APArmando Peña-Duarte

Armando Peña-Duarte

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Armando Peña-Duarte has a total of 72 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Electrochemically Activated Tetra-Metallic Phosphate (Mn–Fe–Co–Ni) Electrocatalyst for the Oxygen Evolution Reaction (OER) in Alkaline Media

    by Yeslie Carrillo Cabrera, José L. Lasso, Armando Peña-Duarte, Carlos R. Cabrera

    The development of highly active and stable oxygen evolution reaction (OER) catalysts based on earth-abundant and low-cost metals remains a major challenge in the field of electrochemical water splitting. Previous studies have shown that metallic and bimetallic phosphates exhibit promising catalytic activity but often suffer from limited long-term stability. In this work, tetrametallic phosphate CoNiFeMn(PO4) microparticles were synthesized using a simple and cost-effective precipitation method with thermal annealing. These microflakes exhibit an average length and width of 4.14 and 1.21 μm, respectively. An electrochemical activation of the catalyst was done by cyclic voltammetry between 1.05 and 1.50 V vs RHE at a scan rate of 10 mV/s in 0.1 M KOH. X-ray photoelectron spectroscopy (XPS) analysis after activation revealed a decrease in the atomic percentage of P from 7.3% to 2.7% and a concomitant increase in O from 74.8% to 78.0%, while the formation of cobalt species with coexisting Co2+ and Co3+ oxidation states, consistent with Co2O3, was observed at a lower scan rate (10 mV s–1). The activated CoNiFeMn(PO4) microflakes demonstrated enhanced OER catalytic activity compared to the RuO2 reference catalyst, achieving an overpotential of 429 mV at 10 mA cm–2 in 0.1 M KOH and 360 mV at 10 mA cm–2 in 1.0 M KOH, with a Tafel slope of 40 mV dec–1, corresponding to the lowest overpotential among the investigated catalysts and 17 mV lower than that of RuO2. In addition, the long-term stability, evaluated by chronopotentiometry on a catalyst-modified GC-RDE at 1600 rpm and at constant current density of 10 mA cm–2 in 0.1 M KOH, showed that RuO2 exhibited a continuous increase in overpotential, exceeding that of CoNiFeMn(PO4) by 235 mV at 9 h, reflecting poor stability due to catalyst dissolution and structural degradation. CoNiFeMn(PO4) maintained a stable overpotential of ∼400 mV over 24 h with only a 7.4 mV variation, confirming its superior durability. The synergistic effect among the four transition metals plays a key role in achieving enhanced OER performance relative to single-metal phosphate catalysts.

  • Open Access

    Stable Uranium Oxide Under Atmospheric Conditions: An Electroplating Technique for U Film Fabrication at Boron-Doped Diamond Electrodes

    by Armando Peña-Duarte, Alexis J. Acevedo-González, Richard M. Lagle, Mebougna Drabo, Stephen U. Egarievwe, Carlos R. Cabrera

    An electrodeposition technique of low-enriched uranium onto boron-doped diamond (BDD) electrodes for uranium electro-assembling, sequestration, uranium electrowinning (as the electroextraction alternative), and future neutron detection applications has been developed. Our findings through physicochemical characterization and an in-depth XPS analysis show that the U/BDD system consists of a blend of uranium oxides with IV, V, and VI oxidation states. Results show that U5+ is present and stable under open atmospheric conditions. The U electrodeposition on BDD creates smooth surfaces, free of voids, with uniform deposition of homogeneous tiny particles of stable uranium oxides, instead of chunky particles, and uranium compound mixtures, like large fibers of the precursor uranyl. Our electrochemical method operates without high temperatures or hazardous compounds. Uranium corrosion and oxidation processes occur spontaneously and parallel to the electrochemical formation of metallic uranium on BDD electrode surfaces, with metallic uranium reacting with water, producing fine particles of UO2. This work represents the first attempt to create a surface of uranium oxides, where the film thickness can be controlled for future applications, e.g., improving sensitivity in neutron detection technologies. Our U electro-assembling method provides a sustainable strategy for uranium electro-recovery from nuclear wastes, immobilizing uranium as a storage method or as U-film fabrication (U/BDD) for future neutron detection applications. Besides, this work contributes to uranium-based technologies, improving them and providing a better understanding of their electrochemical properties, e.g., uranium redox processes, uranium oxides' formation, and stability evaluation. These properties are of remarkable need for uranium-based target formation. The use of our U/BDD method is proposed as an environmental protocol to recover and immobilize uranium-235, and other fissile materials, from civil and defense wastes, contaminated systems, and stockpiles.


