Xu-Bao Sun
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Xu-Bao Sun has a total of 9 co-authors. Here are the top co-authors by number of shared publications:
Mao‐Yong Cao
Department of Communication Engineering College of Electronic Communication, Shandong University of Science and Technology Qingdao China
2 shared publications- Jianjun Hao
School of Electronic and Information Engineering, Shandong University of Science and Technology, China
1 shared publication Jian‐Jun Hao
College of Information and Electrical Engineering, Shandong University of Science and Technology, Qingdao, China
1 shared publicationLin Jiang
Department of Communication Engineering College of Electronic Communication, Shandong University of Science and Technology Qingdao China
1 shared publicationMao Yong Cao
Department of Communication Engineering, College of Electronic Communication Shandong University of Science and Technology Qianwangang Road, No. 579 266590 Qingdao People's Republic of China
1 shared publicationMao-Yong Cao
College of Information, Electrical Engineering, Shandong University of Science and Technology, Qingdao, Shandong 266510, China
1 shared publication
Latest Publications
- Open Access
- 1 January 2020
- Published by The Electromagnetics Academy in Progress In Electromagnetics Research Letters
- Vol. 90, 113-119
DESIGN OF A TRIPLE-BAND ANTENNA BASED ON ITS CURRENT DISTRIBUTION
A triple-band patch antenna operating at 0.9, 1.8 and 2.4 GHz is presented. The triple-band characteristic is realized by using a radiating patch and two meander lines achieved by embedding slots in its radiating patch. According to the current distribution of the radiating patch, the locations of two meander lines are chosen. The proposed antenna has the advantages of the easy control of each resonant frequency and relatively simple antenna structure. The measured-10 dB impedance bandwidths are 30, 40, and 30 MHz at 0.9, 1.8, and 2.4 GHz, respectively. The simulated and measured radiation patterns and gains are also presented and discussed.
- 1 January 2020
- Published by The Electromagnetics Academy in Progress In Electromagnetics Research Letters
- Vol. 90, 113-119
Open AccessDESIGN OF A TRIPLE-BAND ANTENNA BASED ON ITS CURRENT DISTRIBUTION
A triple-band patch antenna operating at 0.9, 1.8 and 2.4 GHz is presented. The triple-band characteristic is realized by using a radiating patch and two meander lines achieved by embedding slots in its radiating patch. According to the current distribution of the radiating patch, the locations of two meander lines are chosen. The proposed antenna has the advantages of the easy control of each resonant frequency and relatively simple antenna structure. The measured-10 dB impedance bandwidths are 30, 40, and 30 MHz at 0.9, 1.8, and 2.4 GHz, respectively. The simulated and measured radiation patterns and gains are also presented and discussed.
- Open Access
- 1 March 2017
- Published by Institution of Engineering and Technology (IET) in Electronics Letters
- Vol. 53 (6) , 368-370
Low mutual coupling antenna array for WLAN application
A mutual coupling reduction antenna design for WLAN MIMO application is proposed. The proposed antenna array consists of two rectangular patch antennas, six parallel metal strips, a single substrate layer, and common ground plane. About −42 dB mutual coupling is achieved at the 5.8 GHz resonant frequency. Both simulation and measurement results confirm improvements in mutual coupling at about 30 dB when compared with those without metal strips. The radiation patterns are almost unaffected by adding these metal strips in the proposed antenna.
- 1 March 2017
- Published by Institution of Engineering and Technology (IET) in Electronics Letters
- Vol. 53 (6) , 368-370
Open AccessLow mutual coupling antenna array for WLAN application
A mutual coupling reduction antenna design for WLAN MIMO application is proposed. The proposed antenna array consists of two rectangular patch antennas, six parallel metal strips, a single substrate layer, and common ground plane. About −42 dB mutual coupling is achieved at the 5.8 GHz resonant frequency. Both simulation and measurement results confirm improvements in mutual coupling at about 30 dB when compared with those without metal strips. The radiation patterns are almost unaffected by adding these metal strips in the proposed antenna.
- 26 September 2015
- Published by Wiley in Microwave and Optical Technology Letters
- Vol. 57 (12) , 2865-2867
A planar equiangular spiral antenna with two annular rings
This article presents a novel antenna with an improved impedance bandwidth and axial ratio bandwidth. This new design is comprised of an equiangular spiral and two annular rings on the same plane. These are printed on a Taconic substrate with a dielectric constant of 2.2 and a thickness of 1.52 mm. The proposed antenna has good performance compared with the conventional equiangular spiral antenna. The simulation results are validated through experimental measurements, and the overall size of the spiral antenna is visibly reduced. © 2015 Wiley Periodicals, Inc. Microwave Opt Technol Lett 57:2865–2867, 2015
- 26 September 2015
- Published by Wiley in Microwave and Optical Technology Letters
- Vol. 57 (12) , 2865-2867
A planar equiangular spiral antenna with two annular rings
This article presents a novel antenna with an improved impedance bandwidth and axial ratio bandwidth. This new design is comprised of an equiangular spiral and two annular rings on the same plane. These are printed on a Taconic substrate with a dielectric constant of 2.2 and a thickness of 1.52 mm. The proposed antenna has good performance compared with the conventional equiangular spiral antenna. The simulation results are validated through experimental measurements, and the overall size of the spiral antenna is visibly reduced. © 2015 Wiley Periodicals, Inc. Microwave Opt Technol Lett 57:2865–2867, 2015
- 20 January 2012
- Published by Wiley in Microwave and Optical Technology Letters
- Vol. 54 (3) , 593-595
A planar circular disc monopole antenna with improved bandwidth
- 20 January 2012
- Published by Wiley in Microwave and Optical Technology Letters
- Vol. 54 (3) , 593-595
A planar circular disc monopole antenna with improved bandwidth
- 6 November 2011
- Published by Elsevier in AEU - International Journal of Electronics and Communications
- Vol. 66 (6) , 465-466
A rectangular slot antenna with improved bandwidth
- 6 November 2011
- Published by Elsevier in AEU - International Journal of Electronics and Communications
- Vol. 66 (6) , 465-466
A rectangular slot antenna with improved bandwidth
- 5 March 2010
- Published by Wiley in Microwave and Optical Technology Letters
- Vol. 52 (5) , 999-1000
Circular-slotted microstrip antenna for GPS
- 5 March 2010
- Published by Wiley in Microwave and Optical Technology Letters
- Vol. 52 (5) , 999-1000
Circular-slotted microstrip antenna for GPS
- 1 October 2006
- Published by Springer Nature in Journal of Shanghai University (English Edition)
- Vol. 10 (5) , 421-424
Adaptive OFDM system based on space-time block code
- 1 October 2006
- Published by Springer Nature in Journal of Shanghai University (English Edition)
- Vol. 10 (5) , 421-424
Adaptive OFDM system based on space-time block code