TMTakashi Manago

Takashi Manago

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Takashi Manago has a total of 50 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Mode-separation-induced spectral dip in width-modulated magnonic crystals

    by Takashi Manago, Tomonari Matsunaga, Taisuke Horaguchi

    Width-modulated magnonic crystals (MCs) are waveguides whose width is periodically varied on a length scale comparable to the spin-wave wavelength. Using micromagnetic simulations, we show that the spectral dip observed in the spin-wave spectrum of a micrometer-scale width-modulated MC does not originate from a Bragg-reflection-induced band gap. Instead, it arises from a separation between two distinct bands associated with spin waves predominantly propagating in the central strip and in the widened arm regions. Although the periodic width modulation produces an internal-field modulation via the demagnetizing field, its amplitude remains below 7 mT within the range of center ±0.4 μ m of the central strip in the 1.5 μ m central strip considered here, which is insufficient to induce appreciable Bragg reflection. These results clarify the mechanism behind the observed spectral dip and indicate that demagnetizing-field-induced modulation alone is unlikely to yield robust Bragg band gaps in micrometer-order width-modulated MCs.

  • Wall material dependence of the band gap in magnonic crystals

    by Tomonari Matsunaga, Taisuke Horaguchi, Kenji Kasahara, Takashi Manago

    Controlling the propagation of spin waves is a significant and fundamental challenge in the development of magnonic devices. One of the most promising candidates for this challenge is the magnonic crystal (MC). The band gap (BG) properties of MCs with surface periodic steps primarily depend on the magnetic properties of the material and the structural period. We have fabricated MCs by adding walls to the base layer, rather than forming grooves in the film. This technique enables the use of different materials for the base layer and the wall layers. By using Co walls on a Permalloy (Py) base layer, instead of an MC consisting entirely of Py, we have successfully doubled the BG width, as supported by micromagnetic simulations. In this BG enhancement, the lower edge of the BG remains almost unchanged, while the upper edge of the BG is shifted upward. These findings provide a novel method of band engineering for MCs and enhance their design flexibility.


  • Modulation of magnonic band structure via wall width variations in 1D magnonic crystals

    by Taisuke Horaguchi, Yuma Takeda, Takashi Manago

    Magnonic crystals are artificial periodic structures that enable control over spin-wave propagation by introducing bandgaps (BGs) in the magnonic band structure. In this study, we systematically investigate how the wall-to-valley width ratio affects the magnonic band structure in one-dimensional magnonic crystals. Micromagnetic simulations demonstrate that as the wall width increases, the BG frequencies shift higher due to an increase in the effective film thickness. Additionally, the BG width exhibits an oscillatory dependence on the wall-to-valley ratio. These behaviors are attributed to changes in the effective film thickness of the entire magnonic crystal and the local wavelength matching to the wall and valley lengths. Furthermore, we developed a Kronig–Penney model incorporating the spin-wave dispersion relation, which reasonably reproduces the band structure observed in micromagnetic simulations. This framework provides a fundamental basis for designing magnonic band structures with tailored properties. Our findings highlight the tunability of magnonic band structures via structural modulation, offering potential applications in spin-wave-based computing and magnonic logic devices.


  • Spin wave excitation and detection using different meander-shaped antennas: experiment and simulation

    by Taiga Hara, Kenji Kasahara, Mustafa M Aziz, Takashi Manago

    The excitation and detection of spin waves (SWs) with specific wavenumbers is very important not only for fundamental SW research but also for the development of future SW devices. Conventional SW theoretical and numerical studies focused on the excitation of dynamic magnetization in waveguides, and did not address the practical limitations imposed by the geometry and configuration of the detection antenna. Using the finite element method, we calculated the induced current with meander-shaped antennas on the detection side, and succeeded in simulating the wavenumber filter effect of SW signals on detection. This was confirmed using experimental measurements on permalloy waveguides. In addition, we investigated, using simulation and experimentally, the effects of combinations of different meander-shaped antennas and broadband signal-ground antennas for excitation and detection. It is found advantageous to set the meander antenna on the detection side to enable filtering and selectivity of SW wavenumber. These findings are important for the development of SW devices.


  • Intensity nonreciprocity reversal of spin wave in magnonic crystal by specific wavenumber excitation

    by Taiga Hara, Kenji Kasahara, Takashi Manago

    Spin wave propagation in a magnonic crystal excited at a specific wavenumber was investigated by micromagnetic simulation modelling with meander-shaped antennae. The dispersion relation when excited at wave number k which corresponds to the boundary of the Brillouin zone, shows a pair of strong spots that originate from the magnonic upper and lower bands. When excited at wavenumber slightly offset from k above, additional strong spots appear and it shows intensity nonreciprocity reversal. It can be interpreted in terms of the repeated or reduced zone scheme of the Brillouin zone. These characteristics have the potential for novel control of nonreciprocity.


  • Open Access

    Thickness dependences of the dynamic magnetic properties of epitaxial YIG films prepared by a metal–organic decomposition method

    by Kenji Kasahara, Shingo Sueda, Takashi Manago

    Epitaxial yttrium-iron garnet (YIG) films with various thicknesses were fabricated on gadolinium-gallium garnet substrates by a metal–organic decomposition (MOD) method, and their dynamic and static magnetic properties were investigated. We varied the thickness of the YIG films by repeating spin-coating of the MOD solution and pre-annealing. The lattice constant and the crystal size of the YIG films were almost independent of the thickness (the coating count N). The damping factor and coercive field increased with N. Moreover, the saturation magnetization MS measured using a vibrating sample magnetometer increased with N, although that measured by ferromagnetic resonance was almost independent of N. Thus, both dynamic and static magnetic properties for the YIG films obviously degraded with increasing N. Judging from these results, the repetition of the coating process generates other ferromagnetic micro-crystalline phases at grain boundaries, for instance, γ-Fe2O3 and Fe3O4, which could cause degradation of the magnetic properties of the YIG films prepared by the MOD method.