  • Open Access

    Autonomous electrochemical system for ammonia oxidation reaction measurements at the International Space Station

    by Camila Morales-Navas, Roberto A. Martínez-Rodríguez, Francisco J. Vidal-Iglesias, Armando Peña, Joesene J. Soto-Pérez, Pedro Trinidad, José Solla-Gullón, Toshko Tzvetkov, Jonathan Doan, Eugene S. Smotkin, et al.

    An autonomous electrochemical system prototype for ammonia oxidation reaction (AOR) measurements was efficiently done inside a 4'' x 4'' x 8'' 2U Nanoracks module at the International Space Station (ISS). This device, the Ammonia Electrooxidation Lab at the ISS (AELISS), included an autonomous electrochemical system that complied with NASA ISS nondisclosure agreements, power, safety, security, size constrain, and material compatibility established for space missions. The integrated autonomous electrochemical system was tested on-ground and deployed to the International Space Station as a “proof-of-concept” ammonia oxidation reaction testing space device. Here are discussed the results of cyclic voltammetry and chronoamperometry measurements done at the ISS with a commercially available channel flow-cell with eight screen-printed electrodes, including Ag quasi-reference (Ag QRE) and carbon counter electrodes. Pt nanocubes in Carbon Vulcan XC-72R were used as the catalyst for the AOR and 2 μL drop of Pt nanocubes/ Carbon Vulcan XC-72R, 20 wt%, ink was placed on the carbon working electrodes and allowed to dry in air. After the AELISS was prepared for launch to the ISS, a 4 days delayed (2 days in the space vehicle Antares and 2 days space transit to the ISS) cause a slight shift on the Ag QRE potential. Nevertheless, the AOR cyclic voltametric peak was observed in the ISS and showed ca. 70% current density decrease due to the buoyancy effect in agreement with previous microgravity experiments done at the zero-g aircraft.


  • [2,1,3]-Benzothiadiazole-Spaced Co-Porphyrin-Based Covalent Organic Frameworks for O2 Reduction

    by Subhajit Bhunia, Armando Peña-Duarte, Huifang Li, Hong Li, Mohamed Noufal, Pranay Saha, Matthew A. Addicoat, Kotaro Sasaki, T. Amanda Strom, Miguel José Yacamán, et al.

    Designing N-coordinated porous single-atom catalysts (SACs) for the oxygen reduction reaction (ORR) is a promising approach to achieve enhanced energy conversion due to maximized atom utilization and higher activity. Here, we report two Co(II)-porphyrin/ [2,1,3]-benzothiadiazole (BTD)-based covalent organic frameworks (COFs; Co@rhm-PorBTD and Co@sql-PorBTD), which are efficient SAC systems for O2 electrocatalysis (ORR). Experimental results demonstrate that these two COFs outperform the mass activity (at 0.85 V) of commercial Pt/C (20%) by 5.8 times (Co@rhm-PorBTD) and 1.3 times (Co@sql-PorBTD), respectively. The specific activities of Co@rhm-PorBTD and Co@sql-PorBTD were found to be 10 times and 2.5 times larger than that of Pt/C, respectively. These COFs also exhibit larger power density and recycling stability in Zn-air batteries compared with a Pt/C-based air cathode. A theoretical analysis demonstrates that the combination of Co-porphyrin with two different BTD ligands affords two crystalline porous electrocatalysts having different d-band center positions, which leads to reactivity differences toward alkaline ORR. The strategy, design, and electrochemical performance of these two COFs offer a pyrolysis-free bottom-up approach that avoids the creation of random atomic sites, significant metal aggregation, or unpredictable structural features.


  • Combined Rotating Disk Slurry Electrodeposition–Spontaneous Galvanic Displacement for Pt-M (M = Co, Ni, and Cu) Catalyst Synthesis for the Oxygen Reduction Reaction in Alkaline Media

    by Joesene J. Soto Pérez, Armando Peña-Duarte, Pedro Trinidad, Gerardo Quintana, Xueru Zhao, Kotaro Sasaki, Miguel José Yacamán, Rubén Mendoza-Cruz, Carlos R. Cabrera


  • Ex Situ and In Situ Analyses of the Mechanism of Electrocatalytic Hydrogen Peroxide Production by CoxZn1–xO (0 < x < 0.018) Materials in Alkaline Media

    by Joselyn Del Pilar Albadalejo, Suheily Alonso-Sevilla, Nicohl I. Cintrón, Xinran Feng, Ángel D. García, Dinorah D. Martínez-Torres, Astrid M. Rodríguez, Natalia I. Román-Montalvo, José I. Torres, Yao Yang, et al.


