Gordon Rinke
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Gordon Rinke has a total of 31 co-authors. Here are the top co-authors by number of shared publications:
- Amaia Zurutuza
Graphenea San Sebastián Spain
2 shared publications - Andreas Hemmetter
Advanced Microelectronic Center Aachen (AMICA), AMO GmbH, Aachen, Germany
2 shared publications Arantxa Maestre
Graphenea S.A., San Sebastian, Spain
2 shared publications- Bartos Chmielak
AMO GmbH, Aachen, Germany
2 shared publications Bianca Robertz
AMO GmbH, Aachen, Germany
2 shared publications- Bárbara Canto
AMO GmbH Advanced Microelectronic Center Aachen Aachen Germany
2 shared publications
Latest Publications
- Open Access
- 6 February 2025
- Published by Springer Nature in Nature Communications
- Vol. 16 (1) , 1-10
Multi-project wafer runs for electronic graphene devices in the European 2D-Experimental Pilot Line project
The commercialization of electronic devices based on graphene has not yet been successful, even 20 years after its first isolation. To this end, the European Commission is supporting research toward establishing a European experimental pilot line for electronic and optoelectronic devices based on graphene and related two-dimensional (2D) materials, namely the Experimental Pilot Line (2D-EPL) project. Here, we report the results obtained during the first and third multi-project wafer (MPW) runs completed at the end of 2022 (MPW run 1) and 2023 (MPW run 3) as an outcome of the 2D-EPL. Test devices were measured across the wafers to assess the device quality and variability before delivering the fabricated dies to the customers. Raman spectroscopy confirmed minimal structural changes in the graphene caused by the fabrication process, while electrical measurements of two different device types verified the device specifications defined in the process design kit.
- 6 February 2025
- Published by Springer Nature in Nature Communications
- Vol. 16 (1) , 1-10
Open AccessMulti-project wafer runs for electronic graphene devices in the European 2D-Experimental Pilot Line project
The commercialization of electronic devices based on graphene has not yet been successful, even 20 years after its first isolation. To this end, the European Commission is supporting research toward establishing a European experimental pilot line for electronic and optoelectronic devices based on graphene and related two-dimensional (2D) materials, namely the Experimental Pilot Line (2D-EPL) project. Here, we report the results obtained during the first and third multi-project wafer (MPW) runs completed at the end of 2022 (MPW run 1) and 2023 (MPW run 3) as an outcome of the 2D-EPL. Test devices were measured across the wafers to assess the device quality and variability before delivering the fabricated dies to the customers. Raman spectroscopy confirmed minimal structural changes in the graphene caused by the fabrication process, while electrical measurements of two different device types verified the device specifications defined in the process design kit.
- Open Access
- 23 September 2024
- Published by Springer Nature in Research Square
Multi-Project Wafer Runs for Electronic Graphene Devices in the European Project “2D-Experimental Pilot Line”
Commercializing electronic devices based on graphene has not yet occurred, even nearly 20 years after its discovery. To this end, the European Commission supports research toward establishing a European experimental pilot line for electronic and optoelectronic devices based on graphene and related two-dimensional (2D) materials, the 2D Experimental Pilot Line (2D-EPL) project. Here, we report the experience of the first and third multi-project wafer (MPW) runs completed at the end of 2022 (MPW run 1) and 2023 (MPW run 3) as an outcome of the 2D-EPL. Test devices were measured across the wafers to assess the device quality and variability before delivering the dies to the customers. Raman spectroscopy confirmed minimal structural changes in the graphene caused by the fabrication process, while electrical measurements of two different device types verified the device specifications defined in the process design kit.
