Shi-Gang Fang
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Shi-Gang Fang has a total of 9 co-authors. Here are the top co-authors by number of shared publications:
- Shi-Wei Qu
School of Electronic Science and Engineering University of Electronic Science and Technology of China (UESTC) Chengdu China
4 shared publications - Shiwen Yang
University of Electronic Science and Technology of China (UESTC)
3 shared publications Hong-Bing Sun
Key Laboratory of Antennas and Microwave Technology, Nanjing Research Institute of Electronics Technology, Nanjing, China
1 shared publication- Jun Hu
University of Electronic Science and Technology of China
1 shared publication - Peng-Fa Li
University of Electronic Science and Technology of China (UESTC)
1 shared publication Xiao-Qiu Li
Key Laboratory of Antennas and Microwave Technology, Nanjing Research Institute of Electronics Technology, Nanjing, China
1 shared publication
Latest Publications
- 23 October 2025
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Antennas and Propagation
- Vol. 74 (2) , 2065-2070
Wideband Low-Scattering Dual-Polarized Phased Array With Stepped Ground
This communication proposes a wideband dual-polarized phased array with ultra-wideband scattering cross section (SCS) reduction. The antenna elements are loaded on a bilateral stepped ground. This ground is carefully designed in terms of height difference, step number, and length to achieve phase cancellation near the normal direction. Wideband dipoles with vertical electric coupling are designed. The radiation frequency band covers the X-band (40%) under VSWR < 2.8. Array patterns are synthesized with the two subarrays, covering the -45° ~ +45° scanning range. The monostatic SCSs of the proposed 17 × 8 array prototype have been reduced within 3.6 ~ 30 GHz, with an averaged reduction of over 19.4/18.9 dB and an averaged in-band reduction of over 15.4/16.6 dB, under the normal x/y polarized incident waves respectively.
- 23 October 2025
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Antennas and Propagation
- Vol. 74 (2) , 2065-2070
Wideband Low-Scattering Dual-Polarized Phased Array With Stepped Ground
This communication proposes a wideband dual-polarized phased array with ultra-wideband scattering cross section (SCS) reduction. The antenna elements are loaded on a bilateral stepped ground. This ground is carefully designed in terms of height difference, step number, and length to achieve phase cancellation near the normal direction. Wideband dipoles with vertical electric coupling are designed. The radiation frequency band covers the X-band (40%) under VSWR < 2.8. Array patterns are synthesized with the two subarrays, covering the -45° ~ +45° scanning range. The monostatic SCSs of the proposed 17 × 8 array prototype have been reduced within 3.6 ~ 30 GHz, with an averaged reduction of over 19.4/18.9 dB and an averaged in-band reduction of over 15.4/16.6 dB, under the normal x/y polarized incident waves respectively.
- 26 June 2024
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Antennas and Propagation
- Vol. 72 (8) , 6437-6447
Broadband Wide-Scanning Large-Curvature Cylindrical Conformal Dipole Array Antenna With Low-Scattering Characteristics
A 1–2 GHz wide-scanning cylindrical conformal array antenna with a large curvature is proposed in this paper. A novel dipole element with integrated feeding balun is proposed, featuring a bending angle of 30° in the E plane, and a metal wall is employed to suppress common-mode resonance. Optimizations based on a cylindrical conformal subarray further improve the beam scanning ability. According to the analyses, the element large-curvature bending suppresses the edge element impedance mismatch and array beam pointing deviation. In addition, the cylindrical contour of proposed array leads to an obvious scattering cross section reduction (SCSR) compared to flat metal ground, and the co-polarized SCSR is enlarged by in-band absorptions of array elements. To increase the cross-polarized SCSR, a cross-polarized absorbing structure terminated by resistor is designed in the flexible impedance matching layer of a polyimide film. Consequently, the proposed conformal dipole array antenna achieves both notable co-/cross-polarized in-band monostatic SCSRs, as well as the beam scanning in the E/H planes within ±75°/±60°. The correctness of proposed design method is verified by the experiment on an 8×6 cylindrical conformal array prototype, and the measured results demonstrate the broadband wide-scanning performances and low-scattering characteristics.
