M. Belmar-Gil
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
M. Belmar-Gil has a total of 8 co-authors. Here are the top co-authors by number of shared publications:
- Jorge Garcia-Tiscar
CMT—Clean Mobility & Thermofluids, Universitat Politècnica de València, Camino de Vera s/n, 46022 Valencia, Spain
3 shared publications - Marcos Carreres
Universitat Politècnica de València
3 shared publications F.J. Salvador
2 shared publicationsM. Carreres
2 shared publicationsR. Payri
2 shared publicationsA. Broatch
1 shared publication
Latest Publications
- Open Access
- 1 November 2021
- Published by Elsevier in Aerospace Science and Technology
- Vol. 118
Spectral analysis and modelling of the spray liquid injection in a Lean Direct Injection (LDI) gas turbine combustor through Eulerian-Lagrangian Large Eddy Simulations
- 1 November 2021
- Published by Elsevier in Aerospace Science and Technology
- Vol. 118
Open AccessSpectral analysis and modelling of the spray liquid injection in a Lean Direct Injection (LDI) gas turbine combustor through Eulerian-Lagrangian Large Eddy Simulations
- 3 April 2018
- Published by SAE International in SAE International Journal of Advances and Current Practices in Mobility
- Vol. 1
An Investigation on the Fuel Temperature Variations Along a Solenoid Operated Common-Rail Ballistic Injector by Means of an Adiabatic 1D Model
Most studies about common-rail diesel injection consider the fuel flow along the injector as isothermal. This hypothesis is arguable given the small diameter of the orifices along which the fuel flows, together with the expansions that take place across them. These phenomena may provoke variations in the fuel temperature, which in turn modify the fuel properties (i.e. viscosity, density, speed of sound…), thus influencing injector dynamics as well as the fuel atomization and mixing processes. The present investigation accounts for these effects by means of a 1D model for the fuel flow along a common-rail ballistic injector. Local variations of fuel temperature and pressure are considered by the model thanks to the implementation of the adiabatic flow hypothesis. The model, validated against experimental results, allows to estimate the fuel temperature changes along the injector, including the fuel temperature at the injector outlet, as well as the influence of the thermal effects on the injection rate shape. Results show a significant influence of the fuel temperature and its changes on injection rate and duration, especially for low fuel temperatures at the injector inlet, typical of engine cold-start conditions.
- 3 April 2018
- Published by SAE International in SAE International Journal of Advances and Current Practices in Mobility
- Vol. 1
An Investigation on the Fuel Temperature Variations Along a Solenoid Operated Common-Rail Ballistic Injector by Means of an Adiabatic 1D Model
Most studies about common-rail diesel injection consider the fuel flow along the injector as isothermal. This hypothesis is arguable given the small diameter of the orifices along which the fuel flows, together with the expansions that take place across them. These phenomena may provoke variations in the fuel temperature, which in turn modify the fuel properties (i.e. viscosity, density, speed of sound…), thus influencing injector dynamics as well as the fuel atomization and mixing processes. The present investigation accounts for these effects by means of a 1D model for the fuel flow along a common-rail ballistic injector. Local variations of fuel temperature and pressure are considered by the model thanks to the implementation of the adiabatic flow hypothesis. The model, validated against experimental results, allows to estimate the fuel temperature changes along the injector, including the fuel temperature at the injector outlet, as well as the influence of the thermal effects on the injection rate shape. Results show a significant influence of the fuel temperature and its changes on injection rate and duration, especially for low fuel temperatures at the injector inlet, typical of engine cold-start conditions.