Arianna Catenacci

This work provides insights into the possibility of integrating recovered volatile fatty acids (VFAs) into biological nitrogen removal processes. VFAs are the main products of the acidogenic fermentation of waste sludge and are an effective carbon source for denitrification in activated sludge processes. The assessment of denitrification rates and the utilisation hierarchy of different VFAs are relevant to evaluating the possibility of replacing external carbon sources with the fermented liquid, FL, from acidogenic fermentation. To this scope, single VFAs, FL collected from a full-scale waste sludge fermenter, and commercial hydroalcoholic solutions have been tested with manometric lab-scale tests. Regarding single acids, acetic acid showed the highest denitrification rates, up to 4 mg N-NO₃ g VSS⁻¹ h⁻¹, while more complex acids usually showed a lower denitrification rate. The synthetic VFA mixture and FL showed a higher denitrification rate than the sole acetate (up to 134% of the acetate denitrification rate). Mass balances across the full-scale wastewater treatment plant demonstrated the positive role of FL dosage in enhancing the denitrification process in the activated sludge treatment, with an average nitrogen removal equal to 57% and 78% without and with FL dosage, respectively. Batch manometric tests proved to be an efficient and reliable tool to assess the quality of the carbon sources as well as the activity of denitrifying bacteria in activated sludge samples.

In this work, different alternatives to conventional tertiary treatment of pulp and paper (P&P) wastewater (WW), i.e., physicochemical coagulation-flocculation, were investigated to enhance the environmental and economic sustainability of industrial wastewater treatment. In particular, following a preliminary characterization of secondary effluents, cloth filtration and adsorption were studied, the former by pilot-scale tests, while the latter at laboratory scale. An economic analysis was finally accomplished to verify the full-scale applicability of the most promising technologies. Cloth filtration showed excellent total suspended solids (TSS) removal efficiency (mean 81% removal) but a very limited influence on chemical oxygen demand (COD) (mean 10% removal) due to the prevalence of soluble COD on particulate COD. Adsorption, instead, led to a good COD removal efficiency (50% abatement at powdered activated carbon—PAC—dosage of 400 mg/L). The economic analysis proved that adsorption would be convenient only if a local low-cost (100 €/ton) adsorbent supply chain was established. Ultrafiltration was considered as well as a potential alternative: its huge capital cost (19 M€) could be recovered in a relatively short timeframe (pay-back time of 4.7 years) if the ultrafiltrated effluent could be sold to local industries.

Anaerobic co-digestion in wastewater treatment plants is looking increasingly like a straightforward solution to many issues arising from the operation of mono-digestion. Process modelling is relevant to predict plant behavior and its sensitivity to operational parameters, and to assess the feasibility of simultaneously feeding a digester with different organic wastes. Still, much work has to be completed to turn anaerobic digestion modelling into a reliable and practical tool. Indeed, the complex biochemical processes described in the ADM1 model require the identification of several parameters and many analytical determinations for substrate characterization. A combined protocol including batch Biochemical Methane Potential tests and analytical determinations is proposed and applied for substrate influent characterization to simulate a pilot-scale anaerobic digester where co-digestion of waste sludge and expired yogurt was operated. An iterative procedure was also developed to improve the fit of batch tests for kinetic parameter identification. The results are encouraging: the iterative procedure significantly reduced the Theil’s Inequality Coefficient (TIC), used to evaluate the goodness of fit of the model for alkalinity, total volatile fatty acids, pH, COD, volatile solids, and ammoniacal nitrogen. Improvements in the TIC values, compared to the first iteration, ranged between 30 and 58%.