Muhammad Ifnan Khan
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Muhammad Ifnan Khan has a total of 43 co-authors. Here are the top co-authors by number of shared publications:
- Ansar Hussain
Affiliation Department of Agronomy, Bahauddin Zakaria University, Multan, Pakistan
2 shared publications - Muhammad Arif
Department of Plant Protection, Faculty of Agriculture, Sakarya University of Applied Sciences, Arifiye, Türkiye
2 shared publications Rahmat Ullah Shah
Department of Soil Science, Faculty of Agricultural Sciences and Technology, Bahauddin Zakariya University, Multan 60800, Pakistan
2 shared publicationsRehmat Ullah
Soil and Water Testing Laboratory for Research, Dera Ghazi Khan 32200, Pakistan
2 shared publications- Shahid Farooq
Department of Plant Protection, Faculty of Agriculture, Harran University, Şanlıurfa, Türkiye
2 shared publications - Abdul Hannan
Department of Aquatic Animal Health Management Sher‐e‐Bangla Agricultural University Dhaka Bangladesh
1 shared publication
Latest Publications
- Open Access
- 10 June 2021
- Published by Elsevier in Saudi Journal of Biological Sciences
- Vol. 28 (10) , 5714-5719
Grain yield and correlated traits of bread wheat lines: Implications for yield improvement
- 10 June 2021
- Published by Elsevier in Saudi Journal of Biological Sciences
- Vol. 28 (10) , 5714-5719
Open AccessGrain yield and correlated traits of bread wheat lines: Implications for yield improvement
- RetractedOpen Access
- 25 February 2021
- Published by Public Library of Science (PLoS) in PLOS ONE
- Vol. 16 (2) , e0247529
Deep placement of nitrogen fertilizer improves yield, nitrogen use efficiency and economic returns of transplanted fine rice
Rice (Oryza sativa L.) feeds to two-third of the global population by serving as staple food. It is the main export commodity of several countries; thus, contributes towards foreign exchange earnings. Unfortunately, average global rice yield is far below than its genetic potential. Low nitrogen (N) use efficiency (NUE) is among the major reasons for low average yield. Current study evaluated the impact of nitrogen fertilizer application methods (conventional and deep placement) on growth, yield-related traits, chlorophyll contents, photosynthesis rate, agronomic N-use efficiency (ANUE), partial factors productivity of applied N (PFP) and economic returns of two different transplanted rice varieties (Basmati-515 and Super-Basmati). Fertilizer application methods significantly affected allometry, yield-related traits, chlorophyll contents, photosynthesis rate, ANUE, PFP and economic returns. Deep placement of N-fertilizer (DPNF) observed better allometric traits, high chlorophyll contents, photosynthesis rate, ANUE, PFP, yield attributes and economic returns compared to conventional application of N-fertilizer (CANF). Similarly, Basmati-515 had better allometric and yield-related traits, chlorophyll contents, photosynthesis rate, ANUE, PFP and economic returns than Super-Basmati. Regarding interactions among N-fertilizer application methods and rice varieties, Basmati-515 with DPNF resulted in higher chlorophyll contents, photosynthesis rate, ANUE, PFP, allometric and yield related traits and economic returns than CANF. The lowest values of these traits were observed for Super-Basmati with no application of N-fertilizer. Both varieties had better yield and economic returns with DPNF compared to CANF. It is concluded that DPNF improved yield, ANUE and economic returns; therefore, should be opted to improve productivity of transplanted fine rice. Nonetheless, lower nitrogen doses need to be tested for DPNF to infer whether it could lower N use in rice crop.
