B. Donkova
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Research Interests
B. Donkova has a total of 7 co-authors. Here are the top co-authors by number of shared publications:
- D. Mehandjiev
Bulgarian Academy of Sciences
2 shared publications Dimitar R. Mehandjiev
Institute of General and Inorganic Chemistry, Bulgarian Academy of Sciences, Acad. G. Bonchev Str., bl 11, Sofia, 1113, Bulgaria
2 shared publicationsJ. Pencheva
University of Rousse, ul. Students 8, 7000 Rousse, Bulgaria
1 shared publicationKatja I. Milenova
Institute of General and Inorganic Chemistry, Bulgarian Academy of Sciences, Acad. G. Bonchev Str., bl 11, Sofia, 1113, Bulgaria
1 shared publicationKatya I. Milenova
Institute of General and Inorganic Chemistry, Bulgarian Academy of Sciences, Acad. G. Bonchev Str., bl 11, Sofia 1113, Bulgaria
1 shared publicationM. Djarova
Faculty of Chemistry, University of Sofia, bul. James Bourchier 1, 1164 Sofia, Bulgaria
1 shared publication
Latest Publications
- Open Access
- 1 March 2008
- Published by Walter de Gruyter GmbH in Open Chemistry
- Vol. 6 (1) , 115-124
Investigation on the catalytic activity of doped low-percentage oxide catalysts Mn/ZnO obtained from oxalate precursor
The precursors with a low manganese content ≤ 0.07% Mn were synthesized by spontaneous crystallization from Zn2+, Mn2+ and C2O4 2−-containing solutions. The initial ratio Zn2+:C2O4 2− = 1:1 and 1:2 influences the morphology and prevailing orientations of the crystallites in the oxalate samples. The presence of such small Mn content in the samples does not change the morphology or size of the crystals. The ZnO and Mn/ZnO oxides with manganese content from 0.51×10−2 to 15.1×10−2 Wt % are obtained after thermal decomposition of the oxalates. The oxides preserved the morphology of the precursors. The catalytic tests show that the pure ZnO has a poor activity for CO oxidation reaction. Its doping with Mn promotes the catalytic activity (up from twice to five times) in spite of the very low contents of the dopants. The observed increase of the activity depends on both dopant concentration and Zn2+:C2O4 2− ratio, probably due to the different mechanism of the manganese inclusion and different morphology of the oxides. The catalysts of the 1:2 series are more active in CO oxidation reaction.
- 1 March 2008
- Published by Walter de Gruyter GmbH in Open Chemistry
- Vol. 6 (1) , 115-124
Open AccessInvestigation on the catalytic activity of doped low-percentage oxide catalysts Mn/ZnO obtained from oxalate precursor
The precursors with a low manganese content ≤ 0.07% Mn were synthesized by spontaneous crystallization from Zn2+, Mn2+ and C2O4 2−-containing solutions. The initial ratio Zn2+:C2O4 2− = 1:1 and 1:2 influences the morphology and prevailing orientations of the crystallites in the oxalate samples. The presence of such small Mn content in the samples does not change the morphology or size of the crystals. The ZnO and Mn/ZnO oxides with manganese content from 0.51×10−2 to 15.1×10−2 Wt % are obtained after thermal decomposition of the oxalates. The oxides preserved the morphology of the precursors. The catalytic tests show that the pure ZnO has a poor activity for CO oxidation reaction. Its doping with Mn promotes the catalytic activity (up from twice to five times) in spite of the very low contents of the dopants. The observed increase of the activity depends on both dopant concentration and Zn2+:C2O4 2− ratio, probably due to the different mechanism of the manganese inclusion and different morphology of the oxides. The catalysts of the 1:2 series are more active in CO oxidation reaction.
- Open Access
- 1 July 2006
- Published by SAGE Publications in Adsorption Science & Technology
- Vol. 24 (6) , 497-506
Porous Texture of CuO Prepared from Copper Oxalate Precursor
The porous texture of CuO obtained from CuC2O4 • 0.5H2O as a precursor, as well as the interconnection between the texture of the initial oxalate and that of the copper oxide obtained, has been studied by physisorption, XRD, XPS and SEM methods. The dimensions of the particle aggregates and the crystalline particles were altered as a consequence of the thermal decomposition of CuC2O4 • 0.5H2O to CuO, and this led to an increase of ca. 1.5-times in the specific surface of the CuO obtained relative to that of the initial substance. The comparatively non-uniform sizes of the intra-aggregate mesopores in CuC2O4 • 0.5H2O were transformed into considerably smaller intra-aggregate mesopores in CuO. A finite increase in the volume of the intra-crystallite pores in CuO was also observed, although this did not change the average size of the intra-crystallite pores in the oxide obtained nor the character of the pore-size distribution with respect to the starting material. In addition, as a result of the thermal decomposition of CuC2O4 • 0.5H2O, the mesoporosity of the prepared oxide also developed. However, the CuO component retained the textural type characteristic of the initial CuC2O4 • 0.5H2O.
