Malgorzata I. Szynkowska-Jozwik
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Malgorzata I. Szynkowska-Jozwik has a total of 9 co-authors. Here are the top co-authors by number of shared publications:
- Aleksandra Pawlaczyk
Institute of General and Ecological Chemistry, Faculty of Chemistry, Lodz University of Technology, Zeromskiego 114, 90-543 Lodz, Poland
2 shared publications - Izabela Witonska
Institute of General and Ecological Chemistry, Faculty of Chemistry, Lodz University of Technology, Zeromskiego 116, 90-924 Lodz, Poland
2 shared publications - Jacek Rogowski
Institute of General and Ecological Chemistry, Lodz University of Technology, ul. Zeromskiego 116, 90-924 Lodz, Poland
2 shared publications - Michal Binczarski
Institute of General and Ecological Chemistry, Faculty of Chemistry, Lodz University of Technology, Zeromskiego 116, 90-924 Lodz, Poland
2 shared publications - Payam Samadi
Institute of General and Ecological Chemistry, Lodz University of Technology, 116 Zeromskiego Street, 90-924 Lodz, Poland
2 shared publications - Beata Smolińska
Institute of Natural Products and Cosmetics, Faculty of Biotechnology and Food Sciences, Lodz University of Technology, 4/10 Stefanowskiego Str., 90-924 Łódź, Poland
1 shared publication
Latest Publications
- Open Access
Zn Modification of Pd/TiO2/Ti Catalyst for CO Oxidation
The main goal of this study was to modify the activity of Pd/TiO2/Ti catalyst in the reaction of CO oxidation by the addition of Zn. Plasma electrolytic oxidation (PEO) of Ti wire was conducted to produce a uniform porous layer of TiO2. A mixture of Pd and Zn was then introduced by means of adsorption. After reduction treatment, the activity of the samples was examined by oxidation of 5% CO in a temperature range from 80–350 °C. Model catalysts with sufficient amounts of the metals for physico-chemical investigation were prepared to further investigate the reaction between Pd and Zn during CO oxidation. The structures and compositions of the samples were investigated using scanning electron microscopy with energy dispersive spectroscopy (SEM-EDS), time-of-flight secondary ion mass spectrometry (TOF-SIMS), inductively coupled plasma mass spectrometry (ICP-MS), Fourier transform infrared (FTIR), and X-ray diffraction (XRD). Modification of Pd/TiO2/Ti catalyst by Zn with a Pd:Zn atomic ratio of 2:1 decreased the temperature of complete CO oxidation from 220 °C for Pd/TiO2/Ti to 180 °C for Pd-Zn/TiO2/Ti. The temperature of 50% CO conversion on Pd-Zn(2:1)/TiO2/Ti was around 55 °C lower than in the reaction on monometallic Pd catalyst. The addition of Zn to the Pd catalyst lowered the binding energy of CO on the surface and improved the dissociative adsorption of oxygen, facilitating the oxidation of CO. FTIR showed that the bridging form of adsorbed CO is preferred on bimetallic systems. Analysis of the surface compositions of the samples (SEM-EDS, TOF-SIMS) showed higher amounts of oxygen on the bimetallic systems.
Open AccessZn Modification of Pd/TiO2/Ti Catalyst for CO Oxidation
The main goal of this study was to modify the activity of Pd/TiO2/Ti catalyst in the reaction of CO oxidation by the addition of Zn. Plasma electrolytic oxidation (PEO) of Ti wire was conducted to produce a uniform porous layer of TiO2. A mixture of Pd and Zn was then introduced by means of adsorption. After reduction treatment, the activity of the samples was examined by oxidation of 5% CO in a temperature range from 80–350 °C. Model catalysts with sufficient amounts of the metals for physico-chemical investigation were prepared to further investigate the reaction between Pd and Zn during CO oxidation. The structures and compositions of the samples were investigated using scanning electron microscopy with energy dispersive spectroscopy (SEM-EDS), time-of-flight secondary ion mass spectrometry (TOF-SIMS), inductively coupled plasma mass spectrometry (ICP-MS), Fourier transform infrared (FTIR), and X-ray diffraction (XRD). Modification of Pd/TiO2/Ti catalyst by Zn with a Pd:Zn atomic ratio of 2:1 decreased the temperature of complete CO oxidation from 220 °C for Pd/TiO2/Ti to 180 °C for Pd-Zn/TiO2/Ti. The temperature of 50% CO conversion on Pd-Zn(2:1)/TiO2/Ti was around 55 °C lower than in the reaction on monometallic Pd catalyst. The addition of Zn to the Pd catalyst lowered the binding energy of CO on the surface and improved the dissociative adsorption of oxygen, facilitating the oxidation of CO. FTIR showed that the bridging form of adsorbed CO is preferred on bimetallic systems. Analysis of the surface compositions of the samples (SEM-EDS, TOF-SIMS) showed higher amounts of oxygen on the bimetallic systems.
