement of soil parameters, such as moisture, density and density change, can provide important information for evaluating the stability of earthwork structures and for structural health monitoring. To ensure the stability of flood protection dikes, erosion at the contact zones of different soil zones must be avoided. In this work we propose the use of impedance spectroscopy to measure changes in density and volume caused by contact erosion. Erosion leads generally to a volume decrease in the contact zones between soils with different grain sizes and, consequently, to cavities in the dike structure. For this purpose, a proctor mould was developed for emulating contact erosion and the realisation of impedance measurements. Experimental investigations show a correlation between volume change of the soils in the proctor mould and impedance value. For a volume change of soil in the range of approximately 1.5% to 5.3%, an impedance change arises in the range of 17.2% to 29.8%. With several investigations we proof, that it is possible to detect material transport by impedance spectroscopy.