- 1 July 2006
- Published by SAGE Publications in Adsorption Science & Technology
- Vol. 24 (6) , 497-506
Open AccessPorous Texture of CuO Prepared from Copper Oxalate Precursor
The porous texture of CuO obtained from CuC2O4 • 0.5H2O as a precursor, as well as the interconnection between the texture of the initial oxalate and that of the copper oxide obtained, has been studied by physisorption, XRD, XPS and SEM methods. The dimensions of the particle aggregates and the crystalline particles were altered as a consequence of the thermal decomposition of CuC2O4 • 0.5H2O to CuO, and this led to an increase of ca. 1.5-times in the specific surface of the CuO obtained relative to that of the initial substance. The comparatively non-uniform sizes of the intra-aggregate mesopores in CuC2O4 • 0.5H2O were transformed into considerably smaller intra-aggregate mesopores in CuO. A finite increase in the volume of the intra-crystallite pores in CuO was also observed, although this did not change the average size of the intra-crystallite pores in the oxide obtained nor the character of the pore-size distribution with respect to the starting material. In addition, as a result of the thermal decomposition of CuC2O4 • 0.5H2O, the mesoporosity of the prepared oxide also developed. However, the CuO component retained the textural type characteristic of the initial CuC2O4 • 0.5H2O.
- 1 August 2005
- Published by Springer Nature in Journal of Materials Science
- Vol. 40 (15) , 3881-3886
Review Thermal—magnetic investigation of the decomposition of copper oxalate—a precursor for catalysts
- 1 August 2005
- Published by Springer Nature in Journal of Materials Science
- Vol. 40 (15) , 3881-3886
Review Thermal—magnetic investigation of the decomposition of copper oxalate—a precursor for catalysts
- 19 February 2004
- Published by Wiley in Crystal Research and Technology
- Vol. 39 (3) , 207-213
Influence of complex formation upon inclusion of Mn(II), Co(II), Ni(II), and Cu(II) in ZnC2O4·2H2O
The inclusion of 3d‐impurities Mn(II), Co(II), Ni(II) and Cu(II) in a crystalline precipitate of ZnC2O4·2H2O is investigated. This study is a part of the systematic one deal with the mechanism of inclusion of 3d‐ions in sparingly soluble oxalate systems. The experiments are carried out in bi‐ end multi‐component systems at two different mediums – one with deficiency of oxalate ions, another with excess. The insertion of 3d‐ions upon mass crystallization of ZnC2O4·2H2O does not proceed by a simple ionic substitution. The results show that the inserted amount of impurity depends on some physicochemical characteristics of the neutral monooxalato complexes [MnC2O4]o, [CoC2O4]o, [NiC2O4]o and [CuC2O4]o. Good agreement between included impurity and the concentration of its complex in the solution is established. The stability constant of monooxalato complex affects the impurity inclusion. This effect depends on the medium nature. In the deficiency of oxalate ions the factor determining the inclusion is thermodynamic one – stability of monooxalato complexes. In the excess of oxalate ions inserted amount depends on kinetic factor – the formation rate of these complexes. In the term of that the insertion of Mn(II) is definitely different in the two mediums while that of the Ni (II) does not depend on the medium. The copper shows deviation from overall dependence in the two mediums due to the Jahn‐Teller distortion. Its double decreasing insertion in the excess of oxalate ions is related with stabilization of [Cu(C2O4)2]2‐. The conclusions presume that by varying the background medium and taking in view the ions present in the solution, the amount of inserted impurities can be predicted and controlled.
- 19 February 2004
- Published by Wiley in Crystal Research and Technology
- Vol. 39 (3) , 207-213
Influence of complex formation upon inclusion of Mn(II), Co(II), Ni(II), and Cu(II) in ZnC2O4·2H2O
The inclusion of 3d‐impurities Mn(II), Co(II), Ni(II) and Cu(II) in a crystalline precipitate of ZnC2O4·2H2O is investigated. This study is a part of the systematic one deal with the mechanism of inclusion of 3d‐ions in sparingly soluble oxalate systems. The experiments are carried out in bi‐ end multi‐component systems at two different mediums – one with deficiency of oxalate ions, another with excess. The insertion of 3d‐ions upon mass crystallization of ZnC2O4·2H2O does not proceed by a simple ionic substitution. The results show that the inserted amount of impurity depends on some physicochemical characteristics of the neutral monooxalato complexes [MnC2O4]o, [CoC2O4]o, [NiC2O4]o and [CuC2O4]o. Good agreement between included impurity and the concentration of its complex in the solution is established. The stability constant of monooxalato complex affects the impurity inclusion. This effect depends on the medium nature. In the deficiency of oxalate ions the factor determining the inclusion is thermodynamic one – stability of monooxalato complexes. In the excess of oxalate ions inserted amount depends on kinetic factor – the formation rate of these complexes. In the term of that the insertion of Mn(II) is definitely different in the two mediums while that of the Ni (II) does not depend on the medium. The copper shows deviation from overall dependence in the two mediums due to the Jahn‐Teller distortion. Its double decreasing insertion in the excess of oxalate ions is related with stabilization of [Cu(C2O4)2]2‐. The conclusions presume that by varying the background medium and taking in view the ions present in the solution, the amount of inserted impurities can be predicted and controlled.