- Open Access
CO Oxidation over Pd Catalyst Supported on Porous TiO2 Prepared by Plasma Electrolytic Oxidation (PEO) of a Ti Metallic Carrier
A porous TiO2 layer was prepared with the plasma electrolytic oxidation (PEO) of Ti. In a further step, Pd was deposited on the TiO2 surface layer using the adsorption method. The activity of the Pd/TiO2/Ti catalyst was investigated during the oxidation of CO to CO2 in a mixture of air with 5% CO. The structure of the catalytic active layer was studied using a scanning electron microscope equipped with an energy dispersive spectrometer (SEM-EDS), time-of-flight secondary ion mass spectrometry (TOF-SIMS), inductively coupled plasma mass spectrometry (ICP-MS), and X-ray diffraction (XRD). The PEO process provided a porous TiO2 layer with a uniform thickness in the range of 5–10 µm, which is desirable for the production of Pd-supported catalysts. A TOF-SIMS analysis showed the formation of Pd nanoparticles after the adsorption treatment. The conversion of CO to CO2 in all samples was achieved at 150–280 °C, depending on the concentration of Pd. The composition of Pd/ TiO2/Ti was determined using ICP-MS. The optimum concentration of Pd on the surface of the catalyst was approximately 0.14% wt. This concentration was obtained when a 0.4% PdCl2 solution was used in the adsorption process. Increasing the concentration of PdCl2 did not lead to a further improvement in the activity of Pd/ TiO2/Ti.
Open AccessCO Oxidation over Pd Catalyst Supported on Porous TiO2 Prepared by Plasma Electrolytic Oxidation (PEO) of a Ti Metallic Carrier
A porous TiO2 layer was prepared with the plasma electrolytic oxidation (PEO) of Ti. In a further step, Pd was deposited on the TiO2 surface layer using the adsorption method. The activity of the Pd/TiO2/Ti catalyst was investigated during the oxidation of CO to CO2 in a mixture of air with 5% CO. The structure of the catalytic active layer was studied using a scanning electron microscope equipped with an energy dispersive spectrometer (SEM-EDS), time-of-flight secondary ion mass spectrometry (TOF-SIMS), inductively coupled plasma mass spectrometry (ICP-MS), and X-ray diffraction (XRD). The PEO process provided a porous TiO2 layer with a uniform thickness in the range of 5–10 µm, which is desirable for the production of Pd-supported catalysts. A TOF-SIMS analysis showed the formation of Pd nanoparticles after the adsorption treatment. The conversion of CO to CO2 in all samples was achieved at 150–280 °C, depending on the concentration of Pd. The composition of Pd/ TiO2/Ti was determined using ICP-MS. The optimum concentration of Pd on the surface of the catalyst was approximately 0.14% wt. This concentration was obtained when a 0.4% PdCl2 solution was used in the adsorption process. Increasing the concentration of PdCl2 did not lead to a further improvement in the activity of Pd/ TiO2/Ti.
- Open Access
Comparison of the Impact of Different Types of nZVI on Lolium westerwoldicum
Increasing environmental pollution causes the search for new methods of purification. Currently, the remediation potential of nanoparticles is increasingly being studied. Unfortunately, there is still a lack of data on the impact of these compounds on living organisms, including plants. This study was designed to test the effects of nanoFER 25 and nanoFER 25S iron on Lolium westerwoldicum Breakw. After cultivation of plants in a soil contaminated with nanoparticles, the biometric parameters, content of polyphenols, flavonoids, chlorophyll changes, carotenoids, anthocyanins, superoxide dismutase, catalase and pyrogallol peroxidase were studied. The conducted experiment showed that nano zero-valent iron (nZVI) is slightly taken from the soil to the plants. The iron passes to the root but there is no further transport up the plant. The content of polyphenols and flavonoids in aboveground parts of plants decreases with a simultaneous increase in roots compared to the control sample. The chlorophyll content in the leaves is strongly related to the concentration of the contaminant. Similarly, the enzyme activity of the antioxidant system in the whole plant is strongly related to the concentration of the pollutant. The amount of vegetable pigments in the leaves increases for low concentrations of contamination and then decreases at higher levels of contamination. The study has shown that both types of nanoFER are not indifferent to the plants’ growth.
Open AccessComparison of the Impact of Different Types of nZVI on Lolium westerwoldicum
Increasing environmental pollution causes the search for new methods of purification. Currently, the remediation potential of nanoparticles is increasingly being studied. Unfortunately, there is still a lack of data on the impact of these compounds on living organisms, including plants. This study was designed to test the effects of nanoFER 25 and nanoFER 25S iron on Lolium westerwoldicum Breakw. After cultivation of plants in a soil contaminated with nanoparticles, the biometric parameters, content of polyphenols, flavonoids, chlorophyll changes, carotenoids, anthocyanins, superoxide dismutase, catalase and pyrogallol peroxidase were studied. The conducted experiment showed that nano zero-valent iron (nZVI) is slightly taken from the soil to the plants. The iron passes to the root but there is no further transport up the plant. The content of polyphenols and flavonoids in aboveground parts of plants decreases with a simultaneous increase in roots compared to the control sample. The chlorophyll content in the leaves is strongly related to the concentration of the contaminant. Similarly, the enzyme activity of the antioxidant system in the whole plant is strongly related to the concentration of the pollutant. The amount of vegetable pigments in the leaves increases for low concentrations of contamination and then decreases at higher levels of contamination. The study has shown that both types of nanoFER are not indifferent to the plants’ growth.