- 26 June 2024
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Antennas and Propagation
- Vol. 72 (8) , 6437-6447
Broadband Wide-Scanning Large-Curvature Cylindrical Conformal Dipole Array Antenna With Low-Scattering Characteristics
A 1–2 GHz wide-scanning cylindrical conformal array antenna with a large curvature is proposed in this paper. A novel dipole element with integrated feeding balun is proposed, featuring a bending angle of 30° in the E plane, and a metal wall is employed to suppress common-mode resonance. Optimizations based on a cylindrical conformal subarray further improve the beam scanning ability. According to the analyses, the element large-curvature bending suppresses the edge element impedance mismatch and array beam pointing deviation. In addition, the cylindrical contour of proposed array leads to an obvious scattering cross section reduction (SCSR) compared to flat metal ground, and the co-polarized SCSR is enlarged by in-band absorptions of array elements. To increase the cross-polarized SCSR, a cross-polarized absorbing structure terminated by resistor is designed in the flexible impedance matching layer of a polyimide film. Consequently, the proposed conformal dipole array antenna achieves both notable co-/cross-polarized in-band monostatic SCSRs, as well as the beam scanning in the E/H planes within ±75°/±60°. The correctness of proposed design method is verified by the experiment on an 8×6 cylindrical conformal array prototype, and the measured results demonstrate the broadband wide-scanning performances and low-scattering characteristics.
- 27 January 2023
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Antennas and Propagation
- Vol. 71 (3) , 2808-2813
Low-Scattering X-Band Planar Phased Vivaldi Array Antenna
A low-scattering X-band planar phased Vivaldi array antenna is proposed in this paper. To reduce the scattering cross section (SCS) of the antenna, two types of Vivaldi elements with the defected ground structures (DGSs) are designed, as well as an embedded absorbing array. Under the normal co-polarized (co-pol) incident waves, the reflections of the two Vivaldi elements are close in magnitude but out of phase. Hence, the scattering of the two elements cancel out in the normal direction. Besides, the problem of obvious bistatic SCS peaks, which always arise when utilizing the phase cancellation method to achieve SCS reduction (SCSR), is solved by the interlacing arrangement of the two elements. Under the cross-polarized (cr-pol) incident waves, the incident power is mostly received and absorbed by the absorbing array, which is composed of the dipole elements in the array center and the slot elements on two edges. According to the measured results, the proposed phased Vivaldi array antenna achieves notable cr-pol SCSR over 6~18GHz, and the average in-band co-pol SCSR reaches 20dB simultaneously, without any deterioration on the radiation and scanning performances compared to a referenced one.
- 27 January 2023
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Antennas and Propagation
- Vol. 71 (3) , 2808-2813
Low-Scattering X-Band Planar Phased Vivaldi Array Antenna
A low-scattering X-band planar phased Vivaldi array antenna is proposed in this paper. To reduce the scattering cross section (SCS) of the antenna, two types of Vivaldi elements with the defected ground structures (DGSs) are designed, as well as an embedded absorbing array. Under the normal co-polarized (co-pol) incident waves, the reflections of the two Vivaldi elements are close in magnitude but out of phase. Hence, the scattering of the two elements cancel out in the normal direction. Besides, the problem of obvious bistatic SCS peaks, which always arise when utilizing the phase cancellation method to achieve SCS reduction (SCSR), is solved by the interlacing arrangement of the two elements. Under the cross-polarized (cr-pol) incident waves, the incident power is mostly received and absorbed by the absorbing array, which is composed of the dipole elements in the array center and the slot elements on two edges. According to the measured results, the proposed phased Vivaldi array antenna achieves notable cr-pol SCSR over 6~18GHz, and the average in-band co-pol SCSR reaches 20dB simultaneously, without any deterioration on the radiation and scanning performances compared to a referenced one.
- 1 January 2021
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Antennas and Wireless Propagation Letters
- Vol. 20 (3) , 308-312
Low Scattering Patch Array Antenna Based on Grooved Ground
A grooved metal ground with slits is utilized to achieve scattering cross section (SCS) reduction of a microstrip patch array antenna in this letter. By arranging the grooves and slits on the ground, 180° scattering phase differences between the elements on the ground and in the grooves are attained on the aperture, and obvious SCS reduction is obtained in a broadband. The proposed low-SCS microstrip patch array antenna is fabricated and measured in an anechoic chamber. Experimental results show that the proposed array antenna can scan up to ±60° in the E-plane and ±45° in the H-plane within the band of 10-10.6 GHz, and realizes a notable monostatic SCS reduction within the band of 7.8-13 GHz.
- 1 January 2021
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Antennas and Wireless Propagation Letters
- Vol. 20 (3) , 308-312
Low Scattering Patch Array Antenna Based on Grooved Ground
A grooved metal ground with slits is utilized to achieve scattering cross section (SCS) reduction of a microstrip patch array antenna in this letter. By arranging the grooves and slits on the ground, 180° scattering phase differences between the elements on the ground and in the grooves are attained on the aperture, and obvious SCS reduction is obtained in a broadband. The proposed low-SCS microstrip patch array antenna is fabricated and measured in an anechoic chamber. Experimental results show that the proposed array antenna can scan up to ±60° in the E-plane and ±45° in the H-plane within the band of 10-10.6 GHz, and realizes a notable monostatic SCS reduction within the band of 7.8-13 GHz.