  • Open Access

    The three pillars of sustainability in education: the sistemic approach of social responsibility

    by Jairo Eduardo Molina, Armando Peña, Edinson Hurtado

    Sustainability should be a cross-cutting theme within the curriculum as a set of essentially attitudinal teaching contents that should become part of the activities proposed in all educational areas. Their incorporation means formalizing an education in values and attitudes not sporadically but constantly throughout each course. However, it is also a poorly understood term that needs to be correctly identified to carry out more effective actions within an educational institution. A topic is transversal if it is important for development and needs, for its success, many teachers from different areas to be involved in it. Therefore, the Universidad del Atlántico in Barranquilla, Colombia is committed to this multidisciplinary project. Three students from 15 classrooms from 3 different careers have been taken to carry out this educational project. This is an analytical observational study of qualitative nature, where the researchers simply attempt to systematically describe the characteristics of categories, and phenomena, then compare constructs and postulates generated from phenomena observed in research context, as well as to discover causal relationships, but avoid assuming a priori constructs or relationships. The general conclusion of the study is that there is a need to broaden the horizons of this study to a much wider population and not only to the educational sector.  


  • Iron Quantum Dots Electro-Assembling on Vulcan XC-72R: Hydrogen Peroxide Generation for Space Applications

    by Armando Peña-Duarte, Santosh H. Vijapur, Timothy D. Hall, Kathleen L. Hayes, Eduardo Larios-Rodríguez, Joselyn Del Pilar-Albaladejo, Mitk’eL B. Santiago, Stephen Snyder, Jennings Taylor, Carlos R. Cabrera

    Highly dispersed iron-based quantum dots (QDs) onto powdered Vulcan XC-72R substrate were successfully electrodeposited by the rotating disk slurry electrodeposition (RoDSE) technique. Our findings through chemical physics characterization revealed that the continuous electron pathway interaction between the interface metal–carbon is controlled. The rotating ring-disk electrode (RRDE) and the prototype generation unit (PGU) of in-situ H2O2 generation in fuel cell experiments revealed a high activity for the oxygen reduction reaction (ORR) via two-electron pathway. These results establish the Fe/Vulcan catalyst at a competitive level for space and terrestrial new materials carriers, specifically for the in-situ H2O2 production. Transmission electron microscopy (TEM) analysis reveals the well-dispersed Fe-based quantum dots with a particle size of 4 nm. The structural and chemical-physical characterization through induced coupled plasma-optical emission spectroscopy (ICP-OES), transmission scanning electron microscopy (STEM), X-ray diffraction (XRD), Raman spectroscopy, X-ray photoelectron spectroscopy (XPS), and X-ray absorption spectroscopy (XAS); reveals that, under atmospheric conditions, our quantum dots system is a Fe2+/3+/Fe3+ combination. The QDs oxidation state tunability was showed by the applied potential. The obtention of H2O2 under the compatibility conditions of the drinking water resources available in the International Space Station (ISS) enhances the applicability of this iron- and carbon-based materials for in-situ H2O2 production in future space scenarios. Terrestrial and space abundance of iron and carbon, combined with its low toxicity and high stability, consolidates this present work to be further extended for the large-scale production of Fe-based nanoparticles for several applications.


  • Potential dependent Ag nanoparticle electrodeposition on Vulcan XC-72R carbon support for alkaline oxygen reduction reaction

    by Melissa Vega-Cartagena, Arnulfo Rojas-Pérez, Guillermo S. Colón-Quintana, Daniel A. Blasini Pérez, Armando Peña-Duarte, Eduardo Larios-Rodríguez, Marco A. De Jesús, Carlos R. Cabrera


  • Open Access

    Electrochemistry for Space Life Support

    by George J. Nelson, Santosh H. Vijapur, Timothy D. Hall, Brittany R. Brown, Armando Peña-Duarte, Carlos R. Cabrera

    Electrochemical technology plays a key role in maintaining habitable environments for human space exploration. Historically, oxygen generation through electrolysis has been a key electrochemical technology for space life support. However, emerging electrochemical technologies are changing the way we process carbon dioxide and urine to supply oxygen and fresh water. Similarly, electrochemical production of hydrogen peroxide can support in-situ resource utilization to produce disinfectants for sanitary needs. These technologies will support space exploration that relies upon closed loop living and is increasingly independent of ground support, opening opportunities for human exploration of the Moon and Mars.