Joohyung Byeon
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Joohyung Byeon has a total of 15 co-authors. Here are the top co-authors by number of shared publications:
- Donggyu Sim
Department of Computer Engineering, Kwangwoon University, Seoul 01897, Republic of Korea
7 shared publications - Mintae Kim2 shared publications
- EunSeong Lee1 shared publication
Hanje Park
LG Electronics Inc., Seoul, South Korea
1 shared publicationHansol Choi
Department of Computer Engineering, Kwangwoon University, Seoul, South Korea
1 shared publication- Hyemi Lee1 shared publication
Latest Publications
- Open Access
- 3 February 2026
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Access
- Vol. 14, 22569-22586
Unified Video-Based Spatially Scalable Coding for Dynamic 3-D Meshes
This study proposes a spatially scalable coding structure for dynamic 3D meshes, enabling adaptive services across diverse network conditions and device capabilities. The proposed method jointly encodes the geometry and texture of dynamic meshes using a multilayer unified video representation, providing spatial scalability via 2D scalable codecs. This representation is constructed by jointly packing displacement videos and texture maps across multiple layers. Specifically, a multilayer displacement video is generated by decomposing the displacements into hierarchical layers using a level-of-detail structure derived from a lifting transform, where each layer captures progressively finer geometric details. Multiresolution texture maps are generated using the proposed Smoothed Push–Pull-based method, which adaptively applies downsampling filters by distinguishing between occupied pixels with valid texture and non-occupied pixels without it. The resulting multilayer displacement video and texture maps are spatially stacked to form a single multilayer video, compressed using a conventional 2D scalable codec. This enables simultaneous spatial scalability of both geometry and color employing a single video encoder–decoder pair. Experimental results indicate that the proposed method achieves Bjøntegaard Delta (BD)-rate improvements of 37.0%, 37.0%, and 35.5% in point-cloud-based D1, D2, and luma Peak Signal-to-Noise Ratio (PSNR) under the All-Intra condition, and improvements of 35.1%, 35.0%, and 35.6% under the Low-Delay condition in the three-layer configuration, compared with those of the simulcast approach. This advance enables adaptive 3D streaming by allowing a single scalable bitstream to support devices with varying capabilities, highlighting its practical relevance for immersive media delivery.
- 3 February 2026
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Access
- Vol. 14, 22569-22586
Open AccessUnified Video-Based Spatially Scalable Coding for Dynamic 3-D Meshes
This study proposes a spatially scalable coding structure for dynamic 3D meshes, enabling adaptive services across diverse network conditions and device capabilities. The proposed method jointly encodes the geometry and texture of dynamic meshes using a multilayer unified video representation, providing spatial scalability via 2D scalable codecs. This representation is constructed by jointly packing displacement videos and texture maps across multiple layers. Specifically, a multilayer displacement video is generated by decomposing the displacements into hierarchical layers using a level-of-detail structure derived from a lifting transform, where each layer captures progressively finer geometric details. Multiresolution texture maps are generated using the proposed Smoothed Push–Pull-based method, which adaptively applies downsampling filters by distinguishing between occupied pixels with valid texture and non-occupied pixels without it. The resulting multilayer displacement video and texture maps are spatially stacked to form a single multilayer video, compressed using a conventional 2D scalable codec. This enables simultaneous spatial scalability of both geometry and color employing a single video encoder–decoder pair. Experimental results indicate that the proposed method achieves Bjøntegaard Delta (BD)-rate improvements of 37.0%, 37.0%, and 35.5% in point-cloud-based D1, D2, and luma Peak Signal-to-Noise Ratio (PSNR) under the All-Intra condition, and improvements of 35.1%, 35.0%, and 35.6% under the Low-Delay condition in the three-layer configuration, compared with those of the simulcast approach. This advance enables adaptive 3D streaming by allowing a single scalable bitstream to support devices with varying capabilities, highlighting its practical relevance for immersive media delivery.
- Open Access
- 31 January 2026
- Published by The Korean Institute of Broadcast and Media Engineers in Journal of Broadcast Engineering
- Vol. 31 (1) , 106-122
4D Gaussian Splatting Compression Framework Compatible with Commercial Video Codecs
- 31 January 2026
- Published by The Korean Institute of Broadcast and Media Engineers in Journal of Broadcast Engineering
- Vol. 31 (1) , 106-122
Open Access4D Gaussian Splatting Compression Framework Compatible with Commercial Video Codecs
- 30 September 2025
- Published by The Korean Institute of Broadcast and Media Engineers in Journal of Broadcast Engineering
- Vol. 30 (5) , 757-771
Adaptive Motion Vector Predictor Selection Method for Dynamic Mesh Compression
- 30 September 2025
- Published by The Korean Institute of Broadcast and Media Engineers in Journal of Broadcast Engineering
- Vol. 30 (5) , 757-771
Adaptive Motion Vector Predictor Selection Method for Dynamic Mesh Compression
- Open Access
- 5 June 2024
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Access
- Vol. 12, 80035-80046
Influence-Based Quantization Method for Lifting Transform of G-PCC
Point cloud is one of the emerging 3D representations used in diverse applications. However, a point cloud typically comprises a huge amount of data; thus, compression is crucial for efficiently transmitting and storing. To meet these requirements, moving picture experts group (MPEG) developed geometry-based point cloud compression (G-PCC). In G-PCC, lifting transform is used as one of the attribute coding methods and it relies on level-of-detail (LoD) structure for transform. The LoD-based lifting transform makes each point have different influence on the transformation. To utilize these characteristics to quantization process, this paper proposes an influence-based point-wise quantization method for the lifting transform of G-PCC. The proposed quantization method includes two novel techniques: influence-based point-wise scaling (IPWS) and influence-based rate-distortion optimized quantization (IRDOQ). The IPWS is a novel scaling function that improves the existing adaptive scaling method. The IRDOQ determines the optimal levels by balancing the rate and distortion of each lifting coefficient based on the point-wise influence weight. The influence weight indicates the frequency with which its current point is referenced for prediction in the lifting transform. The influence weights calculated during the lifting transform are reused for the proposed IPWS and IRDOQ. The proposed method enhances the overall coding performance by adjusting the balance between rate and distortion based on the influence of each lifting coefficient on the quantization process. The experimental results demonstrate that the proposed method achieves an average Bjøntegaard-Delta rate (BD-rate) improvement of 2.0%, 5.5%, 5.4%, and 3.6% for the luma, chroma Cb, chroma Cr, and reflectance, respectively, when compared to the G-PCC reference software.