- 23 September 2024
- Published by Springer Nature in Research Square
Open AccessMulti-Project Wafer Runs for Electronic Graphene Devices in the European Project “2D-Experimental Pilot Line”
Commercializing electronic devices based on graphene has not yet occurred, even nearly 20 years after its discovery. To this end, the European Commission supports research toward establishing a European experimental pilot line for electronic and optoelectronic devices based on graphene and related two-dimensional (2D) materials, the 2D Experimental Pilot Line (2D-EPL) project. Here, we report the experience of the first and third multi-project wafer (MPW) runs completed at the end of 2022 (MPW run 1) and 2023 (MPW run 3) as an outcome of the 2D-EPL. Test devices were measured across the wafers to assess the device quality and variability before delivering the dies to the customers. Raman spectroscopy confirmed minimal structural changes in the graphene caused by the fabrication process, while electrical measurements of two different device types verified the device specifications defined in the process design kit.
- 3 March 2021
- Published by American Chemical Society (ACS) in Journal of the American Society for Mass Spectrometry
- Vol. 32 (7) , 1648-1658
Material and Charge Transport of Large Organic Salt Clusters and Nanoparticles in Electrospray Ion Beam Deposition
Electrospray ion beam deposition (ES-IBD) or ion soft landing has been demonstrated as a technique suitable for processing nonvolatile molecules in vacuum under perfectly controlled conditions, an approach also desirable for the deposition of nanoparticles. Here, we present results from several approaches to generate, characterize, and deposit nanoparticle ion beams in vacuum for deposition. We focus on cluster ion beams generated by ESI of organic salt solutions. Small cluster ions of the salts appear in the mass spectra as defined peaks. In addition, we find nanoparticle-sized aggregates, appearing as a low intensity background at high m/z-ratio, and show by IBD experiments that these clusters carry the major amount of material in the ion beam. This transition from clusters to nanoparticles, and their successful deposition, shows that ES-IBD can in principle handle ion beams of very heavy and highly charged nanoparticles. In related experiments, however, we found the deposition of nanoparticles from dispersions to be of low reproducibility, due to the lack of control by mass spectrometry.
- 3 March 2021
- Published by American Chemical Society (ACS) in Journal of the American Society for Mass Spectrometry
- Vol. 32 (7) , 1648-1658
Material and Charge Transport of Large Organic Salt Clusters and Nanoparticles in Electrospray Ion Beam Deposition
Electrospray ion beam deposition (ES-IBD) or ion soft landing has been demonstrated as a technique suitable for processing nonvolatile molecules in vacuum under perfectly controlled conditions, an approach also desirable for the deposition of nanoparticles. Here, we present results from several approaches to generate, characterize, and deposit nanoparticle ion beams in vacuum for deposition. We focus on cluster ion beams generated by ESI of organic salt solutions. Small cluster ions of the salts appear in the mass spectra as defined peaks. In addition, we find nanoparticle-sized aggregates, appearing as a low intensity background at high m/z-ratio, and show by IBD experiments that these clusters carry the major amount of material in the ion beam. This transition from clusters to nanoparticles, and their successful deposition, shows that ES-IBD can in principle handle ion beams of very heavy and highly charged nanoparticles. In related experiments, however, we found the deposition of nanoparticles from dispersions to be of low reproducibility, due to the lack of control by mass spectrometry.
- 20 April 2012
- Published by Wiley in Advanced Materials
- Vol. 24 (20) , 2761-2767
Crystalline Inverted Membranes Grown on Surfaces by Electrospray Ion Beam Deposition in Vacuum
Crystalline inverted membranes of the nonvolatile surfactant sodium dodecylsulfate are found on solid surfaces after electrospray ion beam deposition (ES‐IBD) of large SDS clusters in vacuum. This demonstrates the equivalence of ES‐IBD to conventional molecular beam epitaxy.
- 20 April 2012
- Published by Wiley in Advanced Materials
- Vol. 24 (20) , 2761-2767
Crystalline Inverted Membranes Grown on Surfaces by Electrospray Ion Beam Deposition in Vacuum
Crystalline inverted membranes of the nonvolatile surfactant sodium dodecylsulfate are found on solid surfaces after electrospray ion beam deposition (ES‐IBD) of large SDS clusters in vacuum. This demonstrates the equivalence of ES‐IBD to conventional molecular beam epitaxy.