HSHao Sun

Hao Sun

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Hao Sun has a total of 53 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Metal Oxide Decorated GeTe Monolayer as Promising Materials for Dissolved Gases in Transformer Oil

    by Hao Qiao, Xiaobo Zhang, Ping Wang, Hao Sun, Lu-Qi Tao

    In the maintenance of transmission lines, prompt detection and repair of electrical equipment faults can greatly reduce losses of public property. Hence, the development of a highly sensitive detection device for transformer oil fault gases (H 2 , CH 4 , CO, C 2 H 2 ) is of significant importance. This study investigates the adsorption behavior and sensing characteristics of TiO 2 and Ag 2 O doped GeTe monolayers on transformer oil fault gases using first principles calculations. The results indicate that doping TiO 2 and Ag 2 O enhances the conductivity of the GeTe monolayer by 16.8 % and 14.9 %, respectively. However, in comparison to TiO 2 , Ag 2 O significantly increases the adsorption energy of the GeTe monolayer for the four gases: H 2 (301 %), CH 4 (252 %), CO (299 %), and C 2 H 2 (249 %). The suitable adsorption energy enables the Ag 2 O-doped GeTe monolayer to exhibit good sensitivity and allow for gas desorption from the substrate at high temperatures, potentially addressing the industrial issue of recovery and utilization of sensing materials. These findings provide a theoretical foundation for the design and application of resistance-based chemical sensors used to detect transformer oil decomposition gases.


  • TiO2 and Ag2O Decorated GeTe Monolayer as a Highly Sensitive Material for SF6 Decomposition Species Detection

    by Hao Qiao, Xiaobo Zhang, Jian Qiu, Ping Wang, Hao Sun, Xianping Chen, Jiabing Yu, Lu-Qi Tao

    The effective detection and maintenance of electrical equipment failures in circuit maintenance is crucial in reducing public property losses. Therefore, the research and development of a highly sensitive SF 6 decomposition detection device is of great significance. Here, in this paper, the adsorption behavior and sensing characteristics of TiO 2 , Ag 2 O doped GeTe monolayer for SF 6 decomposition species (H 2 S, SO 2 ) has been studied through first-principles analysis. The results show that the doping of Ag 2 O and TiO 2 enhances the conductivity of GeTe monolayer by 14.9 % and 16.8 %, respectively, and increases the adsorption energy of the doped GeTe monolayer for H 2 S and SO 2 by 214 % (TiO 2 -GeTe-H 2 S), 184 % (TiO 2 -GeTe-SO 2 ), 361 % (Ag 2 O-GeTe-H 2 S) and 191 % (Ag 2 O-GeTe-SO 2 ) respectively. The adsorption energy with proper size makes both doped GeTe monolayers highly sensitive and selective with a rapid recovery time, which theoretically solves the problem of industrial recycling of sensing materials. The research results provide a theoretical basis for the material selection of a highly selective sensor for detecting SF 6 decomposition products.


  • A Novel Function Fitting Approach Achieves Tunable Adsorption Properties of CuO-Doped SnSe Monolayer for SF6 Leakage Gas

    by Xiaobo Zhang, Ping Wang, Hao Qiao, Hao Sun, Lu-Qi Tao

    Sulfur hexafluoride (SF6) is widely employed in electrical power systems due to its superior insulating properties. However, prolonged use or equipment failure may cause SF6 gas leaks, leading to environmental contamination. While numerous 2-D materials have been proposed by academics for detecting SF6 decomposition gas, investigations into SF6 gas adsorption and the ability to modulate adsorption performance have been relatively limited. Given the strong adsorption of SF6 gas and the tunability of adsorption performance, this article proposes a methodology for achieving distinct adsorption properties by configuring solvents with varying dielectric constants based on CuO-doped SnSe (SnSe-CuO) monolayer. The SnSe-CuO monolayer is used as an adsorbent for SF6 leakage in solvents with different relative dielectric constants. The methodology employs computational analysis to obtain the solvent dielectric constant corresponding to the required adsorption energy from the fit function, which can serve as a solid theoretical basis for future chemisorption studies.


  • Strong Adsorption Capacity for SF₆-Leaking Gas With NiO-Doped and Ag₂O-Doped SnSe Monolayer

    by Xiaobo Zhang, Lu-Qi Tao, Hao Qiao, Hao Sun, Ping Wang

    Sulfur hexafluoride (SF 6 ) gas is widely used in Gas Insulation Switchgear (GIS) systems of power systems due to its efficient arc extinguishing characteristics. However, long-term equipment operation or electrical faults may cause SF 6 insulating gas leakage, leading to environmental pollution. Although there are numerous 2-dimensional materials for detecting SF 6 decomposition, few studies on SF 6 leakage gas exits. This paper proposes an SF 6 adsorbent material based on a SnSe monolayer doped with NiO and Ag 2 O. Theoretical calculations demonstrate that the SnSe monolayer doped with NiO and Ag 2 O exhibits extremely strong adsorption performance for SF 6 gas, with adsorption energies of -2.824 eV and -2.812 eV, respectively, which is an 890.88% enhancement compared to pure SnSe monolayer. Furthermore, the adsorption energy of SF 6 gas in water solvent exceeds -3.5 eV, indicating that water can serve as an effective enhancer of SF 6 gas adsorption. This study provides a new theoretical basis and method for detecting and adsorbing SF 6 leaking gas.


