ANAnna Nazimov

Anna Nazimov

*This is an algorithmically generated author record based on publicly available information.

Anna Nazimov has a total of 26 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • CMOS 16FF Digital Power Amplifier RF Reliability Characterization

    by L. Zohar, I. Shternberg, B. Khamaisi, A. Nazimov, A. Ben-Bassat, O. Degani

    This article describes the reliability characterization process of Switched Capacitor Digital Power Amplifier (SCDPA) manufactured in CMOS 16nm FinFet technology. Power Amplifiers operate at RF frequencies (2.4 and 5-7 GHz) in which the instantaneous voltage on the transistor terminals might exceed the maximum rated voltage, Vmax allowed by the process technology. Since the available technology models for reliability degradation under RF conditions are limited, a detailed design analysis for possible failure mechanisms was done, followed by product data collection while operating in RF. In this paper, we describe this process, including SCDPA reliability risk assessment and stress experiments. We explain how in SCDPA the VDD voltage is critical for failure acceleration and not the output power (as in Analog Power Amplifiers). We also show that the initial design suffered from PMOS Negative Bias Temperature Instability (NBTI) which resulted in 2nd harmonics degradation. The NBTI issue was overcome by a novel design in which the bulk voltage is dynamically changed to lower the effective source-gate voltage (Vsg) on the SCDPA PMOS transistors. To stress the SCDPA, we used a setup in which the SCDPA transmits a Continuous Waveform (CW) along with voltage and temperature acceleration. Finally, we show how the dynamic bulk voltage solution was successful in overcoming the NBTI degradation.


  • A Fully Integrated 27-dBm Dual-Band All-Digital Polar Transmitter Supporting 160 MHz for Wi-Fi 6 Applications

    by Assaf Ben-Bassat, Shahar Gross, Aaron Lane, Anna Nazimov, Bassam Khamaisi, Elad Solomon, Elan Banin, Eli Borokhovich, Nahum Kimiagorov, Nati Dinur, et al.

    This work presents a dual-band polar digital transmitter (P-DTX) based on a digitally controlled two-point edge interpolation digital-to-time converter, which is capable of supporting Wi-Fi 6 applications. The proposed P-DTX is fabricated in a standard 28-nm CMOS process. The 2.5/5GHz digital power amplifiers (DPAs) reach a maximum power (PMAX)/power efficiency (PE) of 27 dBm/53% and 27dBm/37%, respectively. The transmitter meets an error vector magnitude (EVM)/DPA PE/total TX power dissipation of -30.5 dB/33%/532 mW for the low band and -29 dB/26%/718 mW for the high band at 6-dB backoff (dBBO) from PMAX. An EVM as low as -40 dB is achieved using digital pre-distortion at 7-8 dBBO, for 20-160-MHz signal bandwidths, thus demonstrating MCS11 1024-QAM OFDM Wi-Fi 6 operation.