- 25 February 2021
- Published by Public Library of Science (PLoS) in PLOS ONE
- Vol. 16 (2) , e0247529
RetractedOpen AccessDeep placement of nitrogen fertilizer improves yield, nitrogen use efficiency and economic returns of transplanted fine rice
Rice (Oryza sativa L.) feeds to two-third of the global population by serving as staple food. It is the main export commodity of several countries; thus, contributes towards foreign exchange earnings. Unfortunately, average global rice yield is far below than its genetic potential. Low nitrogen (N) use efficiency (NUE) is among the major reasons for low average yield. Current study evaluated the impact of nitrogen fertilizer application methods (conventional and deep placement) on growth, yield-related traits, chlorophyll contents, photosynthesis rate, agronomic N-use efficiency (ANUE), partial factors productivity of applied N (PFP) and economic returns of two different transplanted rice varieties (Basmati-515 and Super-Basmati). Fertilizer application methods significantly affected allometry, yield-related traits, chlorophyll contents, photosynthesis rate, ANUE, PFP and economic returns. Deep placement of N-fertilizer (DPNF) observed better allometric traits, high chlorophyll contents, photosynthesis rate, ANUE, PFP, yield attributes and economic returns compared to conventional application of N-fertilizer (CANF). Similarly, Basmati-515 had better allometric and yield-related traits, chlorophyll contents, photosynthesis rate, ANUE, PFP and economic returns than Super-Basmati. Regarding interactions among N-fertilizer application methods and rice varieties, Basmati-515 with DPNF resulted in higher chlorophyll contents, photosynthesis rate, ANUE, PFP, allometric and yield related traits and economic returns than CANF. The lowest values of these traits were observed for Super-Basmati with no application of N-fertilizer. Both varieties had better yield and economic returns with DPNF compared to CANF. It is concluded that DPNF improved yield, ANUE and economic returns; therefore, should be opted to improve productivity of transplanted fine rice. Nonetheless, lower nitrogen doses need to be tested for DPNF to infer whether it could lower N use in rice crop.
- RetractedOpen Access
- 14 May 2020
- Published by Public Library of Science (PLoS) in PLOS ONE
- Vol. 15 (5) , e0233171
Optimizing planting geometry for barley-Egyptian clover intercropping system in semi-arid sub-tropical climate
Intercropping legumes with cereals has been a common cropping system in short-season rainfed environments due to its increased productivity and sustainability. Intercropping barley (Hordeum vulgare L.) with Egyptian clover (Trifolium alexandrinum L.) could increase the grain yield of barley and improve resource use efficiency of the intercropping system. However, non-optimum planting geometry has been a hurdle in the adaptation of barley-based cropping systems. This study was aimed at optimizing the planting geometry, and assess the productivity and profitability of barley-Egyptian clover intercropping system. Ten different planting geometries, differing in number of rows of barley, width and number of irrigation furrows and planting method were tested. Intercropping barley with Egyptian clover improved 56–68% grain yield of barley compared with mono-cropped barley. Barley remained dominant crop in terms of aggressiveness, relative crowding coefficient and competitive ratio. The amount of water used was linearly increased with increasing size of barley strip from 3 to 8 rows. The highest water use efficiency (4.83 kg/cf3) was recorded for 8-row barley strip system with 120 cm irrigation furrows compared to rest of the planting geometries. In conclusion, 8-rows of barley planted on beds with Egyptian clover in 120 cm irrigation furrows had the highest net income and cost benefit ratio. Therefore, it is recommended that this planting geometry can be used for better economic returns of barley-Egyptian clover intercropping system. However, barley strips with >8 rows were not included in this study, which is limitation of the current study. Therefore, future studies with >8 barley rows in strip should be conducted to infer the economic feasibility and profitability of wider barley strips.
- 14 May 2020
- Published by Public Library of Science (PLoS) in PLOS ONE
- Vol. 15 (5) , e0233171
RetractedOpen AccessOptimizing planting geometry for barley-Egyptian clover intercropping system in semi-arid sub-tropical climate
Intercropping legumes with cereals has been a common cropping system in short-season rainfed environments due to its increased productivity and sustainability. Intercropping barley (Hordeum vulgare L.) with Egyptian clover (Trifolium alexandrinum L.) could increase the grain yield of barley and improve resource use efficiency of the intercropping system. However, non-optimum planting geometry has been a hurdle in the adaptation of barley-based cropping systems. This study was aimed at optimizing the planting geometry, and assess the productivity and profitability of barley-Egyptian clover intercropping system. Ten different planting geometries, differing in number of rows of barley, width and number of irrigation furrows and planting method were tested. Intercropping barley with Egyptian clover improved 56–68% grain yield of barley compared with mono-cropped barley. Barley remained dominant crop in terms of aggressiveness, relative crowding coefficient and competitive ratio. The amount of water used was linearly increased with increasing size of barley strip from 3 to 8 rows. The highest water use efficiency (4.83 kg/cf3) was recorded for 8-row barley strip system with 120 cm irrigation furrows compared to rest of the planting geometries. In conclusion, 8-rows of barley planted on beds with Egyptian clover in 120 cm irrigation furrows had the highest net income and cost benefit ratio. Therefore, it is recommended that this planting geometry can be used for better economic returns of barley-Egyptian clover intercropping system. However, barley strips with >8 rows were not included in this study, which is limitation of the current study. Therefore, future studies with >8 barley rows in strip should be conducted to infer the economic feasibility and profitability of wider barley strips.