  • Pyrolyzed Silk Carbon Fabric-Enabled Wearable Functional Actuators With Heating and Sound-Emitting Capabilities

    by Lu-Qi Tao, Guanya Wang, Hao Sun, Congcong Zhu, Zhirong Peng, Simin Zou, Xianping Chen, Tian-Ling Ren

    Textile-based wearable electronics are widely favored by researchers due to their superior comfort. However, there are few studies on textile-based flexible actuators with multiple uses. In this article, a highly flexible actuator with heating and sound-emitting capabilities enabled by pyrolyzed silk carbon fabrics is developed. The functionalized fabrics with ideal physical properties are prepared by a high-temperature reduction method, which is simple and efficient. Its electrothermal and photothermal effects endow the device with heating function. The steady-state temperature can reach 188 °C and 280 °C under 0.80-W/cm2 electricity power density and 1.46-W/cm2 laser power density with high stability, respectively. By taking advantage of thermoacoustic effect, it can also produce intuitive sound messages. Test results show that acoustic properties are in good agreement with theoretical model. The output sound pressure level can be stabilized at about 55 dB in the range of 8–20 kHz under 101-mW power. The actuator carries great potentials in wearable thermal and acoustic applications.


  • Open Access

    Graphene‐based dual‐function acoustic transducers for machine learning‐assisted human–robot interfaces

    by Hao Sun, Xin Gao, Liang‐Yan Guo, Lu‐Qi Tao, Zi Hao Guo, Yangshi Shao, Tianrui Cui, Yi Yang, Xiong Pu, Tian‐Ling Ren

    Human–robot interface (HRI) electronics are critical for realizing robotic intelligence. Here, we report graphene‐based dual‐function acoustic transducers for machine learning‐assisted human–robot interfaces (GHRI). The GHRI functions both an artificial ear through the triboelectric acoustic sensing mechanism and an artificial mouth through the thermoacoustic sound emission mechanism. The success of the integrated device is also attributed to the multifunctional laser‐induced graphene, as either triboelectric materials, electrodes, or thermoacoustic sources. By systematically optimizing the structure parameters, the GHRI achieves high sensitivity (4500 mV Pa–1) and operating durability (1 000 000 cycles and 60 days), capable of recognizing speech identities, emotions, content, and other information in the human speech. With the assistance of machine learning, 30 speech categories are trained by a convolutional neural network, and the accuracy reaches 99.66% and 96.63% in training datasets and test datasets. Furthermore, GHRI is used for artificial intelligence communication based on recognized speech features. Our work shows broad prospects for the development of robotic intelligence. image


  • A Flexible Graphene-Based Fabric Ultrasound Source for Machine Learning Enhanced Information Encryption

    by Hao Sun, Lu-Qi Tao, Ping Wang, Tian-Ling Ren

    Information encryption has become an essential trend in the era of big data. Ultrasound can be used as an excellent encrypted transmission medium carrying information due to its strong concealment and small interference. And, better wearable needs cannot be ignored. Here, we propose a flexible graphene-based fabric ultrasound source (GUS) for machine learning enhanced information encryption. GUS is prepared by one-step laser method to generate laser-induced graphene on NOMEX fabric substrate. The easily captured low-frequency sound signals are modulated to high frequency to become ultrasound signals and emit through GUS. The key to success of this work is excellent sound pressure level (SPL) output of GUS in high frequency. Besides, the Mel Frequency Cestrum Coefficient (MFCC) feature of ultrasound is extracted by convolutional neural network, and the accuracy of speech recognition is 98.2 %.


  • Theoretical Exploration of C4F7N Decompositions on GeSe Monolayers for Gas Sensing Based on DFT Method

    by Tian-Yi Sang, Hao Sun, Xiqian Hu, Tao Li, Liang-Yan Guo, Zhirong Peng, Guanya Wang, Congcong Zhu, Simin Zou, Xiao Zhang, et al.

    On account of its superior insulating performance and low global warming potential (GWP), C4F7N has been the focus of replacing SF6. Based on density functional theory, the adsorption mechanism and electrical characteristics of GeSe monolayer towards C4F7N decomposition species (COF2, CF4, CF3CN and C2F5CN) are explored to investigate the feasibility of GeSe gas sensors. Compared with other decomposition products, GeSe monolayers are more capable of capturing for C2F5CN, as evidenced by the smallest band gap (0.781 eV) and the highest adsorption energy (-0.427 eV). The adsorption behaviors lead to a larger GeSe band gap and thus a decrease in the conductivity of the adsorption system. The adsorption types of GeSe for four gases are all physical adsorption and can have good desorption properties at room temperature (298 K) with the adsorption capabilities: C2F5CN>CF3CN>COF2>CF4. Theoretically, GeSe monolayers can be used to create a novel gas sensor for and industrial application, which can be utilized to monitor and diagnose high-voltage insulated equipment in real time.