Miloud Ibrir
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Miloud Ibrir has a total of 51 co-authors. Here are the top co-authors by number of shared publications:
- Saadi Berri
Faculty of Science, University of M’Sila, M’sila, Algeria
10 shared publications R. Bensalem
5 shared publications- Safia Alleg
Laboratory of Magnetism and Spectroscopy of Solids (LM2S), Department of Physics, Badji Mokhtar - Annaba University, Annaba, Algeria
5 shared publications D. Maouche
University of Setif 1
4 shared publicationsDjamel Maouche
4 shared publications- J.J. Suñol
Dep. de Fisica, Universitat de Girona, Girona, Spain
4 shared publications
Latest Publications
- 1 September 2026
- Published by American Vacuum Society in Journal of Vacuum Science & Technology B
- Vol. 44 (5)
Review of the fundamental principles of the optoelectronic characteristics of quaternary alloys InxAl1−xAsySb1−y lattice-matched to the InP crystal lattice
We performed a comprehensive theoretical analysis of the structural and optoelectronic properties of quaternary alloys with the formula InxAl1−xAsySb1−y. These alloys were designed to be lattice-matched to InP substrates. The study employed the full-potential linearized augmented plane-wave (FP − LAPW) method within the framework of density functional theory. We used the local density approximation (LDA) and the Wu–Cohen generalized gradient approximation (GGA − WC) to determine the structural parameters. This allowed us to identify the exact (x, y) composition ranges ensuring lattice compatibility with that of InP. The estimated lattice constants for all compositions studied were approximately 5.916 Å, a value very close to the lattice constant observed for InP (5.869 Å). The Tran–Blaha modified Becke–Johnson (TB − mBJ) potential was employed to perform the electronic-structure calculations. The results of these calculations indicated that, across all investigated indium and arsenic concentrations, the InxAl1−xAsySb1−y quaternary alloys retain their direct bandgap semiconductor character, while the calculated bandgap values exhibit a nonmonotonic dependence on alloy composition. We carefully examined their optical properties. The investigated compositions exhibit optical responses spanning the wavelength range from 642 to 803 nm, with a nonmonotonic dependence on alloy composition, while maintaining compatibility with the InP substrate lattice. These results suggest that the InxAl1−xAsySb1−y quaternary alloys could be promising candidates for photovoltaic applications.
- 1 September 2026
- Published by American Vacuum Society in Journal of Vacuum Science & Technology B
- Vol. 44 (5)
Review of the fundamental principles of the optoelectronic characteristics of quaternary alloys InxAl1−xAsySb1−y lattice-matched to the InP crystal lattice
We performed a comprehensive theoretical analysis of the structural and optoelectronic properties of quaternary alloys with the formula InxAl1−xAsySb1−y. These alloys were designed to be lattice-matched to InP substrates. The study employed the full-potential linearized augmented plane-wave (FP − LAPW) method within the framework of density functional theory. We used the local density approximation (LDA) and the Wu–Cohen generalized gradient approximation (GGA − WC) to determine the structural parameters. This allowed us to identify the exact (x, y) composition ranges ensuring lattice compatibility with that of InP. The estimated lattice constants for all compositions studied were approximately 5.916 Å, a value very close to the lattice constant observed for InP (5.869 Å). The Tran–Blaha modified Becke–Johnson (TB − mBJ) potential was employed to perform the electronic-structure calculations. The results of these calculations indicated that, across all investigated indium and arsenic concentrations, the InxAl1−xAsySb1−y quaternary alloys retain their direct bandgap semiconductor character, while the calculated bandgap values exhibit a nonmonotonic dependence on alloy composition. We carefully examined their optical properties. The investigated compositions exhibit optical responses spanning the wavelength range from 642 to 803 nm, with a nonmonotonic dependence on alloy composition, while maintaining compatibility with the InP substrate lattice. These results suggest that the InxAl1−xAsySb1−y quaternary alloys could be promising candidates for photovoltaic applications.
- 23 November 2023
- Published by Springer Nature in Optical and Quantum Electronics
- Vol. 56 (1) , 1-16
Effect of ZnO doping co-carried out by Co–Cu on nonlinear optical properties prepared by the spin coating method
- 23 November 2023
- Published by Springer Nature in Optical and Quantum Electronics
- Vol. 56 (1) , 1-16
Effect of ZnO doping co-carried out by Co–Cu on nonlinear optical properties prepared by the spin coating method
- 1 September 2021
- Published by Elsevier in Computational Condensed Matter
- Vol. 28
Band parameters and thermoelectric properties of chalcopyrite ternary compounds CdXP2 (X = Si, Ge and Sn)
- 1 September 2021
- Published by Elsevier in Computational Condensed Matter
- Vol. 28
Band parameters and thermoelectric properties of chalcopyrite ternary compounds CdXP2 (X = Si, Ge and Sn)
- 9 February 2021
- Published by Wiley in Physica Status Solidi (b)
- Vol. 258 (5) , 2000472
Influence of Cu‐Doping on Linear and Nonlinear Optical Properties of High‐Quality ZnO Thin Films Obtained by Spin‐Coating Technique
To study the effect of Cu concentration on morphological, structural, linear and nonlinear optical properties, copper‐doped ZnO thin films are grown by sol–gel/spin‐coating technique on the glass substrates. Scanning electron microscopy (SEM) images reveal that the surface morphology is homogeneous with good adhesion to the glass substrate. The energy dispersive X‐ray spectroscopy (EDS) spectra confirm that Zn, O, and Cu elements are present in ZnO films. The X‐ray diffraction (XRD) pattern of Cu‐doped ZnO is dominated by (002) peak, indicating an upstanding ZnO nanorods array growing along the c‐axis. The optical bandgap of Cu‐doped ZnO thin films, calculated from optical transmission spectra, is found to decrease with the increase in copper concentration. The refractive index dispersion curve of ZnO films is subjected to the single‐oscillator model. The optical dispersion parameters Eo, Ed, and n∞, the nonlinear refractive index, and nonlinear optical susceptibility are calculated and interpreted.