  • Spin wave propagation and nonreciprocity in metallic magnonic quasi-crystals

    by Takashi Manago, Kanta Fujii, Kenji Kasahara, Kazuyuki Nakayama

    The characteristics of spin waves (SWs) propagating in Fibonacci magnonic quasi-crystals (MQCs) were investigated in micromagnetic simulations. The SWs feel 1/3 of the characteristic Fibonacci sequence length as a period, and mini band gaps reflected by MQCs are formed. The effect of the MQC on the SW’s propagation becomes prominent above the first band gap frequency. The properties of SWs in MQCs generally depend on the propagation direction, because SWs feel different structures depending on the direction. Therefore, the nonreciprocity (NR) characteristics becomes complex. The NR characteristics change at every band gap frequency and hence across the frequency regions defined by them. In particular, some frequency regions have almost no NR, while others have enhanced NR and some have even negative NR. These characteristics seem to provide a new way to control NR.


  • Open Access

    Ferromagnetic-waveguide width dependence of propagation properties for magnetostatic surface spin waves

    by Kenji Kasahara, Ryusei Akamatsu, Takashi Manago

    The width dependence of propagation properties for magnetostatic surface spin waves (MSSWs) in Permalloy (Py) waveguides was investigated experimentally and numerically. When both the short-side width of a Py waveguide (WPy) and the magnetic field (μ0H) were large enough, the spin wave (SW) intensity almost linearly decreased with decreasing WPy, and the resonant frequency fr was almost independent of WPy. However, when both WPy and μ0H were small, the SW intensity rapidly reduced, and fr decreased with decreasing WPy. Micromagnetic simulations revealed that when both WPy and μ0H are large enough, the magnetization direction of Py is almost parallel to the magnetic field direction, and the SW mode becomes the MSSW mode. In contrast, when both WPy and μ0H are small, magnetization direction tilts to the long-side direction of the Py strip from the magnetic field direction due to a strong demagnetizing field, which is the origin of the unexpected reduction in the intensity and fr. When miniaturized ferromagnetic waveguides are used for shrinking MSSW devices, a sufficiently large magnetic field is necessary because the influence of the shape magnetic anisotropy cannot be ignored.


  • Open Access

    Optically detected spin–orbit torque ferromagnetic resonance in an in-plane magnetized ellipse

    by P. S. Keatley, K. Chatzimpaloglou, T. Manago, P. Androvitsaneas, T. H. J. Loughran, R. J. Hicken, G. Mihajlović, L. Wan, Y. Choi, J. A. Katine

    Time-resolved scanning Kerr microscopy has been used to perform optically detected, phase-resolved spin–orbit torque ferromagnetic resonance (SOT-FMR) measurements on a microscale CoFeB ellipse at the center of a Pt Hall cross subject to RF and DC current. Time-resolved polar Kerr images revealed localized dynamics with large amplitude at the center and weaker amplitude at the edges. Therefore, field swept SOT-FMR spectra were acquired from the so-called center mode to probe the SOTs active at the center of the ellipse, thus minimizing non-uniform edge contributions. When the magnetic field was applied at 30° from the hard axis of the ellipse and a DC current was applied, a marked asymmetry was observed in the amplitude and linewidth of the FMR peaks as the applied field was reversed. Both absorptive and dispersive parts of the spectra were in good agreement with a macrospin calculation. The damping parameter (α) and the Slonczewski torque parameter were determined to be 0.025 and (6.75 ± 0.75) × 10−7 Oe A−1 cm2, respectively. The hard axis SOT-FMR linewidth was found to be almost independent of the DC current value, suggesting that the SOT has a minimal influence in the hard axis configuration and that thermal effects were insignificant. This study paves the way for spatially resolved measurements of SOT probed using localized modes of microscale devices that go beyond the spatially averaged capability of electrical measurement techniques.


  • Open Access

    Composition optimization of InAsxSb1−x/AlyIn1−ySb quantum wells for Hall sensors with high sensitivity and high thermal stability

    by Takashi Manago, Kenji Kasahara, Ichiro Shibasaki

    The band diagrams of InAsxSb1−x/AlyIn1−ySb quantum wells (QWs) were calculated covering a wide range of compositions of x and y. Various combinations of active (InAsxSb1−x) and barrier (AlyIn1−ySb) layers were investigated to optimize the Hall elements with high sensitivity and high thermal stability. For high sensitivity, x of 0.1–0.6 is desirable due to the band bowing effect to realize lower bandgaps compared with that of InSb in the active layer. Under the lattice matched conditions (y ∼ 1.22x), the QWs are type II QWs and the bottom of the conduction band is always lower than the Fermi level. Therefore, the QWs with x of 0.6 show large sheet carriers of 4.1 × 1011 cm−2 for 4.2 K without intentional doping, which contributes to the reduction in the temperature dependence of the transport properties. The barrier height monotonously increases with increasing y, and accordingly, the penetration depth of the wave function probability inside the barrier decreases. Under the lattice matched condition, the penetration depth drops significantly toward x = 0.4 (corresponding y ∼ 0.5) and then decreases slowly. Thus, x ≥ 0.4 (y ≥ 0.5) is preferable for a strong confinement effect, which could reduce interface scattering and, as a result, improve the electron mobility. Judging from these results, the optimized composition of the InAsxSb1−x/AlyIn1−ySb QW is x = 0.4–0.6 (under the lattice matched condition, corresponding y = 0.5–0.7).