- 5 June 2024
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Access
- Vol. 12, 80035-80046
Open AccessInfluence-Based Quantization Method for Lifting Transform of G-PCC
Point cloud is one of the emerging 3D representations used in diverse applications. However, a point cloud typically comprises a huge amount of data; thus, compression is crucial for efficiently transmitting and storing. To meet these requirements, moving picture experts group (MPEG) developed geometry-based point cloud compression (G-PCC). In G-PCC, lifting transform is used as one of the attribute coding methods and it relies on level-of-detail (LoD) structure for transform. The LoD-based lifting transform makes each point have different influence on the transformation. To utilize these characteristics to quantization process, this paper proposes an influence-based point-wise quantization method for the lifting transform of G-PCC. The proposed quantization method includes two novel techniques: influence-based point-wise scaling (IPWS) and influence-based rate-distortion optimized quantization (IRDOQ). The IPWS is a novel scaling function that improves the existing adaptive scaling method. The IRDOQ determines the optimal levels by balancing the rate and distortion of each lifting coefficient based on the point-wise influence weight. The influence weight indicates the frequency with which its current point is referenced for prediction in the lifting transform. The influence weights calculated during the lifting transform are reused for the proposed IPWS and IRDOQ. The proposed method enhances the overall coding performance by adjusting the balance between rate and distortion based on the influence of each lifting coefficient on the quantization process. The experimental results demonstrate that the proposed method achieves an average Bjøntegaard-Delta rate (BD-rate) improvement of 2.0%, 5.5%, 5.4%, and 3.6% for the luma, chroma Cb, chroma Cr, and reflectance, respectively, when compared to the G-PCC reference software.
- Open Access
- 31 January 2024
- Published by The Korean Institute of Broadcast and Media Engineers in Journal of Broadcast Engineering
- Vol. 29 (1) , 42-56
Valence based Lifting Wavelet Transform for Video-based Dynamic Mesh Compression
- 31 January 2024
- Published by The Korean Institute of Broadcast and Media Engineers in Journal of Broadcast Engineering
- Vol. 29 (1) , 42-56
Open AccessValence based Lifting Wavelet Transform for Video-based Dynamic Mesh Compression
- Open Access
- 19 February 2021
- Published by MDPI AG in Applied Sciences
- Vol. 11 (4) , 1844
Fast Thumbnail Extraction for H.264/AVC, HEVC and VP9
In this paper, we propose a partial decoding method with limited memory usage for high-speed thumbnail extraction. The proposed method performs a partial inverse transform and a partial intra prediction in order to reconstruct pixels for intra prediction and thumbnails. Thereafter, the reconstructed pixels at the bottom and right line of the block are stored in the line buffer and the thumbnail buffer without being stored in the decoded picture buffer with full resolution. H.264/AVC, HEVC and VP9 video codecs have different coding structures, prediction and transforms; however, the proposed algorithm can be applied to the corresponding codecs in the same manner. In order to evaluate the performance of the proposed method, we implemented the proposed algorithm for H.264/AVC, HEVC and VP9. We found that the thumbnail extraction time of the proposed method decreased by 66% in H.264/AVC, 52% in HEVC and 48% in VP9 as compared to the full decoding method.
- 19 February 2021
- Published by MDPI AG in Applied Sciences
- Vol. 11 (4) , 1844
Open AccessFast Thumbnail Extraction for H.264/AVC, HEVC and VP9
In this paper, we propose a partial decoding method with limited memory usage for high-speed thumbnail extraction. The proposed method performs a partial inverse transform and a partial intra prediction in order to reconstruct pixels for intra prediction and thumbnails. Thereafter, the reconstructed pixels at the bottom and right line of the block are stored in the line buffer and the thumbnail buffer without being stored in the decoded picture buffer with full resolution. H.264/AVC, HEVC and VP9 video codecs have different coding structures, prediction and transforms; however, the proposed algorithm can be applied to the corresponding codecs in the same manner. In order to evaluate the performance of the proposed method, we implemented the proposed algorithm for H.264/AVC, HEVC and VP9. We found that the thumbnail extraction time of the proposed method decreased by 66% in H.264/AVC, 52% in HEVC and 48% in VP9 as compared to the full decoding method.