- 9 February 2021
- Published by Wiley in Physica Status Solidi (b)
- Vol. 258 (5) , 2000472
Influence of Cu‐Doping on Linear and Nonlinear Optical Properties of High‐Quality ZnO Thin Films Obtained by Spin‐Coating Technique
To study the effect of Cu concentration on morphological, structural, linear and nonlinear optical properties, copper‐doped ZnO thin films are grown by sol–gel/spin‐coating technique on the glass substrates. Scanning electron microscopy (SEM) images reveal that the surface morphology is homogeneous with good adhesion to the glass substrate. The energy dispersive X‐ray spectroscopy (EDS) spectra confirm that Zn, O, and Cu elements are present in ZnO films. The X‐ray diffraction (XRD) pattern of Cu‐doped ZnO is dominated by (002) peak, indicating an upstanding ZnO nanorods array growing along the c‐axis. The optical bandgap of Cu‐doped ZnO thin films, calculated from optical transmission spectra, is found to decrease with the increase in copper concentration. The refractive index dispersion curve of ZnO films is subjected to the single‐oscillator model. The optical dispersion parameters Eo, Ed, and n∞, the nonlinear refractive index, and nonlinear optical susceptibility are calculated and interpreted.
- 1 March 2019
- Published by Springer Nature in Journal of Computational Electronics
- Vol. 18 (2) , 415-427
Theoretical investigation of the structural, electronic and thermodynamic properties of cubic and orthorhombic XZrS3 (X = Ba,Sr,Ca) compounds
- 1 March 2019
- Published by Springer Nature in Journal of Computational Electronics
- Vol. 18 (2) , 415-427
Theoretical investigation of the structural, electronic and thermodynamic properties of cubic and orthorhombic XZrS3 (X = Ba,Sr,Ca) compounds
- Open Access
- 31 December 2017
- Published by The Scientific Club of Al Manahil Association in International Journal of Energetica
- Vol. 2 (2) , 25-28
Structural, electronic and thermoelectric properties of the intermetallic materials based on Mg2X (X= Si, Ge, Sn): DFT calculations
The scope of this work is the investigation of the physical properties of chalcopyrite materials using ab-initio methods in order to simulate a new structure of thin-films photovoltaic cells with high conversion efficiency. In the first framework, we obtained the results of calculations based on Density Functional Theory (DFT) using the full-potential linearized augmented plane wave method (FP-LAPW) as involved in the WIEN2K computational package. For the exchange-correlation potential, the local density approximation (LDA) was used to calculate the lattice parameters, Bulk modulus and its first derivative as well as the densities of states of the intermetallic semiconductors materials based on Mg2X (X=Si, Ge and Sn). The semi-local Becke-Johnson (mBJ) potential and its modified form proposed by Tran and Blaha (TB-mBJ) were also used for studying the electronic and thermoelectric properties; (merit factor, Seebeck coefficient, electronic conductivity). The achieved results were compared to computational works and other data acquired experimentally.
- 31 December 2017
- Published by The Scientific Club of Al Manahil Association in International Journal of Energetica
- Vol. 2 (2) , 25-28
Open AccessStructural, electronic and thermoelectric properties of the intermetallic materials based on Mg2X (X= Si, Ge, Sn): DFT calculations
The scope of this work is the investigation of the physical properties of chalcopyrite materials using ab-initio methods in order to simulate a new structure of thin-films photovoltaic cells with high conversion efficiency. In the first framework, we obtained the results of calculations based on Density Functional Theory (DFT) using the full-potential linearized augmented plane wave method (FP-LAPW) as involved in the WIEN2K computational package. For the exchange-correlation potential, the local density approximation (LDA) was used to calculate the lattice parameters, Bulk modulus and its first derivative as well as the densities of states of the intermetallic semiconductors materials based on Mg2X (X=Si, Ge and Sn). The semi-local Becke-Johnson (mBJ) potential and its modified form proposed by Tran and Blaha (TB-mBJ) were also used for studying the electronic and thermoelectric properties; (merit factor, Seebeck coefficient, electronic conductivity). The achieved results were compared to computational works and other data acquired experimentally.
- 1 January 2016
- Published by Elsevier in Materials Today: Proceedings
- Vol. 3 (9) , 2877-2882
Structural and elastic properties of BiOCu1-xS with Cu vacancies
- 1 January 2016
- Published by Elsevier in Materials Today: Proceedings
- Vol. 3 (9) , 2877-2882
Structural and elastic properties of BiOCu1-xS with Cu vacancies
- 1 December 2015
- Published by Elsevier in Materials Science in Semiconductor Processing
- Vol. 40, 58-63
Ab initio prediction of structural, electronic, magnetic and optical properties of Ba2GdSbO6
- 1 December 2015
- Published by Elsevier in Materials Science in Semiconductor Processing
- Vol. 40, 58-63
Ab initio prediction of structural, electronic, magnetic and optical properties of Ba2GdSbO6
- 3 September 2015
- Published by World Scientific Pub Co Pte Ltd in Modern Physics Letters B
- Vol. 29 (24)
Theoretical investigation of elastic and phononic properties of Zn1−xBexO alloys
- 3 September 2015
- Published by World Scientific Pub Co Pte Ltd in Modern Physics Letters B
- Vol. 29 (24)
Theoretical investigation of elastic and phononic properties of Zn1−xBexO alloys